Big Data
boundless digital processing.
-
Product
Miniature Humidity and Temperature Data Logger
MicroRHTemp
-
The MicroRHTemp is a battery powered, stand alone humidity and temperature data logger that can fit in the tightest places. It is even small enough to fit into most pill bottles. It features an LED alarm indicator that alerts when user-chosen temperature limits are exceeded.
-
Product
Thermometer Hygrometer Data Logger
S3120
-
Data logger is designed for record of temperature and humidity. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper communication adapter.
-
Product
Remote Data Acquisition
-
Sometimes your sensors or the piece of equipment you are trying to control is not in a convenient place to have a PC close by. The sensors may be widely distributed through out your plant and it just wouldn’t be cost effective to run all your wiring to where the PC is. In addition, low level signals are more accurately acquired when digitized close to the signal source. In all these cases our REMOTE ACCES line of products will help. The REMOTE ACCES pods are intelligent, sensor to computer interfaces. Each pod can be used as an autonomous data logger to acquire data for later download. Or as many as 31 pods may be connected on a single two wire multidrop RS-485 network allowing a cable distance of up to 4000 ft. You can also go wireless and extend your range by adding RS-485 wireless transceivers to your serial port. Each unit comes in a rugged NEMA 4 enclosure and can withstand harsh industrial and marine environments.
-
Product
Compact Data Logger for Temperature
NANO-T（Medical type）
-
Compact size for portable using; integrated USB interface for a convenient connection with PC Visual alarm when temperature or humidity is out of limit Housing material is free of toxicity and halogen, which is in compliance with food and drug safety requirements Suitable for temperature data collection in narrow space
-
Product
Hydrostik Data Logging Digital Hydrometer
CTL-200
-
The CTL-200 Hydrostik is a digital microprocessor controlled battery test instrument that replaces the traditional, potentially inaccurate, 'paper and pencil' methods previously used. It can be used on either Vented Lead Acid or NiCad Cells. REMEMBER - never mix electrolytes, it kills batteries!
-
Product
Data Loggers
-
Are electronic devices which automatically monitor and record environmental parameters over time, allowing conditions to be measured, documented, analysed and validated.
-
Product
Microsoft Graph Data Connect
-
Microsoft Graph is the Microsoft 365 data that describes the patterns of productivity, identity, and security in an organization. Microsoft Graph Data Connect offers developers a highly secure, efficient way to copy Microsoft Graph datasets, at scale, into Azure Data Factory. It's an ideal way to train AI and machine learning models that uncover rich organizational insights and deliver new value to your productivity solutions.
-
Product
Pressure, Temperature and Humidity Data Logger
PRHTemp101A
-
The PRHTemp101 is a miniature battery powered stand alone pressure, humidity and temperature data logger. This is an all-in-one compact, portable, easy to use device that will measure and record data for up to 13,107 measurements. The storage medium is non-volatile solid state memory, providing maximum data security even if the battery becomes discharged.
-
Product
Temperature Data Logger
DL001
-
Record temperature in a wide range of applications including HVAC testing and balancing, transportation, and energy management with the Model DL001 Temperature Data Logger. Temperature logger has an on-board thermistor and an external sensor channel for remote temperature measurements
-
Product
Data Analyzer, 6 GHz Bandwidth, 4 Input Channels, 40 GS/s Max Sample Rate
SDA 806Zi-B
Analyzer
6 GHz, 40 GS/s, 4ch, 64 Mpts/Ch Serial Data Analyzer with 15.3" WXGA Color Display. 50 ohm and 1 Mohm Input, 6.5 Gb/s Serial Trigger, 8b/10b and 64b/66b decode.
-
Product
IPhone Data Recovery Tool
iPhone Jig (several chips)
-
iPhone and iPad is special with its system.encrypted with several chips;once they get damaged(can't boot or start),it is hardly to get data back.
