VME Chassis
-
Product
Pre-Configured VME Systems
-
Preconfigured VME systems are available in the 6U and 9U form factors and in a variety of chassis sizes, from 7 slots to 21 slots to fit varying price ranges and application needs. Each SKYsystem chassis has been tested for power and cooling requirements for the maximum number of processor boards. VME SKYchannel boards can be ordered as upgrades or additions to an existing SKYchannel System in order to increase processing capabilities for future requirements
-
Product
2 Slot 6U VME 64x Backplane
DP-VME-7008
-
DP- VME-7008 is a 2 slot 6U VME 64x backplane designed to be used with VME boards. This module provides the interface and communication between 2 slot and the rear side mating for the rear boards.
-
Product
6U RL1 VME Thundervbolt V-600 for 4-slot
-
SKY Computers provides one-stop-shopping for Defense contractors and integrators who need the complete spectrum of benign to harsh-packaged multiprocessing systems for their high performance needs. SKY's commercial grade SKYbolt 6U VME products have been ruggedized to two levels in the Xtreme product family. No other high performance embedded systems vendor provides this level of lifecycle support under one roof.
-
Product
CH-14 PXIe 14-slot Chassis
-
The new CH-14 PXIe chassis allows you to create high-performance multifunctional systems for collecting and processing large flows of information, as well as systems for monitoring and adjusting radio electronic equipment.
-
Product
ARINC 429 Test And Simulation VME Module
VME-429
-
*8, 16, 32 or 64 software programmable TX / RX channels*Programmable high / low speed operation*Simultaneous operation of all TX / RX channels*PXI interrupts, star trigger, and PXI clock*Error entry and detection*128 MB RAM*Label selective triggering for recording / filtering*IRIG-B timecode encoder / decoder for data correlation*Real-time recording and later analysis of multiple channels*VXI Plug & Play driver including soft front panel*Supports: C, C ++, C # and .net*Driver support: Windows, Linux, VxWorks and other systems
-
Product
Embedded Chassis For Mini-ITX SBC
ECM100
-
*Designed for Mini-ITX SBC*Two 2.5” HDD drive bays*Optional 250W AC-in power supply*Wall mount kit supported*Slim design with 1 system fan*Easy and quick customization
-
Product
MIL-STD-1553 A / B Test And Simulation VME Module
VME-1553
-
*Dual redundant*1, 2, 4 or 8 channels*Simultaneous bus controller, 31 remote terminals, bus monitor*Error entry and detection*FPGA based hardware architecture*Multi-level trigger for data acquisition and filtering*10 programmable, discrete I / O*IRIG-B timecode encoder / decoder with free-running mode*Real-time recording and physical bus playback*Supports: C, C ++, C # and .net*VISA based VXI Plug & Play driver*Optional twinax front end
-
Product
Chassis
-
Infrastructure housing for instrument cards typically containing a power supply, cooling fans and emi shielding.
-
Product
6U cPCI / PXI / PXIe 6021 Full Size Chassis
-
The WIENER 6021 crate series can be outfitted with cPCI, PXI or PXIe backplanes to provide high performance chassis with highly reliable low-noise power supplies for these bus standards. Typical applications are data acquisition, beam line control and test instrumentation.
-
Product
Rugged Deployable CMFF Chassis Aligned To SOSA™ With SAVE Tray
ATRSAV07BRN1HVQE4
-
CMOSS Modular Form Factor (CMFF) field-deployable chassis, with a tray compliant with the Standard A-Kit Envelope (SAVE). Includes a 7 slot 3U VPX backplane, chassis manager, and VITA 62 plug-in power supply. it is aligned with the SOSA™ Technical Standard and designed for C5ISR, EW and EO/IR applications. Meets MIL-STDs for shock, vibration, and other environmental standards.
-
Product
VME 32X 5 Slot 6U
-
ANSI/VITAV 1-1994 VME32 Backplane, 6U 5 Slot Including J1 & J2.Benefits:• Standard VME backplanes are available also in other slot count configurations• Surface Mount Technology – Excellent high frequency performance, high reliability and reduced cost due to SMT
-
Product
6U VME 3rd Gen Core 17 Computer
VM6054
-
The VM6054 6U VME 2eSST Single Board Computer is built around Intel®’s state-of-the-art 3rd Generation Core™ i7 quad-core processor.
-
Product
VXI Plug & Play Adapter Plate, 8U, (also fits Racal 7U Chassis)
310113248
Adapter Plate
Used to mount 9025 VXI single tier receiver (Part # 310104127) to the VXI chassis. Flanges must be purchased from the manufacturer.
-
Product
Hardware Modules for PXI, PCI, PCI Express, USB, Ethernet, VME, and VXI
MIL-STD-1553
-
Avionics Interface Technologies
MIL-STD-1553 hardware modules for PXI, PCI, PCI Express, USB, Ethernet, VME, and VXI provide advanced features and functionality to support even the most demanding test and simulation applications.
