-
product
Dielectric Loss Tangent Testing Instruments
Insulation materials in electrical equipment are used between a pair of electrodes; therefore it can be expressed as capacitors. Applying AC voltage to a capacitor with insulation materials causes an energy loss due to the leak current, the dielectric polarization, and the partial discharge. Because of this, the phase of the capacitor current is more delayed than that of a zero-loss current (reactive current) flowing in an ideal insulation material. The delay angle is called "Dielectric Loss Angle", and the tangent is "Dielectric Loss Tangent" (tanδ). Please refer to the technical guide explained in detail.
-
product
6U Processor Board
CP62103
LinkedHope Intelligent Technologies Co.,Ltd.
CP62103 is a modular design, based on COMexpress® technology, up to 4-core i7 processor from Intel® Ivy Bridge family. CP62103 is designed to meet harsh environment applications like rural communication, military, medical and outdoor video processing.CP62103 supports up to 3615QE, an Intel® 4-core processor. The 3rd generation Intel® Core™ i3/i5/i7 processors have a completely new microarchitecture, enabling small-sized designs to be created with unmatched computing power, graphics performance and energy efficiency on a small footprint.
-
product
Discharge Test System
The automated testing equipment automatically performs charge and discharge of energy devices such as the rechargeable batteries(cells, modules, packs) that are installed in PHV/ EV and mobile devices, while measuring the voltage, current, temperature, and impedance.
-
product
Directional Couplers
Directional Couplers designed by BroadWave provide an accurate method for sampling microwave energy. Available in single and dual configurations. We can offer couplers for most applications including power measurements, signal leveling, and frequency measurements.
-
product
Generator
Toellner Electronic Instrumente GmbH
In electricity generation, a generator is a device that converts motion-based power (potential and kinetic energy) or fuel-based power (chemical energy) into electric power for use in an external circuit.
-
product
Element 1 Power Systems
The fuel cell will change our lives as much as the computer it powers and the internal combustion engine it replaces. The future of power and transportation will change dramatically when fuel cells become the main producers of clean energy. The car will no longer be an environmental burden, and the electrical grid will be subdivided to the neighborhood and building level. The quality and reliability of this alternative energy source will be superior to the current grid design. Fuel cells and hydrogen technology will make all of this possible, and with little or no pollution.
-
product
DIN RAIL POWER ANALYSERS
STAR3DIN
The STAR3 din is the latest instrument available from Elcontrol Energy Net. This high quality panel energy analyser provides brillant features at a price never reached before. The new bright LCD display, the harmonic analysis, the wide set of measured parameters including the TDH available in all the models, the multi-protocol capability of the RS485 port and the high accuracy class 0.5%, the 3 years warranty period, allow to consider the STAR3 the new state of art of the of the panel analysers market.
-
product
DCU Gateway Solutions
Signals & Systems India Private Limited
SANDS DCU is an ideal gateway solution for the Energy Management System (EnMS). It provides connectivity to the cloud apart from data collection, local data storage. DCU is based on ARM Cortex-A5 processor having 512MB of DDR2 memory and expandable NAND Flash memory upto 2GB. Edge / Sensor data can be stored locally using the on-board SD card option. The cloud interface is LTE with 2G/3G fall back.
-
product
Amplifiers
Amplifiers are used to amplify the energy output of photodetectors as well as convert their electrical signal for a number of illumination measurement or spectroscopy applications. Amplifiers are digital systems that amplify the low electrical current transmitted by photodetectors to easily detectable levels. Amplifiers also convert photodetectors' electrical current into voltage so that their signal may be read by other digital devices. Amplifiers are indispensable for nearly any light measurement applications by greatly increasing the usability of a detector system.
-
product
High-Accuracy Meter
Shenzhen Star Instrument Co., Ltd.
Three-phase four wire CT/VT meter provides unparalleled accuracy and measures forward/reverse active and reactive energy as well as four-quadrant reactive energy.
