-
Product
Pulsed Source Measure Unit
-
The SpikeSafe SMU is a precision pulsed source measure unit that precisely sources pulsed current and simultaneously digitizes voltage. Optimized for precise and repeatable high-power LED and laser testing, SpikeSafe™ SMU (Source Measure Unit) current sources deliver precise pulsing with low microsecond rise times, low-jitter triggering and integrated digitizer for more accurate and repeatable high-power LED and laser testing.
-
Product
Insulation Resistance Measurement
MD 5KVr
-
The digital insulation tester model MD5KVR is TENTECH's cutting edge insulation analyzer equipment and it is one of the most complete and sophisticated available in the international market. A software allows for further analysis of tests results, including features such as graphical representation and automatic report generation. Its proven technology provides safe, reliable and accurate measurements of insulation resistances up to 5 TΩ, with 4 preselected test voltages, 500 V -1 kV - 2,5 kV - 5 kV. Other test voltages, from 50 V to 5 kV, can be selected in 25 V or 500 V steps.
-
Product
Analog And Digital Sensor Measurement Data For CAN Applications.
K- AN8 KIT
-
This K-AN8 (8 analog + 4 digital input) kit contains everything needed to get the K-AN8 set up and tested on a work bench.To help with connecting sensors to the analog and digital ports the K-BoB enables easy connection with BNC connectors.Influx K-Cal is easily connected via the Kvaser LeafLight interface and Kvaser T-CANnector. (Using the Kvaser T-CANnector to power up the K-AN8 (at the desk) and terminate the CAN bus).
-
Product
Electrical Measurements Test
-
The tests are performed to measure and collect data from electrical and electronic parts using various measurement methods including, but not limited, to the following: capacitance, resistance, winding resistance, insulation resistance, magnetic permeability, power input, and quality factor Q.
-
Product
*Terahertz Measurement
-
Terahertz laser power and beam profiling measurement is not a trivial task. But as anyone using or developing THz lasers knows, it is crucial to obtain accurate measurements of your laser. Ophir offers a few choices, depending on what aspect of your laser you need to measure. Read these posts for more about Terahertz measurement.
-
Product
All Measurements 3 Channel Portable Data Logger
DO9847
-
Combinations of all measurements in 3 channel portable datalogger: RH, temperature, pressure, airspeed, light, voltage and current.
-
Product
Cable & Antenna Analyzer - 2 MHz to 4.4 GHz
E7000L
-
The E7000L Cable & Antenna Analyzer provides all necessary measurement functions and performance to accurately diagnose and verify the site’s cable and antenna system and RF connectors, as well as basic fiber-feedline testing. Smaller and lighter than the E7000B, the E7000L is ideal for installation of wireless cell sites.
-
Product
Vibration Measuring System
SmartVibro
-
There are many functions to express characteristics of vibration. However it is necessary for the conventional vibrometers that the same point is measured plural times switching objective functions one by one. SmartVibro which has a simultaneous measurement function can measure Acceleration, Velocity and Displacement simultaneously by just pressing the measurement start key one time. It can reduce the operating time and prevent miss-measurements. By switching the screen, VM-4424S・VM4424H can confirm Acceleration Envelope for bearing condition which enables small scars to be found easily.
-
Product
Measuring Systems For Night Vision Systems
MTF Test Bench For Image Intensifier Tubes (IIT) And Night Vision Devices (NVD)
-
Optik Elektronik Gerätetechnik GmbH
The MTF MASTER NVD was specially designed to measure the MTF of Night Vision Devices (NVD) and of Image Intensifier Tubes (IIT).
-
Product
Flow Measurement Trainer Using Orifice Meter
-
Unitech Scales And Measurements Pvt. Ltd
This setup is a table top model, it comprises of source and measuring tank. The measuring tank is of acrylic with liters graduated. A small FHP pump is fitted to circulate the water. A orifice meter with U-tube manometer is provided to measure the flow rate. A rotameter is provided to measure the exact flow rate. Control valve is provided to control the water flow rate. Digital timer is provided to notedown the duration of flow.
-
Product
Optical Displacement Measurement Systems
ODS Series
-
The optical displacement measurement systems of the ODS series are specially designed for measuring the ultrasonic vibration displacement at bond tools of wire & flip-chip die bonders. The systems are highly accurate and very easy to use. That makes it the perfect tool for displacement based calibration of ultrasonic bond machines.
-
Product
Benchtop Vision Measurement System
HVR-Flip
-
The HVR-Flip large field-of-vision (FOV) Benchtop Vision Measurement System has the unique characteristic of being used in either a vertical or horizontal format offering tremendous versatility and value. Rapidly measure parts up to 3.65 x 3"Working distance of 10". Measure a single feature, an entire part, or multiple parts. MetLogix™ M3 software allows for easy one-touch feature measurement. Auto-detect part recognition.
-
Product
Shaft Power Measurement Kits
-
Shaft Power Measurement Kits are available in two formats, the standard and the compact kit. The compact kit is ideal for single day trials, while the standard one is used for long duration trials of between 30-60 days.
