Showing results: 2761 - 2775 of 5224 items found.
-
40-960-050-M-HV -
Pickering Interfaces Ltd.
This connector is designed to allow users to directly terminate cables with soldered connections.
-
40-960-026-F -
Pickering Interfaces Ltd.
This connector is designed to allow users to directly terminate cables with soldered connections.
-
40-960-009-M -
Pickering Interfaces Ltd.
This connector is designed to allow users to directly terminate cables with soldered connections.
-
40-960-015-F -
Pickering Interfaces Ltd.
This connector is designed to allow users to directly terminate cables with soldered connections.
-
AC136 -
Semapi Corp
Low Frequency Accelerometer, Side Exit Connector / Cable, 500 mV/g
-
AFL
Diverse line of fiber optic cables for structured cabling and enterprise applications.
-
AFL
Smaller diameter cables with higher fiber counts for scalable, flexible networks.
-
DSR-50K & DSR-100K -
Standard Electric Works Co., Ltd
● For discharging and earthing for cables ● For discharging and earthing of test units● For safety purpose
-
M-200 -
MULTI MEASURING INSTRUMENTS Co., Ltd.
*The unique U type CT enabled to measure the load current of single or three phase cable without separating the cable to the wires.*33mmφCT window and ultra compact size.*Data-hold function. Especially useful when working in dark or hard to get areas.
-
Scope T&M Pvt, Ltd.
The CFL SIMF, Cable Fault Secondary Impulse Filter from SCOPE is the ultimate solution for locating underground cable faults in minimum time. It uses advanced technology for fault distance measurement which helps even an unskilled operator to locate the fault accurately.
-
CFL PL3 -
Scope T&M Pvt, Ltd.
CFL PL3, new generation Cable Fault Pre-Locator from SCOPE is the ultimate solution for locating underground cable faults in minimum time. It uses advanced technology for fault distance measurement which helps even an unskilled operator to locate the fault with accuracy.
-
1668A -
Peaceful Thriving Enterprise Co Ltd
Check on 6 and 12V systems. To indicate whether there is an electrical potential at any low voltage point in the system. By using the pointed contact tip to pierce insulation on cables, it will also indicate if current is present. This can be helpful when tracing faults or add cable to a circuit.
-
1668 -
Peaceful Thriving Enterprise Co Ltd
Check on 6 and 12V systems. To indicate whether there is an electrical potential at any low voltage point in the system. By using the pointed contact tip to pierce insulation on cables, it will also indicate if current is present. This can be helpful when tracing faults or add cable to a circuit.
-
Elcometer Limited
Supplied with either standard cables or armoured metal reinforced heavy duty cables, Elcometer convex surface profile probes are supplied with a glass zero tile, calibration test foils (nominal values 125μm (5.0mils) & 508μm (20mils)) and an Elcometer test certificate.
-
Meter MEGA-CHECK -Basic -
List Magnetik GmbH
The new generation of MEGA-CHECK devices first used probes in which an own microcontroller, the analog sensor signals are digitized to the device outputs. This new technique is extremely trouble-free and even allows accurate and repeatable readings. The probe cable is both sides (control unit and probe) and therefore particularly service-friendly, as if a cable breaks, the device must not be returned, but only the cable is replaced. The units are equipped with a large, clear and illuminated graphic display. A variety of Fe, ferrous and dual