-
product
Handheld Water Quality Meters
LAQUA PH210
- Automatic pH calibration - up to 5 points (NIST, USA pH buffers) / up to 6 points (DIN pH buffers) - 0.01 pH resolution- Offset and average slope display - Automatic / manual temperature compensation and temperature calibration function- ORP calibration option- °C & °F temperature readings- Auto log data; built-in memory can store up to 500 data- Auto shut-off (programmable: up to 30 minutes)- Auto stable, auto hold, and real time measurement modes- Calibration alarm (programmable: up to ...show more -
product
180V-260V AC Socket Tester (For UK)
1941
Peaceful Thriving Enterprise Co Ltd
*With UKCA Approval.*LED indicators & Digital display.*Test for 180-260VAC circuit.I*t can perform self test after plug-in ( Voltage sould be above 180V ).*Detect faulty wiring status in 3 wire receptacle.*This socket tester will give LED indication as well if the main voltage is below 200V or above 260V.*Earth loop impedance test.*Power Plug type: UK 13A socket-outlet*Measurement Category: CAT II / 4W*Frequency: 50Hz
-
product
FiberPal FTTH iOTDR
OT-9000
OT-9000 iOTDR series, with power meter built-in, is designed with ultra portable, light, reliable and easy to use as Fiber Quick test and Troubleshooter to locating fiber connector, break and imperfections for PON DSN, FTTX, CATV and optical LANs. FiberPal OT-9000 iOTDR series detects event locations along the optical fiber and displays the results on a portable device like notebook, Tablet PC and Mobiles phones with Android 4.x or Windows XP/ Windows 7 operation system.
-
product
ARINC-708/453 2-Channel Test & Simulation Module for the Weather Radar Display Databus
M8K708
The M8K708 module is an ARINC-708 / 453 2-channel test and simulation module for the Weather Radar Display Databus. The M8K708 supports two ARINC-708 / 453 channels, each selectable as transmit or receive. Each channel implements an 64K×16 FIFO and supports polling and/or interrupt driven operation.The M8K708 comes complete with Windows software, a C-driver software library including source code and may be used with Exalt, Excalibur’s Analysis and Laboratory Tools, a Windows monitoring application. In addition, Excalibur produces adapter cables that convert the carrier board I/O Molex™ connector to two twinax CJ70-49 connectors. The cable may be purchased at an additional cost.
-
product
Product Co. Computer Vision For Elevator Displays
The elevator industry needed a modern solution, as elevator riders do not lose their sense of time and place while they areon their way up and down. The system screens pull interactive and panoramic views of the city that open as the elevator climbs higher.
-
product
Hardness Testers
* Compact plastic case, suitable for use under poor working conditions. Test at any angle, even upside down.* Wide measuring range. It can measure the hardness of all metallic materials. Direct display of hardness scales HRB, HRC, HV, HB, HS, HL* Large screen (segment LCD), showing all functions and parameters. With EL background light.* Large capacity memory could store 100 groups information.* Datapro Software to connect with PC via RS232 port. Micro printer support* Software calibration function.
-
product
PRo-Level TRMS Digital Multimeter w/Bargraph
HH2205B
High Accuracy (Basic Accuracy 0.5%). 3-3/4 Jumbo LCD display 3260 count with symbolic signs and bargraph. Double Injection Casing. Auto Ranging High Voltage test up to 1000V DC and 750V TRMS AC. Higher Current test up to 20A AC/DC
-
product
WaveRunner Oscilloscope, 2.5 GHz Bandwidth, 4 Input Channels, 40 GS/s on 2 Ch Sample Rate
WaveRunner 9254M
2.5 GHz, 40 GS/s, 4ch, 64 Mpts/Ch DSO with 15.4" Capacitive Display.
-
product
Bore Gauge
BG10
Aeronautical & General Instruments Ltd.
