Filter Results By:

Products

Applications

Manufacturers

Showing recent results 1 - 15 of 185 products found.

  • Tone Amplifier And Tone Generator Set

    AM5/TG5xs - JSD TestPhone Ltd

    The New Tone & Amp Set are state of the Art Testers offering touch button technology, visual qTrace (quick trace) as well as audio tracer tone technology providing accurate wire location, high output volume and sensitivity, tone tracker functionality, Visual/Audible indication of Digital Traffic, filtered amplification with multiple volume levels and two normal tones and four tonetracker tones with constant and variable interrupt rates, short detection and indication, capacitive output connection, Quick change battery and low battery indication in New custom designed High impact resistance enclosures, fully sealed to IP67.

  • Tone Generator

    CT107 - Etcon

    Tone mode generates an alternating (700 Hz to 1300 Hz) or continuous (1000 Hz) signal which is sensed with a CT108 Tone Tracer for insulated conductors or a handset for bare conductors.

  • Tone Tracer

    CT108 - Etcon

    Receives tone generated by CT107. Equipped with internal speaker, no handset required. Hannd set connections present for use in noisy areas.

  • Tone Generators

    Psiber Data Systems

    Traditional Tone Generators were designed for one primary mission; to identify the termination point of a cable. Unfortunately, these were designed for telephony, not network maintenance.

  • Tone Generator

    140BMC/6P - Aines Manufacturing Corp.

    The following tests can be performed using the 140BMC/6P Tone Generator:*1000 Hertz or 500/1000 hertz alternating tone for tracing pairs.*Locates broken pairs/cables in walls. *Tone generator emits R.F. signal detectable by Aines Model 250SSP STATIONMAN Probe or 350 Filter Probe.*Provides talk power on dead pair.*Checks for shorts or opens, using a long-life lite-emitting diode (LED).*Continuity test.*Tip & Ring identifications.*Line condition identification. a. Clear line. b. Busy line. c. Ringing line.*Positive line verification.*Long battery life.*Nylon braided tinsel test lead wire for greater wear and flexibility.*Heavy duty nickel silver Aines 6P type alligator clips with custom designed vinyl boots.*Rubber grommet to prevent chafing on the test leads.

  • Tone Generator

    A15TG - Shure Inc.

    The Shure A15TG Tone Generator is a battery-powered 700 Hz signal source used to troubleshoot audio systems by checking microphone lines for correct patching and detecting unusual noise that is present. The output level of the A15TG is approximately 42 dBV.

  • Tone Generator

    ComTekk Engineering, LLC.

    Control and test 2-way radio systems, repeaters, ANI, Paging and more. Activate 2-tone or 5/6-tone pagers. Operate or test EIA tone-remote systems. Record generated signals to a WAV file Accomplish MORE, by carrying LESS hardware in the field. Monitor inputs and outputs with our FREE built-in audio scope and spectrum analyzer. No external hardware required. Output may be fed directly into radio, twisted pair, or service monitor.*

  • Online Tone Generators

    Dr. Ir. Stéphane Pigeon

    Output of our tone generators will be downloaded straight to your computer as a .wav file. In other words, our waveform generators will generate high quality sound files, but won't play them online, ensuring the highest sound quality one can obtain on a computer. Single Frequency: Sine Tone Generator, Square Tone Generator, Sawtooth Tone Generator, Triangle Tone Generator. Dual Frequency: Dual Sine Tone Generator (IMD Test). Variable Frequency (sweep) Audio Signal Generators: Sweep Tone (Chirp) Generator.

  • Tone & Probe Kits

    Triplett Test Equipment & Tools

    ProTone Wire Locator Kit features a powerful tone generator and a filtered, ultra-bright lighted probe. The CTX590 functions as a high quality wire locating tool that uses an inductive probe to sense a tone placed on the wires by its associated tone generator. The tone generator provides RJ11, RJ45 and insulated alligator clip connections. The Red/Green LED on the probe indicates continuity, voltage, and polarity. The probe also includes an ultra bright LED tip, fluorescent light noise filter and sensitivity control. The CTX590 can be used for tracking down short circuits, telephone central office connections, and other wire locating applications. Includes (2) 9V batteries and case.

  • Tone Test Set

    240 Weathertite - Aines Manufacturing Corp.

    The AINES Model 240 Tone Test Set is a water resistant tone generator equipped with a weathertite 2 conductor modular cord and jack. The set can be connected to the Network Interface Device (NID) with either the two individual clips or the modular cord. This allows the CPE circuit to be viewed in both directions, towards the Central Office and towards the customer premise. In the event the CPE does not have a jack, but instead has a cord, plug the cord into the Model 240s jack and transmit tone!

  • World Tone Database

    CPT-Master - 3am Systems Ltd.

    Online resources and tools for checking, configuring and generating international call progress tones.

  • Tone Analyzer Service

    IBM developerWorks

    The IBM Watson Tone Analyzer Service uses linguistic analysis to detect three types of tones from written text: emotions, social tendencies, and writing style. Emotions identified include things like anger, fear, joy, sadness, and disgust. Identified social tendencies include things from the Big Five personality traits used by some psychologists. These include openness, conscientiousness, extraversion, agreeableness, and emotional range. Identified writing styles include confident, analytical, and tentative.

  • Tone And Probe Kit

    3PK-NT023N - Prokit's Industries Co., Ltd.

    For professionals who need fundamental wire identification tools without the extra cost, the 3PK-NT023N basic Tone and Probe Kit is the answer. Use it on de-energized AC wire, telephone/twisted pair wire, all voice and data category rated cable, speaker wire, virtually any cable or wire!

  • Tone Generator and Probe

    26844 - C2G, Lastar, Inc.

    A highly practical network installation and troubleshooting tool which features a single or multi-tone signal, two test leads and a 4-conductor modular cable. The tone generator's signal is easily traced by the probe, even when cables are in a bundle or hidden in a mess of punchdown blocks or wall plates. This system verifies cable continuity, identifies wiring faults, determines line polarity and voltage in network (Cat5 and coax) and modular telephone lines without damaging cable insulation.

  • Signal / Tone Generator

    SG-1 - Component Engineering, Inc.

    The SG-1 is a plug-in circuit card directly interchangeable with Dolby Laboratories' Cat. No. 85 series. From the initial digitally generated white noise, pink noise is produced by a 7-pole filter; red noise is produced with a single pole filter. The adjustable output level meets Dolby's level criteria, and we've included the level-switching circuit necessary for use in the CP-200.