High Voltage Meters
See Also: High Voltage, High Voltage Switching, High Voltage Detectors, High Voltage Programmable Power Supplies, HV, High Voltage Probes
-
Product
Voltage Amplifiers
-
Switchable gain up to 100 dB (x 100,000)Bandwidth DC to 100 kHzDC-drift 0.6 µV/°CInput noise down to 0.4 nV/√HzSwitchable AC/DC-couplingLocal and remote controlInput impedance up to 1 TΩ
-
Product
PXI 16x SPST High Voltage Reed Relays
40-310-101
-
The 40-310/320 Range of High Voltage Switching Modules will hot switch up to 750V peak and cold switch up to 1000V peak in either general purpose relay (40-310) or multiplexer (40-320) configurations. These modules contain high-quality reed relays with switching ratings comfortably higher than the 40-310/320 specification. Applications for the 40-310/320 series modules include; circuit board isolation testing, relay testing, semiconductor breakdown monitoring and cable harness insulation testing.
-
Product
Light Meter
2330 LX
-
Standard Electric Works Co., Ltd
Wide range for measurements up 40000 lux and 4000 fc.. 0.01 lux and 0.001 fc resolution for accurate low light level measurements. Light sensor cover is included for preserving sensor life. Auto off function. Data hold function. Low battery indication. Over range indication. Auto-ranged. Manual-ranged. Calibration mode is provided. 9V battery system. Selection key for lux and fc. The spectral sensitivity close to CIE photopic curve. Ideal tool for workplace, clean-room and computer room light testing. Video, photographic, office, classroom, and architectural uses.
-
Product
Pressure Meter
ZET 7112-A VER.2
-
The ZET 7112-A VER.2 pressure meter is intended for use in automated process control systems for various industrial applications:
-
Product
Digital Pressure Meter
ZET 7012-A-VER.1
-
Digital pressure meter ZET 7012-A in BP4-1 casing is used for fast and simple absolute pressure measurements and measured values data transfer in digital format via RS-485 or 4-20 mA interface.
-
Product
Energy Meter
-
The energy meters were specially developed for measuring energy on board electric traction vehicles. You can measure both the DC and the AC signals of any existing traction power supply system (1.5kV DC, 3kV DC, 15kV / 16.7 Hz, 25kV / 50 Hz). In addition, they are also suitable for multi-system locomotives with more than one electrification system.
-
Product
Energy Metering ICs
-
Analog Devices’ ADE energy measurement ICs address the challenges of next-generation smart meter architectures and are ideal for measuring active energy (kWh), apparent energy (kVA), reactive energy (kVAR), rms, and power quality with the highest accuracy in single phase and polyphase revenue meters, industrial instruments, and energy monitoring applications. ADI’s ADE energy measurement ICs combine analog-to-digital converters with fixed-function digital signal processors to perform critical measurements, while providing unparalleled functionality and ease of use.
-
-
Product
Safety Ohm Meter
Type 1681
-
Aeronautical & General Instruments Ltd.
The Type 1681 Safety Ohm Meter range are rugged highly portable intrinsically safe instruments for use in potentially Explosive Atmospheres. Six measurement ranges enable it to measure resistances from 1mΩ and 20kΩ using a 3½ digit backlit LCD display.
-
Product
LXI High Voltage Multiplexer Plugin Module
65-231-902-HI
-
The 65-231-902-HI plug-in module is part of a scalable high voltage multiplexer platform that provides a high voltage switching solution with capability up to 9 kV.
-
Product
Non - Contact Voltage Detector
Model 273 HP
-
Kusam Electrical Industries Limited
The 273 HP is a Non-contact voltage detector. It has two ranges for selection.The 273 HP consists of an internal pickup sensor, a function selection switch, a visual and a sound annunciator. With the 273 HP, physical contact with electrical conductors is not necessary when testing for live lines. Its sensor senses the radiated field which surrounds live conductors. Radiated field strength increases with voltage and decreases quickly with distance or earth shielding
-
Product
Replacement Alligator Clips for High Voltage Differential Probe
PK-HVA-01
-
Replacement Alligator Clips for High Voltage Differential Probe
-
Product
In-plant Low Voltage Wet Sponge
-
Wet Sponge Holiday Detector for Plant or Stationary Operations is highly sensitive and accurate. A uniform coating of only one mil of paint or other non-conductive material over a metal surface is sufficient to repel a small current flow. If a pin-hole holiday is encountered, moisture from the sponge will seep into the hole and create a free path for electrical flow, activating the signal horn.
-
Product
TOU Energy Meter & Multi-Functional Smart Power Meter
EM133
-
SATEC EM133 is a Smart DIN Rail TOU Energy Meter, part of SATEC best-selling 130 series. It includes all PM130EH functionality plus a 16×2-character LCD display, 2 Digital Inputs, 1 Digital Output, IR (Infra-Red), battery backed up real time clock (RTC) and up to 8MB memory for data logging.
-
Product
ILT UV-VIS-IR Light Meters, Lux Meters & Radiometers
-
International Light Technologies
International Light Technologies has been developing and manufacturing high-performance light meters and measurement systems for over 50 years. Our comprehensive portfolio of light measurement products include radiometers, photometers, optometers, dataloggers, lux meters, chroma meters, spectrometers and spectroradiometers.
