-
Product
PXI Function Generator
-
Our PXI Function Generator is capable of generating sine, square and triangle waveforms to 10MHz with 48-bit frequency resolution referenced to the 10MHz PXI clock or to an external standard. It can generate fast swept frequency signals, permitting the output to emulate the operation of variable speed devices. The module can also generate arbitrary waveforms loaded into its internal 256k memory, allowing the emulation of many waveform types including the typical waveforms of automotive and aerospace sensors.
-
Product
3U 1-Slot OpenVPX P&G, Aperture E, VITA
101V301P02-9X13
-
3U 1-Slot OpenVPX Power & Ground, Aperture E, Supports VITA 66.4/67.3A/67.1 in J2A+B, Pass through, w/o ROHS, Max data rate (Gbps) 25.
-
Product
LXI Chassis
-
Our LXI chassis allow any of our 3U PXI switch modules and many of our instrumentation modules to be controlled in an Ethernet environment. You may also be interested in our 2-Slot USB/LXI Chassis, this chassis allows most of our 1 or 2-slot PXI modules to be controlled via USB or Ethernet. Also our 4-Slot USB/LXI Chassis allow USB or Ethernet control of most PXI modules up to 4-slot width. For more information on these chassis, you can look in the bottom part of the table below.
-
Product
311 HP Eddy Current Chassis Dynamometer
CM-51SR-EC
-
Weight Capacity: 25,000 lb (11,340 kg) per axleRoll Brakes: pneumatically-actuated discShipping Weight: 5,100 lb (2,312 kg)Capacity: 311 hp at 45 mph (232 kW at 72 kph)Rolls: 20 by 36 in. (508 by 915 mm) long, 2 fixedPit Required Depth: 25 in. (635 mm)
-
Product
PCIe to 3U VPX Extender / Riser Card
-
This adapter can be used to run, test or program a 3U VPX card in a standard PC PCIe slot. SSC switchable (ON/OFF) PCs available from PCI-Systems Inc.
-
Product
Basic 3U VPX-to-PCI Express (PCIe/PCI-e) Adapter
8065
-
The Technobox, Inc. P/N 8065 is a 3U VPX-to-PCI Express (PCIe) adapter that provides a convenient and cost-effective means for developing 3U VPX boards in a personal computer environment. It can also be used for production testing of 3U VPX boards. The adapter is a half-length PCIe card with the VPX card under test mounted close to the PCIe edge fingers to minimize signal lengths. When seated in a PC motherboard, the VPX card primary side faces upward to allow convenient access to components.
-
Product
4-slot LXI Chassis
MezaBox-4 LXI
-
MezaBOX-4 LXI is a device that ensures the functioning of various mezzanine modules (up to 4) installed in it, under the control of a personal computer via USB2.0 or ETHERNET 10/100 Base T (local area network) interfaces of a personal computer. MezaBOX-4 LXI is intended for use as a mezzanine carrier in multichannel systems for collecting / issuing information, both digital and analog.
-
Product
Chassis Dynamometer Smoke Testers
-
A chassis dynamometer smoke tester (CDST) is used to test diesel emissions when the engine is under load. This is of course a much more realistic test than the commonly used free acceleration test. It is also better for the diesel engine.During a CDST test an automatic test cycle is performed, whereby the emission is measured at different engine loads. The monitor shows checks and actions to perform before the test, shows real-time measuring data and instructions for the driver during the test, and the end results after the test.
-
Product
PXI Switching Instrumentation
Matrix
-
Marvin Test Solutions’ switch card portfolio includes matrix, multiplexer, and RF multiplexer configurations. 3U and 6U PXI switch cards feature easy to use, reliable, and integration-friendly D-sub style interface connectors – a feature unique to Marvin Test Solutions PXI switch cards. GENASYS switch cards are compatible with MTS’s family of GENASYS Switching and Switching/Digital Subsystems, featuring integrated MAC Panel SCOUT receivers.
-
-
Product
Industrial Computer Chassis
-
ADLINK's rackmount and wallmount industrial chassis are aligned with integrated subsystem design, service and performance, is optimized for combined motion/vision/IO applications
-
Product
3U 7th Generation Intel® Core™ i3-7100E Processor-Based PXI Express Gen3 Controller
PXIe-3937
-
The ADLINK PXIe-3937 PXI Express embedded controller, based on the 7th gen Intel® Core™ i3 processor, is specifically designed for hybrid PXI Express-based testing systems, delivering maximum computing power for a wide variety of testing and measurement applications.
-
Product
Rack Mount Hawk/PC Chassis
9381
-
A slide-in replacement for a Nova/Eclipse. A 10.5 inch (267 mm) high chassis with a 5-position Nova/Eclipse backplane and card cage, 450 watt power supply, cooling and rack slides. Accommodates up to five DG-compatible 15" x 15" (381 x 381mm) boards, a PC motherboard, diskette drive and up to three visible half-height disk drive bays and one internal half-height drive bay.
-
Product
Type 39, E-Frame chassis, 5-slot 3U P&G VPX BP, 250 watt PSU
39E05BUX94Y2VPB0
-
The Type 39 E-Frame (Short), test platform supports 3U, VPX development. With a rugged aluminum construction, the Type 39 E-frame is 9U overall to hold 3U cards. Available in compact (49HP) and full (84HP) for mounting 3-15 slots at 1" pitch.
-
Product
PXI FlexRay Digitizer
PXD7113
-
Digitize high resolution waveforms with the fully isolated PXD series Digitizers. Minimize interference and measure "in-circuit". Measurement errors are reduced by a high input impedance.
