-
product
PCI High Density Resistor Card 10-Channel, 16-Bit, 0 To 65k Ohm
50-295A-121-10/16
The 50-295A is a Programmable Resistor card with up to 18-channels of 8-bit resolution resistor chains in a single PCI slot. The flexible architecture allows the card to also be supplied as 12-bit, 16-bit or 24-bit resolution versions for applications requiring finer resolution, greater resistance range or higher channel count. The card is ideal for simulating the sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.
-
product
XRF analysis
X-Supreme8000
XRF analysis (X-ray fluorescence) with the highly flexible and powerful energy-dispersive X-ray fluorescence (EDXRF) spectrometer X-Supreme8000 for quality assurance and process control requirements across a diverse range of industries.
-
product
WDXRF Spectrometer
Axios FAST
Do you need non-destructive analysis of chemical composition in seconds because of time-critical process control or running sample high-throughputs? With up to 28 elements measured simultaneously in concentration ranges from ppm to 100%, the Malvern Panalytical Axios FAST simultaneous WDXRF spectrometer is the ideal solution. Accurate and robust analysis, ease of operation by less-experienced staff and high uptime go hand in hand with a low cost of ownership.
-
product
Test System for Circuit Breakers
Spitzenberger & Spies GmbH & Co. KG
Thermal testing with long-time currents up to 550 A. Magnetic testing with short-time currents up to 2000 A. Control software. Customer specifically adapted. 4 candidate records with pneumatic adapting.
-
product
The Automation Hardware
CandyBox
Supports any infrared based deviceAutomate unlimited devices from one accountAutomate remote devicesPrecise, collision-free infrared signal targetingBuilt-in recorder for infrared codesExtremely easy and user-friendly setup8 or 40 independent control portsBrowser based virtual remote controlRecord and replay key sequencesEmulate power cutsAPIs coming soon
-
product
Fixed Ultrasonic Heat Meter
E3
Gentos Measurement & Control Co.
In times of increasing energy costs, it is important to measure and control energy consumption accurately. Energy Meters, commonly referred to as BTU meters or heat/ cold meter, can be defined by the measurement of heat/chilled water energy consumption.
-
product
Althletic Chamber
Sanwood Environmental Chambers Co ., Ltd.
The Athletic Environmental Chamber is specifically design for athletic training which request the CO2 , O2 control inside the environmental chamber. It is suitable for sports and science investigation.
-
product
Sludge Level Detector
SL-200B
Sludge Level Detector SL-200B measures the sludge level accurately using ultrasonic reflectometry, and supports more efficient operations, such as remote control and automation.The display section displays the sedimentation state visually and easily understandable using a color graph display. It contributes to sludge removal work.
-
product
Software Abstraction for Easy Control of DC Power Supplies
Konrad DCPower
It consists of three modules:- A windows driver which is responsible for the communication and device abstraction- A DLL with NI TestStand Test Steps which allows easy integration in automated production environments- A standalone executable which simplifies debugging and setup of test sequencesThis architecture allows to open a communication channel from multiple instances to the same device. This is important when for example two channels of a power supply are used in two independent applications.
-
product
Electronic Tire Tester
Model BTT-5700
The Branick BTT-5700 was created from the ground up to be the most efficient, durable and reliable electronic tire tester available. The electronic detector accurately locates flaws that may be missed using conventional methods. A visible spark occurs at the site of a flaw and the rotation stops to allow the flaw to be marked. The adjustable height platform reduces physical strain that can often lead to workers compensation claims. The BTT-5700 also features a bi-directional variable speed elect...show more -
product
Software Packages
GLUON
The software uses notched specimens (CT specimens) to evaluate the material elasto-plastic fracture toughness value (JIC). The test is conducted at constant loading rate under test-force control or CTOD control and the load is removed to calculate the crack length. The software plots graphs of the crack length increase (Δa) and crack growth resistance (J value) from the acquired data, calculates the JIC value, and evaluates its validity.
-
product
Mobilize
The Mobilize Solution dramatically reduces testing time and automatically records all your service work. Combines Pronk Mobilize products to control and capture all the testing information into a single comprehensive electronic report!
-
product
Reach-In Temperature and Humidity Control Chamber
The High Low Humidity and Temperature Test Chamber from Weiber are specially designed equipments that are used for testing a wide variety of products for their performance under alternating hot and cold temperature and humidity conditions. These test chambers are most commonly employed for the testing of electronic items, electrical devices and equipments, aviation products and other materials and find widespread usage in aerospace industries, electronics industry and scientific organizations in...show more -
product
IMS-SIP Network Emulator Software
E6966B
Wireless telephony networks are increasing capacity for high throughput Internet Protocol (IP) packed-data by utilizing radio access technologies such as LTE and HSPA. Session Initiation Protocol (SIP) and IP Multimedia Subsystem (IMS) are progressively being adopted as part of the network infrastructure to carry traditional wireless telephony services over an all-IP network. SIP provides control of communication sessions whilst IMS is the framework that allows delivery of multimedia services over IP. With this new capability comes the need for developers and operators to move their focus to testing user equipment (UE) in this new network environment.