-
Product
High Resistance Meters
-
Measurements International Ltd.
Direct or Substitution Measurements, Automatic and Manual Operation, No Temperature Coefficient, Multiple Modes of Operation.
-
Product
Insulation Meter
HT7051
-
HT7051 has been developed to measure insulation resistance with test voltage programmable up to 5kVDC and measuring range up to 10TΩ which makes it very useful in any industrial application (tests on electric machines, power transformers, electric cables, electric boards, generic devices, etc.) within BT.
-
Product
PHOTO-2000m M-LUX Meter
-
Hangzhou Everfine Photo-E-Info Co., LTD
Designed for low illuminance testing above 10-4 lx. The standard CLASS A photometric detector with pre-amplification is adopted, which greatly improves the output signal quality of the detector. At the same time, the industry's advanced level of m-lux detection technology, better stability, suitable for darkroom, photo photocopying room, metering laboratory, physics laboratory, metrology laboratory and other related scientific research, engineering, product inspection and other occasions.
-
Product
PXIe High Voltage Programmable Resistor Module, REDEL Connector
42-230-252-HI
-
The 40-230-252-HI (PXI) and 42-230-252-HI (PXIe) are programmable resistor modules with 2 channels which can be set between 4.5Ω and 5.762MΩ with 0.5Ω resolution with maximum voltage of 1.2kV. The 40/42-230 range provides a simple solution for applications requiring voltage handling up to 1kV (9-pin D-type connector) or 1.2kV (22-pin REDEL connector).
-
Product
Woltman Meter
-
Key structure is made up of rotary carried helical blades which goes around as the same direction of water flow.
-
Product
UV Curing Meters
-
UV curing meters and spectroradiometers for UV curing intensity and dose measurements. A critical quality feature of UV curing processes and systems is the control of the UV dose within the wavelength range required of the particular photoinitiators with UV curing radiometers.
-
Product
DIGITAL SATELLITE METER
1600
-
The optimal satellite signal meter to test and measure both analog/digital signals(DVB-S, DSS). Especially, these models give users the capacity to measure 'C/N' very easily and correctly, which are very important measurement factors for the satellite broadcasting signal
-
Product
5-50V AC/DC Voltage Tester
1930A
-
Peaceful Thriving Enterprise Co Ltd
*Reinforced casing.*With cETL Approval.*Check voltage on 5-50V AC/DC.*Insulated housing and test leads.*Pocket clip for added convenience.*Built-in LED indicator will glow when voltage is present.
-
Product
PXI 24 Channel High Voltage Multiplexer
40-320-101
-
The 40-310/320 Range of High Voltage Switching Modules will hot switch up to 750V peak and cold switch up to 1000V peak in either general purpose relay (40-310) or multiplexer (40-320) configurations. These modules contain high-quality reed relays with switching ratings comfortably higher than the 40-310/320 specification. Applications for the 40-310/320 series modules include; circuit board isolation testing, relay testing, semiconductor breakdown monitoring and cable harness insulation testing.
-
Product
High Voltage D/A Converters (>=20V)
-
Analog Devices’ offering of digital-to-analog converters with on-chip high voltage output amplifiers includes the AD5501/AD5504, which are single-channel/quad-channel products with a DAC output range of 0 V to 30 V or 0 V to 60 V. The AD5535 is a 32-channel DAC with output range of 0 V to 50 V or 0 V to 200 V.
-
Product
Covermeter & Half-Cell Meters
-
A covermeter, or rebar locator, is a gauge that measures the thickness of concrete cover over steel reinforcement bars and metal pipes. The covermeter can tell you the depth of the rebar, the location and orientation of reinforcement bar (rebar) and determine the diameter of the rebar.
-
Product
Water Activity Meter
LD-LWTM-A10
-
Water Activity MeterLD-LWTM-A10is a real portable water activity meter, with a weight of only 1.5 kg, lighter than a mobile phone. It has 0 to 1.0 aw range and offers operating temperature range from 0 to 50˚C. Designed with 6 bit backlight LCD digital display and integrated nonconductive humidity sensor. It measures fast activity of water within 5 minutes and under-voltage alarm indication function. It is easy to measure water activity anytime and anywhere also used in free water in the state of food balance.
-
Product
Light Meter
-
Lumu Light Meter incorporate two state of the art sensors. True color sensor, based on the color standard CIE 1931/DIN 5033, and fast silicon photodiode capturing light at astonishing 750 000 measurements/second. Each Lumu Light Meter is calibrated before leaving the manufacturing line and comes with calibration certificate.
-
Product
Field Strength Meters
-
The FSM series of field strength meters will measure the strength of a RF signal appearing at its input from +20 dBm to -110 dBm for wide bandwidth models and +10 dBm to -120 dBm for narrow bandwidth models. The RF strength will be displayed on an LCD display to an accuracy of ±3 dB over the entire 130 dB dynamic range. A matching field signal generator is also available to act as a signal source for propagation studies.
-
