CATV Power Meters
Detect, measure, and monitor the intensity of a CATV signal.
-
product
Transformer Ratio Meters / TRM-101
TRM-101
UDEYRAJ ELECTRICALS PRIVATE LIMITED
Produces the 3-ph or 2-ph standard power with stable voltage and phase. Fully automatic: No manual balancing
-
product
Power Dividers
We currently offer coaxial resistive power dividers (aka power splitters), which are inherently broadband and have excellent low frequency response (0!) albeit with poor isolation; and also Wilkinson Power dividers, aka Wilkinson Splitters. We have as connector options SMA, N, 1.95mm, & 2.92mm. Our power dividers cover DC-70Ghz. While most of our power dividers are 2-ways, we also have 3, 4, & 8 way dividers. The resistive power splitters are implemented with tiny resistors. Wilkinson splitters can be microstrip or stripline. RF Power Dividers are often lumped element, Microwave Power Dividers are often microstrip.
-
product
Multifunction Meter for Electrical Installations
AMPI-525
*Short circuit loop measurement:*Impedance measurement with 23 A (44 A phase-to-phase), short circuit resistance RZW =10Ω*Measuring range: 95...440V, frequency 45...65 Hz*Short circuit loop measurement with resolution 0,01 Ω , without tripping the differential protections (I∆n ≥30mA)*Automatic short-circuit calculation, phase-neutral and phase-phase voltage detection
-
product
Torque Metering System
Model TMS2200
Full capability of standard RDT2100 model with the addition of a Class I Division II certification of the system.
-
product
Gloss Meters
Gloss meters are used devices designed for measuring the specular reflection gloss of a surface. The gloss is determined by the measuring of the amount of reflected light at an equal, but opposite angle from the light beam. The quantity of light is determined by shining light from a defined angle at a surface and then measuring the light opposite the source of light at the same angle. The measurement is then compared to a standard. The most common angle for measurement is 60°.
-
-
product
Power Cell Power Transducers for Wide Ranging AC/DC Loads
PH-3A and PH-1000
You can know the load on an electric motor by measuring the electric current going to the motor (Amps). But, this is not the best way to do it since a lightly-loaded motor doesn't use the electricity very efficiently. (In technical terms, the power factor is low.)A better way to know the load is to measure the motor power. (Power is measured in Horsepower or Watts.) Motor power gives you a straight line so it works well even when the motor is lightly loaded.The Power Sensors that we make measure the motor load (Horsepower or Watts) and send a signal to meters or computers. The operator can see what the status is on the meter or, the computer can make decisions.
-
product
AC Power Source
LSP-500VAR
• AC-DC-AC frequency conversion technology, Controlled & tested by 16 bits MCU • Protection for over hot, thundering voltage and current • Total voltage distortion: ≤0.3%; Voltage stability: ≤0.05%/30min • Load adjust rate: ≤0.05%; Frequency stability: ≤0.01%/30min • Output voltage range: AC 0.0~300.0V, Output Frequency Range: 45~70Hz, 100Hz, 200Hz and 400Hz • It is pure sine wave AC power source with low harmonic and high accuracy • Input Power: 220V and 50/60Hz (110V can be option) • Communicate with PC via software, the Voltage & Current set by the software and Power Output can be remote controlled.
-
product
Pocket Weather Meter
Kestrel 2500
The Kestrel 2500 Pocket Weather Meter measures wind and temperature with total accuracy, and has the added benefits of an air pressure sensor that provides altitude and barometric information. Kestrel 2500 technology enables you to follow changes in air pressure that help predict impending changes in the weather. Factor in the 2500's digital altimeter, and you have most of the weather information you need for outdoor activities ranging from model airplane flight to rifle practice.
-
product
Power Potentiostat/Galvanostat
1100C
The Model 1100B series power potentiostat/galvanostat is designed for electrochemical applications that require relatively large current and high compliance voltage, such as battery studies, corrosion, electrolysis, and electroplating. The current range is 2 A, and the compliance voltage is 25 V. The instrument contains a high speed digital function generator, a fast data acquisition system, filters for current signals, iR compensation circuitry, a potentiostat, and a galvanostat (Model 1140B). The potential control range is 10 V.
-
product
Clamp Meters
Omega Clamp Meters provide True RMS Current and Voltage measurements and also include additional measurements typically found in Multimeters such as AC/DC voltage, current, resistance and others.
-
product
Airframe Electrical Power Systems
Rely on Astronics CorePower® airframe electrical power systems, where solid-state technologies deliver highly efficient, clean power that improves aircraft operation through weight and system wiring savings.
