Refrigerant Leak Detectors
See Also: Leak Detectors, Gas Leak Detectors
-
Product
Open Path Gas Detector
Senscient ELDS
-
The Senscient ELDS laser-based open path gas detector is available for a wide range of toxic and flammable gases.
-
Product
Ultrasonic Flaw Detector
ECHO
-
The ECHO scanning acoustic microscope is a nondestructive ultrasonic flaw detector designed to simplify testing, increase yield and maximize productivity in the lab or on the production floor.
-
Product
Lightning Rod Flaw Detector
PADD
-
We developed the PADD for the detection of internal and external partial discharges on metal oxide lightning rods. Defects can cause radio interference in communication systems or TV images, interference whose origin is very difficult to locate. We have developed a unique technology for detecting radio frequencies for use under voltage.
-
Product
Single Photon Detector System For Near-Infrared (1.3 - 1.6 Um Wavelength) Waves With Liquid Helium (LHe) Cryostat
-
Insight Product Company is proud to offer Single Photon Detector System for Near-Infrared (1.3-1.6 um wavelength) with Liquid Helium (LHe) Cryostat. Insight Product Co. offers superconducting single photon detectors and ultra-low noise registration systems for the near infrared range. All systems operate in continuous mode, no gating required.
-
Product
Non-RMS Responding Power Detectors
-
Recognized as the pioneer and leader in RF detectors, Analog Devices offers a broad portfolio of high performance logarithmic amplifiers and TruPwr™ rms detectors. ADI logarithmic amplifiers measure signals up to 100 dB dynamic range, from dc to microwave, and accuracies of ±0.2 dB, and are well-suited for both RSSI and transmit power level detection. The TruPwr rms detectors address the challenge of measuring complex waveforms found in spread spectrum CDMA/W-CDMA and higher order QAM modulation systems and provide an accurately scaled dc voltage, which is the rms equivalent of the input waveform.
-
Product
Combustible Gas Leak Detector
Model - KM 5540EX
-
Kusam Electrical Industries Limited
• CNEX Ex ib IIB T4 GB approved.• High Quality Japanese sensor.• Anti-explosion 3.7V 1500mAH Li-ion battery equipped.• Instant sensor failure indication.• Easily check the status of alarm devices (buzzer, LEDs).• Built-in temperature compensation to provide excellent environment independency.• Audible ticker signal & visual leak size indicator.• Adjustable sensitivity, fast warm-up, low battery indicator.
-
Product
Ground Fault Detectors
-
STB Electrical Test Equipment, Inc
STB's convenient Ground Fault Detectors may be operated with one hand and are ideal for preventative maintenance. Ground Fault Detectors indicate ground faults and electrical leakage while equipment is in operation.
-
Product
Detectors
-
Marktech offers the broadest line of both silicon and InGaAs detectors commercially available. Our main focus has always been in the area of application solutions to optimize your products performance. Our team of design engineers and R&D scientists are committed to providing you with unsurpassed technical support. Our detector series includes product ranging from UV through SWIR.
-
Product
Mini Carbon Monoxide Gas Detector
Model - KM CO-910
-
Kusam Electrical Industries Limited
KM-CO-910 Carbon Monoxide meter detects the presence of Carbon Monoxide (CO) & measures concentrations between 1-1000 parts per million(PPM). The meter indicates the presence of CO by a reading on the LCD & a beeper tone. The beeper function much like clicking of a geiger counter: above 200PPM, the beeper sounds continuously with the concentration of CO; from 35PPM to 200PPM, the beeper sounds discontinuously with the concentration of CO.
-
Product
Radiation Detectors
-
A radiation detector is a device for measuring nuclear, electromagnetic or light radiation. A nuclear radiation detector identifies nuclear radiation by measuring the emission of ionizing radiation of alpha particles, beta particles and gamma rays. Also referred to as a geiger counter, a nuclear radiation detector consists of two main elements: the processing electronics and the geiger tube. The geiger tube is filled with low-pressure inert gas like helium, argon or neon. If radioactive radiation occurs, the inert gas is ionized. An anode within the geiger tube registers the quantity of ionized particles numerically correlating with the strength of the radioactive radiation. The radioactivity measurement is then displayed on the LCD screen of the geiger counter or nuclear radiation detector.
