Product

Rubidium Frequency Standard

RFS VXI

-

Holding Informtest

RFS VXI - Holding Informtest

*RFS VXI is designed to work as part of information measuring systems based on the VXI bus as a rubidium frequency standard.*RFS VXI is intended for use as a highly stable laboratory signal source for checking generator devices, time-frequency measuring equipment and other equipment, synchronizing navigation systems.*The RFS VXI contains two independent rubidium reference oscillators: main and standby.*RFS VXI is a VXI standard, register based device and measures C-1.*RFS VXI implements the "Self-control" mode, which checks the output frequencies of the rubidium standard.

Product

Portable Reference Generator - 5VA

RG-5

-

Control Sciences Inc.

RG-5 - Control Sciences Inc.

Programmable Frequency & Voltage Portable Sine Wave Generator Sunlight Readlable Display Transformer Isolated Output 360 - 11000 Hz with 1Hz Resolution 1.9V to 125V Output with AGC

Product

Standard Emission Monitoring System

CEMS-2000

-

Focused Photonics Inc.

CEMS-2000 - Focused Photonics Inc.

CEMS-2000 is a multi-gas monitoring system aimed to continuously and reliably measure emissions from various industrial combustions. The adoption of the hot-wet extractive method avoids the loss of content during sampling. The system is extendable with additional parameters upon request. All output signals proceed through the data acquisition system and then upload to the DCS or environmental authority server.

Product

Standards Waveform Generator

3110A

-

AE Techron, Inc.

3110A - AE Techron, Inc.

The 3110A software is built around the simple concept of a waveform segment. Each waveform segment can have a unique waveform, (sine, square, triangle, and/or DC offset). Frequency, amplitude and DC offset can be clipped, fixed, variable or swept. Segments can be calibrated (as required in CS101) and set to continue on to the next segment or to hold for an external trigger.

Product

Reference Cells For PIV-IV Systems

-

ABET Technologies, Inc.

ABET Technologies, Inc.

NREL calibrated cell used for calibration transfer.The Abet Technologies solar reference cell is a precision instrument for the determination of solar simulator irradiance levels. The sensor is a mono-crystalline silicon solar cell having an area of2x2cm(4cm).The back of the solar cell is attached to the device in such a way that a good heat transfer to the device housing is guaranteed. Below the solar cell a Pt100 RTD temperature sensor is mounted to allow monitoring of device temperature. The device is not shunted allowing the whole IV-curve to be measured. The solar cell is protected by a high quality fused silica window, assuring spectral sensitivity over a 320 -1100 nm range.

Product

Standard Connectors

-

C.C.P. Contact Probes Co., LTD.

C.C.P. Contact Probes Co., LTD.

The Standard Connector Series aims to offer a comprehensive selection of internationallycompatible connectors. Its smart design and simple structure makes it very cost effectiveeven at small volumes.

Product

Standard Voltage 50 Pin D-Type Connector Blocks and Breakouts for Pickering

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

The connector blocks and breakouts below are suitable to use with Pickering cards and modules that utilize a standard voltage 50-pin D-type connector.

Product

15T Standard Running Line Monitor

RLM15T-3.0-S

-

Dynamic Load Monitoring Ltd.

RLM15T-3.0-S - Dynamic Load Monitoring Ltd.

The DLM 15T Running Line Monitor measures the tension on a rope passing through its three wheels. Typically used in cable laying and winch operations to measure and record line tension the robust design has become an industry standard. The monitor can be supplied as a separate item for integration with customers existing PLC’s or with a DLM digital display/HMI touch screen display.

Product

Disciplined Frequency Standard

2975AR

-

Novatech Instruments , Inc.

2975AR - Novatech Instruments , Inc.

The 2975AR contains a rubidium timebase and provide one 10 MHz, one 5 MHz and one Signal Generator output. The Signal Generator uses Direct Digital Synthesizer (DDS) technology and is programmable from 100Hz to 50 MHz using front panel controls or from an RS232 serial interface. The 2975AR can be disciplined by a 1pps input signal and provides a 1pps output signal. The 1pps input is typically provided by the GPS Frequency output from a device like a smart GPS receiver or antenna. The Novatech GPS1 Smart Antenna is available as an accessory to provide a complete turnkey solution.

Product

Standard Light Source

SLS-50W

-

Lisun Electronics Inc.

SLS-50W - Lisun Electronics Inc.

OSRAM Standard Lamp to calibrate the spectrum and luminous flux with Lisun Lab certification. The data can be traced NIM. The Standard Lamp Source is used to calibrate the integrating sphere system. The different size of Integrating Sphere should choose the right power of standard lamp source.

Product

Standard Resistors for Temperature Measurement

-

Measurements International Ltd.

Measurements International Ltd.

High Stability, Split Guard Circuit, Internal Temperature Sensor, Custom Values Available, Includes Calibration Data.