Systems
are interconnected groups of purpose.
See Also: Equipment, Test Systems, System Integrators, System Test
-
product
GNSS Simulation Engine
Skydel
Test a wide range of applications with advanced GNSS Simulators and helpful tools that generate basic scenarios all the way to complex threat environments, leveraging the power and scalability of the Skydel Simulation Engine. Skydel powers each of Safran Federal Systems' advanced software-defined simulators including BroadSim, BroadSim Anechoic and BroadSim Wavefront.
-
product
48V / 200 Amp Load
BD12-48P
For Battery Discharge testing and Power Supply testing. This particular Load has been designed to operate with 48V and 50V, (24 or 25 cells at 2V each), battery systems and is extremely cost effective.
-
product
Photovoltaic and Electrical Installation Testers
Photovoltaic electrical installation safety testing is a special area of electrical installation safety testing as it also entails tests and measurements on DC systems, which are relatively uncommon in most domestic, commercial and to a certain extent industrial environments. There is also the addition of photovoltaic-specific tests that are outside the realm of standard test and measurement procedures.
-
product
DAS
The Distributed Antenna Systems (DAS) function is to enhance the performance of a wireless network coverage of a specific area. DAS is a network of antennas which are all connected to the same source. The DAS solution is more efficient than having a large single antenna to cover an area and that’s why it is highly suited for in-buildings service and a restricted outdoor area. Amphenol Procom offers a wide range of both indoor antennas and passive devices, especially for Public Safety applications.
-
product
RX Family of 32-bit High Power Efficiency MCUs
RX100
The RX100 Series is the RX Family's entry-level 32-bit MCUs with excellent cost performance and ultra-low power consumption. It delivers a max. of 32MHz CPU operation with 8 to 512KB of embedded flash memory. In addition it features cutting-edge peripherals like capacitive touch and LCD drive as well as USB. The RX100 Series can be used for system control or user interface applications systems such as healthcare devices, home appliances, office equipment, and measuring equipment.
-
product
In System Programmers
In-circuit serial programming, also known as in-system programming (ISP) or in-circuit programming (ICP) enables programming and reprogramming of microcontrollers, serial EEPROMs and flash memories already soldered on a target PCB.
-
product
Mixers and Playback Devices
Monacor International GmbH & Co. KG
If several participants are discussing at conferences or different audio sources are to be combined in your ELA system, mixing consoles are required. MONACOR offers you reliable devices for mixing audio from microphones or other sources perfectly. To expand your PA system, we offer you suitable playback devices for media such as MP3, audio CDs or Bluetooth audio.
-
product
Imaging Goniometers
Radiant Vision Systems fully-automated goniometric systems are combined with a ProMetric® Imaging Colorimeter or Photometer and specialized software to capture a precise, comprehensive model of a light source’s near-field output.
-
product
I-Pi SMARC Development Kit based on NXP® i.MX 8M Plus Quad Arm® Cortex-A53 Processor
I-Pi SMARC IMX8M Plus
The I-Pi SMARC IMX8M Plus is a SMARC-based smart solution development kit powered by NXP i.MX8M Plus (Quad-core Arm Cortex-A53) processor with a Neural Processing Unit (NPU) at up to 2.3 TOPS.This is the first SMARC R2.1 development kit focused on machine learning, vision, advanced multimedia, and industrial IoT with high reliability. As such, it supports dual image processors and two camera inputs for an effective Vision System, as well as applications beyond, including smart homes, building cities, and industry 4.0.
-
product
Primary Current Injection Testers
Primary Current Injection Tester is designed for testing protective relay and circuit breakers and also testing the turns ratio of current transformers at high variable currents. A test current is injected into the primary side of a system to determine how the system behaves at particular levels of current. This test makes it possible to determine whether the relay will trip and how long the current needs to flow before the trip is initiated.