-
product
Linear DC Power Supply
MPS-5 Series
The five-channel programmable DC power supply is a new generation of high quality programmable linear DC power supply. The five channels can independently adjust the voltage and current. This series of products are equipped with RS232 communication interface, which has both desktop and system characteristics, and can be arbitrarily matched with other instruments, integrated as a test system with special functions to complete the measurement requirements in different occasions. The Upper computer program can be edited through the communication protocol, which brings great convenience to the user. It is a replacement product of the ordinary programmable power supple and has a high cost-effective advantage.
-
product
Strength Meter
NOVOTEST IPSM-U+T+D (Pulse Velocity Tester)
The pulse velocity tester IPSM-U+T+D allows to measure the strength and homogeneity of the concrete, bricks and other materials under the composition and surface sounding in products and designs for construction projects, inspection of buildings and structures, according to ASTM C597-16 (Standard Test Method for Pulse Velocity Through Concrete). Has the determining of the depth of cracks by the surface sounding probe function and also flaw detection mode (A-scan).
-
product
Power Divider
Chengdu KeyLink Microwave Technology Co., Ltd.
The series of products are passive devices.The frequency range covered by 0.5GHz~40GHz.The products have the characteristics of good amplitude and phase consistency and low insertion loss.The products can be applied to all kinds of receiving and transmitting channels. KeyLink's power dividers can be categorized as follows.
-
product
High-Accuracy Meter
Shenzhen Star Instrument Co., Ltd.
Three-phase four wire CT/VT meter provides unparalleled accuracy and measures forward/reverse active and reactive energy as well as four-quadrant reactive energy.
-
-
product
Ophir Power Amplifiers
Ophir RF power amplifiers are rugged and reliable. They are available as complete rack mounted units incorporating power supply, fans and heatsinks, or as compact modules requiring a DC supply. Fans and/or heatsinks can be included if required.
-
product
Digital Flux Meters
Digital Fluxmeter is instrument made by electronic integration principle and displays the magnetic flux digitally. It can test magnetic materials. It not only measures flux but also directly tests magnetic performance for the purpose of quality control. With the features of legible display and convenient operation, it is an ideal device for flux measurement.
-
product
RF Power Detectors
Monitors or samples the output of an RF circuit and develops a dc output voltage pro- portional to the power at that point.
-
product
Three-phase Program-controlled Power Supply
HT3050 / 676
Wuhan Huatian Electric Power Automation Co., Ltd.
It is suitable for the power department which needs to check the high-precision standard signal source for the electric measurement, thermal engineering, telecontrol and dispatching of the power system.
-
-
product
Microwave Moisture Meter
RX-95
The system works based on the absorption of microwave energy by water molecules contained inthe x-rayed material. It is a non-contact, non-destructive method of instant measurement of water content - used for materials such as coal, flour, grain, cement, seeds, sugar, etc. Thanks to high measurement sensitivity (resolution greater than 0.01% of water content by weight), short measurement time (about 5 times/sec.) and repeatability of measurement - the system is suitable for continuous measurement of material moisture, e.g. on conveyor belts and its recording on a PC or using a 4-20 mA current loop.
-
product
Industrial Plug-in Power Relays
The unique D-series power relay concept and the miniature C-series relays are specifically designed for heavy-duty applications, power-utilities, petrochemical industries, and mining. High DC breaking capacity and inductive load switching offer long electrical life and low life-cycle costs. The Solve-All™ relay application concept offers ultimate flexibility to design and supply tailor made D-series power relay products. Today the D-series power relays are used in its millions across the world.
-
product
Livestock Environmental Meter
5000AG
The Kestrel 5000AG is designed to meet the needs of livestock, agriculture and animal health professionals. Producers, growers, veterinarians, and consultants in every field of agriculture will gain vital information regarding micro-climate conditions needed to maximize performance and profitability. This lightweight, handheld, multi-function meter can be used inside and out for spot measurement of current conditions and also tracks and logs over 10,000 sets of time-stamped data.
-
product
Galley, Lavatory, And Other Power
Astronics powers lavatories, galleys, and other aircraft cabin environments with power supplies and outlet units built on our reputation as the industry's in-cabin power leader.
-
product
7-Channel Field-Strength-Meter
H7
7-Channel tabletop-unit for constant and alternating magnetic field.
-
product
4 Digit Voltage/Current Meter
CM2-VA
CM2-VA Voltage/Current Meter is designed in simple operation and 20.0mm LED displays in 4 digits with economic cost.They are can be programmed by buttons that are hidden in front panel.They are also available to option relay output and an analog output or RS485(Modbus RTU Mode) communication
-
-
product
Digital Micro Ohm Meter
PM-506
Laxtronics Instruments & Controls Pvt. Ltd
1 Micro Ohm To 20 Kilo Ohms, Test Current 1 Ampere To 1 Micro Ampere.
