Product

Measuring Microscopes, Image Processing + Drawing Die And Wire Measurement

Easy Low Cost Wire Drawing Die Measuring Microscope

-

Optik Elektronik Gerätetechnik GmbH

Easy Low Cost Wire Drawing Die Measuring Microscope - Optik Elektronik Gerätetechnik GmbH

Simple optical measuring system for diameter and ovality of wire drawing dies with image processing software.

Product

Cables, Harnesses & Wiring Looms

-

AmFax Ltd

AmFax Ltd

​Amfax manufacture a wide range of wiring harness solutions in a variety of styles and finishes. These wiring harnesses, or looms as they are often called, can be constructed using heat-shrink, conduit tube, braid, tape, tie-wraps or lacing cord.

Product

DSE Wire Testers

-

DSE Test Solutions A/S

DSE Test Solutions A/S

DSE Test Solutions your gateway to a world of wire technology.We supply high-quality test equipment for the wire and cable industry. Our extensive range of intelligent test equipment is used for quality control and production optimisation of enamelled wire and cable.

Product

Wires and Pipe Locator

LKZ-720

-

Sonel S.A.

LKZ-720 - Sonel S.A.

*Detection of wires and cables (live or not)**detection of cables in ceilings, walls and floors,**detection of breaks in cables,**tracing cables in building installation,**locating power points and switches in buildings,**locating short circuits between leads,**tracing shielded cables,**tracing cables in metal ducts.*Identification of fuses on the distribution board.*Tracing underground cables.*Tracing conductive water and heating pipelines.*Non-contact detection of live cables.

Product

Gauge Type T Thermocouple Wire

W-TW-44P

-

Physitemp Instruments

W-TW-44P - Physitemp Instruments

Most thermocouple wire used in the manufacture of sensors is "Special Limits" wire which, to meet NIST standards, must be accurate to 0.5°C in the range 0-50°C. This means that even with most sophisticated electronics, the best possible accuracy for the system is 0.5°C.

Product

Enameled Wire Portable Pinhole Tester

-

Shanghai Dean Electrical Co., Ltd

Shanghai Dean Electrical Co., Ltd

DZK high and low voltage (portable) pinhole detector is designed and produced in accordance with GB/T4074.5-2008 standard, and can be used by users to monitor the continuous performance of the paint film of the product in real time during production and use. . It takes into account the detection function of the traditional high-voltage paint film continuity tester, and the advantages of being easy to move and replace the use position (the whole machine weight is less than 5KG and can be equipped with lithium batteries), which is convenient for users to detect multiple environments and multiple cables. use.

Product

Wire Systems Analyzer

Console Test Systems (CTS)

-

Eclypse International

Console Test Systems (CTS) - Eclypse International

Wire Systems Analyzer Commercial Roll around detects and locates faults and detects degradation in electrical interconnect systems ranging from simple to complex. Used to verify the operation of relays, circuit breakers, indicators, switches, diodes, transformers, 1553 couplers, etc.

Product

Wire Crimp Pull Tester (Motorized)

WT3-201M

-

Mark-10 Corp.

WT3-201M - Mark-10 Corp.

The WT3-201M motorized wire crimp pull tester is designed to measure pull-off forces of up to 200 lbF [1 kN] for wire and tube terminations. The tester conforms to numerous UL, ISO, ASTM, SAE, MIL, and other requirements for destructive testing. Non-destructive testing is also possible, such as pulling to a load or maintaining a load for a specified period of time, as per the requirements of UL 486A/B. Programmable pass/fail limits with red and green indicators and audio alerts help identify non-conforming samples.

Product

Gauge Type T Thermocouple Wire

W-TW-24

-

Physitemp Instruments

W-TW-24 - Physitemp Instruments

Most thermocouple wire used in the manufacture of sensors is "Special Limits" wire which, to meet NIST standards, must be accurate to 0.5°C in the range 0-50°C. This means that even with most sophisticated electronics, the best possible accuracy for the system is 0.5°C.

Product

Wire Piercing Clips

619

-

Electronic Specialties Inc.

619 - Electronic Specialties Inc.

This new clip makes wire piercing much easier. Just slide the wire into the cradle and screw the pin down into the wire. This method is clean and leaves minimal wire damage. If you have to proceed to pierce the wire, do it the right way with 619.