-
Product
Precision Measurement System
OmniMic V2
-
Updated software and improved hardwareCompact, portable, accurate, affordableIntuitive software—open the box, start testing in minutesPerfect for setting up home theater systemsOptimized for use with netbooks and laptopsAccurate response down to 5 Hz, fully calibrated, includes FRD fileFor professionals and hobbyists—design and tune speaker systems and arrays
-
Product
Dual Polarized Antennas
-
Dual polarized horn antennas are offered as both standard and custom models with rectangular waveguide interfaces for both horizontal and vertical ports. These dual polarized horn antennas support both linear and elliptical polarized waveforms. When the antenna receives a circular polarized waveform, equal amplitude linear polarized waveforms are output at both horizontal and vertical ports. When two equal amplitude linear polarized waveforms are input into the vertical and horizontal ports, the antenna will transmit a circular polarized waveform. The listed models offer 15 dB nominal gain and 33/28 degrees typical half power beamwidth at the center frequency of the band. They also exhibit 40 dB typical port isolation and 35 dB nominal cross polarization. These antennas cover full waveguide bandwidths within the frequency range of 8.2 to 110 GHz. In addition to the models listed below, models with 10, 20, 23 and 25 dB gain and other frequency bands are also available.
-
Product
Flexible Automatic Measuring System Release
FAMS-R5
-
FAMS-R5 uses the system with high-speed communication, FAMS High-Speed Link2, to share data with each unit.Sensors can be directly connected to the measurement unit in a laboratory.Simple wiring and highly accurate measurement can be achieved.By adding the MCU that can calculate the control model with MATLAB/Simulink, it also supports the simulation bench.
-
Product
Measuring Systems
-
Select your individual Meter Test System (MTS) from our single components. Hints for useful combinations of devices can be found on the corresponding product page.
-
Product
Industrial Gas Chromatographs for Trace Impurity Measurements
-
The industrial gas chromatographs from LDetek ensure the quality of over 30 pure gases and UHP gases. They can be calibrated to detect over 50 different gases as trace impurities including permanent gases, sulphurs and noble gases as well as many others. Contact us if you have any special requirements for any background gas or impurity not listed.
-
Product
Materials Measurement Suite
N1500A
-
With Keysight N1500A materials measurement software suite, you can determine the intrinsic electromagnetic properties of many dielectric and magnetic materials. The complete system is based on a versatile Keysight network analyzer which measures the material’s response to RF or microwave energy. The N1500A software controls the network analyzer and calculates results. Depending on the Keysight network analyzer and sample holder or fixture used, frequencies can extend from a few hundred MHz into the low THz.
-
Product
Hall Effect Measurement System
RH 2010
-
The RH 2010 Hall Effect Measurement System has been designed for high flexibility and ease of use as a standard system for quick routine control measurements as well as for sophisticated temperature dependent Hall measurements for material research.
-
Product
Temperature Measurement
-
HighReach Measuring & Controlling System Co.,Ltd
Describes the process of measuring a current temperature for immediate or later evaluation.
-
Product
Voltage and Current Measuring Technology
-
HIGHVOLT Prüftechnik Dresden GmbH
Designed for the measurement of alternating current (AC), direct current (DC), lightning (LI) and switching (SI) impulse high voltages (HV) as well as AC and impulse high current (HC) according to IEC 60060, IEC 61083 and IEC 60052, available as indoor and outdoor design.
-
Product
Self-Discharge Measurement Solutions
-
Directly measure self-discharge current in 1-2 hours instead of monitoring cell open circuit voltage over weeks or months. Quickly measure & analyze self-discharge current during cell design and evaluation. Reduce design cycle time and get to market faster. Rapidly discern good vs. bad cell self-discharge performance in manufacturing. Dramatically decrease work-in-process inventory.
-
Product
CO,CO,light and Sound Measurement
-
Everyone is exposed to different environmental influences in their day-to-day lives. For example, in an average workplace illuminance, sound level, and indoor air quality are all significant factors that influence people's performance and well-being. Testo offers suitable measuring instruments for controlling each of the measurement parameters of lux, sound, and CO2 (for indoor air quality).
-
-
Product
IPCE Action Spectrum Measurement Device
PEC-S20
-
●Compact design with light source and spectrometer integrated ●Optical fiber direct injection method for maskless current density calculation ● Measurement with only a sample set and measurement start button
-
Product
Incremental Length Gauges For Measuring Stations And Multipoint Inspection Equipment
CERTO series
-
*Interferential scanning principle*Very high system accuracy of down to ±0.03 µm*Well-matched ball-bearing guide for very high quality*Defined thermal behavior*Large measuring ranges of up to 60 mm*Interface: 11 µAPP
-
Product
Temperature Measurement IR Sensors & Detectors
1SC Compensated
-
A thin film-based single channel thermopile detector that offers thermal compensation to minimize effects of sudden ambient temperature change during the initial five seconds of change. The 1SC Compensated comes in a TO-5 package with a medium sized 1.0 x 1.0mm active area. Compensation is achieved through the integration of two additional half-sized thermopile elements. Internal aperture is standard and precisely defines active area for applications with FOV and/or spot size requirements.
-
Product
X-ray Fluorescence Measuring System
FISCHERSCOPE X-RAY/XDV-SDD
-
Premium model for universal use for the inspection of very thin or complex layers up to RoHS screening at very low detection limits.
-
Product
Antenna, Log Periodic
EM-6946 | 300 MHz – 3 GHz
-
The EM-6946 offers an exceptional combination of frequency coverage of 300 MHz –3 GHz and high power handling capability without compromising the consistent performance versus frequency that makes the log periodic antenna so desirable for test applications.
