Solder Paste Measurement
assures volume and area of paste application.
See Also: Solder Paste, Solder Paste Inspection
-
Product
Loop Resistance Measuring Device According to DIN EN 61557-3 (VDE 0413-3)
-
PeakTech Prüf- und Messtechnik GmbH
A loop tester which is used to test the safety of electrical systems. These device measures the impedance of the short-circuit loop between the outer conductors of a circuit, whereby the probable short-circuit current is calculated. The protection of the circuit (miniature circuit breaker) must therefore trigger at a lower current than the expected short-circuit current, in order to avoid excessive heating of the lines and thus a fire risk. The PeakTech 2715 is due to its function and its robust design almost indispensable when performing new installations, but also for general checking of electrical systems, this device is the ideal companion.
-
Product
Measurement
Power Meter
-
Power Meter is used for determining the power of the electrical current coming to the input channels of ADC modules and FFT spectrum analyzers, or that of the electromagnetic signal.
-
Product
temperature Measurement
-
Educated Design & Development, Inc.
Up to 8 resistance reading channels, 4-wire methodUp to 12 temperature reading chanels, use of Type K, 24 AWG, Teflon thermocouplesIn the Box:8 - data cable (Cat5e) to connect the isolation modules to the Resistance Reading Channels8 - Isolation Module connected between the HOT-30 and EUT (Equipment Under Test) to isolate high voltage8 - Banana Jack Sets (2 red, 2 black), to replace Kelvin Leads in tight places8 - Kelvin Probe Set12 - 72 inch K Type Thermocouple1 - USB2.0 Type A (standard) to Type B USB cable
-
Product
Vibration Measuring System
-
here are several parameters to express about vibration.For conventional vibrometers, repetitive measurements at each point switching parameters is necessary.However,for CardVibro Air2 equipped with a simultaneous measurement function, measurements of Displacement, Velocity, Acceleration and furthermore Envelope for bearing condition diagnosis is possible by just pressing a start key at the same time.
-
Product
Rotary Torque Measurement System
-
Honeywell Industrial Automation
Honeywell's analogy telemetry rotary torque systems are often well suited for both short and long term testing and monitoring of torque or strain on rotating applications where other measurement methods are affected by vibration, dust, moisture, high RPMs, and large axial/radial shaft movements.
-
Product
Current To Pressure Measurement Trainer
-
Unitech Scales And Measurements Pvt. Ltd
Current to Pressure Trainer. This setup comprises of a I to P converter fitted on a base. Two pressure gauges are fitted one at the input side and the other at the output of the I to P converter. A current source with digital display is provided to excite the I to P converter. A constant air supply should be provided to the system at 20 PsI Pressure from a standard compressor.
-
Product
Measuring System for Assessment of Optical Radiation Safety
IEC62471
-
The system is designed especially for the determination of optical radiation hazard exposures specified in IEC62471, such as actinic UV hazard exposure for the skin and eye, near-UV hazard exposure for the eye, retinal blue light hazard exposure, retinal thermal hazard exposure, thermal radiation hazard for eye and skin, for LED products, UV-Lamps, lighting sources, luminaires and etc.
-
Product
Low Level Voltage Measuring Instruments
-
This instrument has a very wide range of source resistance capability and has an equivalent noise resistance of less than 10 ohms. Sub-nanovolt resolution is possible. The N11 has many applications, including cryogenic measurements.
-
Product
Coordinate Measuring Machine
SF87
-
Entry-level CMM for the production environment. WENZEL’s SF87 has the attributes needed for a shop floor CMM and benefits from an optimum measuring volume of 800 x 700 x 700 mm , its cantilever style configuration providing a very efficient footprint relative to measuring range.
-
Product
Software For Measuring Process Automation
NMS AutomationSoft
-
A software tool made by NMS, intended especially for users of measuring systems. It allows simple and fast creation of measuring programs – complete work procedures, from the choice of measured part and navigation through the entire measurement to automatic data evaluation and the creation of reports. The program allows the use of dialogues and images that simplify orientation in the measurement process for operation
-
Product
Source / Measure Unit (SMU) Modules, N6700 Power System
System
The Keysight N6780 family of source/measure units (SMUs) provide advanced features and precise control and measurements of voltage and current down to the microampere and nanoampere regions. They provide stable, glitch-free output voltage and current during high-speed load changes, fast output modulation, and high-speed measurements of both voltage and current simultaneous.
-
Product
Automated Live Fish Measuring System
-
The system for measuring and identifying aquatic organisms is designed to measure the linear dimensions and volume of live fish on a conveyor. The conveyor speed can reach 2.5 m / s, that is, up to 5 fish can pass through the installation in one second.The measurement of the thickness and volume of fish is carried out using a specialized camera Sick Ranger D40, which works on the principle of laser triangulation.The camera operation is synchronized with the conveyor movement using the Sick DGS-60 encoder.The industrial color camera Basler Scout scA1300-32gc is used for measuring the linear dimensions of fish (length and width), as well as highlighting characteristic features of different types (color of scales and fins) and possible defects.
-
Product
Measurement Software
-
From real-time, multi-monitoring system operation and analysis, to complex automation, internet measurement platforms and control interface displays - we provide all the software solutions that you need for your measurement tasks.
