Control Systems
-
product
Breadboard to DAQ Converters
0001026-1 / -2
VI Control Systems has designed two converter boards that make it easy to connect data acquisition boards to breadboards and allow easy computer control and monitoring of prototyped electronic circuits. The converter boards are 0.8 x 3.5 inches and have silk-screened pin numbers for every pin on the board. The 68-pin SCSI converter can also be used to connect 68-pin SCSI cables to prototype solder boards that have 0.1 inch centers.
-
product
PCI Resistor Card 2-Channel 1.5 Ohm To 4.09k Ohm
50-293-023
The 50-293 is a Programmable Resistor card with either two channels of 16-bit or four channels of 8-bit resistor chains in a single PCI card. The card is ideal for simulating sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.
-
product
ADC DAC Module
ZET 210
ZET 210 ADC DAC module is used for constant and alternating voltage signals digital processing and parameters control (the signals are retrieved from various primary transducers). Digital and analog outputs can be used within the scope of actuating units control systems.
-
product
PCI 96 Channel TTL Digital Interface
8009
The 8009 digital I/O interface provides 96 channels of buffered drive digital I/O emulating 8255 mode zero, which can be utilized for PC based control and automation of equipment including sensors, switches, security control systems, and other industrial automation systems. 10K pull-up resistors are included. Optional values are available.
-
product
Motion Control
ADLINK motion control solutions have been widely adopted, to date driving over 700,000 axes industry-wide. ADLINK’s extensive field experience has driven the development of powerful, high-efficiency rapid response pulse motion controllers, real-time network controllers such as EtherCAT, Ethernet and MotioNnet, and application-level software for operating control systems with over 400 APIs
-
product
PCI Programmable Resistor Card 2-Channel 2.5 Ohm To 4.09k Ohm
50-294-023
The 50-294 series of PCI Programmable Resistor cards are available with two channels of 16-bit, two channels of 12-bit or four channels of 8-bit resistor chains in a single card. These cards are ideal for simulating sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.
-
product
Sine Vibration Control
Sine control is one of the two basic and most common excitation modes for Environmental Shaker testing. This control mode performs real-time closed-loop control of swept sine vibration. The m+p VibControl vibration control system allows the user to designate all input channels as control, watchdog and/or measurement channels.
-
product
R&D Solutions
We offer fully-integrated solutions to control and automate factory problems from individual sensing devices and transducers to multi-functional measurement and control systems.
-
product
MORTAR FIRE CONTROL SYSTEM
FireCon
Elbit Systems of America provides a full arsenal of engineering and production capabilities for the U.S. Army’s Mortar Fire Control System-Dismounted (MFCS-D). As a trusted supplier, Elbit Systems of America works closely with the U.S. Army to ensure on-time delivery of each new Dismounted Mortar Fire Control System.
-
product
PXI Strain Gauge Simulator Module 6-Channel, 1k
40-265-206
The 40-265 range consists of 6, 4 or 2 channel modules (this version is the 6-channel, 1kΩ) that simulate the operation of a range of strain gauges making it ideal for testing strain gauge meters and a wide variety of industrial control systems. The range provides a simple way of replacing in house developed sensors with a low cost simulator having excellent performance. The 40-265 uses the same resistor bridge techniques that real life strain gauges are based on, ensuring accurate emulation under all conditions.
-
product
PXIe-8830MC, Intel Core i7 Processor PXI MultiComputing Processing Module
783564-33
The PXIe‑8830mc allows two or more intelligent systems to exchange data using PCI Express technology. Featuring an Intel quad-core processor, the NI PXIe‑8830mc can be installed in any PXI Express peripheral slot. It runs on the LabVIEW Real‑Time OS and can act as a coprocessor to offload the processing from the main embedded controller in the system.
-
product
TTPPowernode
TTPPowernode is a quick and cost-effective solution to start the development of a time-triggered system. It enables design of scalable applications, from smart sensors/actuators to complex control system prototypes, using production-proven software and hardware COTS components.
-
product
UV Exposure Sources
Standard maintenance, lamp, or filter replacement, does not require any tools. Locking indicator dials on all the system controls, located together for ease of alignment, provide for a reproducible setup. A beam imaging accessory makes alignment even faster.
