Showing results: 151 - 165 of 587 items found.
-
HDK -
Laser-Detect Systems Ltd.
LDS Hybrid Detection Kit (HDK) - By operating the sensors in parallel, and in real-time, results in much higher probability of detection than the performance of each specific detector. Integrated solution including laser detection technologies, dual Ion Mobility Spectroscopy (IMS) and chemical detection, that operate in synch. The HDK employs a proprietary algorithm to processes the feeds from each of the detectors. Operating the sensors in parallel, and in real-time, results in a much higher probability of detection than the performance of each specific detector. HDK also provides much lower false positive rate, even in conditions that hinder detection by each of the specific techniques.
-
XJFlash -
XJTAG Ltd.
XJFlash is an FPGA-based advanced and innovative method that uses JTAG for high-speed in-system programming (ISP) of flash memories – all serial and parallel flash devices are supported. The most common use of XJFlash is programming the SPI/QSPI NOR flash used to configure an FPGA.
-
Teradyne, Inc.
TestStation Multi-Site Inline is the most productive, lowest cost in-circuit test solution. This "zero-footprint" inline test system provides true 2x-4x parallel test, delivering 200% to 400% greater productivity, and 40% to 50% lower total cost of test.
-
Dynamic Engineering
The parallel Input and Output channels are highly programmable and fully independent. The standard interface offers Data, Clock and Strobe. The 32 RS485 channels are programmable as input or output allowing for a variety of implementations. The programmable output rates and RS422/485 compatability will interface to a multitude of systems.
-
3430-SW -
TESEC, INC
The Dynamic Test System 3430-SW measures dynamic characteristics of IGBT/MOSFET devices at high speed. Maximum of 4 parallel measurement is available by connecting the 3430-SW mainframe test stations for each test items ( normal 2stations). One PC controls the whole system.
-
7410 -
Elcometer Limited
The electrodes transmit parallel low frequency signals, calibrated to give average moisture content by comparing the change in impedance between damp and acceptably dry concrete.Calibrated ready for use on concreteInstant readings on a clear, easy to read scaleFully portable, battery operated and non-destructive
-
TOMSAD
*on / off switch output section*two independent adjustable DC output*independent outputs serial and parallel*constant voltage and current*Low ripple and noise*four digit LED displays three*for 16 hours at full load*automatically search out
-
TOMSAD
*on / off switch output section*two independent adjustable DC output*independent outputs serial and parallel*constant voltage and current*Low ripple and noise*four digit LED displays three*for 16 hours at full load*automatically search out
-
EE301-I2C -
Executive Engineering
Cable can be used with EE301-I2C or EE301-DCMI Model Numbers only. Cable + Power for Loads & Control Modules / Connects to a PC Parallel Port / Supports (2) Electronics Loads & Control Modules / 6' Power cable & 5' Data cable
-
Teledyne Paradise Datacom
The PowerMAX system maintains complete parallel redundancy down to the embedded control level. Therefore the loss of an entire HPA chassis will not interrupt remote communications with the system. The system will automatically correct its gain level in the event of one or more HPA chassis failures.
-
ANALYSIS 4N -
ZOGLAB Microsystem Co., Ltd.
It supports a management on the on-site equipment, such as to add subnets, to add subnet equipment, or to config equipment parameters, etc. Subnet fulfills the following applications: parallel communication, interaction with equipment, batch logging, downloading, configuration, ending, timing synchronization and system status viewing.
-
Keysight Technologies
Keysight's AXIe Modular Logic Analysis and Protocol test modules and powerful analysis software provide essential capabilities for engineers working on fast digital designs and chipsets using high speed parallel and serial buses, such as DDR and PCI Express Gen 3.
-
Ranatec Instrument AB
Ranatec’s digital step attenuators covers all mobile frequency bands and gives a calibrated attenuation range of more than 90 dB in steps of 0.25 dB. All Ranatec digital attenuators are built as modules and offers both serial and parallel control logic.
-
Analog Devices Inc.
Analog Devices programmable gain amplifiers (PGAs) provide excellent gain accuracy, channel-to-channel matching specifications, and low 1 ppm/°C drift. Set your gain with a simple serial or parallel interface from 1 V/V to over 4000 V/V.
-
Power-1410 -
Quantifi Photonics Inc.
Quantifi Photonics’ Power-1410 optical power meter provides fast monitoring of signal power from -60 to +10 dBm and broad wavelength range of 1250 to 1650 nm. It provides unrivalled channel density with up to 288 parallel channels in a single 1U rack-mountable instrument.