Showing results: 1 - 15 of 145 items found.
-
Chassis CH-14 AXI-1 -
Holding Informtest
The CH-14 AXIe-1 chassis is designed to accommodate a system module in the seventh slot and up to 13 AXIe-0/AXIe-1 tool modules placed in the remaining slots.
-
Holding Informtest
Infrastructure housing for instrument cards typically containing a power supply, cooling fans and emi shielding.
-
CM AXIe-0 MODULE -
Holding Informtest
CM AXIe-0, made in the AXIe standard, is designed to work as part of measuring systems created on the basis of the AXIe-0 backbone. CM AXIe-0 is intended for use as part of AXIe-0 standard crates with the number of seats (slots) not more than 14. CM AXIe-0 complies with the requirements of the AXIe-0 standard for system modules of the AXIe-0 bus.
-
-
Holding Informtest
Electrical device consisting of a flat insulated surface that contains switches and dials and meters for controlling other electrical devices
-
-
MTD32 -
Holding Informtest
The mezzanine module (mezzanine) MTD32 is designed to measure instantaneous current values over 32 channels.
-
Holding Informtest
Measure current using either "Average responding" meters reading linear loads or "True RMS" meters measuring non linear loads.
-
MON8P -
Holding Informtest
Mezzanine MON8P is designed to generate DC voltage in the range of ± 10 V through eight galvanically isolated channels from each other and from the case, which allows to reduce the level of interference and increase the safety of the device.
-
MOSTs5 -
Holding Informtest
MOSTS5 is designed to convert instantaneous voltage values of an electrical signal into a digital code, measure instantaneous voltage values, measure time intervals between two instantaneous voltage values through two independent galvanic isolation channels.MOSC5, according to the conditions of use, meets the requirements for measuring instruments of group 3 in accordance with GOST 22261-94.
-
MOS1 -
Holding Informtest
The mezzanine module (mezzanine) MOS1 is designed to convert instantaneous voltage values of an electrical signal into a digital code, measure instantaneous voltage values, measure time intervals between two instantaneous voltage values through two independent channels, measure the magnitude of the phase difference and the ratio of the amplitudes of two signals.
-
-
MEMS5 -
Holding Informtest
Mezzanine MEMS5 is designed to reproduce the values of resistance to direct current through five channels independent and galvanically isolated from each other and from the case.
-
MEMS2-4L -
Holding Informtest
The mezzanine serves as an electronic store of resistance to direct current, the value of which is set by software, through two isolated channels.
-
Holding Informtest
Is designed to reproduce the values of resistance to direct current through channels independent and galvanically isolated from each other and from the case.