-
product
PCI Strain Gauge Simulator Card, 2-Channel, 2k
50-265-302
These cards simulates the operation of a range of strain gauges making them ideal for testing strain gauge meters and a wide variety of industrial control systems. They provide a simple way of replacing in house developed sensors with a low cost simulator having excellent performance that is easy to calibrate and use.
-
product
Temperature, Humidity And Others Relevant Environment Tester
King Design Industrial Co., Ltd.
Allows your product quality and reliability tests more realistic toward actual environment; simulate the actual environment in the temperature, humidity and vibration by separated of combined tests. The tester is equipped with control panel, Chinese-English display and micro-computer temperature control system; applicable to aerospace, military, vehicles, electronics and other high-tech products.
-
product
2-CH MIL-STD-1553A/B Bus Simulator Module
1553 WA73A-455
The WA73A-455 MIL-STD-1553A/B Bus Simulator Module allows a system controller in an ATE system to communicate with and test devices that conform to the MIL-STD1553A/B data bus used in military aircraft and communications systems. Each of the WA73A-455's two channels operate as two separate and independent channels with their own VXIbus logical address, interrupts, and complete set of controls and indicators. As a result, each channel of the WA73A-455 is truly an independent instrument, and, therefore, individually programmable.
-
product
LXI Matrix Switching Unit
ProDAQ 6140
The ProDAQ 6140 provides a relay matrix which can be fitted between the sensors and actuators on a device under test and the data acquisition and control system. It allows to separately connect/disconnect the signals from either side and to connect them to an internal bus. In this way signals can be routed via the bus to new destinations or the bus can be used to monitor or supply test signals. This allows calibrating and debugging the system without disconnecting and separating channels throughout the system wiring.
-
product
VME
VME remains a strong solution for a wide variety of tech refresh programs. Applications range from command and control systems to high performance signal-processing radar, sonar and intelligence, surveillance, and reconnaissance (ISR) applications. Keeping VME relevant for these applications requires ongoing advancements to achieve processor migration, extending I/O capabilities on the backplane, and supporting higher bandwidth applications.
-
product
3-CH RTD Input Module
ND-6013
ADLINK's NuDAM data acquisition modules make up a total acquisition network and control system. Up to 256 NuDAM modules an be romotely controlled on any RS-485 network from a host computer, via a single serial RS-232, allowing communication from as far as 4000 feet from the host. Based on the RS-485 multi-drop network system, each module has a unique address ID, whereby simple ASCII command & response protocols through the standard RS-485 interface can control all the NuDAM modules in the RS-485 network. The NuDAM modules provide direct communications with a wide variety of sensors, perform all signal conditioning, scaling, linearization and conversion, and can acquire measurements of temperature, pressure, flow, voltage, current, and multiple digital signal types.
-
product
PCI-8361, PCI Host, 100 MB/s, Copper Cable MXI-Express Device for PXI Remote Control
781394-01
The PCI‑8361 is an MXI‑Express remote controller for devices or systems over cabled PCI from a computer with a PCI slot. The PCI‑8361 card provides a PCI link over a copper cable to the PXI‑8360 remote control module when used for PXI system control. This link is transparent to software applications and drivers, so computers and servers can control connected devices with no additional programming. With NI remote controllers, PXI modules can be used as if they are PCI devices directly installed in the computer.
-
product
SpaceWire-USB Brick Mk3
326
The SpaceWire Brick Mk3 is a USB 3.0 (also works with USB 2.0 and USB 1.1) to SpaceWire interface device that is suitable for use in all stages of SpaceWire equipment development: initial SpaceWire evaluation, instrument simulation, control system simulation, unit testing, integration support, and EGSE. The SpaceWire Brick Mk3 provides two SpaceWire interfaces, support for high speed data transfer, the capability to inject various types of errors on demand, the ability to transmit and receive time-codes and act as a time-code master, and comes complete with highly optimised host software for low latency transmission of SpaceWire packets directly to and from the host PC.
-
product
Portable RF Analyzer
PMT-330
The Process Sensors Portable Moisture Tester (PMT-330) puts the capabilities of an on-line moisture analysis and control system into the palm of your hand, allowing operators to spot-check moisture content of boards, wood, plastic, and paper products quickly and easily. It features radio frequency dielectric (RF) measurement technology that penetrates the surface of products and instantly displays accurate moisture data.