-
product
PXI-6232, 16 AI (16-Bit, 250 kS/s), 2 AO, 6 DI, 4 Sourcing DO, Bank-Isolated, PXI Multifunction I/O Module
779618-01
16 AI (16-Bit, 250 kS/s), 2 AO, 6 DI, 4 Sourcing DO, Bank-Isolated, PXI Multifunction I/O Module—The PXI‑6232 is a bank-isolated DAQ device designed for voltage I/O. It offers analog I/O, digital input, sourcing digital output, two 32‑bit counters, and digital triggering. The digital input and outputs are compatible with 24 V signals. It combines the safety and performance benefits of isolation with high-performance timing, amplification, and calibration technologies to offer accurate measuremen...show more -
product
On-line Crossbelt Analyzers
CNA Range
CNA online elemental analyzers are available in three models:*CNA³: This cross belt analyzer is designed for minerals applications that feature wide conveyor belts with deep loads and large material size. It is an open analyzer that is installed below the belt with both the neutron source and the detectors below. *CNA Pentos Cement: This cross belt analyzer is used primarily in cement and related industries. It is a closed analyzer that encircles the conveyor belt with the neutron source below the belt.*CNA Nickel: This cross belt analyzer offers real-time quality control for the nickel ore mining industry.
-
product
Polarity Indicator Circuit Tester
CT8007
No ground wire means no wire tangles nor time lost searching for grounding points. High Impedance electronic circuitry. Negligible current draw ( 1 microampere) is 30,000 times less than regular lamp type testers. This gives complete safety when working around sensitive electronic control modules and sensors. Operating range between 6 and 28 Volt DC in battery powered systems
-
product
Area/process radiation monitoring
Monitors gamma and beta rays/ neutron with high accuracy and reliability. *Each monitor is controlled with central control system and alarm is given when the measurement exceeds alarm level. Area monitors and dust monitors.
-
product
PXIe-8399, Gen 3, x16, 2-Port PXI Remote Control Module
784180-01
PXIe, Gen 3, x16, 2-Port PXI Remote Control Module—The PXIe-8399 enables control of a PXI Express chassis from an external host, such as a desktop PC, rackmount controller, or a separate master chassis. Using a Gen 3 x16 PCI Express link, the PXIe-8399 provides up to 16 GB/s of data transfer between the chassis and host over a copper cable connection. An additional port allows daisy-chaining for multi-chassis configurations.
-
product
Voltage Meter
MN3I
М-module МН3И is a mezzanine module designed to measure the instantaneous voltage value of high-frequency signals via 3 galvanically isolated channels from each other, control circuits and crate frame.
-
product
Laser Series
Jutze
Jutze laser marker series is equipped with Panasonic high-quality laser units. The laser unit, coupled with Z axis control, makes it capable of handling different thicknesses of PCBs & components. Adjustable range ± 3mm.
-
product
Vapor Source Mass Flow Controller With Viscous Laminar Flow
The 1152C Vapor Source Mass Flow Controller is a pressure-based measurement and control system designed to meter and control vapor from low vapor pressure liquid and solid sources directly, without the need of a carrier gas. The 1152C consists of a fixed flow element and two capacitance manometers for flow measurement, with a proportioning solenoid control valve for flow control.
-
product
Source Phase Control
S96088B
The S96088B allows users to set calibrated, arbitrary phase differences between two signal sources running on the E5080B ENA.
-
product
PXI DeviceNet Interface Module
PXI DeviceNet Interface Modules have an onboard microprocessor and optically isolated physical layer to communicate with a DeviceNet network system as a master (scanner) or slave device. The modules ship with a high-level API that provides complete access to a DeviceNet network and features easy access to device data and streamlined explicit messaging. PXI DeviceNet Interface Modules are ideal for prototyping DeviceNet systems, PC-based control, embedded control systems, PC-based human machine interface (HMI), and DeviceNet network management utilities.
-
product
PCI, IEEE 488 GPIB Instrument Control Device for Windows, Low Profile
783007-01
The PCI‑GPIB is a plug‑and‑play IEEE 488 interface for PCs and workstations with PCI expansion slots. The PCI‑GPIB can sustain data transfer rates of more than 1.5 MB/s using the IEEE 488.1 three‑wire interlocked handshake. It also implements the high-speed IEEE 488.1 noninterlocked handshake (HS488) for benchmarked data transfers at more than 7.7 MB/s. The onboard bus master DMA controller means that there are no microprocessor interruptions in data transfer.
-
product
2-Axis Automation
ASX-6300 Series
The ASX-6300 series fraction collector gathers up to eight fractions from a digester or other source. Waste is minimized by returning unused material to the source. It is designed to be sturdy, reliable, and easy to use. The fraction collector is typically interfaced to and controlled by the same computer which controls the rest of the system.
-
product
Solid State Relay for AC Power Switching Applications
Part No. 601
The 601 is a state-of-the-art solid-state relay designed for use in AC power switching applications. These relays utilize optical isolation and feature zero-cross switching. MSL 1Available options include:601-1 5A, 280Vac Load; 3.0-32Vdc Control601-2 10A, 280Vac Load; 3.0-32Vdc Control
-
product
AI ANALYZER
Nanotronics uses artificial intelligence to give our customers’ unprecedented freedom and control for defect detection. We offer an AI based Anomaly Detection Algorithm (ADA) toolkit that automates the work of writing computer vision algorithms to detect and classify defects on bare substrate and epi wafers as well as on thin films, glass and any other material with a uniform background.
-
product
Saab Oxygen Sensor
KS60113 - Saab
Konstar Electric Industrial Co., Ltd
An oxygen sensor, also known as a lambda sensor, continually detects the oxygen content in the exhaust gases of an engine. The oxygen sensor output signal informs the vehicle's ECU (Electronic Control Unit) whether the AFR (Air-Fuel Ratio) is lean or rich. Based on this, the ECU adjusts the amount of fuel injected into the engine to achieve an optimal AFR.
-
product
Digitally-Tuned Matching
Navigator II
The Navigator® ll is equipped with microprocessor-controlled, stepper-motor drives, and advanced tuning algorithms — enabling optimized RF power. An optional internal Z’Scan® II RF sensor provides real-time analysis of process power and impedance — allowing you to quickly identify and significantly reduce process variability. Optional Virtual Front Panel software is available for monitoring and control through a user’s computer.
