Product

NFPA 701-1 Flammability Tester

TF320

-

TESTEX Testing Equipment Systems Ltd.

TF320 - TESTEX Testing Equipment Systems Ltd.

NFPA 701-1 Flammability Tester, to determine the ignition resistance properties of draperies and other hanging fabrics according to test method NFPA 701#1, and it is suitable for single-layer or multi-layer fabrics, but not suitable for fabrics with density larger than 700g/m2 (21oz/yd2).

Product

8-Channel VME Isolated Resistance Simulator

V420

-

Highland Technology, Inc.

V420 - Highland Technology, Inc.

The V420 is an 8-channel, isolated, programmable resistance simulator. It uses entirely solid-state simulation to eliminate transient errors associated with relay switching, and provide for monotonic resistance changes. Channels are individually programmable in four resistance ranges, from 5 ohms to 65.5K. Channels can operate from microvolts up to 35V / 50mA. Overload protection and channel error detection are included.

Product

Butt Set

MT-8001

-

Prokit's Industries Co., Ltd.

MT-8001 - Prokit's Industries Co., Ltd.

Recognized as the new industry standard, the MT-8001 butt set provides superior quality at an affordable price. With its high impedance monitor for data safe operation, technicians can clip onto a line in Monitor mode without disrupting existing traffic. Prokit's unsurpassed protection standards and durability assure the butt set will keep working even in the toughest environments. New weatherproofing provides enhanced resistance to severe weather conditions.Features

Product

Inline OEM High Resolution Thickness & Resistivity Module for PV / Solar Sorters

MX 152

-

E+H Metrology GmbH

MX 152 - E+H Metrology GmbH

To allow three thickness scans during belt transport at different wafer sizes, two measuring bars, one from top and one from bottom, hold 3 sensors each.

Product

Short Circuit Test System

-

Shanghai Guantu Technology Co., Ltd.

Shanghai Guantu Technology Co., Ltd.

The short-circuit test system refers to what kind of short-circuit test is carried out by which equipment, and how long is the test time. But I have one thing to tell you, the short circuit test is a kind of destructive test, mainly to test the working condition of the used equipment in a crisis situation, or to test how strong the anti-destructive ability of the used equipment is. Just like a lot of equipment in the military must undergo a short-circuit test, some for 3 minutes or longer, in order to resist breaking calls against the enemy during wartime.

Product

3 Terminal Digital Earth Resistance Tester

Model KM 1520

-

Kusam Electrical Industries Limited

Model KM 1520 - Kusam Electrical Industries Limited

KUSAM-MECO Digital Earth Resistance Tester is a very versatile& handy instrument for checking Earth Resistance. It consists of the indicator & set of 3 spikes (stake) and connecting wires. Earth Resistance is measured by putting the spikes in the earth at distance of 5-10m (as shown below) & switching ON the instrument indicates the Earth Resistance directly in ohms.

Product

Signal Relays

-

Panasonic Industrial Devices Sales Company of America

Panasonic Industrial Devices Sales Company of America

Mechanical Relay ideal for signal control, etc., with less than 2A nominal switching capacity. Low Level current switching below 2A. Features include gold contacts, stable contact resistance, fully sealed construction, Form C contact arrangement, available latching and low operating power, and compact size for optimal board space usage. Applications include: AC Control, Communications, Security, Measurement Equipment, Audio Visual Devices, and Automotive.

Product

Micro-Ohmmeter

MR 300 C-A

-

Schuetz Messtechnik GmbH

MR 300 C-A - Schuetz Messtechnik GmbH

The MR300C-A micro-ohmmeter enables you to perform highly accurate resistance measurements at objects with an extremely low resistance such as cables, contacts, fuses, power connections, graphite, carbon and metal samples. In the lowest measuring range of 100 µΩ the resolution is 10 nΩ.

Product

Economical Single Point Bending Beam Load Cells

ESP SERIES

-

Transducer Techniques, Inc

ESP SERIES - Transducer Techniques, Inc

The ESP Series is a economical, high accurate single point bending beam load cell. It is ideal for OEM applications such as electronic scales and weighing machines. The single point bending beam design is highly resistant to eccentric loading allowing direct mounting to the scale base and weighing platform. The ESP Series features a moisture proof sealant.

Product

Eddy Current Probes and Drivers

-

Monitran Ltd.

Monitran Ltd.

