Systems
are interconnected groups of purpose.
See Also: Equipment, Test Systems, System Integrators, System Test
-
product
IRIG Time Code Receiver for Computers (PCI Express)
TCR180PEX-EL
Meinberg Funkuhren GmbH & Co. KG
The TCR180PEX-EL receives IRIG-A/B/G, IEEE 1344, IEEE C37.118 or AFNOR NF S87-500 time codes and can be used for synchronizing the system time of its host PC. The IRIG output of this card can generate an IRIG signal for other IRIG time code readers. It is used in applications like data acquisition, standalone computer time synchronization (for systems without a network connection or higher accuracy requirements).
-
product
DDS Software
Vortex Data Distribution Service | DDS
ADLINK DDS is a ubiquitous data sharing software framework based on the open and proven DDS standard that supports a wide range of device technologies, operating systems and programming languages. Combining deterministic data delivery, system-wide data sharing and support for data analytics, ADLINK DDS helps system integrators, OEMs, device platform vendors and Cloud service providers (SaaS, PaaS and DaaS) deliver software solutions for many vertical markets, including: Aerospace and Defense, Energy, Robotics, Healthcare, Transportation / Automotive and Industrial Automation.
-
product
Universal Test System
LS6601A
LS6601A Universal Test System is based on LXI bus, primarily used for functional electronic product or system verification, test parameters. Because the system design is based on LXI bus structure, so its addition to general characteristics of versatility, scalability, but the architecture of the system more flexible, the test system is not limited to one or more cabinets, but may be needed test network and multiple LS6601A and can be easily grouped into one or more of the ground test system, depending on the test mechanism, form a powerful set of test, control, simulation, simulation, data management as one; distributed in different places .
-
product
Trace All Accessory - Inductive Coupler
CZ1803
The CZ1803 is an inductive antenna accessory used to put a signal on any pipe or cable without having to make direct connection to that pipe or cable. You can simply plug the Inductive Coupler into the transmitter and your signal will be transmitted onto your target pipe or cable. When used with the TraceAll locator system, this inductive coupler is suitable for locating all services such as data, electrical, television, telecommunications cables and gas and water pipes.
-
product
Polarity Indicator Circuit Tester
CT8007
No ground wire means no wire tangles nor time lost searching for grounding points. High Impedance electronic circuitry. Negligible current draw ( 1 microampere) is 30,000 times less than regular lamp type testers. This gives complete safety when working around sensitive electronic control modules and sensors. Operating range between 6 and 28 Volt DC in battery powered systems
-
product
Ultrastable Microwaves
Ultra-stable microwave sources are paramount for a broad range of applications, including precision metrology, deep space navigation, telecom and next generation wireless communication, as well as coherent radar. With the PMWG-1500 Menlo Systems offers a unique commercial solution for providing ultrastable microwaves in an all-in-one solution.
-
product
AFM for Heavy & Large Samples
Alphacen 300
Nanosurf is the market leader for custom developed systems for large and heavy samples. Over the past years our team has built a substantial knowledge base developing these custom stages for various customers.
-
product
Torque Metering System
Model TMS2200
Full capability of standard RDT2100 model with the addition of a Class I Division II certification of the system.
-
product
PCI High Density Potentiometer Card 9-Channel, 8-Bit, 0 To 255 Ohm
50-296A-121-9/8
The 50-296A series are Programmable Potentiometer versions of the 50-295A Programmable Resistor cards with up to 9-channels of 8-bit resolution resistor chains in a single PCI slot. The flexible architecture allows the card to also be supplied as 12-bit, 16-bit or 24-bit resolution versions for applications requiring finer resolution, greater resistance range or higher channel count. The card is ideal for simulating the sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.
-
product
PCI 48 Channel TTL Digital Interface
8005
The 8005 digital I/O interface provides 48 channels of buffered drive digital I/O emulating 8255 mode zero, which can be utilized for PC based control and automation of equipment including sensors, switches, security control systems, and other industrial automation systems. 10K pull-up resistors are included. Optional values are available.