-
product
Transducer Calibrator Systems
Unholtz-Dickie Calibration Systems have earned their place in industry as the standard for calibrating accelerometers and velocity transducers. The Models 660C & 680C are UD''s latest generation of automatic calibration systems, both utilizing the expanded features of the i5 based APEX SL Windows vibration control system.
-
product
CryoVision
CryoVision is the software package to control the CryoLab from a PC and is included with all systems. Although the CryoLab can be fully operated as a stand-alone apparatus, with CryoVision you are able to control the system in more detail. You can see all parameters in a glance, switch between single set-point and programs. Create, edit and save programs and export your data. System requirements for CryoVision stand-alone program: Windows™ 7 or later. Sub-VIs for temperature control or parameter read-out: LabView 8.0 or higher.
-
product
Dissolution Software for Enhanced Data Management
Agilent dissolution software systems enable more effective management and analysis of dissolution data, while ensuring ongoing regulatory compliance. Our dissolution testing data systems integrate analysis and sampling and provide real-time access to test status and simultaneous control of multiple systems.
-
product
Military-Grade 4-In-One Temp/Humidity/Vibration/Pressure Test Chamber
Guangdong Test EQ Equipment co., Ltd.
- Integral structure, the internal overall TIG seamless welding, beautiful appearance; Door lock device adopts lever power opening mechanism. - The use of Chinese color LCD touch man-machine interface + high-performance programmable controller (PLC), with TESTEQ test box independently developed special software, with automatic, intelligent, human control and other characteristics. - Control mode: constant operation mode, program operation mode. - TEST EQ patent "Cold and heat balance technology”, low temperature constant temperature season can be more than 30%. - Refrigeration compressor and key accessories are selected international and domestic well-known brands, long-term and reliable operation; Environmentally friendly refrigerant, in line with the requirements of international environmental protection conventions. - The humidification system adopts TEST EQ patented technology. - The lift structure through the lift (wireless remote control) up and down and left and right movement to match the shaking table horizontal or vertical table, comprehensive performance test. - Gantry structure: Through worm gear (wireless remote control), the studio box is lifted up and down and the gantry is moved around to match the horizontal or vertical table of the shaking table, and the comprehensive performance is tested. - The seal of temperature and humidity box and vibration table adopts TESTEQ patent technology low pressure flexible connection device. - Pressure mode: internal pressure type or external pressure type. - Vacuum system: the world famous brand ""Laibao"" or ""Jitis"". - Configure RJ45 communication interface, remote control system (open data transmission protocol support Modbus/OPC). - Surface electrostatic powder spraying; chamber color ""TESTEQ White "", controller panel color ""TESTEQ Blue "".- TESTEQ patent cold well adsorption anti-condensation function (optional).
-
product
Group3 Control
Group3 Control is a fiber optically linked control system using distributed I/O modules called Device Interfaces, or DIs. A DI is positioned at the point to be controlled and the appropriate I/O boards added to it from the list below.
-
product
Virtualized Front End Processor
quantumFEP
Kratos Defense & Security Solutions, Inc.
OpenSpace quantumFEP provides the digital processing and network connectivity needed between the Command & Control (C2) system and the RF Signal processing equipment. All of the digital processing functions in a typical satellite ground system are included - command and telemetry processing, recording, AES COMSEC security, CSSDS processing, packet-level FEC, and network gateway interface support.
-
product
PXI Programmable Resistor Card 2-Channel 2.5 Ohm to 8.19k Ohm
40-294-024
These PXI Programmable Resistor modules are available with either two channels of 16-bit, two channels of 12-bit or four channels of 8-bit resistor chains in a single 3U PXI module. The module is ideal for simulating sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.
-
product
PCI Strain Gauge Simulator Card, 4-Channel, 350 Ohm
50-265-014
These cards simulates the operation of a range of strain gauges making them ideal for testing strain gauge meters and a wide variety of industrial control systems. They provide a simple way of replacing in house developed sensors with a low cost simulator having excellent performance that is easy to calibrate and use.
