Product

Current logger0 to 20mA

TK-4802

-

Gemini Data Loggers Ltd.

TK-4802 - Gemini Data Loggers Ltd.

Supplied with an input cable, this logger can measure current between 0 and 20mA DC and can be connected to many industry standard devices, such as CO2 sensors and current clamps, enabling the logging of a wide range of process parameters.

Product

Leakage Current Tester

2675

-

Shenzhen Chuangxin Instruments Co., Ltd.

2675 - Shenzhen Chuangxin Instruments Co., Ltd.

RK2675 series Leakage Current Tester is used to measure the electrical insulation quality and products’ safety performance of the main indicators.

Product

High Voltage Surge Current Monitors

HVSCM

-

Test Electronics

HVSCM - Test Electronics

Designed to be used with the Model HVST High Voltage Surge tester. The Surge Current Monitor allows simultaneously surge testing 20 units. The Surge Current Monitor monitors the current going through each unit under test at the time of the surge. If a unit under test breaks down or leaks, the Surge Current Monitor will identify the bad unit by lighting the corresponding LED. The most important features of the surge tester are its ability to test the entire winding insulation system. A high voltage surge generates turn to turn, coil to coil, and phase to phase voltage stress, as well as ground insulation stress. When used as a dielectric test, accurate voltage readings are essential. The HV Surge Tester monitors the voltage directly across the winding under test. In production testing we expect that most of the time the devices will pass. In the event that one should fail, the failed device would be removed and then all the parts would have ot undergo another surge test. Since most devices pass most of the time, simultaneous surge testing can be a real time saver.

Product

Current Differential and Overcurrent Relay

SEL-387

-

Schweitzer Engineering Laboratories, Inc.

SEL-387 - Schweitzer Engineering Laboratories, Inc.

Protect and control any two-, three-, or four-winding power transformer with the SEL-387, which provides thermal and through-fault monitoring, and with SELogic Control Equations, can detect breaker failure.

Product

High Power Switch and Bias Module

-

Macom Technology Solutions Holdings Inc.

Macom Technology Solutions Holdings Inc.

MACOM’s High-Power Switch and Bias modules are extensively used in 4G and 5G TDD base stations as well as aerospace and defense applications. The PIN Diode Switch features high power handling, low insertion loss, and super board band performance. The integrated bias controller utilizes a boost circuit and provide the driver circuitry to the switch. The modules require only a single 5 V supply, and a single TX / RX control signal which greatly reduced the customer design complexity.

Product

Current Probe For Non-Intrusive Measurement Of AC, DC, And Waveform Currents

CP 305

-

GMC-I-PROSyS

CP 305 - GMC-I-PROSyS

The CP 305 current probe has been designed for use with oscilloscopes respectively for accurate, non-intrusive measurement of AC, DC and complex waveform currents.Using advanced Hall Effect technology the CP 305 can measure currents accurately up to 450A peak over the frequency range of DC to 20 kHz.

Product

High Current Sensor

HCS-BTA

-

Vernier Software & Technology, LLC

HCS-BTA - Vernier Software & Technology, LLC

Use the High Current Sensor in experiments that involve currents larger than 1 A, such as solar panels, hand generators, and other alternative energy projects.

Product

Impuls Current Generator

-

Hilo Test GmbH

Hilo Test GmbH

Hilo-Test manufactures power generators for surge current material and safety tests, in particular for the examination of diverting elements such as gas discharge tubes, varistors, SPDs, and components in which such protective elements are installed, according to according to the IEC / EN 61643-11. Below you will find the right solution.

Product

50A, 50 MHz CURRENT PROBE, BNC, AC/DC, 50A rms, 75A Peak Pulse

T3CP50-50

-

Teledyne LeCroy

T3CP50-50 - Teledyne LeCroy

50A, 50 MHz CURRENT PROBE, BNC, AC/DC, 50A rms, 75A Peak Pulse.

Product

Current Injection

-

K&S Engineering and Scientific Ltd

K&S Engineering and Scientific Ltd

The  outputs are continuously variable from zero and are all isolated.  The current outputs can be used at twice their continuous rated current on a 25% duty cycle with a maximum ON time of 5 minutes.

Product

Broadband Current Probes

-

A.H. Systems, Inc.

A.H. Systems, Inc.

Conducted currents can be measured without making direct contact with the source conductor or metallic surface by means of clamp-on broadband current probes. The BCP-5xx EMC Current Probes are designed to permit field intensity meters, spectrum analyzers, and other 50W impedance instruments to measure quantitative magnitudes of current.

Product

622 HP Eddy Current Chassis Dynamometer

CM-51-EC

-

Taylor Dynamometer, Inc.

CM-51-EC - Taylor Dynamometer, Inc.

Weight Capacity: 25,000 lb (11,340 kg) per axleRoll Brakes: pneumatically-actuated discShipping Weight: 8,340 lb (3,783 kg)Capacity: 622 hp at 45 mph (464 kW at 72 kph)Rolls: 20 by 36 in. (508 by 915 mm) long4 front fixed rolls, 2 rear rolls fixed toaccommodate axle spreads from48 to 60 in. (1,219 to 1,524 mm)tandem centersPit Required Depth: 25 in. (635 mm)

Product

SY024 Pulse Rate to Current or Voltage Converter

-

Synectic Electronics

Synectic Electronics

SY024 PR* is a Pulse Rate-Analog converter designed to accept a frequency and produce a proportional Current or Voltage output. The current output can be 0-20mA or 4-20mA and the voltage output version is user adjustable from 0-5V to 0-10V.

Product

Clamp type AC Current Sensor／for Load Current Measurements(CT Series)

CT-3000

-

MULTI MEASURING INSTRUMENTS Co., Ltd.

CT-3000 - MULTI MEASURING INSTRUMENTS Co., Ltd.

*Ultra big CT window*AC 1A～3000A*Current measurements of main cable

Product

Current Clamp Adapter

-

PeakTech Prüf- und Messtechnik GmbH

PeakTech Prüf- und Messtechnik GmbH

It uses a pair of jaw which allow clamping around an electrical conductor to measure the current in a conductor without the need to make physical contact unlike a normal multimeter.

Product

Handheld Digital Multimeter, AC/DC Current, AC/DC Voltage, Capacitance, Resistance, True RMS

72-2995

-

Tenma

72-2995 - Tenma

40,000 count industrial True RMS digital multimeter is a highly versatile handheld instrument boasts 5-1/2 digit TRMS accuracy. It provides AC/DC voltage and current measurement, resistance, capacitance, temperature and frequency measurement, displaying readings on a backlit LCD digit and analogue bargraph display. Other features include non-contact voltage detection, continuity and diode test and USB data logging. All this is housed in a rugged overmolded enclosure with carry case, test leads and USB interface cable included.

Product

Bias Network, 45 MHz to 50 GHz

11612B

-

Keysight Technologies

11612B - Keysight Technologies

The Keysight 11612B broadband high power bias network can be used in a wide variety of biasing applications for test and measurement requirements in laboratory and production environments. Bias networks provide the means of supplying dc bias to the center conductor of the coax connector for your device while blocking the dc to the RF port.

Product

Current Probes

XQ13

-

Beijing GFUVE Electronics Co.,Ltd.

XQ13 - Beijing GFUVE Electronics Co.,Ltd.

The model XQ13 ac micro amp clamp on current probe is suitable for 10A-100A cable online measurement, it belongs to high performance current sensor field.