-
Product
2U 3-Slot Rackmount Chassis
IPC-603MB
-
2U 3-Slot Rackmount Chassis for ATX/MicroATX Motherboard with Front I/O
-
Product
Chassis - Controls up to 16 8x1 Modules, 32 4x1 Modules or Mixtures or 8x1's, 4x1's, 2x1's and 2x2 Modules in Any Combination or Configuration up for up to 128 Relay Drives
CXM/128-MF
Chassis
These Chassis controls up to 16 8x1 modules, 32 4x1 modules or mixtures of 8x1"s, 4x1"s, 2x1"s and 2x2 modules in any combination or configuration for up to 128 relay drives. LEDs on the front panel show switch and power status. Add Switch Modules, display / driver modules and a Control Module to complete the system or simply buy the chassis wired out to D connectors to control your own relays. A manual control is optional. Chassis is available with sink or source relay drivers from + 5 to + 28 volts, ot TTL drivers for programmable attenuators. Firmware commands for Fade and Handover for WiFi, Cell Phone and WiMax labs. Fully custom systems built with little to no NRE.
-
Product
6-Slot C-Size VXI Chassis
1264 Series
Chassis
The Astronics 1264C is a low-cost, 6-slot, C-size VXI chassis, designed and built with ISO-9001 certified quality. This chassis includes performance features normally found only in high-end, 13-slot chassis.
-
Product
PXI Chassis for Standalone Operation
OTP2 module no.181
-
PXI chassis for standalone operation with the VPC G12 receiver, also required for mounting the Signal Routing Box
-
-
Product
VME Intelligent Interface Card
IIB-3910-VME
-
The IIB-3910-VME is a single slot (6U) intelligent interface card providing complete STANAG 3838 and STANAG 3910 test, simulation and bus analysis capability for the VME Bus.
-
Product
5-Slot All-Hybrid 3U PXIe chassis
PXES-2305
Chassis
The ADLINK PXES-2305 compact 5-slot PXI Express chassis with integrated extension controller is compliant with PXI Express and cPCI Express specifications, providing five hybrid peripheral slots to support a wide variety of enhanced-bandwidth testing and measurement applications.
-
Product
MBoS Support Frame For 42-924-001 Chassis
95-901-004
Breakout Box (BoB) Chassis
Frame assembly for mounting a Pickering 42-924-001 PXIe chassis in the Modular Breakout System.
-
Product
PCI Express® Bus To 3U PXI Express™ Chassis Expansion Kit
ACL-EXPRESS-7
-
The PCIe-to-PXIe expansion kit includes one PCIe-8560, one PXIe- 8565, and one ACL-EXPRESS cable (7 meters).
-
Product
ARINC825 (CAN Bus) Test & Simulation Module for VME With 4, 6 Or 8 CAN Bus Nodes
AVC825-x
-
ARINC825 (CAN bus) Test & Simulation Module for VME with 4, 6 or 8 electrically isolated CAN bus nodes operating concurrently at CAN bus high speed bit rate of up to 1Mbit/s. The AVC825-x VME card can work either with full functionality as an active CAN node for testing and simulating or in Listening Only mode for monitoring and recording purposes.
-
-
Product
14-slot Rack-Mountable PXI Chassis
PX2000-514A (TE1014)
-
Team Solutions' TE1014 (PX2000-514A) is a 14 slot, 19î rack-mountable chassis, which fully compies with the PXI and Compact PCI standards. All slots have full PXI functionality. Separate forced-air cooling is provided for the power supply and PXI slots. Fan noise is minimized by varying fan speed according to system temperature. Standard features include temperature and PSU monitoring with full software support. The expanded slot capability of the unit provides system integrators with a single-box solution, thus avoiding synchronization, integration and cost issues associated with multi-platform solutions. With a compact case size of 4U / 19î, the TE1014 (PX2000-514A) provides the small footprint required for today's ATE and Data Acquisition applications.
-
Product
Chassis
-
With over 20 different chassis configurations, our Smart PXI chassis product line (3U chassis, 6U chassis, 3U/6U chassis) offers the most features, slot configurations, UUT interface options, system power, and embedded / external controller options in the industry.
-
Product
1100 HP Water Brake Chassis Dynamometer
TD-24
-
AC power, air and water required at one side wallas applicable.• Room length, and pit location within length,must be determined by user to fit maximumtruck length and rear overhang.• Provide at least one man door for fire escapenear rear of room, but not in rear wall becausesomeone entering during a test could be struckby a stone flung from a tire. Provide ample fireextinguishers at each door and near driver.• “Back-on, Drive-off” installation configurationpreferred
-
Product
Rack Mount Kestrel Chassis A-Series
0072
-
ATXstyle Motherboard, 3 x 5-1/4" Bays, 2 x 3-1/2". A 10-Slot HP 1000 backplane, cooling fans, and slides are provided plus space for a standard ATX PC motherboard, diskette and hard drives (3 x 5-1/4" and 2 x 3-1/2").
-
Product
Mounting Flange Kit, G20/G20x Slide Mount, For NI PXI-1045 & PXI-1085 Chassis
310113622
Mounting Kit
A mounting flange kit for the G20/G20x series receiver for mounting in a NI PXI-1085 Chassis.
