Test Software
programs, procedures or rules and associated documentation pertaining to the operation of a computerized test set.
See Also: Test Software Development, Software Testing
-
product
Line Input Test
Measure the dB level and frequency of the iAudioInterface2 line input or line output (also works with any dock input audio source).
-
product
10 dB V-Band Waveguide Directional Coupler for Test Labs
SWD-5038531040H-15-SB
ModelSWD-5038531040H-15-SB is a V band, three-port waveguide directional coupler that delivers a 10 dB nominal coupling level and 30dB minimum directivity across the full waveguide band from 50to 85GHz. The three-port coupler uses a traditional multi-holeand split block design to achieve a flat coupling level, high directivity, and low insertion loss. The interfaces of the coupler are WR-15waveguides with UG-385/Uflanges. Custom coupling levels are available under different model numbers.
-
product
Universal Function Test System
UFTS-CM_20Ch/ 20Ch
All of the lithium batteries need protection circuit module to prevent any loss of battery function capacity and explosion during over charge , over current or short to cause increased temperatures. This equipment is used to test and inspect a battery's voltage, current, charge, discharge PCM status, IR, and others.
-
product
Automatic Coil Test System
LM Series
Koyo Electronics Industries co., ltd
Models in LM-2100 series equipped with LCR meter are designed to measure inductance and dissipation factor of the coil to which DC current is superimposed. Special circuit is built in to protect the LCR meter from surge voltage. Applied current can be step by step in the remote mode. Voltage application is impossible with the safety cover open.
-
product
Test & Simulation Interface for PCI
PCI-C1760
Avionics Interface Technologies
HS1760/MIL-STD-1760E Test & Simulation Interface for PCI
-
product
Battery Tester - Rapid Test
FY-64
Provide a rapid test of the battery condition. 10-second test will indicate the battery's state. Further testing will show if the faulty condition is dueto a defective or discharged battery. Also be used to check the charging system,etc
-
product
Software
Srive-Level Capacitance Profiling (DLCP) Measurement
Materials Development Corporation
Drive-levelcapacitance profiling is an extremely useful technique to characterize amorphoussilicon or other semiconductor material with large concentrations of deep band gap states.
-
product
Analysis Software for FCS and cross-FCS
Burst-Analyzer
*FCS Fit with User-Defined Model Functions*Identification of Single-Molecule Photon Bursts in Parameter-Tag Data*Analysis of Fluorescence Intensity and Lifetime within Photon Bursts*One- and Two-Dimensional Histograms of Burst Parameters*Filtered Histograms of Burst Parameters*Discrimination of Different Fluorescent Species or FRET States*Determination of FRET Efficiencies*Exclusion of Artifacts in Intensity Traces
-
product
EMC Test & Measurement Solutions
MVG provides anechoic chambers and absorbing materials for antenna and EMC measurement and testing as well as RF and EMP shielding. Our SmartShieldTM modular shielding and precision cut and coated absorbers are designed with the flexibility to meet specific customer requirements. Our knowledge gained from over 30 years of experience ensures the high quality and durability of our products and the expertise from our team.
-
product
Ground Continuity Test Instrument
MODEL M25
Performs ground continuity tests in full compliance with BSI, VDE and IEC. Measures AC resistance from Chassis of Device Under Test (DUT) to power-cord ground lead - 0 to 0.15 ohm
-
product
High Flexibility Test Controller Card
TCC 1800-UE
The TCC1800-UE Test Controller Card is a generic control board for production testing of printed circuit boards (PCBs). The board is controlled by a command language on a PC to which it is connected via Ethernet.The TCC1800-UE is designed to work with positive voltages up to 24V. The card provides extensive IO: Analog and digital interfacing, counters, PWM outputs, bidirectional I/O, ethernet-, CAN, USB, SPI and I2C interfacing.
-
product
Multi-Layer Network Test Platform
From fiber installation to service deployment, these platforms are designed to maximize network performance and accelerate the deployment of new services. Critical network parameters and performance can be monitored and network impairments quickly identified to accelerate the deployment of new services. A modular design with different size bay adapters allows you to customize your test set as needed adding further value.
-
-
product
6 MHz Level Test Set ET 92
ET 92
100 Hz to 6 MHz selective/wideband Level Meter & Generator, with Spectrum Analyser
-
product
Test Instrument for LAN Cabling Verification
MI 2016 Multi LAN 350
High performance, multifunction test instrument for LAN cabling verification.
