VME Chassis
-
Product
6 Channel 6 kV/300 µA VME HV Power Supply
V6521
-
The V6521 is a 1-unit wide VME 6U module housing 6 High Voltage Power Supply Channels 6kV, 300µA. The board is available with either positive or negative output polarity; mixed version with 3 positive and 3 negative channels is also available. The channels share a common floating return, which allows on-detector grounding reducing the noise level. HV outputs are delivered through SHV connectors.
-
Product
PXIe-1065, 18-Slot (9 PXI Slots, 3 PXIe Slots), Up to 3 GB/s PXI Chassis
779730-01
Chassis
PXIe, 18-Slot (9 PXI Slots, 3 PXIe Slots), Up to 3 GB/s PXI Chassis—The PXIe‑1065 is designed for a wide range of test and measurement applications and provides a high-bandwidth backplane. The NI PXIe‑1065 has nine PXI peripheral slots, one PXI Express slot with system timing capabilities, three PXI Express slots, and four hybrid slots that accept both PXI and PXI Express peripheral modules.
-
Product
VME J1J2 Monolithic 20 slot
101VMEM120-0500
-
VME J1J2 Monolithic backplane 20 slot, compliant with ANSI/VITA 1-1994. 8-layer stripline design Includes passive termination inboard and automatic daisy chain connectors.
-
Product
Configurable 6U VME Multifunction I/O Boards
Multifunction I/O
NAI offers a variety of rugged 6U VME I/O boards – designed to be combined with our pre-integrated smart function modules – to create a highly flexible COTS-based solution ideally suited for I/O intensive sense, response and communications requirements operating over VME Bus.
-
Product
VME Test Extender 9U/220mm Universal
110EXT9122-0000
-
The VME extender boards are designed to bring a circuit card completely out of a card cage so that it can be tested or debugged on both sides of the test board. Each signal, power, and ground line can be individually isolated with the DIP switches.
-
Product
550 HP Water Brake Chassis Dynamometer
CM-51S
-
AC power, air and water required at one side wallas applicable.• Room length, and pit location within length,must be determined by user to fit maximumtruck length and rear overhang.• Provide at least one man door for fire escapenear rear of room, but not in rear wall becausesomeone entering during a test could be struckby a stone flung from a tire. Provide ample fireextinguishers at each door and near driver.• “Back-on, Drive-off” installation configurationpreferred.
-
Product
LXI/USB 12-Slot Modular Chassis With Scan List Sequencing & Triggering
60-107-002
Chassis
Our 60-107-002 modular LXI/USB chassis occupies only a small, 2U rack-height form factor, making it suitable for portable and space-restricted rack-mount applications. It features remote control via USB or LXI Ethernet. Remote control over a network enables the switching function of a test system to be located as close as possible to the target equipment, allowing for optimal performance.
-
Product
6-Channel VME Optical-to-Electrical Converter
V730
-
The V730 is a six-channel logic-level optical-to-electrical converter, packaged as a single-width, 6U VME module. When used with compatible Highland optical transmitter modules, the V730 provides fast, low-jitter, EMI-proof distribution of pulses, triggers, and precision timing signals.
-
Product
LXI/USB Modular Chassis
Chassis
For applications requiring diverse switching functions but preferring an LXI interface, look no further than our LXI/USB modular chassis. These chassis are capable of hosting our extensive range of 3U PXI switching and simulation modules in an LXI environment, allowing remote control over a gigabit Ethernet connection. Additionally, our LXI/USB Chassis support up to 18 PXI modules and can be controlled via USB or Ethernet.
-
Product
Chassis Position Sensors
-
Chassis height sensing is a specific application of CTS' rotary sensor technology. Chassis height sensors measure the position of the control arms relative to the frame or body of the vehicle. This information is used in systems such as headlight leveling and real-time-dampening. Key features of the CTS' chassis height sensors is the ability to mount in a variety of angles and projections to accommodate difficult packaging as well as robust sealing required for under chassis applications. With a global team of application engineers, CTS can package one of our generic, tooled for sales sensors or develop a custom product, unique for your application.
-
Product
Chassis Mount Kit for PXIT 2000-514A/B, 14 Slot
310113374
Mounting Kit
The Chassis Mount Kit allows you to mount the Vertical Hinged Mounting Frame to a chassis. The row of mounting holes allow for adjustability.
-
Product
VME Type 32 with 6U, 5 slot Backplane
32V05MMX36N3V10
-
VME Type 32 with 6U, 5 slot Backplane J1, J2.
