Scintillation Detectors
absorb ionizing radiation and convert a small part of their energy into light for photodetection.
See Also: Scintillators, Particle Detectors, Photodetectors
-
Product
Terahertz Generators and Detectors
-
Terahertz generators and detectors are produced and optically prepared at the facilities of Rainbow Photonics in Switzerland.
-
Product
Thin Film Lithium Tantalate (TFLT™) Pyroelectric Detectors
-
For room temperature measurement of THz sources, from nW to mW.
-
Product
Heat Detector Testing
Solo 461
-
Functional checking of heat detectors, with a genuine heat source, is now required by major national standards around the world. Testing with heat sources not designed for the purpose can be both dangerous and damaging. The Solo range of heat detector testing equipment, designed specifically for the purpose, provides a genuine professional’s solution.
-
Product
SF6 Leakage Detector
GDWG-IV
-
GDWG-IV SF6 Gas Leak Detector is infrared type leak detector. It is color LCD display and real-time shows SF6 concentration. It rapidly detect SF6 breaker, GIS leakage point and yearly leakage rate qualitatively and quantitatively. It's a good device suitable for power supply department, installation and overhaul unit, power test institute.
-
Product
Hybrid Photon Counting Detectors
MYTHEN2 Series
-
MYTHEN2 detectors guarantee noise-free performance, maximum resolution, and outstanding signal-to-noise ratios for an extended energy range from 4 to 40 keV. These systems include two module sizes: 1K with 1280 strips, and 1D with 640 strips. Their compact size, symmetrical sensor position, and DCS4 control unit make the MYTHEN2 series suitable for any diffractometer geometry — from portable instruments to large systems.
-
Product
RF Proximity Detector
Type RPD-2 AND Type RPD-2A
-
The Type RPD-2 Radio Frequency (RF) Proximity Detector is designed to detect and locate devices that radiate radio waves in the high frequency to low microwave frequency range. Such devices often include surveillance and “spy” equipment. The Type RPD-2, when used with the different sensors, will detect the emanation of the radio wave within a confined area, and then isolate its location to within approximately a square foot. The type RPD-2A may be used as an RF field strength indicator for antenna field strength measurements. The RPD-2A is identical in function except that the meter scale is calibrated in relative dB units.
-
Product
Temperature Measurement IR Sensors & Detectors
1SC Compensated
-
A thin film-based single channel thermopile detector that offers thermal compensation to minimize effects of sudden ambient temperature change during the initial five seconds of change. The 1SC Compensated comes in a TO-5 package with a medium sized 1.0 x 1.0mm active area. Compensation is achieved through the integration of two additional half-sized thermopile elements. Internal aperture is standard and precisely defines active area for applications with FOV and/or spot size requirements.
-
Product
Digital Multimeter Detector
MS-WDMMD20
-
An external wireless connectivity Digital Multimeter Detector integrated. True RMS, auto and manual measurement. One of the most advantages of the meter is wirelessly connect to Smart phone / Tablet / PC (require different external wireless modules, sold separately) to view data, record reading, capture picture with data on it and send the information to headquarter.
-
Product
Infrared Gas Detector
iTrans2
-
Teledyne Gas & Flame Detection
The iTrans2 infrared gas detector employs an intelligent electronics platform to provide one or two points of detection from a single head for maximum flexibility, superior performance and lower installation costs. With the optional HART Communication Protocol, the iTrans2 offers remote diagnostics, set-up or calibration by superimposing a high-frequency current across the industry standard 4-20mA analog line.
-
Product
Personal Safety Voltage Detector
288 SVD
-
Standard Electric Works Co., Ltd
● AC Voltage detection: 240V ~ 50kV ● Waterproof● Easy-to-wear on body or belt ● Ultra-bright LED indication● High pitch sound indication● Self-test & diagnostic circuitry● Friendly priority alert reporting● High impact type casing● Different alerting sound & light● Meets EN 61326-1● Dimension : 114(L) × 67(W) × 27(D) mm● Weight : Approx. 152g (battery included)● Power supply : 9V(6F22) × 1
-
Product
Voltage Detector
KEW 5711
-
Kyoritsu Electrical Instruments Works, Ltd.
Senses AC voltage through insulation. Buzzer sounds and tip glows upon ac voltage detection. Powerful flashlight. Dual range (Hi/ Lo) sensitivity. Ready to use without power-on. Designed to meet IEC61010-1.
-
Product
Crack Detectors
-
GAOTek offers a large selection of crack detectors which are affordable, easy to operate and user-friendly. For some industries such as aviation, civil, infrastructure and space technology, even the slightest crack can lead to risks of hazards. There have been cases in the past where projects costing billions were destroyed in seconds due to a minute crack on the surface of the body. GAOTek provides trustworthy devices with various features that are helpful in detecting the smallest crack on an object.
-
Product
Flange-Type High Stiffness Torque Detector
TQ-3507
-
The improvement of energy efficiency has been required in future generation vehicles. The TQ-3507 Torque Detector developed for the measurement of torque capacity 5 kNm accurately captures minute torque fluctuations. It helps to grasp the energy loss precisely and improve energy efficiency of your system.