-
Product
Data Loggers
FlashLink BLE
-
Monitor temperature and locationTracks route and conditions inside vehicles during deliveryTracks conditions in storage, processing and packing facilitiesView data on mobile device up to ~100 feet / 30 meters awayNo need to open doors and locate logger for downloadingWirelessly transmits data to smart devices with appCustomize settings: ID/name, logging interval, high/low alarm limitsEmail PDF and CSV reports from mobile device and web appData stored in a cloud-based applicationAnalyze information from any web enabled device to make cold chain management decisions
-
Product
Shop, Bench-top 615-3/4 Data Loader
F-SIM-LDR-615
-
Avionics Interface Technologies
An ARINC 615-3/4 compliant Data Loader software package that includes an easy to use, intuitive, software data loader user interface and command line interface.
-
Product
Digital OneWater Module for Collecting Live Data to Improve Wastewater Network Performance
Aqua DNA
-
Aqua DNA is an intelligent Digital OneWater solution that collects live data and improves wastewater network performance using smart sensors and AI-powered predictive analytics to reduce risk and make a positive societal and environmental impact.
-
Product
USB Reusable Data Logger
-
Single channel, internal sensor for ambient air temperatureUser Programmable: manual or automatic start, sample interval, alarm limits, data tagsLarge, easy to read LCD displayRemaining Battery Indicator (low battery)Trip history statistics available on LCDNIST traceable and CE MarkUSB Connection
-
Product
Low Level DC Current Data Logger
Process101A
-
The Process101A is one of MadgeTech's newest data loggers. It is part of a new series of low cost, state-of-the-art data logging devices. MadgeTech has taken the lead in offering the most advanced, low cost, battery powered data loggers in the world today.
-
Product
Instrument Grade Data Sensor
WISER 8000
-
TECAT Performance Systems, LLC
The TECAT WISER Model 8000 dual strain measurement and monitoring system is a wireless data acquisition system for measuring two external strain channels at high data rates up to 8kHz. The small, light, power-efficient, and non-invasive design enables strain measurements in a wide range of applications. With dual external sensor inputs two Micro-Measurements strain gauge bridges can be measured by a single system, for example to measure both thrust and torque loads simultaneously.The Model 8000 has a long range data transmission of >1,000 meters with up to +/- 0.025% FSR sensitivity for remote measurements. After initial setup using the WISER software interface, the system can be wired directly to your DAQ system, for seamless data collection.
-
Product
Vegas Data Diode
01-09838
-
Non-ruggedized module that addresses concerns regarding use of untrusted, commercial-off-the-shelf (COTS) bus logging on aircraft with a MIL-STD-1553 or ARINC-429 bus interface.
-
Product
Data Communications
-
Renesas' MIL-STD-883-compliant CMOS Manchester Encoder-Decoder (MED) is a high-speed, low power device manufactured using self-aligned silicon gate technology. The device is intended for use in serial data communication, and can be operated in either of two modes, a converter mode or repeater mode. This device is qualified to QML Class Q military standards.
-
Product
FMC for Data Communication Dual 1 Gigabit Ethernet FMC
FMC431
-
Sundance Multiprocessor Technology Ltd.
The FMC431 is a dual 1 Gigabit Ethernet FPGA Mezzanine Card with two RJ45 connectors available on the front panel. Compliant with the VITA 57.1 standard the FMC431 offers a High Pin Count connector but is compatible with FPGA carrier cards with Low Pin Count connectors. The Ethernet interface (1000BASE-T) is either implemented using RGMII (Low Pin Count compatible) or SGMII (High Pin Count compatible). The FMC431 also offers the option to stack an additional FMC over it. Any of the 4DSP FMC that use LVDS and single ended signaling only can be mounted over the FMC431, thus offering users with the ability to build a complete data acquisition, waveform generation and communication solution while using a single FMC site on an FPGA carrier card. The FMC431 is an ideal solution to bring Ethernet connectivity to an FPGA based system and ensure reliable external communication.
