Product

Standard Voltage 9 Pin D-Type Cables - Connector to Unterminated for Pickering Products

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

The connector to unterminated cable assemblies below are suitable to use with Pickering cards and modules that utilize a standard voltage 9-pin D-type connector.

Product

Power Integrity Analyzer Reference Solution

-

Keysight Technologies

Keysight Technologies

The power integrity analyzer reference solution is a hardware-based solution with the Keysight Infiniium S-Series 10-Bit ADC oscilloscope and probes, including the N7020A power rail probe that lets you see the true AC power noise on your DC power line and supports up to +/- 24 V offset and the N2820A high-sensitivity current probe that can measure down to 50 uA.

Product

High Voltage Standard

HVS

-

Ohm-Labs, Inc.

HVS - Ohm-Labs, Inc.

The HVS uses precision matched resistors for high accuracy; it is a modified Park divider structure.

Product

PXI Standard Programmable Resistor Modules

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

Pickering's PXI Standard Programmable Resistor Modules include fully programmable resistor and potentiometer modules for applications such as sensor emulation that require fine adjustment with a resolution down to 0.25 Ohm. All of our Programmable Resistor Modules can easily be formed to make Programmable Potentiometers by connecting two channels in series, using the unconnected terminals as the A and B connections and the link between the two channels as the wiper connection. For applications with more demanding accuracy and resolution requirements, consider our Precision Programmable Resistor Modules .

Product

Multiparameter CTD with a Wide Choice of Standard Sensors.

MIDAS CTD+

-

Teledyne Valeport Ltd,

MIDAS CTD+ - Teledyne Valeport Ltd,

Featuring Valeport’s latest 400 Series electronics, the CTD+ will sample all fitted sensors at exactly the same instant, at up to 8Hz. Advanced setup software allows a variety of sampling regimes including burst modes, delay starts and conditional sampling. Available with up to 64Mbyte memory and internal battery pack, as well as a selection of real-time output formats, the CTD+ may be used with Valeport’s own water bottle carousel.

Product

AC Reference Generators

SR25

-

Computer Conversions Corporation

SR25 - Computer Conversions Corporation

The SR Series are miniature, low cost AC reference generators designed to supply 26 or 115 volt excitation to synchros or resolvers in military and industrial control applications. They accept +/-15V DC and provide up to 5VA of transformer isolated output power. These converters are packaged in PC card mounting modules 2.6”x3.1”x1”H.

Product

Standard Clamp-On Ultrasonic Transmitter

KATflow 100

-

Katronic

KATflow 100 - Katronic

The KATflow 100 is a compact clamp-on ultrasonic flow transmitter with a robust and practical design for permanent installation and flow measurement on single pipes.

Product

Standard - 5.00 (142.00) - 8.30 (235.00) Feed Through Probe

P3325-0

-

ECT

P3325-0 - ECT

Current Rating (Amps): 10Average DC Resistance lower than (mOhm): 10Test Center (mil): 125Test Center (mm): 3.18Full Travel (mil): 100Full Travel (mm): 2.54Recommended Travel (mil): 66Recommended Travel (mm): 1.68Overall Length (mil): 645Overall Length (mm): 16.38

Product

Reference Frequency Generator

MFCh

-

Holding Informtest

MFCh - Holding Informtest

*Frequency reproduction accuracy ± 2 x 10 -9 *Output frequency 1 Hz - 10 MHz *Output pulse signal 1 kHz The MFC is designed to generate high-frequency pulse signals with a frequency of 1 kHz and a frequency in the range from 1 Hz to 10 MHz along two output lines. The MFC is designed to operate in measuring systems based on the VXIbus trunk. In the MFC, a rubidium frequency standard is used as a reference frequency source. Time to reach the mode when the power source of the rubidium standard is turned on, no more than 10 min

Product

Charge Coupled Device (CCD) Standard Image Sensors

-

Teledyne e2v

Teledyne e2v

Teledyne e2v is the leading supplier of scientific grade Charge Coupled Device (CCD) image sensors for the most challenging low light imaging and spectroscopy applications.

Product

Temperature Stabilized Resistance Standards

-

Measurements International Ltd.

Measurements International Ltd.

The temperature stabilized resistance standards offer customers the very best in accuracy, and stability. With 3 different models to choose from, covering the full range of resistance values.

Product

Redundant Reference Frequency Shaper

CH7-317

-

VREMYA-CH JS Company

CH7-317 - VREMYA-CH JS Company

Redundant reference frequency shaper Ch7-317 is designed to generate and reproduce frequency and time signals protected from frequency and phase failures based on the results of signal processing from a group of frequency and time keepers.

Product

Electrical Standards

-

Fluke Calibration

Fluke Calibration

To verify the performance of an electrical calibrator or dc calibrator, you need an electrical standard. Fluke Calibration standards are found in primary calibration laboratories across the world. A wide range of electrical standards and frequency standards are designed to meet the needs of today’s laboratories for traceability and quality accreditation while also being portable, simple to use, and easy to support. Electrical standards include: Voltage standards; ac/dc transfer standards; ac measurement standards; resistance standards; ratio standards; current shunts.

Product

(125×150×22mm) Single-Channel Full Function Standard Booster EDFA module

EATV5100-FM05

-

Hangzhou Huatai Optic Tech. Co., Ltd.

EATV5100-FM05 - Hangzhou Huatai Optic Tech. Co., Ltd.

The EATV5100-FM05 standard Booster EDFA module provides high power, high reliability, and superior optical performance in an industry standard form factor. This product enables deployment fo flexible, high-density optical networks, while reducing capital and operating applications' requirements. This module is ideal for today's highly dynamic networks and cost sensitive market. EATV5100-FM05 Full Function Booster EDFA Module adopts Standard Versions for Single Channel and Narrowband. The EDFA includes a cooling pump laser, input monitor and input isolator, output monitor and output isolator, and a reel of optimized erbium-doped fiber. These components are contained within a standard 125×150×22mm package.