-
Product
Engine Sensor Simulation Card
CP-ENG-SIM
-
The CP-ENG-SIM Engine Sensor Simulation PCIe Card is an FPGA-based I/O solution designed for real-time simulation of engine and vehicle sensor signals. Built for Hardware-in-the-Loop (HIL) environments, the card enables accurate emulation of crank, cam, ignition, fuel injection, and other sensor signals used in engine control systems.
-
Product
Temperature Sensors
-
It is used by many factory because of its simple and convenient temperature measurement.
-
Product
Soil Moisture, Temperature, and EC Sensors
-
Soil volumetric water content probes (sometimes referred to as soil moisture sensors) measure the water content of soil. These probes can be used to estimate the amount of stored water in a profile or how much irrigation is required to reach a desired amount of water in the soil. These probes can be used for quick measurements or installed for long-term measurements.
-
Product
AMR Switch Sensors
-
MultiDimension Technology Co.,Ltd.
A 360-degree digital omnipolar magnetic switch that integrates anisotropic magnetoresistance (AMR) and CMOS technology in order to provide a magnetically triggered digital switch with high sensitivity, high accuracy, and low power consumption.
-
Product
Carbon Dioxide Sensor, CO2
ENVIROMUX-CO2
-
CO2 room sensor for periodically unoccupied areas. Measures CO2 in a range of 0 to 2,000 ppm. 0 to 5 VDC output. Continuous automatic air pressure compensation. LED indicators for operation status and system test. Maximum cable length: 1000 ft (305m). Powered by ENVIROMUX-2D/5D/16D. Regulatory approvals: RoHS.
-
Product
Sensor Products: Weld Force Gage
90061
-
Model 90061 is a self-contained, portable measurement system which allows auditing of the pinch force generated between the electrodes of resistance spot welders. Resistance welding uses a pair of electrodes to clamp two base metals firmly together prior to and during application of electrical current. Poorly clamped parts result in a defective joint. A correctly clamped assembly aids in reducing the resistance in the joint and allows the current flow to properly heat the base metals to weld the part.
-
Product
Gas Flow Sensors
ESRF-HF Transmitter
-
The ESRF-HF is a family of mass flow transmitters which enable fast and accurate measurements of gas flow over a wide dynamic range. Each transmitter integrates a MEMS flow sensor and readout electronics inside a housing with very small form factor made from stainless steel. The duty pressure of the flow transmitter is 11bar. All measurement data are fully calibrated, and temperature compensated on board, leading to a reduced temperature coefficient and high measurement accuracy.
-
Product
Fiber Optic Sensors
-
Fiber optic sensors are a special type of sensor that uses fiber optic light guides to deliver the light to the sensing position. They work well for applications involving small targets, unfavorable conditions and tight areas. Glass fibers can be used in harsh environments without damage and are more rugged than plastic fiber optics. Plastic fiber optics are more flexible and cost-effective and can be cut to length. When applied correctly, fiber optic sensors solve many applications general purpose sensors can't solve.
-
Product
High Pressure up to 1000 Bar Peak Pressure Inductive Sensors
-
Contrinex High Pressure up to 1000 Bar Peak Pressure Inductive Sensors
-
Product
Clamp type DC/AC Current Sensor／with Voltage Output
LAD-240
-
MULTI MEASURING INSTRUMENTS Co., Ltd.
*Compact size*With DC voltage output*DC 1A～200A
-
Product
Small Diameter Tubes Optical Bubble Sensor
BE-A
-
Panasonic Industrial Devices Sales Company of America
*One-touch Attachment*For Small Diameter Tubes*High Speed Response Time*Ultra Compact*For A Wide Range Of Power Supply Voltages*Built-In Amplifier*Allows For Close Proximity Attachment*CE Approved*CE: EMC Directive
-
Product
LoRaWAN LCD Dual Temperature Probe Sensor
LEO-S552-TP
-
Food level PT100 temperature probes sensor, IP65 waterproof enclosure with dust plug, suitable for harsh environment. Built-in 4000 mAh replaceable battery and long battery life, Integrated and compact design for wireless deployment.
-
Product
Force Sensors
-
General purpose force sensors are offered in either stud or axial mounted configurations. They are internally pre-loaded and can be used for dynamic compression, tension, and impact force measurements. Tapped mounting holes on both ends of the radial connector style support link, platform, integrated link, and free-standing installations. The axial mounted type offers protection of the electrical connector and sensor cable from potential damage during drop testing and in free-standing installations. Supplied impact caps facilitate impact and drop force measurements.
-
Product
Digital Linear Gauge Baby Sensor
BS-1210/1310
-
Industrial products are being made smaller and smaller these days. The BS-1210/1310 linear gauge baby sensor is the best solution for measurement of such a small product. With the compact body, many sensors can be installed closely together even in a limited space.