-
product
Optical VisionInspection System
NIDEC-READ's inspection systems serve to locate open/leak circuits on printed substrates forming different conductor patterns within inner/outer layers. These vision inspection systems are also used to measure the shape of via holes and solder bumps and to find scratches and stains on them.
-
product
PXI 2A Multiplexer, 4-Bank, 8-Channel 4-Pole
40-614-008
The 40-614 High Density 2 Amp multiplexer module is available in 20 configurations. All configurations use high quality electro-mechanical signal relays allowing each channel to switch current up to 2A and voltage up to 200VDC/140VACThe module is suitable for signal routing in ATE and data acquisition systems. User connections are made via a front panel 160-pin DIN 41612 connector which is fully supported by our range of cabling and connector solutions.
-
product
Computery Control Torsion Tester
SG-L10
The machine is mainly used for torsion test of metal and nonmetal,also it is applicable to the torsion test of parts and members. Servo-motor and cycloid gear reducer are introduced to the loading system in this product, the system for measuring torque and distortion angle are composed of high accurate torsion sensor, photoelectric encoder and computer measuring force.It possesses automatically tracking test torque and distortion angle, maintaining maximum peak load and displaying loading speed....show more -
product
3 Function Slot MOSA Nano Data Concentrator Unit (DCU)
NIU3A-DCU-01
NIU3A-RDC-01 is a Modular Open Systems Approach (MOSA) Data Concentrator with low power high performance ARM Cortex -A53 processing. 8 GB RAM, 32 GB SATA Flash, 2 x 10/100/1000Base-T Ethernet.
-
product
Module Breakage Tester
King Design Industrial Co., Ltd.
1. Destruction System Hardware: *est rack system: support, shielding cover, crane & fixed wall. *Hit bag: FRP bag; 45kg of No.7.5 lead pills; hook, sleeve and hoisting ring. *Attachment: electronic scale, stopwatch, digital caliper
-
product
Switch Device for PCI Express
The Switch Device for PCI Express provides two PCI Express upstream ports and eight downstream ports. You can connect the downstream ports to external devices, such as a Software Defined Radio Reconfigurable Device, to create large multichannel, multiple input, multiple output (MIMO) systems. You can also connect multiple Switch Devices for PCIe to a single PXI Express chassis to create large MIMO systems with a Software Defined Radio Reconfigurable Device.
-
product
Power Analyzers & Wattmeters
Measurements International Ltd.
Direct Replacement for 2010A Wattmeter in the AccuLoss® Loss Measurement Systems, Basic Power Accuracy < 0.005 %, 10 Current Ranges, 2 Voltage Ranges, Line-and-Line and Line-to-Ground Voltage Measurements, Full Power Factor Range, Complete Waveform Analysis, Total Harmonic Distortion Analysis, Phasor Analytical Representation.
-
product
PXI 36 Channel Data Comms MUX, 96-pin SCSI
40-735-912
The 40-735 data communications multiplexer is designed for switching the data lines of serial interfaces (RS232, USB). Careful attention to the design of the module ensures that the switching system minimizes its impact on the transmission distance of USB1.1 interfaces. The MUX is available in 36:1 or 18:1 formats and enables a single source of serial data to be switched to one of 36 or 18 devices under test. This allows the data source to load information to, or receive information from, the...show more -
product
USB Cable
784387-02
USB Cable - The USB Cable works with SuperSpeed or Hi-Speed USB hosts and devices but is backward-compatible with USB 1.1 hosts and devices. You can use this cable for vision acquisition hardware, CompactDAQ or CompactRIO systems, or any device that supports USB Cables.
-
product
Bus Digital-Synchro-Resolver
PC104
Computer Conversions Corporation
The PC104-DS Series are Low Cost, Dual Channel, PC104 Compliant Digital / Synchro / Resolver Output Cards designed to simulate precision AC Synchro and resolver formatted signals for use in navigation and positioning systems or test sets on both industrial and COTS - military type applications.