The BG10 Gun Barrel Bore Gauge System is an electro-mechanical measuring device that was originally introduced into service by the RAF for the high-speed measurement of aircraft cannons, to ensure minimum operational aircraft turnaround time. Measurements are taken at 16 pre-determined positions along each bore, which are then compared to pre-stored warning and rejection criteria. The actual measurements taken are displayed to the Operator on an LCD display and the measurements stored for future...show more -
product
Battery Analyzer
KT-97C
● Battery ImpedanceRange: 60mΩ / 600mΩ / 6 Ω / 60Ω (auto-range)Accuracy: ±1.0% of reading ±3digits Resolution: 0.01mΩ● DCV Range: 6V / 60V (auto-range) Accuracy: ±0.8% of reading ±3digits Resolution: 0.001V●StorageCan storage 50 groups data (impedance and voltage) and veryconvenient for you to number the batteries for detection.●Connect to PC RS-232 interface ● Display impedance and voltage of battery together. ●Supplied with lithium batteries, it is very convenient to test outdoors and indoor...show more -
product
CATIII Digital Clamp Meter
UTL261
UEi Test & Measurement Instruments
The UTL261 is a 600V AC/DC Digital Clamp Meter with AC amps, resistance, diode test and continuity. It also features a backlit LCD display, a worklight, Max capture, data hold and Auto/ Manual ranging and is backed by a 1-Year limited warranty.
-
product
PocketDetect LRM
PD-01LM
Hachmann Innovative Elektronik
With a PocketDetect LRM you have a highly specialized, miniaturized and easy-going voltage detector at your fingertips. A thorough self-test ensures reliable function. A permanently enabled interface-tester warns against defect interfaces or residual voltages, while the low-power long-term display mode secures live working. The PocketDetect can be carried along due to its diminutive dimensions and lightweight (e.g. in the optional available belt case).
-
product
Spectrophotometers
GAOTek Color Spectrophotometer with Customized Aperture – a portable and impressively precise color measurement device. This piece of equipment comes together with an extensive PC software and 3.5-inch TFT touchscreen LCD display combined with SCI and SCE supported 8mm aperture, 256 image element double arrays CMOS image sensor and D/8 geometrical optics that conform to tails such as CIE No.15, GB/T 3978 and ISO7724/1 above others makes this GAOTek Spectrophotometer perfect both for professional...show more -
product
Require External Wireless Module
Metal Detector
The most advance features of multifunction detector is wirelessly connect to Smart phone / Tablet through free APPS. Attractive digital / analogue / graphic display, view recorded data le, snap picture with data recorded, save or send le to e-mail.
-
product
Controllable, Programmable Linear DC Source
LAB / S
*Linear laboratory power supply*High quality DC sources with the lowest residual ripple*CV / CC mode with LED display*Protection against short circuit, overload and overtemperature*Optional IEEE 488, RS232, analog interfaces*3-phase input optional
-
product
Semiconductor Curve Tracer
CS-3000 Series
*Max. Peak Voltage : 3,000V（HV mode）*Max. Peak Current : 1,000A（HC mode）*Equipped all models with LEAKAGE mode (Cursor resolution 1pA）*USB port for display hardcopy, waveform data (CSV format) and measurement setup SAVE/RECALL*LAN interface for Remote Control
-
product
Fixed Toxic Gas Detector
CTX 300
Teledyne Gas & Flame Detection
When hazardous levels of toxic gases or oxygen threaten the safety of an unclassified area, the CTX 300 detector can satisfy the most demanding safety requirements.The CTX 300 detector is designed to detect oxygen, toxic and refrigerant gases, and also uses a new sensor for CO2 detection over three different ranges: 0-5000 ppm, 0-5% vol. and 0-100% vol.The CTX 300 transmits data in record time. With a wide range of sensor options, it has the flexibility to protect many potentially hazardous environments.Maintaining the unit is easy with pre-calibrated sensors and an optional LCD display.
-
product
DWDM DFB Light Source (42CH)
DWOS-1000
Hangzhou Huatai Optic Tech. Co., Ltd.
Huatai DWOS-1000 seires DFB optical source is the DWDM test platform with high capability, high stability and high flexibility. It is consist of the system rack and plug-in function module. The system rack is equipped with high capability RS232 communication interface, high precision parameter display and power supply module. There are 3 types of the function module: DFB Source module, DWDM, EDFA (optional).
-
product
Bidirectional AC Source / Sink With Regenerative Power Supply
EAC-4Q-GS
*Single system from 30kVA to 500kVA and in parallel up to 2MVA and more*Galvanic isolation from the network*TFT touch display with simple menu navigation*Emergency stop in the front door*Indicator lights for operating status*Bidirectional current flow, up to 100% of the nominal output power can be fed back into the grid*Output voltage and phase angle adjustable per phase
-
product
Sound Level Meters
PeakTech Prüf- und Messtechnik GmbH
This digital sound level meter with LCD display and function symbols offers manual range selection in 2 measuring ranges. The fast / slow switching as well as the measured value and maximum value holding function and the internal circuit for checking the calibration (94 dB) emphasize the versatility of this device.
