Showing results: 211 - 225 of 439 items found.
-
Ceramic Blades -
SV Probe, Inc.
SV TCL offers a variety of ceramic blades and blade probe cards. We have patented ceramic microstrip blade probes available in low leakage and low capacitance for optimal signal transference, while SV TCL's blade cards are ideal for parametric and RF testing.
-
SPEA S.p.A.
Current and voltage measures are executed on defined pins, in stable conditions.Measurements:- Open/short- Input leakage current- IDD Supply instant/average current test (static/dynamic mode)- Input capacitance @13 MHz and inductance- Retro modulation index (RMI)Test of passive devices:- Capacitors- Resistors- Resonators
-
National Technical Systems
Volume resistivity represents an insulating material’s resistance to leakage current through its body. It calculates the ratio of the potential gradient in relation to the current in a material with the same density. A direct-current resistance between opposing faces of a one-meter cube of the material numerically equates to volume resistivity in SI (Ohm-m).
-
PGB-745 -
Prostat Corporation
- Designed for measuring charge movement and decay time of ESD controlled materials- The set consists of two stainless steel electrodes and two very high resistance test leads selected for this application- The high resistance leads minimize leakage during the test cycle and are equipped with male banana plugs
-
CS-5000 Series -
IWATSU Electronic Co., Ltd.
*Max. Peak Voltage : 5,000V(HV mode)*Max. Peak Current : 1,500A(HC mode)*Equipped all models with LEAKAGE mode (Cursor resolution 1pA)*USB port for display hardcopy, waveform data (CSV format) and measurement setup SAVE/RECALL*LAN interface for Remote Control
-
CS-3000 Series -
IWATSU Electronic Co., Ltd.
*Max. Peak Voltage : 3,000V(HV mode)*Max. Peak Current : 1,000A(HC mode)*Equipped all models with LEAKAGE mode (Cursor resolution 1pA)*USB port for display hardcopy, waveform data (CSV format) and measurement setup SAVE/RECALL*LAN interface for Remote Control
-
GF Instruments, s.r.o.
GF Instruments provides methodical research, near-surface measurements, consulting and services in: engineering-geological surveys (for civil engineering, dams and dikes monitoring, utility mapping, landslides). environmental monitoring and mapping (waste sites, leakages, pollution plumes). UXO surveys. hydrogeological surveys (ground water explorations and protection).
-
D118 -
Gentos Measurement & Control Co.
The D118 ultrasonic flowmeter is based on Tansit-time technology, which has ultra-high measurement accuracy. D118 uses an external clipped Transducer, which can collect flow data simply by clamping it on the outside of the pipe, and it will never come into contact with the fluid, and will not cause liquid pollution, pressure reduction, leakage, etc.
-
PM2000 -
Applied Test Resources
The PM2000 is a high voltage power source capable of supplying up to 2000 V and sourcing 10mA to a load. The high potential at 2 kV fulfills coverage for mostly all semiconductor devices where leakage and breakdown measurements are involved. The module has been incorporated with interlock feature to ensure safety.
-
ULD-410 -
Amprobe Test Tools
When equipment begins to fail due to an air or gas leak or vibration, or electrical discharge, the leakage point emits an ultrasonic sound wave that is above the natural range of human hearing. The ULD-410 Ultrasonic Leak Detector converts this ultrasonic sound into a signal that can be used to pinpoint the exact location of the equipment failure.
-
DB62X Series -
Danbridge a/s
The Danbridge Megohmmeter program is designed for fast measurement of leakage currents and insulation resistance (IR) of various components, cables, materials, etc. The fast and powerful measurement cycles, the high accuracy, and the broad measurement range make the Danbridge Megohmmeters to one of the most versatile insulation measurement instruments on the market today.
-
13100 -
Chroma ATE Inc.
Analyzer is a general measurement instrument designed for analyzing the features of electrolytic capacitor s. It has multiple func tions that can be programmed based on the capacitor features by altering the settings to test metal oxidization thin-film withstand voltage, capacitor leakage current, capacitance, dissipation factor, impedance and equivalent serial resistance, etc.
-
PXC-M Series -
TDK-Lambda Corp.
*Industry Standard DIP-24 Package*9-36 Vdc, 18-75 Vdc Inputs*3.3, 5, 12, 15, 24, ±5, ±12, ±15 Vdc Outputs*5 kVAC Isolation (2 x MOPP)*IEC/EN60601-1, ES60601-1, CE Mark*Low Off-Load Power Draw*2.5µA Leakage Current
-
Macom Technology Solutions Holdings Inc.
MACOM’s MIS capacitors utilize a silicon nitride dielectric over a thermally grown silicon dioxide base. The resultant composite dielectric exhibits low leakage current and insertion loss with excellent long-term stability. The temperature coefficient of capacitance is typically +55 ppm / ºC and is ideally suited for high reliability applications.
-
AudioJog Rack -
CableJoG Ltd
There are 2 rows of 6 LED's corresponding to each of the possible connector pins and one for the screen (or ground) connection. As each pin is activated, the LED's indicate all connections associated with that pin, so that short, open and crossed circuits can be easily found. The LED's also show the possibility of high resistance or leakage connections.