Receivers
Equipment that is the sink or terminator of any signal on a transmission medium. (atis.org)
See Also: ITA
-
Product
Power, Module, Receiver, CASS, 76 Position
510114107
-
Module, ID, Cass, Signal, 76 Positions, Discrete Wiring
-
Product
Cable Assembly, Receiver, QuadraPaddle, 20", 100-Pin Male SCSI
540009040140
-
Cable Assembly, Receiver, QuadraPaddle, 20", 100-Pin Male SCSI
-
Product
Cable Assembly, Receiver, 36", QuadraPaddle, 160 Pin Female DIN
540069120240
-
Cable Assembly, Receiver, 36", QuadraPaddle, 160 Pin Female DIN.
-
Product
Signal, Module, Receiver, TriPaddle, 90 Series, 96 Position
510104136
-
Primary mating module 510108126. (May mate with other ITA modules, as well.)
-
Product
Ear Simulator
BO1028
-
The BO1028 Ear Simulator is a special coupler for microspeakers or earbuds that has been designed to be compliant with ATU-T P.57 and IEC 60318-1. While mics in our BP1090 couplers receive sound waves the way they travel through air, the dual compartment chamber of the BO1028 is designed to modify sound pressure so that the mic receives air vibrations the way a human ear drum would receive them.
-
Product
Spectrum Analyzer
SA-S
-
RF Frequency Range: 1 Hz to 4.2 GHz. Low noise amplifier available above 500 KHz. Wide dynamic range: -151 dBm to +10 dBm. Resolution bandwidths (RBW) of 0.1 Hz to 250 KHz and 5 MHz. Includes a High Dynamic Range Measuring Receiver. 0.25 dB relative accuracy. 0 dBm to -125 dBm, 150 KHz to 1 GHz. 0 dBm to -115 dBm, 1 GHz to 4.4 GHz. Adjustable digital audio filters. Accurate AM and FM measurements
-
Product
Enclosure, 9025TR, Front Mount, Sloped, 15" Depth
410114004
-
-Due to depth and probable weight of this enclosure, VPC recommends use of this enclosure with the TR model of the 9025 (platform). -When using this enclosure to mate with a standard 9025 Receiver (non-TR/platform), ITA p/n 410104260 with 2" depth must be used for proper clearance.
-
Product
2-Channel 200 MHz A/D with 766 DDCs, Kintex UltraScale FPGA - 6U VPX
Model 57865
-
- Jade Xilinx Kintex UltraScale FPGA Products and Navigator Design Suite Software Video- Jade Xilinx Kintex UltraScale FPGA Family Brochure- Complete software radio receiver solution for extremely high-channel-count applications- Uses Xilinx Kintex UltraScale KU035 FPGAs- Two 200 MHz 16-bit A/Ds- Four wideband DDCs (digital downconverters)- Up to 762 narrowband DDCs- Sample clock generation and synchronization to an external system reference- Ruggedized and conduction-cooled versions available- Synchronize up to eight modules with Model 7893 System Synchronization and Distribution Amplifier - PCIe
-
Product
Interface RS-485 and RS-422
-
The RS-485 specification meets the requirements for a truly multipoint communications network, and the standard specifies up to 32 drivers and 32 receivers on a single (2-wire) bus. Some RS-485 transceivers modify the input impedance to allow up to 8× more nodes to be connected to the same bus. Analog Devices offers a wide range of standard RS-485/RS-422 transceivers and iCoupler® isolated RS-485/RS-422 transceivers to suit many applications.
-
Product
Signal / High Power, Module, Receiver, TriPaddle, iCon Series, 4/4 Position
510160124
-
Signal / High Power, Module, Receiver, TriPaddle, iCon Series, 4/4 Position.
-
Product
FlexRay Communications Expansion Kit
OP-SB88
-
The FlexRay communication is anticipated as a next-generation high-speed in-vehicle network.The OP-SB88 is an expansion kit that allows monitoring of FlexRay communications on up to two channels in real time. The kit incorporates a monitor function that does not require complicated parameter settings, and a simulation function with which the OP-SB88 works as a FlexRay communications node to transmit and receive data, thus powerfully supporting the initial development. The filter function and high-capacity memory greatly shorten the analysis time of trouble.
-
Product
Brix Meter
-
Hand-held, digital brix meterLight-weight, portable, includes protective carrying caseMeasures concentration of sugar and dissolved solids in aqueous solutionAutomatic Temperature Compensation (ATC)Ideal for on-site measurement of juices and other sugar-based liquidsDetermine fruit quality during harvest, shipping, receiving, processing, storage
-
Product
Portable Telemetry Systems
-
Lumistar’s portable receivers and test transmitters take the state of the art technology found in the PCI receivers and simulators and install it into a hand held units. Our luggable Telemetry Systems can be configured using our card level products into unique custom solutions.
-
Product
Fiber Optic Modem
VCH-608
-
The VCH-608 fiber optic modem is designed to receive and transmit via a fiber optic communication line (FOCL) signals of frequency and time standards (TSV) :- pulse signals 1 Hz (1 PPS) with delay compensation,- harmonic electrical signals with a nominal value frequency 100 MHz with phase instability compensation.
