Showing results: 976 - 990 of 2622 items found.
-
Sencera Co.
Alcohol Sensor for use in Breathalyzer's or in an alarm unit, to detect the presence of alcohol vapors. This sensor unit offers very high sensitivity, combined with a fast response time. The unit will work with a simple drive circuit and offers excellent stability with long life.
-
EM-6860 | 60 MHz – 1GHz -
Electro-Metrics Corp.
The EM-6860 Omni Wideband Antenna is a vertically polarized broadband antenna designed to operate from 60 MHz to 1 GHz and is intended for Spectrum monitoring. The antenna utilizes a passive filter plus an amplifier circuit for increased gain over the entire bandwidth.
-
Guangdong Bell Experiment Equipment Co.,Ltd
DGBell's battery test equipments series mainly for testing the battery module of Electric-bike, Electric Motorcycles, etc. These series meet the standard compliance of IEC62619, UL2580 and GB31485-2015. Including short circuit, thermal test, drop test and crush test, etc.
-
OP-SB85C -
LINEEYE Co., Ltd.
This expansion kit supports current loop communications.The kit incorporates a communications circuit with photo-coupler isolation and constant-current power supply of insulated type, thus realizing not only monitoring but also easy communications testing with passive or active current loop devices.
-
ECT
Functional testing is done to insure that a completed printed circuit board will operate correctly in the final product. Failures detected at this time will consist of interactional problems between components. Testing here can be used to set board variables such as timers or limiters to proper settings.
-
LRA -
RARA Electronics Corporation
*This specification is applicable to lead free, halogen free of RoHS directive for metal alloy low-resistance resistor.*This product is for general purpose.*LR-A series : AEC-Q200 qualified available.*Miniature size suitable for compact Print Circuit Boards of high-precision electronic products.
-
Teledyne Labtech
Teledyne Labtech is recognised as a world leading supplier of complex RF PCB and Microwave Printed Circuit Boards. With over 35 years’ experience, Teledyne Labtech is your “one-stop” solution for design, manufacture and test of the most demanding RF/Microwave PCB designs.
-
ROMpak -
Rotork plc
The ROM range of actuators can be enhanced with the addition of a self-contained control package to create a ROMpak actuator. This adds local controls, status indication relays, isolated control circuits and support for Rotork control options such as Folomatic, Pakscan™ and other bus systems.
-
JFW Industries
In circuits are used to lower voltage, dissipate power, and to improve impedance matching. In measuring signals, attenuator pads or adapters are used to lower the amplitude of the signal a known amount to enable measurements, or to protect the measuring device from signal levels that might damage it.
-
PVR™ 2 -
Peavey Electronics
Omni-directional microphone for free-field measurement. With a highly reliable circuit and a 1/4" pre-polarized condenser capsule, it boasts high stability, low distortion and low noise in performance. Its excellent flat frequency response makes it ideal for sonic analysis systems and recording.
-
Crest Test Systems Pvt. Ltd.
HV Test, which is also known as Hipot Test – short form of high potential – is used to test the insulation quality of the auxiliary circuit of circuit breakers. The HV Test is useful in finding damaged insulation, stray conductive materials around the conductors, and problems due to terminal spacing and tolerance errors in cables.
-
YL Series -
Shanghai Jiuzhi Electric Co., Ltd.
The SF6 gas insulated standard capacitor is used together with a C and tan delta measuring bridge as the comparison standard leg of the bridge. It is used as Capacitance standard in measuring bridge Circuits to measure the dielectric dissipation Factor tand, Further-more, It can be used as high-voltage capacitor for voltage divider circuits of high-voltage transformer test.
-
DWX Series -
ECG KOKUSAI Co., Ltd.
The DWX tester is designed to test other coils and low inductance coils used in high-end electronic components. Through the use of impulse power source with high-speed switch, highly efficient input circuit, and high-speed A/D sampling circuit, the DWX tester can offer a new solution to the low inductance coil tests.
-
ITA -
Circuit Check, Inc.
Circuit Check is focused on the military and aerospace market. Our solutions are delivered according to a rigorous set of test requirements and quality metrics. The Circuit Check staff of engineers follow a defined Project Management process to control the project deliverables,manage the scope, and meet the quality needs for in-field serviceability and test system longevity.
-
LAB / S -
ET System Electronic GmbH
*Linear laboratory power supply*High quality DC sources with the lowest residual ripple*CV / CC mode with LED display*Protection against short circuit, overload and overtemperature*Optional IEEE 488, RS232, analog interfaces*3-phase input optional