-
product
PXI Precision Resistor Module 4-Channel, 2 to 26.7k
40-297-132
This 4-channel PXI Precision Resistor Module provides a simple solution for applications requiring accurate simulation of resistive sensors. The 40-297 series is available in a variety of resistance ranges and resolution capabilities that meet the needs of most functional test systems. It is particularly well suited to applications such as the testing of engine controllers where resistive sensors provide information on parameters such as temperature.
-
product
Electromagnetic Sounding System(TDEM)
WTEM-3Q
WTEM-3Q time-domain shallow transient electromagnetic sounding system is our latest equipment developed for magnetic survey by TEM method, which integrated with WTEM-1J/GPS TEM system receiver and WTEM-1X low-power TEM system transmitter.
-
product
DC/AC Current Probe 400A
697
Use this instrument to test starting and charging systems. It can even be used to test relative compression when used with your lab scope or graphing meter. Unit is designed for use with digital multimeters, lab scopes or graphing meters.
-
product
1 Mm Calibration Kit
85059B
The Keysight 85059B is a 1.0 mm calibration kit designed for vector network analyzer systems operating over the frequency range of DC to 120 GHz. The opens, shorts and loads in this kit are optimized to provide accurate and traceable calibrations over the specified frequency range. The 85059B with 85059V 1 mm Verification kit are replacements for the 85059A 1 mm calibration/verification kit.
-
product
Multiparameter Multichannel Analyzers
The open system technology concept is capable of accomodating future system expansion. Four systems can be operated to provide a max. of 64 input channels. For dependent single- and multiparameter acquisitions, coincidence resolving times can be set from approx. 150 ns to more than 3 ms in steps of 50 ns. The counting rate capabilities are matched only by our MPA4 Multiparameter System: With 7072 ADC''''s we have observed counting rates up to 4.8 Mevents/s. The theoretical limit is 6 Mevents/s.
-
product
PXI MUX 8 Banks of 8 Channel 2 Pole
40-610-022-8/8/2
This series of high density multiplexer modules feature a wide range of switching configurations, especially useful where a large number of small multiplexers are required. Typical applications include signal routing in ATE and data acquisition systems. Connections are made via a front panel 200-pin connector. Inter-bank linking relays allow multiplexer size to be increased in multiples of in multiples of three by joining the common terminals of adjacent banks. Closing one linking switch produces a 6-channel multiplexer, closing all linking switches produces an 54-channel multiplexer
-
product
Inline Beverage Analyzer
The inline beverage analysis systems are the result of more than 40 years of experience in inline and laboratory beverage analysis, based on thousands of samples covering the production of beer, wine, cider, FABs, juice, soft drinks, diet drinks, tea, and other beverages. Anton Paar is the leading manufacturer of inline beverage analyzers with custom-made solutions for all beverage applications, ready-to-use without time-consuming on-site adjustment. These beverage analyzers can be fully connect...show more -
product
Amplifiers
MMICs
RF core has been innovating GaN-based MMIC solutions for active phased array system pursuing more ease of use, higher performance, lower SWaP (Size, Weight, and Power) as well as lower cost. We aim at integrating all components of TRM front-end for active phased array on single die.
-
product
CEAST VisualMELT Software
VisualMELT Software is designed to control all the functions of the Modular Melt Flow Systems, from single-weight to multiple-weight tests. The software enables the user to manage all optional equipment, including the load cell, the automatic cutting device, and the motorized weight lifter. When working with a multi-weight tester, it is possible to set up and control single-weight or multi-weight tests, as well as define the order and number of weights to be applied.
-
product
Dynamic Gas Analyser
ExQ
The Hiden ExQ quantitative gas analyser is a new multi-featured and compact mass spectrometer system providing continuous on-line analysis of dynamic gas streams at pressures from sub-atmospheric up to 30 bar, the fully integrated system now being configurable both for benchtop and for rack-mounting operation. Connection to the process is via a flexible heated inert capillary line with a sample consumption rate less than 10 mL/minute and a response time of less than 300 milliseconds at pressures...show more -
product
Flight Line Armament Test System
SST
The Stores System Tester (SST) is a ruggedized flight line armament test system that enables real-time diagnostic analysis. U.S forces need to perform alternate mission equipment (AME) troubleshooting and diagnostic analysis on the flight line. BAE Systems' SST provides this capability in a one-person portable package.