-
Product
Thickness Measurement Products
-
Our film thickness measurement products are available for every application. We stock most of the products listed below for fast delivery. Browse through them or contact one of our Application Engineers, who can immediately assist you with your film thickness measurement needs.
-
Product
Big Data Web Platform to Measure Vehicle, Transit, Bike, and Foot Traffic Virtually
StreetLight InSight
-
StreetLight InSight® is big data web platform that harnesses connected device and IoT data to measure vehicle, transit, bike, and foot traffic virtually anywhere. Use our self-serve software 24/7 to analyze traffic volumes, Origin-Destination, turning movement counts, and other transportation metrics — for any road, area or time period.
-
-
Product
Measurement Sensors
-
measurement sensors convert a physical phenomenon (such as sound or temperature) into a measurable analog voltage or digital signal. This signal is then further processed and converted into a legible display.
-
Product
Dielectric Loss Tangent and Transmission Attenuation Measurement System
RTS03
-
RTS03 measures relative permittivity (dielectric constant), dielectric loss tangent in the frequency range between 5GHz and 26.5GHz based on a correlation between measurement frequency and transmission attenuation as the microwave passes through the flat plane sample.
-
Product
Thread Measuring
-
Bowers Group provides a range of innovative thread measuring equipment for global industry, with solutions including thread profile gauges to check form and pitch, and both standard and bespoke solutions for precision thread diameter measurement.As UK Distributors for Gagemaker, a Houston based manufacturer of precision inspection equipment and measuring devices for the Quality Control industry, we can offer solutions including thread diameter measurement, API thread inspection, and large diameter measurement.
-
Product
Physical Property Measurement System
PPMS® DynaCool™
-
The popular Physical Property Measurement System (PPMS) from Quantum Design is now available in a truly cryogen-free package. The PPMS DynaCool uses a single two-stage Pulse Tube cooler to cool both the superconducting magnet and the temperature control system, providing a low vibration environment for sample measurements. It offers continuous low temperature control and precise field and temperature sweep modes.
-
Product
Combination Measuring Devices According to DIN EN 61557-10 (VDE 0413-10) are permitted
-
PeakTech Prüf- und Messtechnik GmbH
This innovative combination measuring device for testing electrical installations according to official laws convinces with its technical performance data in the high-end area. All important safety tests such as FI, voltage, loop, low-resistance, earth resistance and insulation tests for e-checks and new installations can be carried out safely by the electrician via the large 3.5“ TFT color display. Of course, the device comes with an extensive range of accessories, such as all necessary test leads, adapters, rods and the required software CD for the PC. The device can be charged with a power adapter or via a car adapter. During the daily use, this high-quality device is protected against dust and all-round water jets by its protection class IP 65.
-
Product
High Resistance Measurement Universal Adapter
N1414A
-
N1414A High Resistance Measurement Universal Adapter is used to simplify the connection for high resistance measurements by B2980A series electrometer.
-
Product
Combo Measuring Receiver/ TV Analyzer
VAROS 106
-
High accuracy, an easy handling as well as the modularand rugged construction will support the technician onsite in his tasks: perfect troubleshooting in all distribution networks with FM, return channel, DAB/DAB +, DVB-T2, cable TV, WiFi or SAT – the VAROS 106 covers all ranages reliably. By any means a real allrounder.
-
-
Product
PC USB Noise & Vibration Measurement Systems
-
IEPE Sensor Based Measurement Systems, Charge Amplifier Based Measurement Systems, All-in-One Integrated Vibration Measurement Systems
-
Product
Ferrous Wear Metal Measurement In Lubricants
FerroCheck 2000 Series
-
The FerroCheck 2000 Series of portable ferrous analyzers offer accuracy and convenience for total ferrous measurement of in-service lubricating oil and grease. Fast and easy to use samples are analyzed in less than 30 seconds. Small sample volumes of just 1.5 ml of oil or 0.75 ml of grease are needed to measure ferrous content in part per million (ppm) by weight. The FerroCheck measures the total ferrous content of both small particles from normal machine wear and large abnormal wear particles.
-
Product
PV Measurements System
PH-IQE200
-
PV Measurements offers to combine a Spectral Response/QE/IPCE system with an I-V system into one compact measurement system. Depending upon the configuration required for your devices,it may share a test fixture.This reduces overall system cost.
-
Product
9-Pin D-Type Male, Solder Bucket, HV
40-960-009-M-HV
D-Sub Male Connector
9-Pin Male D-Type Connector, High Voltage, Solder Bucket - With Backshell
-
Product
Measurement
Phasemeter
-
Phasemeter is used for measuring the phase difference of two signals coming to the input channels of FFT spectrum analyzers. The upper line of the indicator displays the current phase difference value in degrees, the lower line – phase difference value in radians. It is possible to change the averaging of the displayed value (0.1 or 1 s) and to select necessary FFT spectrum analyzer channels.
-
Product
Level Measurement
-
As a market leader in level detection with the largest selection of agency approved level switch technologies, the K-TEK level products line has the proven technology to provide solutions for the most difficult liquids and solids level applications.
