Barometric Pressure
See Also: Pitot Static Testers
-
Product
Ultra Pure Pressure Switch
W117G
-
The W117G Ultra Pure Stainless Steel Pressure Switches have all welded stainless steel interiors which are Helium leak checked to pass 4 x 10-9 Std CC/Sec. These switches are used in silicon wafer ovens, numerous medical devices and other applications where even the slightest impurities are not tolerated.
-
Product
Economical Pressure Switch
P88G
-
The P88G Economical Pressure switches are typically used in applications where reliable switch control supersedes accuracy of set point.Controlling on and off functions for fans and pumps where one may need a wide differential to prevent over-cycling is an ideal application use for the P88G.
-
Product
Compact Pressure Switches
-
These vacuum pressure switches based on Baratron® capacitance manometer technology provide relay outputs that are readily interfaced with alarms, valve actuators, computers, process controllers, load locks and other protection devices.
-
Product
Pressure Sensors
ESCP-MIS1 Sensor
-
ES Systems has developed a series of medium isolated pressure sensors suitable for applications with harsh environmental conditions where resistance to corrosive fluids or gases is required. Each sensor integrates a MEMS capacitive pressure sensor die, and a CMOS ASIC for the signal conditioning. The MEMS pressure sensor dies are underpinned by ES’s innovative microfabrication process for silicon capacitive sensors.
-
Product
Industrial Pressure Transducers
-
These industrial Baratron® capacitance manometers feature industrial enclosures and higher operating temperature ranges for industrial pressure measurement applications.
-
Product
Multifunction Unit - Up to 80 Channels of Digital I/O for Observing and/or Recording 16 to 64 Channels of Pressure of Temperature
Trig-Tek™ 260B
Multifunction I/O
Delivers up to 80 channels of digital I/O for observing and/or recording 16 to 64 channels of pressure or temperature. Consists of a motherboard that connects up to four daughterboards to the IP 1553 serial bus.
-
Product
Low Pressure Cylinder Leak Tester
CLT4PB
-
Tests leakage at 35psi compared to 100psi in current leakage tester. Lower pressure prevents smaller bore cylinders from moving as they might under 100psi. Works well on small engines found in recreational, marine and other applications.
-
Product
Intrinsically Safe Pressure Module
APMi
-
AMETEK Sensors, Test & Calibration
The APMi intrinsically safe portable pressure modules offer the functionality and flexibility to read up to four pressure inputs with a single HPC50 handheld pressure calibrator. Use the modules to either expand the range of the HPC50, view all four readings at the same time, or read two different differential pressures simultaneously. The APMi intrinsically safe pressure modules deliver the same high level accuracy whether in the lab or in the field.
-
Product
Pressure / Force Sensors
-
Panasonic Industrial Devices Sales Company of America
Panasonic offers high precision Pressure Sensors for industrial, medical, clean room and other gauge equipment uses. Some include a built-in amplifier and compensating circuit in a compact, low and high pressure Sensor with high accuracy and reliability.
-
Product
3U Centrifugal Blower for Pressurizing Consoles
CB-300A
-
3U centrifugal 300 cfm blower for pressurizing consoles, computers and electronic systems with cool, filtered air. Includes easy-to-remove, washable dust filter, 3-conductor AC cord and removable, brushed aluminum grille. Installs on 19” panel mounting rails.
-
Product
Pressure Transducers with USB Interface
P61
-
The Validyne model P61 is a digital differential pressure transmitter designed for industrial pressure measurement applications. The on-board microprocessor provides high accuracy and improved stability in changing thermal environments. Communication and power via USB interface provides remote zero and span adjustment as well as digital pressure readings in engineering units. Drivers and software for the USB interface are included.
-
Product
40N Switch Tester Coupling Implement Shell Pressure Test Device
CX-F01
-
Shenzhen Chuangxin Instruments Co., Ltd.
This device is according to the IEC60320-1 standard requirement to design. Appliance inlets designed for surface mounting and having a shroud of metal, are compressed in an appropriate test apparatus, an example of which is shown in figure 20. The spherical end of the jaws shall have a radius of 20mm±1mm. A force of 40N±2N shall be applied for 60s±6s through the jaws to the most unfavourable point half-way up the outer surface of the shroud, in a direction perpendicular to the axis of the shroud. After the test, there shall be no deformation or loosening of the shroud such as will impair the further use of the appliance inlet.
-
Product
Hydrostatic Head Pressure Tester
-
Sataton Instruments Technology CO., Ltd
Hydrostatic head pressure tester is designed to determine the resistance to water penetration of materials by hydrostatic pressure method. By measuring the opposition to the passage of water through the tested specimen, the tester is to provide standard testing conditions for operator to note the test terminal point. The tester is primarily intended for ducks, tarpaulins, tentings, waterproof materials and other materials which are used for impermeable application, such as chemical protective clothing or medical protective clothing.
-
Product
Pressure Module
APM CPF
-
AMETEK Sensors, Test & Calibration
The APM CPF Series portable pressure modules offer the functionality and flexibility to perform pressure calibrations with a multifunction process calibrator. Or, combine with a hand-held pressure calibrator to expand its range. The APM CPF delivers the same high level accuracy whether in the lab or in the field.
