Showing results: 2836 - 2850 of 8764 items found.
-
LCR01D -
MINPU TECHNOLOGY CO., LTD.
*Basic accuracy:0.3%*Test Voltage: 0.5Vrms* Circuit Calibration:Open/Short*Test Frequency:10MHz,5MHz,1MHz,100KHz,10KHz,1KHz*Measure Parameters Include:Z, Lp, Ls, Cp, Cs, ESR, D, Q, θ
-
CNS346 Series -
Spanawave Corporation
The Spanawave CNS346 Series is designed for precision noise figure measurement applications. The superior VSWR characteristics reduce multiple reflections of the test signals and significantly increase the measurement accuracy of most noise figure set-ups. The CNS346 Series noise sources have broadband coverage and extremely good temperature and voltage stability, for the finest noise figure meter-compatible laboratory standards. Outputs of 6, 15.5 and 22 dB ENR are available, allowing the units to accurately measure noise figures up to 20 ,30 and 36 dB respectively.
-
CM-51 -
Taylor Dynamometer, Inc.
AC power, air and water required at one side wallas applicable.• Room length, and pit location within length,must be determined by user to fit maximumtruck length and rear overhang.• Provide at least one man door for fire escapenear rear of room, but not in rear wall becausesomeone entering during a test could be struckby a stone flung from a tire. Provide ample fireextinguishers at each door and near driver.• “Back-on, Drive-off” installation configurationpreferred.
-
TD-24 -
Taylor Dynamometer, Inc.
AC power, air and water required at one side wallas applicable.• Room length, and pit location within length,must be determined by user to fit maximumtruck length and rear overhang.• Provide at least one man door for fire escapenear rear of room, but not in rear wall becausesomeone entering during a test could be struckby a stone flung from a tire. Provide ample fireextinguishers at each door and near driver.• “Back-on, Drive-off” installation configurationpreferred
-
AVC1553-x -
AIM GmbH
MIL-STD-1553 Test and Simulation module for VME (6U) with 1, 2, 4 or 8 dual redundant channels.Integrated modular solution by using the AMCX1553-x PMC cards installed on AIM’s AVC-2 Generic VME64x (6U) Carrier card.
-
AR438 -
6TL Engineering
AR438 module helps with interconnection, power supply and load switching, monophasic and triphasic, adding the current measurement capability up to 10A.Enable input helps for a safe relay disconnection. It is a quick electrical -hardware- disconnection of the relays and is designed to be an auxiliary safety element, so that loads cannot reach the device under test.
-
CP TC12 -
OMICRON electronics
The CP TC12 oil test cell is for determining the relative permittivity, the dissipation factor and the power factor of insulating liquids such as transformer oil.
-
1465 -
Saluki Technology Inc.
1465 series microwave signal generators, with the frequency range of 100kHz – 67GHz, is provided with high purity spectrum and high output power. It can meet the high-end requirements of electromagnetic signal tests. S1465 series are mainly used in the radar performance evaluation, high-performance receiver test and components parameter test etc., and applicable to aviation, aerospace, radar, communication and navigation equipment etc.
-
EL63150B -
MCH Instruments Co.,Ltd.
Features:*Number operation and control*LED display with high definition and high contrast, rich display information*Easy operation of knob encoder switch*Basic load function: constant current, voltage, power and resistance*Multi units used to multiple load ability*Short-circuit test*Battery test*Dynamic test*Multi parameters measured in the list*Remote voltage measurement*Panel and exterior trigger function*Protection function: over-voltage, over-current, over-power, over-heat, polarity connection in reverse*10 sets of parameters memorized and loaded, and automatically loaded on turning on the instrument*Intelligent fan control*Key lock and knob lock functions
-
QCP-1553 -
Terotest Systems Ltd.
The QCP-1553 module is a rugged, reliable, full featured, Compact PCI module designed to provide a stand-alone, MIL-STD-1553A/B interface for avionics applications. Up to four independent dual redundant MIL-STD-1553 databus streams are supported by the 3U QCP-1553 module. Additionally, the module offers full functional test, simulation, monitoring and databus analyzer functions for MILSTD-1553A/B applications. An onboard IRIG-B time code decoder and generator allows users to accurately synchronize single or multiple QCP-1553 modules to a common time source.
-
QCP-1553 Series -
Marvin Test Solutions, Inc.
The QCP-1553 module is a rugged, reliable, full featured, Compact PCI module designed to provide a stand-alone, MIL-STD-1553A/B interface for avionics applications. Up to four independent dual redundant MIL-STD-1553 databus streams are supported by the 3U QCP-1553 module. Additionally, the module offers full functional test, simulation, monitoring and databus analyzer functions for MILSTD-1553A/B applications. An onboard IRIG-B time code decoder and generator allows users to accurately synchronize single or multiple QCP-1553 modules to a common time source. The QCP-1553 module is available in dual or full function (RT simulation, monitoring, and bus controller) configurations.
-
PCCextend 120CIB -
Sycard Technology
For those applications that require access to the 16-bit PC Card that can't use a standard extender card, Sycard provides the PCCextend 120CIB (Card Interface Board) which allows full access to all 68-signal and power pins on the PC Card peripheral. Standard 0.1" headers allow the user to connect standard 34-pin ribbon cable to test or prototype hardware.
-
PCCextend 100 -
Sycard Technology
The PCCextend 100 is the ultimate in extender cards. It provides developers of 16-bit PC Card hosts and cards a convenient way of accessing signals on the 16-bit PC Card interface. All 68-pins are accessible via standard 0.1" test posts. Multi-layer design with separate ground and power planes assure trouble free operation.
-
PCCextend 120 -
Sycard Technology
The PCCextend 120 is a flexible extender card designed to provide easy access to a 16-bit PC Card for debug or test. Designed with the same low noise characteristics of our PCCextend 100, the PCCextend 120 takes this design a step further by connecting the host and card via ribbon cables.
-
PCCextend 120 HIB -
Sycard Technology
For those applications that require access to the 16-bit PC Card interface that can't use a standard extender card, Sycard provides the PCCextend 120 HIB (Host Interface Board) which allows full access to all 68-signal and power pins on the PC Card host. Standard 0.1" headers allow the user to connect standard 34-pin ribbon cable to test or prototype hardware.