-
Product
4U 20-slot Extended Rackmount Chassis
AX61492
-
*Three 5.25" and two 3.5" HDD drive bays*Three 12 cm hot-swap ball-bearing fans*Supports 20-slot backplane*Hot-swap redundant or PS/2 power supply supported
-
Product
Chassis Mount / Open Frame AC-DC Power Supplies
-
Chassis Mount / Open Frame AC-DC Power Supplies
-
Product
AXIe Chassis and Controllers
-
AXIe is a new open standard for high-performance, modular instrumentation, and incorporates the best features of other modular formats including VXIbus, LXI and PXI. Keysight has designed a new line of scalable chassis in this new format. Along with controller options, these new AXIe chassis will form the basis of a high-performance, AXIe-based test system.
-
Product
VME J2 14 slot
101VMEJ214-0900
-
VME J2 backplane 14 slot, compliant with ANSI/VITA 1-1994. The A+C rows are bussed in all slots. Also, row B has onboard, inboard termination.
-
Product
Mounting Flange Kit, G20/G20X, f/ NI PXI-1095 and PXIe-1084 Chassis
310113760
Mounting Kit
Mounting Flange Kit, G20/G20X Slide Mount, 6.75" Series Adapters, for NI PXI-1095 Chassis and NI PXIe-1084 Chassis
-
Product
PCI Express® Bus To 3U PXI Express™ Chassis Expansion Kit
ACL-EXPRESS-3
-
The PCIe-to-PXIe expansion kit includes one PCIe-8560, one PXIe- 8565, and one ACL-EXPRESS cable (3 meters).
-
Product
4U Rackmount Chassis
Chassis
4U rackmount chassis is a cost-effective computer chassis featuring a complete line of backplanes, power and storage device options. The 4U computer chassis provide the best support for various wallmount and rackmount system.
-
Product
VME Generic Carrier Card For Conduction Cooled PMC(PCIbus Mezzanine Card) Modules
AVC-2-CC
-
VME64x (6U) generic carrier card for conduction cooled PMC (PCIbus mezzanine card) with 2 PMC slots. Modular solution combines any AIM conduction cooled PMC module for ARINC429, MIL-STD-1553 or any conduction cooled 3rd party PMC module.
-
Product
VME J1 10 Slot with ADC Connectors
101VMEJ110-0590
-
VME J1 backplane 10 slot, compliant with ANSI/VITA 1-1994. 8-layer stripline design Includes passive termination inboard and automatic daisy chain connectors.
-
Product
LS-28-1U Chassis Cable Assembly Set
28U-CBLSET
-
Cable assembly set for LS-28-DRSM 1U Rack Mount Unit
-
Product
6 Channel 6 kV/1 mA VME HV Power Supply
V6534
-
The V6534 is a 1-unit wide VME 6U module housing 6 High Voltage Power Supply Channels 6kV, 1mA. The board is available with either positive or negative output polarity; mixed version with 3 positive and 3 negative channels is also available.
-
Product
4, 8, 16 Or 32 Channel ARINC429 Test And Simulation Modules For VME (6U)
AVC429-x
-
Integrated modular solution by using the AMCX429-x PMC cards installed on AIM’s AVC-2 Generic VME64x (6U) carrier card.
-
Product
10U cPCI Chassis
DP-cPCI-8010
-
DP-cPCI-8010 is a Compact high performance, high reliablity 10U cPCI chassis. The DP-cPCI-8010 provides user the right platform options to meet the system integration needs. The chassis is complied with the features defined by the Compact PCI specifications, including rugged features, modular construction, integrated cooling and EMI-EMC protection. The DP-cPCI-8010 is available with high performance 4 - 21 cPCI slot backplane and with various power supply configurations.
-
Product
Receiver, G20, Slide Mount, with Mounting Flanges for Pickering Chassis
310120143
Receiver
Receiver, G20, Slide Mount, with Mounting Flanges for Pickering Chassis (40-908, 40-914, 40-918)
-
Product
Chassis Controllers and Bus Expanders
-
With over 20 different chassis configurations, our Smart PXI chassis product line (3U chassis, 6U chassis, 3U/6U chassis) offers the most features, slot configurations, UUT interface options, system power, and embedded / external controller options in the industry.
-
Product
PXI Chassis And Remote Controllers
-
We offer both PXI & PXIe chassis and controllers that support all of our PXI switching and simulation modules as well as those from third parties. There is a choice of up to 21-slot 3U chassis with options to reduce acoustic noise and modules that can be powered from a DC source.
-
Product
5 Slot VME64x Portable Tower Development Platform; Type 32 Tower Chassis
32V05OP146N3VGBX
-
Elma Type 32V family of enclosures provide a lightweight, tower platform for packaging portable VITA System applications. Designed to VITA & IEEE . Systems can be configured with or without rear I/O card cage.
-
Product
Open Frame 3U 50HP Chassis
-
An open-frame solution for the open-minded engineer. With moveable rear profiles (up to 2.5mm,) 3U and 6U backplane compatibility options, air or conduction cooling options and the ease of fast and simple backplane interchangeability for fluid transition between VITA and PICMG bus architectures, the Hartmann Open Frame Chassis solution is the tool for customers who need versatility, accessibility and longevity.