-
Product
Data Acquisition System - 3U 5-Slot
DAQ-35CP0G
-
is a preconfigured rugged system ideally suited to support a multitude of military/aerospace data acquisition applications that require "SBC-less" remote Gig-E command and control of high-density, multichannel programmable ARINC 429/575; Dual-Redundant, Quad Channel MIL-STD-1553B; CANBus (CAN 2.0 A&B or J1939); A/D Conversion; RTD Measurement; RS-232/422/485 Serial Communications; Thermocouple Measurement; Discrete I/O; Differential Transceiver and Dual-Port Gig-E Ethernet.
-
Product
VPX3424, OpenVPX 3U Single Board Computer
VPX3424
-
The Medusa VPX3424 is a 3U OpenVPX™ (VITA 65) Single Board Computer (SBC) features the all-new Freescale T4240 QorIQ® processor.
-
Product
4-Channel 200 MHz A/D with DDC with Virtex-6 FPGA - 3U VPX
Model 52661
-
- Complete radar and software radio interface solution- Supports Xilinx Virtex-6 LXT and SXT FPGAs- Four 200 MHz 16-bit A/Ds- Four multiband DDCs (digital downconverters)- Multiboard programmable beamformer- Up to 2 GB of DDR3 SDRAM or 32 MB of QDRII+ SRAM- Sample clock synchronization to an external system reference- LVPECL clock/sync bus for multiboard synchronization- Optional LVDS connections to the Virtex-6 FPGA for custom I/O- 3U VPX form factors provides a compact, rugged platform- Compatible with several VITA standards including: VITA-46, VITA-48 AND VITA-65 (OpenVPX™ System Specification)- Ruggedized and conduction-cooled versions available- Synchronize up to eight modules with Model 7893 System Synchronization and Distribution Amplifier - PCIe
-
Product
3U OpenVPX 8 Slot Profile BKP3-CEN08-15.2.15-3
1OVX308JZ3-1X11R
-
Dual star, no expansion plane, 2x control planes, 3U, 8 Slots.
-
Product
3U OpenVPX 12 Slot CMOSS - Profile BKP3-TIM12-15.3.6-3
1OVX312VZK-1X11
-
This 14 slot 3U OpenVPX backplane (12 payload +2 power supply slots) supports high speed signals on all data paths plus has VITA67.3 modular connectors compatible with legacy VITA 67.1 and VITA 66.4 RF and optical I/O connectors.
-
Product
3U VPX Dual-Plane Gen3/4 PCIe & 40 Gigabit Ethernet Switch
ComEth4420a
-
ComEth4420a is a cutting-edge hybrid managed switch combining PCIe Gen3/4 and 10/40 Gbs Ethernet technologies.
-
Product
8-Slot Desktop/Wallmount Chassis
IPC-6608
-
8-Slot Desktop/Wallmount Chassis with PS/2 or Redundant Power Supply. Bidirectional options to mount the chassis on the wall or workbench. Supports versatile 6/8-slot backplanes to hold 6/8 full-size cards. One/two front-accessible 5.25" disk drives and one 3.5" FDD. High-speed cooling fan supports abundant cooling and streamlined ventilation.
-
Product
3U 1-Slot OpenVPX P&G, Aperture J, VITA 67.3D
101V301P05-9X13R
-
3U 1-Slot OpenVPX Power & Ground, Aperture J, Supports VITA 67.3D , Pass through, w/ROHS, Max data rate (Gbps) 25.
-
Product
Custom VPX 3U 4Slot
-
4 slot custom 3U VPX backplane with a dedicated interface for IO panel.
-
Product
SBC347A 3U OpenVPX Intel Rugged Single Board Computer
SBC347A
-
The SBC347A Rugged SBC features the 5th Generation Core i7 processor from Intel, with integrated graphics and memory controller plus quad core processing up to 2.7 GHz.
-
Product
IC-ARM-VPX3a, 3U VPX LX2160A ARM-based Single Board Computer
IC-ARM-VPX3a
-
Designed for applications requiring high processing and communication performance and low power, the IC-ARM-VPX3a is a highly versatile SBC for small, 3U OpenVPX systems. The IC-ARM-VPX3a is developed in alignment with the SOSA™ Technical Standard.
-
Product
3U cPCI Serial Dual-Port SFP+ 10Gbps Ethernet NIC
SN5-TOMBAK
-
The SN5-TOMBAK is a peripheral slot card for CompactPCI® Serial systems, with a dual port 10Gbps Ethernet controller. Both ports are available via SFP+ front bezel connectors for optical cables via SFP+ transceivers or SFP+ twinaxial copper cables.
-
Product
PXI & PXIe Controllers
-
We offer you a choice of PXI controller options: embedded and remote. Embedded controllers have all the necessary components to operate your PXI system independently without needing an external PC. Remote controllers, on the other hand, allow you to control your PXI system from desktops, laptops, or server computers.
-
Product
3U OpenVPX 6 Slot variant Profile BKP3-CEN06-15.2.2X-3
1OVX306UY6-1X11R
-
Single star, no expansion plane| control plane 3U, 6 Slots.
-
Product
3U CPCI I/O & Comm Board W/Gig-E Switch
75D4-H2
-
The 75D4-H2 is a Layer 2+ Gigabit Ethernet Switch built upon NAI’s multifunction, 3U cPCI board technology. The 75D4 motherboard contains a high-density I/O module slot that supports an H2 switch function. The 75D4 with H2 consumes approximately 9.5 W of total power at 5 V to operate at full 1000 Base-T speeds. In addition, the 75D4 motherboard can integrate four channels of RS232/423/422/485 serial communications. This adds an additional 1.5 W of 5 V power. Serial data is available on the cPCI bus or can optionally be available over Ethernet via the use of one of the switch ports.