-
Product
Solar Radiation Detector PCE-SPM 1
-
PCE-SPM 1 is a photovoltaic (PV) light meter used to measure solar radiation, solar energy or solar power. The meter's easy-to-read 4-digit LCD screen clearly displays Ptot in W/m² or BTU/(ft² x h), while the device's auto data memory stores up to 43,000 data sets.
-
Product
Non-Contact Type Magneto-Electric Rotation Detector
MP-9820
-
MP-9820 is a magneto-electric-rotation detector using an internal hall element, a permanent magnet, DC amplifier, and voltage regulator in its compact body. Using MP-9820 in combination with detection gear enables deriving stable rectangular waveform from ultra low speed all the way through high speed. (1 Hz to 100 kHz)MP-9820 finds wide range of applications and rotational measurement objects by using with TM-3100 series tachometer and FV-1500 FV converter.
-
Product
Heat Detector Testing
Solo 423 / 424
-
Available in both 110 / 120 and 220 / 240 volt versions the Solo 423 and 424 are the professionals’ choice where cables and leads are acceptable. Unconstrained by energy availability they provide the quickest of test times and are, perhaps, most suitable for the highest temperature detectors.
-
Product
Magnetism Detector DET
432
-
The MAC Magnetism Detector is widely used by steel suppliers and fabricators to determine residual magnetism in iron and steel objects.
-
-
Product
Work Area Voltage Detectors
-
*Warns of high voltage electric fields using WAVi technology - Work Area Voltage Indication*Visual and audible warning indicates the location of energized fields in a red-yellow-green sequence*Detectors communicate with each other within a mesh network*Remotely control detectors through the Lookout mobile app*Battery life of up to 500 hours in Monitor mode and up to 8 hours in Alert mode*Durable water-resistant housing
-
Product
Holiday Detector
-
Used to detect holes, known as holidays or discontinuities, in a coating. Holiday testing allows the detection of even smallest coating flaws invisible to the naked eye.
-
Product
CBRNE Detectors
-
Investments in intellectual horsepower, research and development; enable Bruker to offer a wide range of products with a broad technological base and high end instrumentation
-
Product
Portable Flaw Detector
EPOCH 6LT
-
Portable and easy to use, the EPOCH 6LT flaw detector is an ergonomic, rugged instrument that delivers user comfort and more uptime. Weighs just 1.95 pounds (890 g) with a grip-oriented weight distribution for one-handed operation with minimal wrist fatigue. Rotary knob and simple button design make it easy to use, even when wearing gloves. Engineered to IP65/67 and drop tested. Clear, bright screen for readable A-scans in any light. The EPOCH 6LT flaw detector’s workflow is simple and straightforward. Despite the instrument’s small size, it has the features and functions to meet the requirements of nearly any conventional ultrasonic inspection application.
-
Product
On-Board Fuel Consumption Detector
MF-3200
-
- High accuracy within ±0.2 % of reading- Compact size and light weight- A fuel cooling function is provided as standard.- Simultaneous measurement of temperature and pressure together with the flow rate
-
Product
Sludge Level Detector
SL-200B
-
Sludge Level Detector SL-200B measures the sludge level accurately using ultrasonic reflectometry, and supports more efficient operations, such as remote control and automation.The display section displays the sedimentation state visually and easily understandable using a color graph display. It contributes to sludge removal work.
-
Product
Torque Detectors
RH series
-
High rigidity: highly accurate detection of torque fluctuation with high response. The RH series is a torque detector that can accurately detect torque fluctuations with high torsional rigidity about 4.5 times compared to the existing products.
-
Product
Scalable Detector Module
X-Tile
-
Off-the-shelf, easily scalable detector module speeding up time-to-market and lowering total costs of the highest-tier volumetric CT systems.
-
Product
Portable Gas Detectors
Altair
-
Portable single and multi-gas detectors combine reliable detection and LED/audible/flashing/vibrating alarms with clear, backlit LCD displays. Sensors measure concentrations of; Ex, Ex-M, Ex-H, O2, CO/H2S, CO-HC, H2S/CO H2 RES, CO/H2S-LC, SO2, H2S/SO,CO/NO2, NH3, CL2
-
Product
Detectors
-
Thorlabs' photodetectors are capable of detecting light throughout the UV, VIS, NIR, IR, and THz spectral regions. Our photodetectors feature sensors that enable properties such as intensity, power, intensity distribution, wavefront shape, energy, and wavelength to be measured. We offer unmounted photodiodes as well as amplified, biased, and avalanche photodetectors. Thermal power detectors are available unmounted, mounted on a PCB, or mounted on an aluminum plate. Also available are position-detecting sensors, integrating spheres, and an acoustic detection module.
-
Product
Stealth Pipeline Metal Detector
-
Stealth Pipeline metal detectors are custom manufactured to suit any piped product application. The Stealth uses digital signal processing technology and has high sensitivity levels to ensure the detection of the smallest ferrous, non-ferrous and stainless steel contaminants. The built-in data collection software with USB data transfer establishes the Stealth as an effective critical control point complying with stringent HACCP regulations.
-
Product
Ultrasound Detector
-
It’s a fact: All machines can fail. Therefore, you need a solution that helps predict those failures early. Schedule your maintenance tasks on your terms. Let SDT help you take back control of your assets.