-
product
High Energy Switches
Excelitas' High Energy Switching Solutions are a diversified family of ultra-fast thyristors, spark gaps and trigger transformers designed to address the most demanding applications.
-
product
Battery Chargers
Following a power outage, various power engineering objects such as power plants should operate on battery back-up systems. It is necessary that these batteries are being properly charged in order to compensate its energy loss and keep their voltage within the predefined limits. DV Power’s chargers are portable and universal battery charging solution. They are primarily intended for charging Lead-Acid, Ni-Cd and Li-ion batteries from 1 V DC to 300 V DC level.Charging modes provide a safe regulation of charging procedure and achieves fast recharge and low risk of overcharge. Variety of implemented protections, such as thermal, overcurrent, undervoltage and overvoltage, assure the charging process is safe for the battery and the charger itself.
-
product
RL78 Family of 8/16-bit Ultra-Low Energy MCUs
RL78/I1x
The RL78/I1x microcontrollers are part of the RL78 microcontroller family with rich analog integration and support high temperature operation. RL78/I1x is ideal for application specific solutions but also suitable for many general purpose application In the mass market with tough environment operation.
-
product
Monitors
The Gentec-EO monitors come in various sizes and types to cover all applications. We have monitors with or without display (PC-based) and for power or energy readings, or both. We also offer the fastest digital needle display on the market.
-
product
TAP Adapter for Corelis JTAG Controllers
Low Voltage Adapter
High technology, energy efficient, and small form factor products push JTAG interfaces to the limits; low power and high performance means low voltage, high speed, and high drive requirements. Building specialized interface circuits on product Printed Circuit Boards (PCBs) is inconvenient and costly—an out-of-the-box, external solution is needed.The Corelis Low Voltage adapter is an add-on accessory that provides existing scan controllers with an active, plug-in interface to access low voltage scan chains, without sacrificing performance.
-
product
TRMS AC/DC Clamp-on Power
HT9023
HT9023 has been designed to measure AC, DC AC+DC current up to 1000A in TRMS reaching CAT IV 600V and CAT III 1000V in compliance with safety standard IEC/EN61010-1. The clamp also measures DC voltage up to 1500V, AC, AC+DC voltage up to 1000V, Active, Reactive and Apparent Power, Power Factor, Energy, voltage/current harmonic analysis up to the 25th with THD% calculation in balanced single-phase or three-phase systems.
-
product
Thermal Infrared Sensors
Excelitas “Thermal IR Sensors” represent a wide range of Pyroelectric Detectors, Thermopile Detectors and IR sensor modules. Our leading edge IR sensing technologies are used for motion detection, presence monitoring, temperature measurement and gas detection to enable smarter homes, improved energy efficiency, better health, safer home security and a more expansive and connected IOT. In addition to our wide offering of off-the-shelf devices, we also specialize in customized solutions for your specific needs.
-
product
Amplifiers
The amplifier is one of the most important components in a pulse processing system for applications in counting, timing, or pulse amplitude (energy) spectroscopy, providing the pulse-shaping controls needed to optimize the performance of the analog electronics.
-
product
Three Phase Din-rail Multi-rate kWh Meter
SY 1041
Hong Kong Songyang Industrial Ltd.
Type SY1041 three phase DIN rail watt-hour meter is a kind of new style three phase electronic multi-rate watt-hour meter, energy data display adopt 7 digits wide temperature type crystal display, with many functions of multi-rate (time-of use) energy measurement, infrared carrier wave communication and RS485 serial port communication reading meter, etc
-
product
NI-9247, 50 kS/s/ch, 50 Arms, 147 Apk, 24-Bit, 3-Channel C Series Current Input Module
783589-01
50 kS/s/ch, 50 Arms, 147 Apk, 24-Bit, 3-Channel C Series Current Input Module - The NI‑9247 is designed to support direct ring lug connectivity to the three-phase high-current measurements of 1 A and 5 A current transformers (CTs). It is optimized for power, energy, and industrial applications. The safety features, certifications, input ranges, overvoltage ranges, and connectivity are well suited for applications such as power quality monitoring and metering, utility pole-mounted smart switches, utility pole-mounted smart grid reclosers, substation merging units, industrial machine measurements, health monitoring, predictive maintenance and prognostics, and phasor measurement units (PMUs).
