Showing results: 616 - 630 of 805 items found.
-
eBee Plus -
senseFly SA
eBee Plus system includes: long-flying fixed-wing airframe; photogrammetry-optimised RGB sensor; next-gen flight & data management software . The eBee Plus can map more square kilometres per flight. The eBee Plus includes built-in RTK/PPK functionality that can be activated either out of the box or later when required. The eBee Plus offers a camera to suit every application, including the senseFly S.O.D.A. (supplied), the first camera designed for photogrammetric drone mapping.
-
PCIe4LXMCX1 -
Dynamic Engineering
Simple and easy to use. Install PCIe4LXMCX1 into your PCIe system to adapt an XMC card. The XMC can have bezel and or rear IO. Pn4 and/or Pn6 are supported with PCIe8LXMCX1. 8 lanes are routed from the PCIe gold fingers to the XMC position. XMC´s with up to 8 lanes can be used. The PCIe lanes to/from the XMC are routed per PCIe specifications with matched lengths and impedance control.
-
MT1000 And MT2000 Series -
Maury Microwave Corporation
The MT1000 and MT2000 mixed-signal active load pull systems are the best commercially proven solutions capable of performing load pull at high speeds of up to 1000 impedance/power states per minute with no limitation on Smith Chart coverage, under the following conditions:Single-tone CW and pulsed-CW RF signalDC and pulsed-DC biasTime-domain NVNA voltage and current waveforms and load linesFrequencies between 1 MHz and 40 GH
-
PCI-C588/PCI-C584/PCIe-C588 -
ADLINK Technology Inc.
*IRQ & IO address automatically assigned by BIOS*Supports up to 2 cards per system, jumper-less, easy to configure*Isolated RS-422/RS-485 interface (C422/C485, C518/C514)*PCI Rev 2.1 Plug-and-play*PCI Express® x1 compliant (PCIe-C588)
-
Mountz Inc.
It’s frustrating when you waste precious time fumbling for screws, but you can solve the problem by replacing an open bin or shaker tray with a Mountz screw presenter. These tools deliver up to two screws per second to a fixed point where a human or robotic operator picks them up, cutting production time in half. Mountz screw presenters are engineered to stay online without jamming or needing repair. Small enough to fit onto crowded benchtops, Mountz screw presenters provide all the function of high-priced custom screw feeder systems at a percentage of the price.
-
WinSystems, Inc.
This add-in module is 40 times faster than USB 1.x implementations and supports signaling up to 480 Megabits per second (Mbps). It is based upon the NEC uPD720101 USB 2.0 host controller that is supported by a wide range of operating systems including Windows and Linux.
-
5033 -
Abaco Systems Inc
ECM P/N 5033 provides eight channels of RS485 / RS422 I/O. The 110 ohm termination for each channel is enabled or disabled in software. Disabling termination saves power by eliminating unneeded or redundant termination. Speeds of up to 20 Mega bits per second are possible, but this design also features a 250K bits per second slower edge rate mode. The 250K bit mode is valuable when EMI is more of a concern and throughput is not important. All channels power up as inputs with the outputs disabled.
-
5041 -
Abaco Systems Inc
ECM P/N 5041 provides eight channels of RS485 / RS422 I/O with fixed 120 ohm termination for each channel. Speeds are up to 30M bits per second. All channels power up as inputs. Also transceiver inputs are always enabled for loop back diagnostic use when the outputs are enabled. Software can enable outputs on a channel by channel basis.
-
Tekscan, Inc.
At the heart of every Tekscan pressure measurement system is an ultra-thin, tactile pressure sensor. Every Tekscan sensor is comprised of numerous individual sensing elements, or sensels. The sensel density represents the total number of sensels per unit of area. In order to use Tekscan's pressure sensors, you must have a Tekscan pressure measurement system as well as the corresponding sensor map (software driver) for the sensor.
-
Ajinkya Electronic Systems
Ajinkya Electronic Systems Manufactures water level controller with timers These controllers controls the operation of pump as per programmed time. Facility to set on time and off time for pump is available.
-
UBSi -
nac Image Technology Inc.
The Invisible® Vision Ultra UBSi series of compact ultra high speed framing cameras are designed to capture up to 24 mega-pixel performance frames at speeds up to and beyond a true 1 Billion frames per second (optically calibrated exposures to 1ns) The cameras are derivatives of the UHSi camera system but with enhanced timing capabilities and optimized shuttering for the accurate imaging of the very fastest events.
-
KI 256 -
Tech-Aid Products
This is the Gyro Rate board built to the manufacturer’s specs per Service Aid KI256-103. This board is required by the OEM when testing the KI256/KI258 gyros. All parts obtained from service aid kit.
-
Atec, Inc.
Atec’s Portable Calibration Kit, PN AHT63506-1, is used to calibrate instrumentation and transducers in engine test cells, as required per T.O. 33K6-4-3416-1 or Atec Technical Manuals.
-
JRebel -
Perforce Software Inc.
JRebel saves Java teams a month of coding time per year on average. Stop waiting on redeploys. Reload code changes instantly.
-
Agilent Technologies
Learn about our extensive range of CGH + SNP microarrays dedicated to cytogenetic workflows. We provide whole genome CMA at variable resolutions, down to exon level, CGH+SNP arrays to analyze CN and LOH in a single experiment and application specific designs, including pre- post-natal, PGS, CNV and Cancer specific microarrays. Agilent’s CGH platform provides unmatched flexibility on content and throughput, thanks to eight different microarray formats with variable density and arrays per slide. Agilent provides a database of more than 28 million validated probes, and easy tools to customize array content based on needs. Custom or catalog, all Agilent’s CGH & CGH+SNP arrays benefit from proprietary SurePrint technology with long, high quality oligos.