-
-
Product
WaveLink Temperature Extension cables for Dx10
Dx10-HiTemp
-
- Choice of 4 GHz or 6 GHz bandwidth models- Up to 5 Vpk-pk dynamic range with low noise- ±3 V offset range- Low loading and high impedance for minimal signal disturbance- Ideal for DDR2, DDR3, LPDDR2- Deluxe soft carrying case- Innovative QuickLink architecture- Wide variety of tips and leads-- Solder-In Lead-- Optional Positioner (Browser) Tip-- Quick Connect Lead-- Square Pin Lead-- HiTemp Solder-In Lead
-
Product
Temperature Cycling Test Chamber
-
Guangdong Bell Experiment Equipment Co.,Ltd
DGBell’s Temperature Cycling test chamber is performed on materials to determine the resistance of exposure to alternating extremes of high and low temperatures.
-
Product
Low Temperature Kinematic Viscosity Tester
SYD
-
Chongqing Lushun Scientific & Technological Development Co., Ltd.
The instrument is designed and made as per the Industry Standard of People's Republic of China SY/T5651 "Technical Requirements for Petroleum Products Kinematic Viscosity Tester". It is suitable to determine kinematic viscosity of liquid petroleum products (Newton liquids) at a constant temperature as per the National Standard of People's Republic of China GB/T265 "Test Methods for Kinematic Viscosity of Petroleum Products and Calculation of Dynamic Viscosity".
-
-
Product
System
SYS-24
-
The system shown here was built for a customer to be used in metallization, a common use for many smaller systems. It is also fully capable of performing optical coatings when equipped to do so. This particular system came equipped with a 16" APD ISO Flange mounted cyropump, and a Varian tri-scroll for roughing. The cooling tubes for the crystals as well as the drive motor for the parts holder can be seen on the top of the chamber.
-
Product
ELECTRIC BRAKE FORCE METER WITH DYNAMIC LOAD SIMULATION AND CIRCUIT TESTING
MDTT9107
-
*Tests truck-side brake controller output and all towing-lighting functions without a trailer*Displays real-time brake controller output gain and timing*Quickly troubleshoots electrical circuits and ground condition*For use with aftermarket and integrated brake controllers*Microprocessor controlled; simulates trailer brake loads*25' cable allows one-man, in-cab testing of brake controller and all truck-side tow circuits*Use to verify that the vehicle’s adaptive (speed/load sensitive) brake-controller output is functioning properly
-
Product
On / Off Control Of Temperature
ULP-28
-
Unitech Scales And Measurements Pvt. Ltd
Unitech on/off temperature control module through relay with present value and set value display.
-
Product
Temperature, Humidity, Bar. Pressure Transmitter
T7311-4
-
Humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy. Built-in pressure sensor.
-
Product
Upstream-Measurement-System
AMA 310 UMS & VAROS 107
-
This system combines the KWS devices AMA 310/UMS and VAROS 107 to a high-end monitoring system for the return path frequency range. An AMA 310 in a 19-inch version (3.5 RU) with UMS module is used in the headend, in the field the CATV handheld VAROS 107 is the counterpart.
-
Product
Low Temperature Retraction Tester
EKT-100TRB
-
EKT-100TRB-Low Temperature Retraction Tester is designed in accordance with ASTM D1329, ISO 2921 with fully automatic and computerized controlling system.
-
Product
Combined Temperature – RH probe
HP475AC1R
-
Relative humidity and Pt100 temperature combined probe, with SICRAM module.
-
Product
Temperature Sensors
-
Temperature sensors have a well-defined relationship between electrical resistance and temperature, allowing them to measure temperature precisely. The sensor body is made of a thermally conductive material and is as small as possible to produce a rugged device which gives an accurate measurement of temperature with a fast response.
-
Product
Analyzer System
Ruggedized Test Systems (RTS)
-
This analyzer is a rugged, field deployable system that detects and locates faults and detects degradation in electrical interconnect systems ranging from simple to complex.
-
Product
Humidity & Temperature Loggers
-
Out of clusters of humidity and temperature instruments,this low power consumption data-logger combines the functions of signal-sampling,display,storage and analysis,widely be applied in the industries of medics,food,agriculture,laboratory,electronics,air-conditioning, weather service,archives management,archaeology study,fibre manufacturing and cold chain logistics,because this device can provide just-in-time solution of environment-monitoring,alerting and recording.
-
Product
Temperature and Humidity Regulator
H3061-2
-
Relative humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
Product
Online Temperature Measurement Thermal Imager
-
Zhejiang ULIRvisionTechnology Co., LTD
According to different forms of use, infrared cameras can be divided into online thermal imaging cameras and portable thermal imaging cameras. Here we will discuss the usage and application of online thermal imaging camera compared to portable infrared camera.