-
Product
0.50° Accuracy Full Attitude Surface Dynamic Motion Sensor
DMS-550
-
The DMS range of motion sensors is designed specifically for the motion measurement needs of the marine industry. Whether it is achieving IHO standard survey from any size of vessel, or providing safety critical monitoring of offshore platforms, large vessels, helicopter landing decks, cranes and positioning systems, the DMS provides accurate motion measurement in all sea conditions. Incorporating an enhanced external velocity and heading aiding algorithm for improved accuracy during dynamic manoeuvres, the solid state angular rate sensors offer reliability in the highest performing vertical reference units ever produced by TSS.
-
Product
SparkFun Current Sensor Breakout
ACS723
-
The SparkFun Current Sensor Breakout is a high accuracy board that utilizes the ACS723 for moderate AC and DC current sensing applications. The ACS723 sensor uses a Hall effect sensor to output a voltage relative to the current flowing through the IP+ and IP- pins on the board. The advantage of using a Hall effect sensor, specifically, is that the circuit being sensed and the circuit reading the sensor are electrically isolated meaning that, although your Arduino is running on 5V, the sensed circuit can be operating at higher DC or AC voltages!
-
Product
Adjustable Liquid Metering Valve
ASYMTEK DV-07
-
The DV-07 dispenses low to medium viscosity fluids for a variety of applications from microdots to volume fill. The DV-07 valve tolerates aggressive fluid formulations including acid-based fluids, reactive adhesives such as cyanoacrylates, solvents, and fluxes.
-
Product
CMOS Imaging Sensors
-
CMOS imaging sensors from ams feature global and rolling shutter capability, low noise, high dynamic range and high frame rates.
-
Product
Wide Angle PIR Sensor With LED Signal
28032
-
Similar in functionality to our original PIR Sensor with LED Signal (#555-28027), the Wide Angle PIR Sensor features a larger detection angle of 180˚. This makes it ideal in applications where users need to track movements across a large, open area.
-
Product
Barometric Pressure Sensors
-
Accurate within 1.5 % across a pressure range of 15 to 115 kPa (4.43 to 34.96 in Hg). Long-term non-stability has been measured continuously indoors and in natural conditions (with sensors mounted inside a datalogger enclosure) for multiple sensors and is less than 0.5 % per year. Temperature effects on signal are less than 1 % across a wide temperature range (-20 to 50 C).
-
Product
Magnetic Float Type Liquid Level Gauge
HR9210
-
HighReach Measuring & Controlling System Co.,Ltd
The HR9210 magnetic float type liquid level gauge is a measuring instrument that reflects the measured liquid level or interface by the magnetic float as the sensing element and through the coupling of the magnetic float and the magnetic body in the display color strip.
-
Product
Inductive Sensor
Ampstik®
-
The Ampstik is easy to use and provides accurate information to anyone working with medium and high voltage. It gives line personnel the right answers so they have the ability to make decisions in the field.
-
Product
Rotary Position Sensors
-
We offer a full range of Rotary Position Sensors, in a variety of housings, utilising wirewound, cermet and conductive plastic technology.
-
Product
Contact Ultrasound Sensors
-
Inspect bearings, steam traps and perform other mechanical inspections with our Needle or Threaded contact sensors.
-
Product
Turbidity Logger Sensor
NUL-231
-
This sensor measures the reflected light that enters into a tube containing a solution. As solution turbidity is higher, more light is reflected and measured by the light sensor, located perpendicular to the light source.
-
Product
Compressed Air RH+T+Tdp Sensor
T3111P-2
-
Relative humidity, temperature sensors at probe on the cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
Product
SparkFun Load Sensor Combinator
-
The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. If you open up an electronic bathroom scale, you’ll find a large rat's nest of wires. The Load Sensor Combinator was created to combine the 12 wires found in a bathroom scale into the standard four-wire Wheatstone bridge configuration.
-
Product
SparkFun ToF Range Finder Sensor for VL6180
VL6180
-
This is the SparkFun "Time-of-Flight" Range Finder, a sensor board for the VL6180 distance sensor. Unlike most distance sensors that rely on reflected light intensity or reflected angles to determine range, the VL6180 uses a precise clock to measure the time it takes light to bounce back from a surface. This affords the ToF Range Finder and VL6180 a great benefit over other methods because it can be much more accurate and more immune to noise. Does this technology sound familiar? Well it should, it's the same means cellphones use to detect when the caller is holding their phone to their ear.
-
Product
Hand Dynamometer Logger Sensor
NUL-237
-
This sensor comes with a hand held unit with a built in strain gauge. The sensor measures the pressing force on the hand held unit.
-
Product
Separate Amplifier Pressure Sensor
AP-40 Series
-
Separate Amplifier Pressure Sensor. The industry's smallest and lightest air pressure sensor head, weighing only 7g. The super-small sensor head can be mounted close to the detection point decreasing response time.
