Showing results: 661 - 675 of 7502 items found.
-
Series 118 -
Pickering Electronics
The Pickering Series 118 is a range of very sensitive reed relays that are ideal for portable electronic instruments or other applications where low power consumption and a very small footprint is important. They have 5 volt coils with a resistance up to 2200 Ohms and the option of an internal diode.
-
YAV90CIN -
6TL Engineering
12 Independent SPST relays Switching up to 8A 250Vac 12 current measurement channels 8x Sense connections General inhibit input CAN Control (or Ethernet with Ethernet to CAN Gateway) Drivers dll & VIs available
-
Power-1410 -
Quantifi Photonics Inc.
Quantifi Photonics’ Power-1410 optical power meter provides fast monitoring of signal power from -60 to +10 dBm and broad wavelength range of 1250 to 1650 nm. It provides unrivalled channel density with up to 288 parallel channels in a single 1U rack-mountable instrument.
-
MHD/MDD/MDP Series -
Smiths Interconnect
Smiths Interconnect's MHD/MDD/MDP series is an ESA qualified, high density board to board and board to wire interconnect available in up to 400 positions, with available insulators to accommodate coax and power contacts.
-
VPX340 -
W-IE-NE-R, Plein & Baus GmbH
WIENER VPX power supplies are commercial off-the-shelf (COTS), conduction cooled single stage converters according to the ANSI/VITA 62.0 specification. They can be used to power a VPX chassis and will fit into the standard envelope defined by VITA 48.0 specifications.
-
Green4Cast Series -
TeamCast
The Green4Cast product line is targeted to meet transmitter manufacturers’ requirements for high efficiency as well as high quality DVB-T2 or ISDB-T/TB transmitting products and is designed to be integrated within high, medium and low power Broadcast Transmitters.
-
-
Model 2100HF -
TREK, INC.
The Model 2100HF incorporates an all-solid-state design for high reliability and low-noise operation, thus achieving accurate output response and high slew rates, even into highly capacitive loads. Full power frequency response of the amplifier is essentially flat up to 2 MHz. No overshoot or instability of the waveform occurs due to the amplifier's unique dual feedback feature.
-
SKS-H04GA -
Shanghai Sanki Electronic Industries Co., Ltd.
The high-frequency noise simulation generator is an EMC test instrument that reproduces high-frequency noise with a fast rise time when the switch is turned on/off. Since the pulse rise time is less than 1ns and contains wide bandwidth noise, it is very suitable for reproducing malfunctions. The line noise entering the power line and the induced noise entering the communication line can be reproduced, and the performance evaluation of the malfunction and function degradation of electronic products can be performed.
-
Alliance Support Partners, Inc.
he ASP-DCD-00 board is a high impedance input clock divider circuit. It is designed to provide minimum load to a clock source for frequency measurement. It accept single ended (Unbalanced) or differential (Balanced) signals with amplitudes as little as 100mV rms; it divides the input signal frequency from 2 to 256 times depending on shunt jumper selections on J3. The board requires 5VDC 500mA power source to operate. The output is capable of driving 5V TTL logic levels.
-
Mors Smitt Group
High impedance protection schemes are widely used for the protection of BUS bars, generators, motors & power transformers. BUS bar protection schemes utilizing electromechanical high impedance differential relays are often used due to their simplicity, reliability & comparatively low cost.
-
Alpes Lasers sa
Based on a unique gain-guided design, these Quantum Cascade Lasers are optimized for emitting short pulses from 20 ns to 1000 ns with minimum peak power of 20 W, or ~5 microjoules per pulse. Available on submount or in a HHL package with a dedicated driver, these lasers can be used for free-space optical communications, LIDAR applications and IR countermeasures.
-
MXC-6400 Series -
ADLINK Technology Inc.
The Matrix MXC-6400 series is a line of high-performance fanless embedded computers, integrating 6th generation Intel® Core™ i7/i5/i3 processors and the QM170 chipset for more powerful computing and graphics performance with minimal power consumption.
-
LTK-1 -
EXFO Inc.
The LTK-1 combines the FTB-1750 power meter module with the new LTB-1 platform. The kit delivers a high-performance benchtop power meter solution. This test kit can be tailored to meet the needs of the lab engineer looking for high performance as well as the needs of the production manager looking for a small, cost-effective solution that can easily be automated. The LTK-1 was designed to help network equipment manufacturers get the best performance from their test sets.
-
EnsembleSeries™ -
Mercury Systems, Inc.
Our high-performance compute blades are characterized by their compute power and density achieved by embedding the most contemporary processors, including Scalable Intel® Xeon® datacenter processors.