Showing recent results 856 - 870 of 1974 products found.
-
VUVAS-10X - McPherson, Inc.
A new ultraviolet spectrophotometer system for optical metrology just arrived at NASA Goddard! The VUVAS-10X spectrophotometer works best in the 90 to 160 nanometer wavelength range, also known as deep or vacuum ultraviolet (VUV) region. It uses a windowless hydrogen plasma light source and differential pump section to reach many wavelengths beyond those of conventional deuterium lamps. The source also works with other gases, or gas mixtures, for atomic spectral line emission from about 30 nanometers (double ionized Helium gas) up to the Visible light range. The new spectrophotometer system, McPherson VUVAS-10X, uses a one-meter focal length high-resolution monochromator with the special light source, scintillated detector and Model 121 goniometric sample chamber. The system is ideal for optical transmission, absorbance and specular reflectance at incident angles up to 60 degrees. This McPherson spectrophotometer system will help develop, inspect and qualify optical materials and coatings used for very high altitude and extraterrestrial space flight missions.
-
Inframet
Solar blind UV cameras are imaging devices optimized to detect ultraviolet light of wavelengths below about 280nm. Such cameras are insensitive against sunlight due to negligible sensitivity to visible and long wavelength UV light. Solar blind UV cameras are used in a series of applications like corona detection, fire detection, combustion analysis, plasma research, testing UV lamps, etc. However, highly sensitive corona detection is the main mass application and these devices are of crucial importance in electric power industry. These imaging devices enable easy detection of degraded insulators of high voltage transmission lines, distributions and substations. They can see the emission of UV light when discharges occur at defect insulators. From design point of view solar blind UV cameras are actually bispectral imaging systems built by combining true UV camera with typical visible camera. These bispectral imaging system generate output image as overlay of typical visible image with UV image of analyzed UV source.
-
24550 - Lisle Corp.
Safe for automotive computers. Won’t damage sensitive electronic components. Draws less than 21 mA. at 12 volts DC. Operating range 3-28 volts. The red light indicates positive polarity, green indicates negative polarity.
-
Renesas Electronics Corp.
DC input/Darlington transistor output photocouplers (optocouplers) are optically coupled isolators containing a GaAs infrared light emitting diode and an NPN silicon Darlington connected phototransistor. This type can operate on a low-current DC input because of its Darlington configuration.
-
SwitchPilot - Electronic Solutions ULM GmbH & Co. KG
The ESU SwitchPilot Decoder is especially optimised for the stationary use on your layout. Regardless of what you prefer, the usual twin coil magnetic switches, switching electrical light signals or an ultra-modern servo control: One of the SwichtPilot decoders will "fit".
-
Sparklike Handheld™ - Sparklike Oy
Sparklike Handheld™ is practical and quick method to test IG gas concentration. Technology is based on plasma emission spectroscopy. A high voltage spark is launched in the IG unit's cavity causing a light emission which is observed and analyzed further.
-
GAO Tek Inc.
Years ago, testing fiber optic connections required a fiber optic power meter and fiber optic light source. These two pieces of equipment were carried side-by-side and used together to verify a fiber optic connection was working.
-
FOD1204H - Fiber Optic Devices Ltd.
The FOD 1204 & FOD 1204H Fiber Optic Power Meters are intended for accurate measurements of up-to-date optical communication. Very small temperature and temporal variations of Loss in Fibers and Connectors. Calibration of Optical Attenuators, Light Sources etc.
-
FOD 1204 - Fiber Optic Devices Ltd.
The FOD 1204 & FOD 1204H Fiber Optic Power Meters are intended for accurate measurements of up-to-date optical communication. Very small temperature and temporal variations of Loss in Fibers and Connectors. Calibration of Optical Attenuators, Light Sources etc.
-
STM Sensors, Inc.
Optical fork sensors are all arrangements in which the electronic and optical components are mounted and precisely aligned in a fork-shaped metal housing. From standard through beam forks with visible red light, infrared or laser up to label detection sensors.
-
Renesas Electronics Corp.
Are solid state relays containing GaAs LEDs on the light emitting side (inputside) and MOS FETs on the output side. They are suitable for analog signal control because of their low offset and high linearity. The PS7360L-1A has a surface mount type lead.
-
290 HD - Standard Electric Works Co., Ltd
● Telescopic, compact, lightweight.● High voltage detection.● Self test button feature.● Easy to recognize indication.● High intensity red light emitting diode and intermittent audible sound for easy recognition in full sunlight and noisy environments.● Waterproof.
-
230 HD - Standard Electric Works Co., Ltd
● Telescopic, compact, lightweight.● High voltage detection.● Self test button feature.● Easy to recognize indication.● High intensity red light emitting diode and intermittent audible sound for easy recognition in full sunlight and noisy environments.● Waterproof.
-
D3S - Kromek Group plc
The D3S ID wearable RIID gamma neutron detector identifies radioisotopes and detects neutrons in seconds but unlike a conventional RIID, it is small and light enough to be wearable and concealable. All a suspect will see is someone looking at their mobile phone or listening to an earbud.
-
ALS Co., Ltd
This quite unique material transmits only visible light whereas it does not transmit UV radiation. Our ITO electrodes consist of 100 nm thick of ITO layer deposited on quartz or borosilicate glass substrate (0.5 mm thick).