Showing results: 646 - 660 of 2823 items found.
-
-
-
-
-
-
-
Probe 13 -
Shenzhen Chuangxin Instruments Co., Ltd.
Short Test Pin Probe 13 The model CX-13 short Test Pin Probe is used to test for accessibility of small objects and meets IEC, CSA and UL requirements.
-
CX-112 -
Shenzhen Chuangxin Instruments Co., Ltd.
1. Jointed test finger probe (Figure 2 / Test Probe B / IEC 61032)This is a precision probe made in accordance with all IEC standards. Examples are IEC 61032, 60950, 61010 and 60601; and it is also used for Canadian and USA standards. It features a palm simulator and a restricted joint movement, which simulates the characteristics of the human hand. The finger is made of stainless steel and the rest of the instrument is Delrin®. Handle is designed to accept either a banana jack or a force gauge.It is no longer necessary to have a separate probe for the medical safety standard. This one probe will meet all the different requirements that are in the IEC standards.
-
MetrologyWorks, Inc.
MetrologyWorks can provide substantial savings on your next Faro Arm probe. When it comes to unique probes and accessories we have the largest selection of ball probes and styli for portable CMM arms. This includes standard length rigid probe configurations and extended length styli in a variety of materials including Stainless Steel and Zircon (Zirconia). We also stock magnetic mounts, rolling tripods, portable stand and a number of other portable CMM accessories including leapfrog spheres and cones.
-
RF100 -
Laplace Instruments Ltd.
The RF100 probe set consists of a passive E field probe and H field probe, BNC adaptor and carry case. The output is via a BNC socket. These are general purpose probes which are ideal for use in conjunction with an EMC measuring system. They are sensitive to sources in close proximity, but are insensitive to background signals. This makes them ideal for the identification of emission frequencies in noisy environments... thus making measurements easier and quicker. The proximity requirement also enables sources to be located and the exit route identified.
-
Four Dimensions, Inc.
Based on decades of experience with needle four point probes and C-V, I-V Mercury probing stations, Four Dimensions developed a Mercury four point probe (patent pending). The liquid metal Mercury is used to form temporary electrical contacts at four terminals. These probes cause no damage to the sample and permit no contact pressure probing.
-
Metal Samples Company
Linear polarization resistance (rosion probes are commonly used in the water treating industry and other environments where instantaneous, on-line corrosion rate readings are required. Linear polarization probes are ideally suited to monitor fluctuations that may occur within a system; for example, these probes can be used to monitor corrosion inhibitor effects on a regular basis.
-
Monitran Ltd.
Proximity sensors work on the eddy current principle. A proximity system consists of an eddy current probe, extension cable and driver. A high-frequency RF signal is generated by the driver, sent through the extension and probe cables and radiated from the probe tip. The tip consists of a precision wound copper coil inside a chemical and temperature resistant PEEK case.
-
S.TV -
Delta OHM S.r.L.
Temperature and humiduty vertical probe for transmitters.
-
Coda Systems Ltd.
Low profile, short travel test probes for restricted space applicationsApplications where long travel is not required such as thin film/hybrid circuits or bareboard PCB testingReplaceable test probe by use of a receptacle