-
product
Measurement & Test
Electronic test engineers use a variety of precision instruments for R&D, vendor verification, and production testing. ETPS can supply a number of general test instruments that can be used in stand alone mode or automated for high throughput testing. Dedicated battery test systems with automatic charge and discharge modes with data logging are available. The standard 16 and 32 channel systems have range up to 5VDC ensuring their suitability for a wide variety of cells.
-
product
V-FullWaver
The V-FullWaver systems were specifically developed for precise full waveform time domain Induced Polarisation, Resistivity and SP measurements. Each system is fully independent; incorporating its own power source, GPS module and digital memory for up to 3 months continuous recording. The V-FullWaver is a dual channel Induced Polarisation, Resistivity and SP receiver. Continually recording at 10ms sample rate provides a full waveform record. It can be synchronized on the GPS PPS signal, allowing an easy process of the signal. Data on the memory can be downloaded directly on a simple USB stick from all the Fullwavers.
-
product
Torque Station Pro
TS-8700
TS-8700 Torque Station Pro is torque measurement system for motor basic property with high precision and high response.In combination with the motor torque detector MT series with the TH series torque detector, it is possible to perform high-precision, high-response motor torque measurement with up to 5.12 kHz sampling and ± 0.1 % of accuracy.In addition, the high rigidity compact torque detector RH series (10 N･m/ 20 N･m) can be mounted on the MT series. It has achieved more highly accurate measurement with ±0.05 %/F.S.This system is ideal for measuring torque fluctuations of motors on-board such as EPS motors.
-
product
High Temperature Test System
129620A
Solartron Analytical, specialists in the design of precision impedance test equipment, has joined forces with high temperature Furnace specialists Carbolite, and sample holder specialists NorECS to produce a range of advanced high temperature materials characterization test systems.
-
product
Turbine Logging System
This Turbine Overspeed Trip Logging system has been developed to check the operation of steam turbines. The speed of the turbine is monitored using an optical sensor, the logging system can be mounted up to 30 meters from the sensor. This allows the overspeed trip speed to be monitored and recorded with greater safety that using a simple tachometer. The results are logged together with time and date stamp so that it can be demonstrated that the test has been carried out.
-
product
DC Filament Switching and Line Relays
*Heavy duty Elkonite contact tips*AC and DC versions available*AC versions available with or without internal rectifier PCB*Automated vision system and operator inspection*Comprehensive automated end of line testing*Test Certificates supplied with each relay*Certificate of Conformity supplied with each order*Recertification and repair services available
-
product
CEAST VisualMELT Software
VisualMELT Software is designed to control all the functions of the Modular Melt Flow Systems, from single-weight to multiple-weight tests. The software enables the user to manage all optional equipment, including the load cell, the automatic cutting device, and the motorized weight lifter. When working with a multi-weight tester, it is possible to set up and control single-weight or multi-weight tests, as well as define the order and number of weights to be applied.
-
product
802.11be Test System
IQxel-MX
Next generation wireless devices Access Points, CPEs and client devices like smartphones or tablets based on the IEEE 802.11be EHT (Extremely High Throughput) standard require stringent RF performance to meet the latest standard requirements.
-
product
Ultrafast Laser Pulse Measurement System
FROG Scan Ultra
With a slightly larger format than our high value FROG Scan system, our FROG Scan Ultra platform allows any Ocean Optics spectrometer to be used (including the QE65000 and InGaAs models). This means higher resolution and the availability of InGaAs detectors for your ultrafast laser system. It can measure pulses from nearly 4 ms (custom systems only) to as short as 450 nm.
-
product
photonCLASSIC
The tried-and-tested Photonfocus 2D camera systems from the photonCLASSIC platform are the ideal solution for classic tasks in 2D industrial machine vision. The high-performance and versatile industrial scanning cameras combine the highest image quality with outstanding reliability and durability, while their high flexibility means they can also be integrated into complex automation environments.
