Showing results: 1231 - 1245 of 1676 items found.
-
SimSAAS -
Spirent Federal Systems
Comprehensive testing of SAASM for classified military applications. Military GPS receivers can use a Selective Availability Anti-Spoofing Module (SAASM) to enable decryption of precise positioning data. Selective Availability (SA) refers to a discontinued practice by the U.S. government to degrade the civil signal to prevent full accuracy. Since May 1, 2000, Selective Availability has not been operational.
-
SFT3503A -
Hangzhou Softel Optic Co., Ltd.
SFT3503A Bidirectional IP Gateway is a head-end interface device which is used for DVB and Ethernet. It can be used both for a receiver and a lancers! On one hand, in the lancers part, this machine can be used for sending IP stream, turning the TS stream into IP Stream. On the other hand, in the receive part; this machine can be used for receiving IP stream, turning the IP stream into TS stream.
-
Hot Electron Bolometer (HEB) -
Insight Product Company
Insight Product Company offers Hot Electron Bolometer (HEB) mixers, receivers, and chips made from NbN or NbTiN thin film. The HEB mixers can operate at frequencies of up to several terahertz. Advantages: Above about 1 THz Hot Electron Bolometer mixers offer the best sensitivity and lowest noise of all the technology for the coherent detection of radiation.
-
Multiple Access Communications Ltd.
Building on MAC Ltd’s MONITOR product family, our CatchAll units combine these with additional functionality to realise RF receiver and transceiver products ready to be deployed in a wide range of real world applications. As well as being available pre-configured with standard application software, these units can also be supplied with application software developed specifically to meet your own requirements.
-
Electrocon Systems
We hold the expertise in trading a wide range of Cable Route Tracer, which works using electromagnetism technology. Our ranges of products are sourced from trusted organizations. It consists of a Transmitter and a Receiver that helps in the depth measuring and long distance tracing. The product range consists of industrial cable route tracer, electrocon systems, cable route tracer.
-
M4K429RTx -
Excalibur Systems, Inc.
The M4K429RTx is an ARINC-429 multi-channel test and simulation module to be used on the Excalibur 4000 family of carrier boards. The module supports up to ten ARINC-429 channels in any combination of transmitters and receivers. Each of these channels feature error injection and detection capabilities. The receive channels allow for the storage of all selected Labels with status and time tag information appended to each word.
-
N5181B -
Keysight Technologies
Take your devices & designs to their limit with outstanding hardware performance, including unmatched phase noise & spurious characteristicsDrive power amplifiers & characterize nonlinear behavior with industry-leading output powerThoroughly test receiver performance by simulating complex analog modulation scenarios with multi-function generator capabilityLower your cost of ownership with 3-year cal cycles & comprehensive solutions for self-maintenance
-
AB-CLP -
Lisun Electronics Inc.
• EMI Receiver equipped with absorbing clamp can indirectly test radiated interference power of household electrical appliance, power tool and similar electrical appliance with frequency from 30~300MHz.
-
Teledyne Lincoln Microwave
Up and down conversion is often used because waveform generation in a transmitter is less expensive at lower frequencies and the dynamic range of analogue-to-digital converters in the receiver is higher at lower frequency.
-
6TL Engineering
Capable of performing the necessary switching between test points of the device under test, to give access to low frequency measuring instruments, in electronic test systems based on tool receivers.
-
21-8575-00 -
LANTAC Techtronics Co. LTD
The HDMI Tester is designed to provide fast convenient verification of proper pin connections of HDMI cables and wall plates. The set includes a Main Test Unit and Remote Test Receiver.
-
NRQ6 -
Rohde & Schwarz GmbH & Co. KG
The R&S®NRQ6 is based on receiver technology and can perform band-limited power measurements down to -130 dBm. The R&S®NRQ6 combines high-precision with high-speed measurements beyond the limits of currently available power meters. In addition to conventional continuous average measurements, the R&S®NRQ6 has a trace display function and also performs ACLR measurements.
-
Lino L2P5G -
Leica Geosystems AG
The Leica Lino L2P5G uses the latest green laser technology which projects clearer and crisper laser lines at exact right angles to one another. This allows for the highest accuracy of detailed interior tasks. The working range is up to 35 meters depending on the lighting conditions, and can easily be extended up to 80 meters using the laser receiver Leica RGR 200.
-
SM-8X8-C6HDR-POE-HDBT -
Network Technologies Inc
The VEEMUX® HDMI Matrix Switch Over HDBase-T with Power Over Ethernet routes and distributes uncompressed HD 1080p, multi-channel audio, Ethernet, and IR from eight HDMI video sources to eight displays via inexpensive CAT6a/7 cable using HDBase-T technology. Power over Ethernet provides power to receivers that can be located up to 328 feet away.
-
310113547 -
Virginia Panel Corporation
The 6U Slide-Mounted Plate mounts to standard 19" racks and slides open to allow access to wiring between the instruments and VPC i1 Receivers. The 4 cutouts are spaced evenly across the panel. iCon cover plate sold separately (310 113 546). This mounting plate is designed to work with a slide kit and includes flanges and an instrument bracket. A slide kit is required for use.