Showing results: 5191 - 5205 of 9089 items found.
-
IFB112 -
Axiomtek Co., Ltd.
The IFB112.supports the low power consumption NXP (Freescale) i.MX6UL ARM® Cortex™-A7 528MHz SoC. The design concept of IFB112 is aiming to meet the demands of mission-critical applications. The gateway controller with IP30-rated aluminum and steel enclosure supports an extended operating temperature ranging from -40°C to 70°C, a wide voltage range of 9V - 48V DC power input with terminal block, and has been designed to withstand vibration up to 5G. For system integrators with wireless communication needs, the IFB112 has one PCI Express Mini Card slot, one SIM card slot, and two internal antennas. It supports one serial port, two LANs and one CANbus port to enable fast and efficient data acquisition and communication. Its digital I/O port provides users with a convenience of digital devices connection.
-
Exodus Advanced Communications
Exodus Pulse SSPA products feature LDMOS and GaN discrete and Chip & Wire technologies covering frequency ranges from 1MHz to 12GHz at power levels exceeding 1KW for Modules and 10KW for Systems.
-
Dynamic Engineering
The PIM-Parallel-IO facilitates rear panel IO in cPCI based systems using PMC's. The PIM-Parallel-IO provides the PMC_Parallel_IO front panel IO where rear panel IO is desired. The PIM-Parallel-IO can be used with other PMCs as well.
-
310113460 -
Virginia Panel Corporation
The receiver protective cover is designed to protect your modules and contacts while the test system is not in use. A protective cover is included with the iCon Receiver. The receiver protective cover comes with a beaded chain and mounting hardware.
-
STME-PVS -
Statclean Technology (S) Pte Ltd
This meter is designed to measure static charges and to verify ionizer performance. It consist of three components- an Electrostatic Fieldmeter, a Detachable Plate and a Charger.
-
ChenYang Technologies GmbH & Co. KG
Is designed and made according to the Standard JB/T8225-1999 for DC resistors used in laboratory and electrical engineering.By using full closed structure and automatictemperature control it ensures resistor good long-term stability and small temperaturecoefficient. This DC resistor is very suitablefor DC current measurement and calibration of current measuring systems and current sensors. The maximal measuring current is 100A with measuring accuracy of ±0.02%
-
The Elephant -
Netcare International
Drawing its name from the well known analogy of the elephant in the room: where everybody knows it’s there but are chosing to ignore it, we realised that this was the situation with the front end to SAP Document Management (SAP DMS) where the future decommissioning of several features was known about but no one was making an effort to find a replacement. With our highly skilled developers and working in partnership with Vestas Wind Systems to answer specific requirements we have arrived at a solution that will not only fill the missing capabilities that EasyDMS offered but also offer many advanced features to further enhance your working practices.
-
DP-cPCI-5112 -
Data Patterns Pvt. Ltd.
DP-cPCI-5112 provides a compact high performance cPCI bus gateway to four ANSI approved M-Module Interfaces. This is a non-intelligent 6U form factor M-Module Carrier board. The DP-cPCI-5112 allows a flexible I/O solutions to be implemented in the carrier board. The M-Module carrier board occupies single slot in a CompactPCI system. Different mix and match of various I/O solutions will simplify the job for system integrators.
-
ICAP/4Rx -
Intusoft
ICAP/4Rx RF Deluxe is an extended version of ICAP/4Rx, including simulation capability for RF frequency design. This powerful system includes everything you need to design and verify all types of board, engineering system and IC-level design. Of course, ICAP/4Rx Power Deluxe includes Intusoft's time-tested "IsSpice4" analog and mixed-signal simulation kernel, featuring more enhancement than any SPICE kernel on the market for convergence, accuracy, speed and interactive capability.
-
TERRA -
Olympus Corp.
The TERRA Mobile XRD System, a high performing, completely contained, battery operated, closed-beam portable XRD, provides full phase ID of major, minor and trace components with a qualitative XRF scan of elements Ca - U. Its unique, minimal sample prep technique and sample chamber allow for fast, in-field analysis.
-
MARGA -
Metrohm AG
MARGA is a fully autonomous sampling and measurement system that continuously measures the water-soluble gas and aerosol components that have a direct effect on air quality. These results can then be used to study the formation of aerosols from their precursor gases and how their concentration and composition vary with diurnal and seasonal cycles.
-
XPS1 -
NG Systems Ltd
The NG Systems PoE/Data Splitter (XPS1) is an installation device which allows PoE power to be delivered to a camera whilst allowing a direct connection to a laptop or other device (e.g. Pinger). This significantly simplifies camera configuration or lens focusing and shortens installation time.
-
FuG Elektronik GmbH
Global Mobile Personal Communication (GMPCS) or simply Satellite Phone Communication Interception solutions assist LEAs with real-time interception and analysis of voice, short message and data communication over Thuraya, Inmarsat and Iridium satellite phones and BeiDou terminals. The solutions are scalable and customizable based on the end customer’s requirements.
-
SKY Computers, Inc.
Preconfigured VME systems are available in the 6U and 9U form factors and in a variety of chassis sizes, from 7 slots to 21 slots to fit varying price ranges and application needs. Each SKYsystem chassis has been tested for power and cooling requirements for the maximum number of processor boards. VME SKYchannel boards can be ordered as upgrades or additions to an existing SKYchannel System in order to increase processing capabilities for future requirements
-
CT-450 -
CoolMax Technology Inc.
The CT series has a dual smart fan system that provides the fastest cooling system while maintaining a low noise level. The fans are installed in the front and rear of the power supply for maximum cooling efficiency. The CT series have all the necessary connectors to power all your devices and components. And it is PCI-E ready.