-
Product
PCI Data Acquisition Boards
AD8-1500DMA Series - 8 bit, 1.56 GS/s
-
The AD8-1500DMA series has a 1500 MSPS 8-bit A/D, 8GB/16GB of on-board SDRAM memory and the ability to transfer data directly into the computer system's memory at up to 320 MB/s on 64-bit PCI systems. Sampling is controlled by an onboard oscillator or by an external clock input, which may be in the frequency range between 20 MHz and 1500 MHz. Multiple boards may be configured to acquire either concurrently, for more simultaneous acquisition channels, or sequentially, with an automatic overlap selectable from 0 to nearly 2GB, in 512KB steps, for longer record length. Drivers for 64 bit Linux and Solaris operating systems included.
-
-
Product
Conductivity-Thermometer Data Logger
HD2106.2
-
Conductivity-Thermometer measures conductivity, liquid resistivity, total dissolved solids, salinity and temperature. Datalogger which can store the maximum, minimum, average value and can store up to 36,000 samples.
-
Product
3-Slot Data Acquisition Mainframe With Two 20-Channel Switch Modules And One 20-Channel Multiplexer Module
DAQ970SB
Mainframe
The DAQ970SB good switching bundle offer includes a DAQ970A single 3-slot data acquisition mainframe (USB and LAN), two 20-channel DAQM903A Actuator/GP switch modules and one 20-channel DAQM901A multiplexer module. This bundle gives you 5% off the list price.
-
Product
Temperature Data Acquistion
THERMES-USB RF
-
Physitemp’s original Thermes high accuracy ISA based data acquisition system has been redesigned to create a more versatile USB model. The new system requires no internal connections to your computer and simply connects via an external USB port on your laptop or desktop computer. Two versions of the data acquisition system are available. The standard version, THERMES USB, is connected to your computer USB port. The wireless version - THERMES USB WFI, can be either directly connected to a USB port or, with the included wireless receiver, positioned up to 100 feet from the host computer. Each unit will accommodate up to 7 type T thermocouple sensors and multiple Thermes units may be connected to the same computer for more thermocouple inputs. A high accuracy electronic cold junction compensation circuit maintains typical system accuracy of ±0.2°C over an ambient temperature range of 15 to 35°C. Individual offsets may be added to each input in software to facilitate individual calibration of each channel. For information on our wide selection of Type T Thermocouple temperature probes.
-
Product
Compact Data Logger: Monitoring Temperature, RH and Dew Point
HD208
-
The data loggers of the series HD208 are compact instruments for monitoring temperature, relative humidity (RH) and dew point temperature. Usable in a wide spectrum of applications, are available in various models (with or without LCD display):
-
Product
Data Loggers
-
Data loggers are small electronic devices used to track and store location-specific data via built-in or external sensors. They are typically battery-powered and equipped with internal memory, and have become the predominant method of monitoring in most contemporary industries, having increasingly replaced the electromagnetic chart recorders that originated back in the early 19th
-
Product
Digital Serial Data Audio Interface
PIO-9216
-
For accurate testing of devices that use the I2S, Left Justified, Right Justified and TDM audio data formats.
-
Product
Temperature And Humidity Data Loggers
-
These dataloggers are used to monitor and record temperature and/or humidity. Available in either single or multi channel inputs for thermocouple, RTD, thermistor, & infrared temperature sensors.
-
Product
Bench Digital Multimeter, Calibrated, Data, 1 kV, 10 A, 3.8 Digit
72-1015 CAL D
-
The 72-1015 CAL D from Tenma is a digital bench type true RMS multimeter. It has auto and manual range options with maximum reading of 5999 counts and 3-5/6 digits which has a unique outlook design. In addition to all the conventional features including DC/AC voltage, current, resistance, diode, continuity test, diode test capacitance, temperature, transistor, max/min, there is a data hold, low battery display, sleep mode, RS232C serial port for easy connection with computer to realize macro recording, monitoring and capture of transient dynamic data, displaying change of waveform during the measurement, providing data and evidence to engineering technicians for scientific research. This meter complies with the standards IEC61010, pollution degree 2, overvoltage category (CAT I 1000V, CAT II 600V) double insulation and CE marked.