Proximity sensors work on the eddy current principle. A proximity system consists of an eddy current probe, extension cable and driver. A high-frequency RF signal is generated by the driver, sent through the extension and probe cables and radiated from the probe tip. The tip consists of a precision wound copper coil inside a chemical and temperature resistant PEEK case.

Product

Micro OHM Meter

-

Cambridge Instruments & Engineering Co.

Cambridge Instruments & Engineering Co.

This Test set is capable to measure low resistance like switch contacts, breaker contacts, busbar slices, joints, fuses, low inductive windings etc.

Product

Spray Rating Tester

TF160

-

TESTEX Testing Equipment Systems Ltd.

TF160 - TESTEX Testing Equipment Systems Ltd.

Spray Rating Tester, to determine the surface wetting resistance of fabrics, which may or may not have been given a water-resistant or water-repellent finish.

Product

Digital Multimeters

-

Triplett Test Equipment & Tools

Triplett Test Equipment & Tools

compact digital multimeter with a backlit LCD display. It offers a large variety of measurement features including AC/DC Voltage, DC Current, Resistance, Continuity, Diode Test, Transistor hFE, and Temperature. The rubberized boot provides impact and drop resistance in a sleek ergonomic design, and the user-friendly Auto Power Off feature helps maximizes battery life. The Model 1101-B is well suited for a variety of commercial and residential applications such as security, home theater, electrical, HVAC installations and more. Includes test leads with alligator clips, Type K bead probe and battery (9V).

Product

High Precision Digital 10A Mirco-Ohmmeter

DRM-10A™

-

ndb Technologies Inc.

DRM-10A™ - ndb Technologies Inc.

The DRM-10A™ is a lightweight and portable micro-ohmmeter designed to measure very low resistances from 0.01 μΩ to 200 Ω. It is the most accurate in its category.

Product

Systemkit 12K Rail | 19" subrack for railway

-

ELMA Electronic, Inc.

ELMA Electronic, Inc.

The best base for every customized 19" subrack for cPCI, VME or VME64 for railway applications. It supports many advantages like EMC shielding, climatic and mechanical resistance according to EN50155.

Product

Resistivity Cell For N1413 (50 Mm Electrodes)

N1424A

-

Keysight Technologies

N1424A - Keysight Technologies

The N1424A is designed to operate specifically with the B2985B/87B Electrometer/High Resistance Meter. It is used to measure surface or volume resistance/resistivity of insulation materials. The N1413A High Resistance Meter Fixture Adapter is required to connect the N1424A to the B2985B/87B.

Product

Handheld Water Quality Meters

LAQUA PD220

-

HORIBA, Ltd.

LAQUA PD220 - HORIBA, Ltd.

- Automatic pH calibration - up to 5 points (NIST, USA pH buffers) / up to 6 points (DIN pH buffers)- 0.01 pH resolution- Offset and average slope display - Automatic / manual temperature compensation and temperature calibration function- ORP calibration option- Dissolved oxygen (DO) concentration in ppm (mg/L) and % saturation- 0.01 mg/L or 0.1% DO resolution- Compensates salinity, temperature, and atmospheric pressure - Up to 2 DO calibration points - With real-time clock and date/time stamp for GLP compliance- Auto log data; built-in memory can store up to 1000 data- Auto shut-off (programmable: up to 30 minutes)- Auto stable, auto hold, and real time measurement modes- Calibration alarm (programmable: up to 90 days)- Built-in electrode holder allows 2 electrodes to be attached- Monochrome LCD with white LED backlight: 50 x 50 mm- Phono jack output for connecting the meter to computer via PC (USB) cable for data collection and to printer via printer (RS232) cable for printout - Casing is IP67 waterproof/dustproof, shock & scratch resistant, non-slip- Powered by 2 x AA batteries- Packaged with electrodes and calibration solutions in carrying case- 3 years meter warranty

Product

10A DIGITAL MICRO-OHMMETER

MPK-2000e

-

MEGABRAS srl

MPK-2000e - MEGABRAS srl

The MPK-2000e digital very low resistance ohmmeter is a portable, microprocessor controlled instrument used to accurately measure resistances of switches and circuit breaker contacts, transformer and motor windings, wire and cable samples, joints in busbars, etc., using test currents from 1mA up to 10A. It uses the Kelvin-type, four-terminals measurement principle, thus eliminating errors caused by lead and contact resistances.