-
Product
Probe Temperature Meter
-
Kusam Electrical Industries Limited
• Measurement Range : -50°C ~ 270°C; -58°F ~ 518°F• Resolution : 0.1°C (-50°C ~ 200°C) ; 1°C (200°C ~ 270°C)• Accuracy : -50°C ~ -20°C : ± (reading x 1.5% + 1°C), -20°C ~ 200°C : ± (reading x 1.0% + 1°C), 200°C ~ 270°C : ± (reading x 2.0% + 4°C)• Auto Power Off : 8min• Low Battery indication• °C / °F display selection
-
Product
Temperature, Humidity Transmitter
T3218
-
For exacting interiors in building energy management and HVAC systems. Are designed for easy installation on ordinary KU68 wiring boxes for household switches and sockets.
-
Product
Compressed Air Temperature and Humidity Regulator
H3021P-4
-
Humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
Product
Review System
RV-3000
-
Reduces surface inspection device review time and contributes to greater inspection efficiency! This system uses address information for defects detected by surface inspection equipment to acquire images of defects with a high level of magnification, and categorizes defect types.
-
Product
Compact Temperature Test Chambers
TJR
-
Specifically designed these benchtop and floor chambers to have a compact exterior yet an ample interior workspace to maximize valuable floor space. Temperature Range: -73C - 200 °C. Internal Dimensions: WxDxH (inches) 16 x 11 x 11.75.
-
Product
Temperature and humidity outdoor, indoor probe
T3110
-
Programmable temperature and humidity transmitter is equipped with temperature and relative humidity sensors. Measured values are also converted to other humidity interpretation - dew point temperature, absolute humidity, specific humidity, mixing ratio or specific enthalpy. Degrees Celsius and Fahrenheit are user selectable. Transmitter contains a microprocessor based control circuitry in a durable plastic case with connection terminals and sensors in a filter with stainless steel mesh. Humidity transmitters is equipped with two galvanic isolated 4-20mA outputs. Configuration of outputs and output range are user adjustable. Large dual line LCD for simultaneous display of T+RH or other humidity interpretation is an advantage. Display is possible to switch off. Computerized design ensures temperature compensation of the humidity sensor and fail indication. State-of-the-art capacitive polymer sensor ensures excellent calibration long term stability, inertia against water and condensation. Transmitters are designed for use in non-aggressive environment.
-
Product
High and Low Temperature Thermal Shock Chamber
HLST-500D
-
The specimen is placed in test chamber specimen which cannot be placed in high temperature chamber or low temperature chamber. High temperature chamber pre-heats the air and low temperature air chamber pre-cools the air. When doing the test of temperature changing from high to low, the low temperature chamber will blow the pre-cooled air to the test chamber. Then, the air in test chamber will reach your target temperature in several minutes (“recover time”). When doing the test of temperature changing from low to high, the high temperature chamber will blow the pre-heated air to the test chamber. Then the air in test chamber will reach your target temperature within the recover time.
-
Product
Multi-Mission System
Improved Shadow® Tactical Unmanned Aircraft Systems
-
With more than 30 years of unmanned aircraft systems (UAS) experience, Textron Systems' Shadow® is the most reliable and capable tactical UAS to help you accomplish your missions. The battle-proven system has surpassed 1.25M hours in flight, supporting global military operations for countless U.S. troops and their allies. Our multi-mission systems are paired with Textron Systems' interoperable Universal Ground Control Station (UGCS) and remote products for collaboration across the battle space.
-
Product
SMART SystemS
-
The SMART systems architecture is developed around open, standard technologies such as Linux, InfiniBand™, MPI, VSIPL and Corba. Through the support of well-know development tools and libraries, customers can reduce development time and shorten time-to-deployment. This approach also provides customers the flexibility to operate within a heterogeneous computing environment.
-
Product
High Temperature Aging Environmental Test Chamber
-
Guangdong Bell Experiment Equipment Co.,Ltd
DGBell's High Temperature Aging Chamber is widely applied for automotive parts ,electronic and electric products ,components and materials by constant high temperature reliability test.
-
Product
Analog Force Gauges
-
Phase II force gauges are designed and engineered to achieve WORLD-CLASS tension/compression measurements. Heavy duty construction allows the force gauges to undergo rough handling in any environment, while providing for extremely sensitive and highly accurate readings. The Phase II force gauges include a direct dual scale reading in both lbf and kgf, eliminating the need for two separate gauges in the shop.
-
Product
Temperature Data Acquistion
THERMES-USB RF
-
Physitemp’s original Thermes high accuracy ISA based data acquisition system has been redesigned to create a more versatile USB model. The new system requires no internal connections to your computer and simply connects via an external USB port on your laptop or desktop computer. Two versions of the data acquisition system are available. The standard version, THERMES USB, is connected to your computer USB port. The wireless version - THERMES USB WFI, can be either directly connected to a USB port or, with the included wireless receiver, positioned up to 100 feet from the host computer. Each unit will accommodate up to 7 type T thermocouple sensors and multiple Thermes units may be connected to the same computer for more thermocouple inputs. A high accuracy electronic cold junction compensation circuit maintains typical system accuracy of ±0.2°C over an ambient temperature range of 15 to 35°C. Individual offsets may be added to each input in software to facilitate individual calibration of each channel. For information on our wide selection of Type T Thermocouple temperature probes.
-
Product
2D Color Temperature Tester
LCC-900
-
Screens the pass/fail results or module type LED image information that is automatically reset via data transfer with handler unit. Data results are stored in server for unified management.