-
product
PCI Express® 2.0 Protocol Test
The E2960B family is one of the best tools in the industry for PCI Express® 2.0 testing and debug. That’s not just from us, in fact the E2960B series wins the 2007 Best in Test Award – Honorable Mention.
-
product
Battery Discharge Test Unit
125V DC 100A
KV Hipot Power Test Equipment Co.,Ltd
Battery Discharge Capacity Tester is used to perform discharge testing which is the verifiable method to determine actual capacity of battery systems.
-
product
EV Battery Pack Test Equipments
Guangdong Bell Experiment Equipment Co.,Ltd
All industrial battery tester from BELL lithium battery test chamber supplier meet the standards of GB31467.3, ECE-R100 and UL2580. The tests mainly simulating all the condition that driving an EV meet, including battery crush test, battery drop test, flammable test, temperature cycle test, short circuit test, thermal test, explosion test, and environmental test, etc.
-
product
Chloride Ion Test Kit for Surfaces
134S
Elcometer 134S test method: a latex sleeve is filled with a Chlor*Rid extract solution and stuck to the test surface where the solution is worked against the surface to extract the salts. The titration tube is inserted and the results can be recorded.
-
product
Software Tools for Efficient Code Development and Analysis
Specador Documentation Generator
Specador is a tool that automatically generates accurate HTML documentation from comments inserted in the source code. It works in batch mode (command line) and uses dedicated language parsers.
-
product
Software Development Kit for 2D Imaging Sonar
Sonar Software Development Kit (SDK)
Teledyne BlueView offers a software development kit (SDK) for its 2D Imaging Sonar to enable integration onto complex platforms and/or customized systems for OEMs and vehicle manufactures. The SDK enables control of the sonar, and provides access to the raw data files to facilitate sonar operation and data flow-through.
-
product
Arbitrary Waveform Generator Software
SourceXpress
PC-based software for arbitrary waveform generator control & emulation. From your PC, create waveforms using tools specifically targeted for your needs. From your PC, control one or many source instruments such as the AWG70000s. Control one or several AWG70000 instruments from one application. Load and play waveforms remotely. There is no new application to learn! SourceXpress™ has the same look and feel as the AWG70000 instruments.
-
product
Three-Phase Relay Test Equipment
AK-10
The new AK-10 three-phase relay test equipment from Amperis features AC and DC Voltage Source ; AC Current Source ; AC/DC Auxiliary Power Source ; 8 possible configurations.
-
product
Probe Needles for Wafer Sort and Test Applications
Advanced Probing Systems, Inc.
APS is the global leader in the manufacture of probe needles used in cantilevered probe cards. All probe needles used in wafer sort are manufactured according to customer specifications using stringent in-process quality assurance procedures.
-
-
product
Test Adapter
RAMCHECK® SIMM
The RAMCHECK SIMM Adapter is another addition to the RAMCHECK memory tester. It provides a needed solution for testing older 72-pin EDO/FPM DRAM SIMM modules. An optional adapter for 30 and 72-pin SIMMs is also available
-
product
System Test Fixture
Chassis Level Test Fixture, Set Box Test Fixture, and more by IST Engineering
-
product
Non-Destructive Resonant Inspection Drop Test Fixture
RAM-DROP
The Drop Test Fixture, Model RAM-DROP, Resonant Inspection System, allows automated sorting and quality testing of small metal injection molded (MIM), powder injection molded (PIM), additively manufactured, and other small parts by using the Resonant Acoustic Method (NDT-RAM).
-
product
HV Switch Test Equipment
KV Hipot Power Test Equipment Co.,Ltd
High Voltage testing is usually performed to qualify the device to operate safely during rated electrical conditions, a way to check the effectiveness of its insulation. The objective sought during the high voltage testing will determine the type and amount of voltage applied and the acceptable current flow.
-
product
Automated Analysis Software
RevospECT Pro
RevospECT Pro is the industry’s first commercially available high-powered, adaptable and scalable automated analysis system. It provides end users the power and control to perform comprehensive automated analysis of eddy current data. RevospECT has a proven track record in the field and meets rigorous industry standards for flaw analysis from bobbin, rotating and array inspection techniques. Once configured for an inspection, RevospECT Pro will process and analyze data at an extremely fast rate ...show more