Product

Minigrabber® Test Clip For Max. .090" Wire Dia, Do-It-Yourself

3925

-

Pomona Electronics

3925 - Pomona Electronics

Minigrabber? test clip for max. .090" wire dia, Do-It-Yourself, available in ten colors

Product

Gauge Type T Thermocouple Wire

W-TW-44

-

Physitemp Instruments

W-TW-44 - Physitemp Instruments

Most thermocouple wire used in the manufacture of sensors is "Special Limits" wire which, to meet NIST standards, must be accurate to 0.5°C in the range 0-50°C. This means that even with most sophisticated electronics, the best possible accuracy for the system is 0.5°C.

Product

Trailer Buddy 4/5 Pin One Man Trailer Wiring Tester

220

-

Electronic Specialties Inc.

220 - Electronic Specialties Inc.

*Tests 4 & 5 Pin Flat connector wiring *Each signal from vehicle emits a unique tone *Loud beep can be heard over shop noise *One person makes complete test in 30 seconds! *Just apply brakes, turn signals, running lights& engage reverse *Tester also emits unique tone for any shorts in the wiring! *Greatly reduces time spent verifying vehicle trailer wiring *Very simple & easy to use - saves time!

Product

Thermocouple & Fine Wire Welder

L60

-

Labfacility Ltd.

L60 - Labfacility Ltd.

The Thermocouple Welder, manufactured by Labfacility, is a compact, simple-to-use instrument designed for thermocouple and fine wire welding.

Product

Cellular Phone/RF Signal/ Wired Camera/Bug Detector

SH-055GRV / 01125

-

Suresafe Technology Inc.

SH-055GRV / 01125 - Suresafe Technology Inc.

This Cellular Phone Detector / RF Signal Detector / Wireless Camera Detector applies with fuzzy scanning technology to detect peeping cameras, tapping, cellular phones and other radio frequency devices

Product

- RS-232 to RS-422/RS-485 Concentrator - Wiring Hub

Model 290

-

Telebyte, Inc.

Model 290 - Telebyte, Inc.

FEATURES: Break RS-485 Limit, Expand to 496 Nodes 16 Port Capacity; Each Port Settable to RS-422 or 2 Wire RS-485; Provides Isolation Between Ports; All Ports Surge Protected; Increased System Reliability. The Model 290 RS-232 to RS-422/RS-485 Concentrator offers a unique group of features for those applications using RS-422 and/or RS-485 for communications between a multiplicity of devices.

Product

Gauge Type T Thermocouple Wire

W-TW-44TEF

-

Physitemp Instruments

W-TW-44TEF - Physitemp Instruments

Most thermocouple wire used in the manufacture of sensors is "Special Limits" wire which, to meet NIST standards, must be accurate to 0.5°C in the range 0-50°C. This means that even with most sophisticated electronics, the best possible accuracy for the system is 0.5°C.

Product

Mating Coax Connector and 20 Coax Pins Crimped (both ends) to 5' wires

GX96405-60

-

Marvin Test Solutions, Inc.

GX96405-60 - Marvin Test Solutions, Inc.

Mating coax connector and 20 coax pins crimped (both ends) to 5 ft wires

Product

4-Wire Resistance Measurement | Continuity & HiPot Cable & Wire Harness Testers

-

CAMI Research Inc.

CAMI Research Inc.

An add-on option for the CableEye HVX high voltage cable tester series that permits expanded testing for contact and wire resistance as low as 1 mΩ. After checking for opens, shorts, miswires, and resistance limits, the 4-wire Kelvin measurement applies a user-selectable test current from 10 mA to 1 A to determine connection resistance within 1 mΩ. The resistance profile of a model cable may be stored and used as a basis of comparison during later testing to reveal cold solder joints, faulty crimps, recessed pins, pin contact contamination, improper wire gauge, and stress-extruded wire.This option may be purchased with any new HVX tester, or added as an upgrade to any of your existing HVX testers.

Product

Lo-PRO®file Collet Socket with Wire Wrap Pins

Series 503

-

Aries

Series 503 - Aries

LO-PRO file Collet Sockets with Wire Wrap Pins. Features: LO-PRO file Collet Sockets are available with solder tail or wire wrap pins. Consult Data Sheet No. 12011 for solder tail pins. Choose from several sizes and plating options.