-
Product
Extreme Low Power Detector Laser Power Meters
11XLP12
-
11XLP12 extreme low power detector is best suitable for low power im both the µW and mW regimes with very low thermal drift. Featuring broadband flat spectral response, minimal thermal drift and a noise equivalent power as low as 1 µW the 11XLP12 is ideally suited for measuring any pulsed or CW low power laser.
-
Product
Thin Film Based Thermopile Detector: 4 Channels
2M Quad
-
A four-channel thin-film thermopile in a TO-8 package. Each active area is 2mm x 2mm. Offers the world's highest 4-channel sensitivity with exceptional signal-to-noise performance in a TO-8 package. Internal aperture minimizes channel-to-channel crosstalk while increasing sensitivity.
-
Product
Detectors and Associated Electronics
CdZnTe/CdTe
-
Baltic Scientific Instruments, Ltd
CdZnTe (CZT) is a room temperature semiconductor which allows to create X- and gamma-ray detectors with comparably high energy resolution and high count rate capability without cooling. Detectors performance allow to use CdZnTe detectors successfully in Nuclear Industry and Medicine, Safeguard and Homeland Security, many others industrial and laboratory applications.
-
Product
Solar EL Defect Detector
-
Jiangsu Keyland Laser Technology Co., Ltd.
Features: - Reveals invisible defects- Improves line yield prior to lamination- Improves quality and reliability of final product- Exceptional optical resolution in its class- Flexible system configuration for framed or unframed modules testing
-
Product
Flange-Type High Stiffness Torque Detector
TQ-3507
-
The improvement of energy efficiency has been required in future generation vehicles. The TQ-3507 Torque Detector developed for the measurement of torque capacity 5 kNm accurately captures minute torque fluctuations. It helps to grasp the energy loss precisely and improve energy efficiency of your system.
-
Product
CBRNE Detectors
-
Investments in intellectual horsepower, research and development; enable Bruker to offer a wide range of products with a broad technological base and high end instrumentation
-
Product
Single- Multielement Customized Infrared Detectors
LEPTON uncooled detector
-
Single element uncooled VPD PbSe detector, in 2 standard sizes: 1×1 mm2, 2×2 mm2, packaged in SMD or TO-5 (with cap, hermetic) with sapphire window
-
Product
Broadband Detectors
-
These waveguide bandwidth detectors use silicon beam lead diodes on a planar stripline circuit to obtain an extremely rugged and compact device. Most millimeter wave broadband detectors have very poor VSWR due to the difficulty in obtaining a good wideband impedance match to the diode. To overcome this problem, these detectors utilize two diodes and an internal matched termination and 3 dB hybrid as shown below. This circuit allows a VSWR of 2.0 or better over a full waveguide bandwidth for most of these detectors. Detectors for waveguides WR-8 and smaller use a single zero bias GaAs diode. The high sensitivity zero bias GaAs diodes can also be special ordered for use at lower frequencies when highest sensitivity is required.
-
Product
Pyroelectric Detectors
-
Pyroelectric detectors are thermal detectors; i.e. they create an electric signal due to temperature changes in the chip. This temperature change is caused by absorption of light. We do use LiTaO3 and DLaTGS as pyroelectric materials. Basically such detectors cover the whole spectra. However, they are mainly used for mid-wave and long-wave infrared detection (MWIR and LWIR). In addition, the usage in the THz region seems to become more popular these days.
-
Product
Directional Detectors
-
KRYTAR offers the industry's widest selection of Directional Detectors specifically designed for use in today's high-performance microwave instrumentation and systems. KRYTAR detectors are designed for such applications as power measurements, analyzing radar performance, leveling pulsed signal sources, AM noise measurements, system monitoring and pulsed RF measurements in ultra-broadband and mm-Wave applications. Complete engineering services for custom designs that meet or exceed critical performance and/or packaging specifications are available.