-
product
Smart Power Stage
Renesas Smart Power Stage (SPS) modules have integrated high accuracy current and temperature monitors that can be fed back to the controller and doubler to complete a multiphase DC/DC system. They simplify design and increase performance by eliminating the DCR sensing network and associated thermal compensation.
-
product
Metallic Pendulum Impact Testing Machine
JB-S Series
Jinan Testing Equipment IE Corporation
JB-S series superior metallic pendulum impact testing system is strictly designed according to international standards ISO148, ASTM E23 and EN10045. The pendulum impact testing system is mainly used to determine the anti-impact capability of metal materials under dynamic load and is capable of doing a large number of of impact tests continuously. Adopting the important intelligent programmable logic controller (PLC) system, the pendulum impact testing system can realize the test process control ...show more -
product
sbRIO-9870, Non-Enclosed, 4-Port, RS232 C Series Serial Interface Module
780922-01
The sbRIO‑9870 adds RS232 serial ports to CompactRIO systems. The serial ports are accessed directly from the FPGA to offer you flexibility in communicating with serial devices. The module has individual buffers on every port that save FPGA space and simplify programming. The sbRIO‑9870 supports standard start bit, stop bit, and handshaking settings. It uses an external power to provide maximum compatibility and reliability under all serial port conditions. Non-enclosed modules are designed for OEM applications.
-
product
SINE M-13-60 Sinusoidal Array
The Sinusoidal Array SINE M-13-60 is designed to be used for evaluating systems that work in the reflective mode such as scanners, machine vision systems and cameras. It is imaged on Photo Paper in four different sizes getting larger from 1X – 8X. The ½X and 1X slides incorporate the same spatial frequencies. Spatial frequencies for the 2X, 4X and 8X versions are 1/2, 1/4 and 1/8 respectively.
-
product
Signal Conditioners
Omega's modular signal conditioners provide a low-cost, high-performance method of inter-connecting real-world analog signals with data acquisition, monitoring, or control systems.
-
product
LXI Microwave Multiplexer, SP6T, 12-Bank, 40GHz, 50Ω, SMA-2.92, Terminated
60-800-512
Our 60-800-512 is a 12 bank terminated SP6T multiplexer and is part of a range of LXI based microwave multiplexers suitable for switching 50 ohm signals up to 40GHz. The 60-800 range is capable of supporting up to 14 banks of 6 channel terminated multiplexers and is ideal for constructing complex microwave switching systems for many applications. Connection is by high performance front panel mounted SMA, SMA-2.9, SMA-2.4 or SMA-1.85 connectors.
-
product
Portable Photosynthesis System
LI-6800
The LI-6800 Portable Photosynthesis System simultaneously measures photosynthetic gas exchange and chlorophyll a fluorescence over the same area in plants and aquatic samples, revealing additional insights into photobiology. Highly extendable, it is capable of measuring gas exchange from soil, insects, and many other sample types for countless experiments.
-
product
PXI 8 Slot BRIC 198x8 1-Pole (9 sub-cards)
40-562A-121-198X8
This version of our BRIC is part of a range of high-density PXI matrix modules. These modules are available in 2, 4 or 8-slot PXI sizes to suit all high performance matrix requirements and are constructed using instrumentation quality reed relays. With this high level of switching density, these PXI matrix modules allow a complete Functional ATE system to be housed in a single 3U PXI chassis. These BRIC matrix modules allow the use of lower cost 8 or 14-slot PXI chassis.
-
product
Fuel Injection Pressure Tester with Quick Couplers
53900
Quick couplers provide for fast and easy hook-up. Kit contains adapters to test all GM vehicles with Multi-port and some Throttle Body Injection (TBI). Tests all Chrysler cars with Multi-port turbos and some TBI. Use on Ford older TBI systems not equipped with small Schrader test valve. Includes Large Gage with hang-up hook calibrated from 1-100 PSI (0-7.0 BAR). Supplied with instructions in a vinyl pouch.