-
Product
Receiver, G18, 18 Module, Slide Mounting (slide Kit Required)
310120141
-
This lightweight and rugged 18 module receiver will accommodate larger ATE chassis’ (PXI, VXI, SCXI). It allows space for up to an 18-slot PXI chassis. This receiver is designed to work with a slide kit and includes a mounting plate, mounting flanges and instrument bracket. A slide kit is not included and required for use.
-
Product
Antenna, Log Periodic
EM-6947 | 200 MHz – 5 GHz
-
The EM-6947 is an ultra-wide bandwidth log periodic dipole array aimed at applications requiring consistent performance over a very wide frequency range. Capable of both receiving and moderate power level transmitting, the EM-6947 can take the place of two or more conventional antennas, allowing you to take full advantage of the tuning range capabilities of modern receiver and spectrum analyzer designs with less inconvenience caused by the need to switch antennas.
-
Product
Antenna, Wideband Discone
EM-6115 | 10 KHz – 2 GHz
-
The EM-6115 is a broad band collinear array allowing very wide Omni-Directional frequency coverage in a single package. Below approximately 100 MHz, the EM-6115 acts as an active vertical rod which offers 10 to 12 dB Greater unsaturated instantaneous dynamic range than competitive antennas (overload field strength: 2 V/meter) which greatly reduces intermodulation generated signals in a typical read world RF environment. In the congested spectrum above 100 MHz the antenna is passive and contributes no intermodulation products so the overload point is determined solely by the receiving instrument. This immunity to overload can often make the difference between useful signal output and an indecipherable jumble of spurious products and is accomplished without compromising sensitivity. The antenna collapses for convenient storage and transport.
-
Product
Cable Assembly, Receiver, TriPaddle, 20", 10 Position Combicon and 4 Position Omnimate
540295010101
-
Cable Assembly, Receiver, TriPaddle, 20", 10 Position Combicon and 4 Position Omnimate
-
Product
Cable Assembly, Receiver, TriPaddle, 20", 44 Pin ML DSub, (2) SMB Plugs, Twisted Pair
540149050101
-
Cable Assembly, Receiver, TriPaddle, 20", 44 Pin ML DSub, (2) SMB Plugs, Twisted Pair.
-
Product
ZonuSkyShot GPS Tester
-
The ZonuSkyShot GPS Tester is a compact GPS receiver which detects the presence and, the signal strength of a GPS signal, and identifies all the satellites “seen” carried by the signal. The device enables laptop or phone connectivity to report and indicate this at the LED device’s screen. Furthermore this GPS receiver can be accessed at the USB port on the Base Unit, or via a Bluetooth™ device allowing the user to see the available satellites using the app provided with the system.
-
Product
Single Channel One Analyzer
MVNA-8-350-1
-
The upper half of the Central Unit is the Vector Receiver (VR) of the Analyzer, which can be a single channel one, model VR-8-350-1 (one millimeter wave signal detected at a time only)
-
Product
9050, 50 Module, Receiver, VXI and Discrete Wiring, Double Tier
310104248
-
This 50 module receiver is rugged and designed to accommodate high I/O. With high contact point availability, the 9050 receiver is suited for larger test and measurement systems. The top tier accommodates VXI instruments and accepts VPC's interconnect adapters with the bottom tier for discrete wiring.
-
Product
10-Ch Pneumatics CAN without RCV module
YAV90PNF
-
This pneumatic subsystem is the same as YAV90PNE, but without the VPC receiver module integrated, making it a good option to be used inside the fixture. Since the control is CAN, user can easily place electrovalves inside the fixture without the need to use a bunch of wires.
-
Product
Megohmmeter Insulation Tester
AMIC-30
-
The AMIC-30 insulation tester is a small portable meter designed to measure insulation resistance in electrical and telecommunications installations, cables, motors, transformers and other equipment. The test voltage can be programmed in steps from 10 V to 1000 V. The instrument can measure both insulation resistance over a wide range (0,1kΩ...100GΩ), and insulation leakage current, capacitance and other parameters. All test results can be stored in the internal memory and sent to a computer via the included wireless USB receiver. The meters are supplied with rechargeable Ni-Cd batteries.
-
Product
Photodiode
-
A high sensitivity receiver in a fiber pigtail coupled package, it includes a high speed InGaAs avalanche photodiode with a high gain TIA in a hermetically sealed coaxial package. It incorporates an LC/UPC pigtail and a flexible printed circuit (FPC). The signal GND and a receptacle are electrically isolated in this APD receiver.
-
Product
Protective Cover, G18, Receiver
310113327
-
The Receiver Protective Cover is provided to keep your modules and contacts enclosed to prevent damage, keeping your test system in proper working order.
-
-
Product
Micro Coax/Micro Power, Module Insert, Receiver, I2 MX, 15 Position
510143009
-
Micro Coax/Micro Power, Module Insert, Receiver, i2 MX, 15 Position
-
Product
Receiver, ICon, With Protective Cover
310123101
-
iCon accepts two modules and allows a variety of signal, power and coaxial connections. A protective cover is included with the receiver, and other accessories, such as keying pin kits and strain relief, are available.
-
Product
Receiver, 9050, 50 Module Double Tier
310104115
-
The 50 Module Receiver is a rugged system designed to accommodate high I/O. With high contact point availability, the 50 Module Receiver is suited for larger test and measurement systems.