-
product
Waveform Monitors
LV5350
The LV5350 waveform monitor offers a 7-inch HD screen display in a compact 3 x ½ RU package that can operate on AC or DC. Waveform, vector and picture with 4K 12G-SDI and audio options . Easy menu operation with touch screen, mouse, and front panel button controls.
-
product
Electrical Circuit Tester with LCD Display
TE6-0717
Hangzhou Tonny Electric & Tools Co., Ltd.
*Used to detect voltage, power, ground and circuit integrity*LCD display provides a ‘no guess’ voltage value of the circuit*Backbit LED indicates Green for Ground or Red for Power*One hand free to jiggle wires, replace fuse or operate a switch*Surge protected circuitry displays 3 to 30V DC (± 0.3V accuracy)*Computer safe<10mA circuit draw for confident testing
-
product
Multimeters
Bench-top digital multimeters for professional applications. High accuracy and resolution. Dual display and dual measurement models.
-
product
Economic Type Strain Gauge/Load Cell Indicator
CS1-SG
Chuan Sheng Electronics Co., Ltd.
CS1-SG economic type strain gauge/load cell indicator is equipped with high accuracy measurement, display and communication of DC signal 0~1.0/~4.0mV or 0~10.0/~40.0mV.It supports field calibration, and It can calibrate with sensor (load cell/strain gauge) according to actual needs.It is able to select one from these three functions, 1 relay output, 1 analogue output or 1 RS-485 (Modbus RTU Mode) interface; they provides many functions such as control, alarm, re-transmission, and communication.
-
product
PD Test Systems
1. Number of channels: 2/4 electric signal interfaces & 1 EXT interface 2. Sampling frequency: maximum 200MGa/s 3. Sampling precision: 12bit 4. Range: 0.1mV~20V 5. Range switch: 1mV, 2mV, 5mV, 10mV, 20mV, 50mV, 100mV, 200mV, 500mV, 1V, 2V, 5V 6. Frequency band range: 1Hz-60MHz 7. Range non-linear error: 5% 8. Range of capacitance for test object: 6pF~250µF 9. Power source mode: internal lithium cell / AC 220V 10. Display: 6.5 inches TFT LCD 11. Resolution: 640×480 12. PV: 4GB 13. Hard disk: 32G stiff disk used for storing the test data
-
product
Pen-Type Food Thermometers
This thermometers look like an extra-large needle with a temperature gauge on the end. It delivers reliable results when you want accurate measurement readings of both internal and ambient temperatures. This electronic temperature meter can also be used in getting food temperatures. The probe can measure temperature that range from -50°C~ 300°C (-58 ~ 572°F). The easy-to-read digital readouts has a large screen that quickly displays temperatures in either Fahrenheit (°F) or Celsius (°C) with just one press
-
product
Bench Type LCR Meter
LCR-900
*Dual LCD Display. *Capacitance, Resistance, Impedance, Inductance, Quality Factor, *Dissipation Factor Phase Angle. *Auto Detect Function. *Open Circuit/Short Circuit Compassion. *Operation Frequency 100Hz to 100KHz. *Basic Accuracy: 0.3% *Measurement Voltage Fixed at 0.6Vrms.
-
product
Display Unit For The Bluetooth Connecting Instrument
MDU-200X
MULTI MEASURING INSTRUMENTS Co., Ltd.
・Can be connected to HCL-36UX/HCL-7000X/ALCL-80X (As of Aug 2, 2022)・Data hold function available・Record function available・Recorded values can be saved in 4 spaces for Three phase 4 line measurement・The measured value can be displayed remotely and separately from the display of the measuring instrument・Easy to read large display
-
product
Air-Littoral Weather Radar Processor System
This system example will provide a Moving Target Indicator (MTI) / Moving Target Detector (MTD) processing capability, and will use existing COTS RF receiver and processing systems hardware. An optional upgrade will incorporate weather radar processing and displays.
-
product
Software for Configuration, Logging and Analysis
LMG-CONTROL
ZES ZIMMER Electronic Systems GmbH
Real-time display of configuration and measuring valuesTransfer of up to 3000 measuring values per secondTimestamps with a resolution of 1 millisecondVersatile analysis of sampling valuesExport of measuring values to other applications