-
Product
Tire Pressure Gauge
-
ZhangZhou Weihua Electronic co.,ltd
Is a pressure gauge used to measure the pressure of tires on a vehicle. Since tires are rated for specific loads at certain pressure, it is important to keep the pressure of the tire at the optimal amount.
-
Product
Wet/Wet Differential Pressure Transmitter
655
-
The Series 655 Wet/Wet Differential Pressure Transmitter converts a positive or a positive differential pressure measurement into a standard 4-20 mA output signal. Designed for use as a wet/wet differential pressure transmitter, units can be used to measure gas or liquid pressures compatible with 316/316L stainless steel wetted parts
-
Product
Tire Pressure Monitoring Systems
TPMS
-
With the widespread use of tire pressure monitoring systems (English: Tire Pressure Monitoring System - TPMS) come to new requirements on dealers, garages and tire shops. Since November 2014 every newly registered vehicle must have on board a tire pressure monitoring system as standard. With its carefully designed parts solutions and efficient service devices of VDO They are well equipped for the service!
-
Product
Digital Indicating Pressure Transmitter
DSGT
-
Series DSGT Digital Indicating Transmitter is a versatile multi-function process gage that features an excellent 0.25% full scale accuracy.
-
Product
Pressure
-
Pressure transmitters measure process pressures as well as the levels of liquids, gases and vapours.
-
Product
Sanitary Pressure Transmitter
681
-
The Series 681 Sanitary Pressure Transmitter is designed to meet 3A standards for applications in food, dairy, beverage and pharmaceutical processing, liquid level control, and sanitary pipelines. The unit is fully sealed to withstand high pressure washdown in Clean-in-Place (CIP) and Sterilize-in-Place (SIP) installations.
-
Product
XP2i Digital Pressure Gauge
-
AMETEK Sensors, Test & Calibration
We provide some of the world’s most popular XP2i digital test gauges for a variety of applications and markets. Included are intrinsically safe "percent of reading" gauges, process gauges, differential pressure gauges, panel mounted gauges, and gauges specifically designed for use in the maritime industry. Whether you’re looking for a gauge with long battery life to mount in hard to reach locations, a gauge to collect and store readings in the field in extreme conditions, or one that doesn’t require recalibration for up to three years, we have the perfect gauge for you.
-
Product
Static Pressure Manometer Kit
EM201SPKIT
-
UEi Test & Measurement Instruments
A digital, time saving electronic manometer static pressure kit
-
Product
”Two Pressure" Humidity Generator
2500 Mobile
-
The Model 2500 Benchtop Humidity Generator is a self contained system capable of producing atmospheres of known humidities using the fundamental, NIST proven, "two-pressure" principle. This system is capable of continuously supplying accurately known humidity values for instrument calibration, evaluation, and verification, as well as for environmental testing.
-
Product
Medical Mask Gas Exchange Pressure Difference Tester
DRK371-II
-
Shandong Drick Instruments Co., Ltd.
It is used to measure the gas exchange pressure difference of medical surgical masks and other products.
-
Product
Digital Tire Pressure Gauge 230 PSI
AstroAI ATG230
-
Green Backlit LCD display and flashlight for visibility in dimly light areas, easy-to-read digits help you easily measure your vehicle's tire pressureHeavy Duty Stainless Steel Made And RV/Truck Special Designed to maintain correct tire pressure, reduce tire wear and extend tire life; Digital display reading instantly and clearly being shown, no longer do the guesswork of analog gaugesBi-directional push-pull (Dual) head design; Nozzle easily forms a seal with the valve stem giving quick and accurate readings in 0.1 increments; 4 settings with longer range: 0-230 PSI / 0-16 Bar / 0-16 Kg/cm2 / 0-1585 Kpa
-
Product
PORTABLE PRESSURE MAPPING
I-SCAN® HANDHELD SYSTEM
-
Handheld pressure measurement system for collecting tactile pressure data.
-
Product
Pressure Meters
-
PeakTech Prüf- und Messtechnik GmbH
Is a measuring device that is used to determine pressure differences. It has a digital multifunction display with backlight.
-
Product
Differential Pressure Adapter w/ App Compatibility
DPA1
-
UEi Test & Measurement Instruments
The DPA1 measures positive, negative and differential pressure and is compatible with iOS® and Android™ mobile devices. Measurement units can be selected from the following scales: InH2O, mmH2O, psi, bar, mBar, kPa, InHg and mmHg. The mobile device screen will display a numeric reading. And is backed by a 1-year warranty.
-
Product
Diaphragm Operated Pressure Switch
SA1100
-
Extremely rugged construction assures excellent reliability in chemical, petroleum and industrial plants. New design also provides burst pressure protection to 3000 psi (206 bar). The rolling diaphragm design maintains a constant effective area to minimize friction.
-
Product
Precision Pressure System
PPS 4.0
-
Precision Pressure meter for testing to IEC 80601-2-30, and any application that requires pressure waveforms to be graphically monitored at relatively high speed.
