Showing results: 1396 - 1410 of 5217 items found.
-
IRGUN500 -
Power Probe Group, Inc.
The No-Contact Thermometer detects the infrared rays that an object emits. The instrument focuses the infrared energy of the object through the lens and onto a sensor. As a result, the instrument changes the surface temperature into an electrical signal, and a microcomputer calculates and displays the measured temperature on the LCD.
-
Tenmars Electronics Co., Ltd.
Measures air speed, temperature and humidity. It is ideal for spot measurements at air outlets on account of its 30mm vane. In addition to air speed and temperature, also measures air moisture and absolute pressure. In this way, air conditions can be reliably checked.
-
UNIVANS Co., Ltd.
The reliability test board is used for testing of HAST, THB, HTOL, BURN-IN, etc. It is a product that evaluates the environmental test and durability when applied to actual products such as lifetime test, high temperature, low temperature, high humidity and thermal shock
-
MultiDimension Technology Co.,Ltd.
AMR linear sensor utilizes two push-pull Wheatstone bridges each composed of four highly sensitive AMR sensor elements. These Wheatstone bridges effectively compensate the sensor’s temperature drift to achieve outstanding temperature stability with minimal noise.
-
Extech 801515 -
Extech Instruments Corporation
The Extech 801515 is a Type-J General Purpose Temperature Probe. It has a temperature range of -40°C to 450°C (-40°F to 842°F). For use with any meter that accepts Type-J probes. Comes with a six-month warranty. CE certified.
-
SI58 -
Validyne Engineering
The SI58 software allows the user to set zero and span as well as do full temperature compensation and linearity corrections for your Validyne USB pressure transducer. The SI58 provides everything needed to change the range of your transducer and calibrate it through the new full scale pressure. Corrections to non-linearity and temperature error are also possible. The SI58 software provides prompts to the operator for temperature and pressure points to achieve an accurate calibration.
-
Teledyne RF & Microwave
Teledyne RF & Microwave has designed a Voltage Controlled Oscillator to replace an existing application. The oscillator covers the 520 to 560 MHz frequency range. The oscillator provides +10 to +13 dBm output power. The oscillator has internal heaters designed to maintain the oscillator assembly at constant temperature. The unit operates over the 0° to 60° C temperature range with ~200 KHz frequency variation due to temperature variation.
-
TGA-1000/1500 -
Thermtest Instruments
The Thermogravimetric Analyzer TGA-1000/1500 is a thermal analysis instrument that measures weight changes as a function of temperature or time. The system allows for multiple heating, cooling, and isothermal segments to be linked together to achieve a complex profile. Automatic gas switching is also supported during the temperature program. The vertical hangdown design offers stable and smooth weight readings to be recorded during the experiment. The TGA’s small mass furnace responds quickly to changes in the temperature profile and cools down quickly for fast turn around between experiments. Typical analyses for a TGA-1000/1500 include percent weight loss, onset temperature calculations and residual weight.
-
King Design Industrial Co., Ltd.
1. Technical index:*Power: 380V, 3-, 50/60HZ 110A*Temperature range: 50°C~120°C*Humidity range: 20%~95% RH*Accuracy: 1) temperature ± 0.3°C;2) humidity ± 2.5% RH*Uniformity: 1) temperature ± 2.0°C;2) humidity ± 3.0% RH*Uniformity test: measured at T=85°C, RH=85%; set 9 points for temperature measurement and 2 points for humidity.*Inner wall is above 50 cm; within 20 min after temperature/humidity meets the setting value, the distribution uniformity of temperature/humidity can meet the aforesaid requirement.
-
MPS-D+ series -
Matrix Technology Inc.
Voltage stabilitySource effect CV≤0.01%+2mVLoad effect CV≤0.01%+2mVRipple and noise CV≤1mV(rms)CC≤5mA(rms)Voltage temperature coefficient 150ppm/°CCurrent stabilitySource effect CC≤0.2%+2mALoad effect CC≤0.2%+5mACurrent temperature coefficient 500ppm/°C
-
MultiDimension Technology Co.,Ltd.
Magnetic grate sensors integrate two push-pull Wheatstone bridges, each of which contains four high-sensitivity anisotropic magnetoresistance (AMR) sensing elements. Such a design effectively compensates temperature drift to ensure high accuracy under wide temperature range.
-
P0260 -
P3 International Corp.
The Sol-Mate Window Thermometer® is solar powered, displays temperature, minimum and maximum values, and even shows temperature trends. Its sleek European design features a transparent housing that is held directly onto your window with a strong suction cup.
-
042-641 -
ELMA Electronic, Inc.
The SysMon 3 Gen is a platform-independent system monitoring unit which monitors- and, if necessary, controls - the internal parameters of a System Platform such as voltages, temperatures, digital inputs and fan speeds. Other versions with extendend temperature range and conformal coating also available.
-
041-039 -
ELMA Electronic, Inc.
The SysMon 3 Gen is a platform-independent system monitoring unit which monitors- and, if necessary, controls - the internal parameters of a System Platform such as voltages, temperatures, digital inputs and fan speeds. Other versions with extendend temperature range and conformal coating also available.
-
BA T-7001H -
Physitemp Instruments
In applications where clinical accuracy is not mandatory and cost is a consideration , the BAT-7001H is Physitemp‘s most compact, low cost thermocouple thermometer. The Model BAT-7001H is a high performance, precision hand-held instrument for the measurement of temperature using Type T (copper-constantan) thermocouples. This versatile instrument measures temperature in both °C and °F. The internal memory of the micro-computer stores the minimum and maximum measured temperature for instant recall via the LCD display. BAT-7001H operates on a 9V battery.