-
Product
Safety Voltage Detector ( Rechargeable Battery Type )
350 SVD
-
Standard Electric Works Co., Ltd
● Protection class: IP65● Bright LED visual indication● Audible indication● Non-contact voltage detection: 220Vac ~ 132kVac● Wide angle voltage detection● Frequency range: 40 ~ 70Hz ● Easy-to-prove method● Self-test function● Power source: 9V rechargeable battery ● Non-contact detection by proximity● Flashlight function● Operating temperature: 0°C~50°C● Humidity: 80% RH Max● Lightweight, robust and compact● Comply with EN 61326-1
-
Product
Ultrasonic Flaw Detectors
-
Our full range of portable ultrasonic flaw detectors (UT) provides unmatched capabilities for locating discontinuities and other flaws. A wide range of software options is available for enhanced flaw detector inspection.
-
Product
Detectors
-
Keysight detectors offer very flat frequency response versus frequency and temperature and exhibit excellent square law response with very low junction capacitance. Planar Doped Barrier Diode Detectors are available only from Keysight.
-
Product
Low Voltage Detectors
LVD-15
-
Standard Electric Works Co., Ltd
Bright LED and audible alarm sound when voltage is present. Designed for non-contact voltage detection. Can be used to find a break in a wire. Flashlight function. ON/OFF switch for longer battery life.
-
Product
Oxygen Index Detector
DRK304A
-
Shandong Drick Instruments Co., Ltd.
DRK304A Oxygen Index Detector has simple structure and convenient operation. It has the following advantages: high-precision oxygen sensor, digital display, high precision, long life, simple structure, easy to operate, without going through the formula, panel-style operation, gas pressure. Adopting table control method to ensure its accurate readings convenience, and high reliability. The use of imported oxygen analyzer control oxygen Gas passage adopts high pressure connector to prevent air leaks effectively.
-
Product
Single Channel Detectors
-
HORIBA offers a comprehensive array of single point detectors for a wide variety of applications in spectroscopy and biomedical research. These are complete detectors including housings, power supplies and facility for cooling if necessary. Available on a stand-alone basis, or in conjunction with our monochromators and spectrographs these detectors allow you to configure a custom solution for your unique requirements. Many of our spectrographs have dual exit ports allowing you to have both a point detector for ultimate resolution and a multi-channel imaging spectrograph for high speed spectral acquisitions. HORIBA offers more choices and better specifications to ensure you can select the best components for your needs.
-
Product
Conductivity Detector
CDD-10AVP
-
Low noise, low drift and wide dynamic range assure proven performance of the Shimadzu VP series HPLC. Data acquired by the CDD-10AVP is transferred to the SCL system controller via an optical fiber interface and are digitally processed by workstation. By adding the optional cell (dual kit NS), a low-cost and compact non-suppressor type dual ion chromatograph, which detects anions and cations simultaneously, can be made.
-
Product
Triple Alarm CAT IV Non-Contact Voltage Detector with Flashlight
FLIR VP50-2
-
The FLIR VP50-2 is a durable, CAT IV-rated non-contact voltage detector featuring light, vibration, and beeper feedback alarms and a powerful LED flashlight. Use the VP50-2 to reliably check if an AC circuit is live before beginning work; detect voltage on exposed conducting parts or through insulation; identify live wires within electrical panels, switches, and outlets; or trace live wires and map circuits. With an ergonomic and drop-tested design, the FLIR VP50-2 is the right choice for professionals performing field troubleshooting and verification of electrical installations within residential, commercial, and industrial buildings.
-
Product
Detector of Earth Faults on Multi/Single-Core Terminations
CableTroll 2310
-
CableTroll 2310 is an indicator for detection of earth faults (PtG) on multi-core and single core cable terminations. The unit uses NorTroll type current sensor (CT)
-
Product
Card type, Mini Wireless Camera Detector, with vibration
SH-005V / 10127
-
This "Card type Mini Wireless Camera Detector / Hidden Camera Detector" is special made for detecting all kinds of wireless spy camera, but insensitive to mobile phone signal that leads user a peaceful mind without panic.