-
product
Process & Lab FTIR FT-NIR Analyzers
Using a broad spectral region from the near-infrared to the mid-infrared, our Guided Wave ANALECT® Series of FTIR/FT-NIR analyzers measure physical and chemical properties of liquids, solids and gases. They are ideal for complex refinery applications such as fuels blending and component streams applications for polymers, petrochemicals, chemicals, pharmaceuticals in addition to general manufacturing. Customers include ADNOC, BP, CITGO, CPCL, Gazpromneft, HPCL, IOCL, Orpic, Phillips 66, Rompetrol, Statoil, PBF Energy and Tesoro.
-
product
Dual Payload Drone Gimbal
FLIR XT2
The FLIR XT2 integrates a high-resolution FLIR thermal sensor and a 4K visual camera with a leading stabilization and machine intelligence technology to quickly transform aerial data into powerful insights. The advanced thermal sensor provides high sensitivity imaging for infrastructure monitoring, energy inspections, firefighting, search and rescue missions, and more. With a fully-integrated dual payload, professionals can now capture actionable thermal and color visible data in a single flight, saving time, money, and lives.
-
product
X-Ray Seamless Pixel Array Detector
XSPA-400 ER
In general, X-ray diffraction measurements using a Cu X-ray source are known to have difficulty detecting trace crystalline phases because of increased background when measuring samples containing transition metals. The high energy resolution of the XSPA-400 ER supresses the fluorescent X-rays originating from the sample, thereby reducing background, enabling highly sensitive measurements of samples containing transition metals, such as iron and steel compounds and battery materials.Therefore, it achieves higher sensitivity measurements than conventional detectors.
-
product
CU-2 Digital Controller
SX-E
The new controlled charging method using a three-phase power supply reduces power consumption compared to the past and enables high-speed charging. In addition, the exclusive patent "regeneration function" has realized further energy saving.
-
product
Pressure Transducer Module
PTM-1000
Advanced Thermal Solutions, Inc.
The PTM-1000, Pressure Transducer Module, is a four-channel test instrument for measuring differential pressure in enclosures where air flow integrity is critical to proper performance. As the demand for more energy efficient cooling grows, the need for measuring the pressure at each source of heat generation will follow.
-
product
Save A Watt® TV Standby Killer
P4150
Stop energy hogging TVs which continue to draw electricity even in “off mode”. Now you can really turn off your TV with the TV Standby Killer.
-
product
Process RF Analyzer
ST-3300
The Sensortech ST-3300 is a smart analyzer for process moisture measurement and control of materials used in chemical, mining, textiles, agriculture, and other industrial industries. Used by quality assurance professionals, the ST-3300 improves methods for controlling moisture at key areas in a manufacturing process, helping operations conserve energy, reduce waste, increase capacity, and generate revenue.
-
product
Power Recorders
A range of Low Cost Voltage, Current and Energy Recorders (Analysers, Analyzers) allows users to check loading and voltage performance, as well as Power and Energy surveys. A great replacement for a Hawk 5000 Meter.
-
product
Regenerative Power System, 500 V, 20 A, 5 kW, 200/208 VAC
RP7951A
The RP7951A regenerative power system is a single output, bi-directional, regenerative DC power supply with highly integrated safety features that protect both your people and your device under test. The regenerative capability enables the energy normally consumed to be returned to the grid cleanly, saving costs associated with energy consumption and cooling.
-
product
PXI/PXIe Battery Simulator Module, 4-Channel With V/I Readback
41-752A-012
Targeting EV, automotive, aerospace, energy storage and electric aircraft applications, the new battery simulator modules occupy a single PXI slot. These 4-channel battery simulators are capable of supplying up to 7 V and 300 mA per channel. The channels are fully isolated from ground and from each other, allowing series connection to simulate batteries in a stacked architecture.
