CompactPCI Chassis
A metal frame that serves as the structural support for a CompactPCI bus. (sbc.webopedia.com)
-
Product
550 HP Water Brake Chassis Dynamometer
CM-51S
-
AC power, air and water required at one side wallas applicable.• Room length, and pit location within length,must be determined by user to fit maximumtruck length and rear overhang.• Provide at least one man door for fire escapenear rear of room, but not in rear wall becausesomeone entering during a test could be struckby a stone flung from a tire. Provide ample fireextinguishers at each door and near driver.• “Back-on, Drive-off” installation configurationpreferred.
-
Product
LXI/USB 12-Slot Modular Chassis With Scan List Sequencing & Triggering
60-107-002
Chassis
Our 60-107-002 modular LXI/USB chassis occupies only a small, 2U rack-height form factor, making it suitable for portable and space-restricted rack-mount applications. It features remote control via USB or LXI Ethernet. Remote control over a network enables the switching function of a test system to be located as close as possible to the target equipment, allowing for optimal performance.
-
Product
MIL-STD-1553 CompactPCI Interface Card
CPCIC3/6-1553-PXI
Interface Card
The CPCIC-1553/PXI Interface Card and AltaAPI Represent the Latest MIL-STD-1553 32-bit FPGA Protocol Engine Technology with Multi-Layer Software. Our Card and Software Packages are Designed for Fast, Portable Integrations. The CPCIC-1553 is the Only Commercial Off the Shelf (COTS) Card that Passes and Executes the SAE AS4111/4112 Protocol Tests.
-
Product
CompactPCI 6U 16 slot P1-2s, P3-5l, 2 x P47
103CPCI616-7157
-
CompactPCI 6U 16 slot 64 bit Easyplug with 2 x P47 power connector, system slot right, fully compliant to the PICMG basic specification 2.0 R3.0 and Hot Swap specification 2.1 R1.0.
-
Product
Electronical Load Board 6U CompactPCI (air cooled)
056-169
-
The 6U load boards are designed to simulate the power consumption of a single board computer and other boards on the backplane.
-
Product
3U CompactPCI Serial 5-slot SSL w/ RTM w/ Ethernet
1CPCIS-305-L210
-
3U CompactPCI Serial Backplane with 5 CompactPCI S.0 slots, system slot left, with rear IO : 1x CompactPCI S.0 CPU slot, 4x CompactPCI S.0 peripheral slots, with connectors for RTMs (RearTransition Modules) in slots 2 to 5, Ethernet full mesh.
-
Product
LXI/USB Modular Chassis
Chassis
For applications requiring diverse switching functions but preferring an LXI interface, look no further than our LXI/USB modular chassis. These chassis are capable of hosting our extensive range of 3U PXI switching and simulation modules in an LXI environment, allowing remote control over a gigabit Ethernet connection. Additionally, our LXI/USB Chassis support up to 18 PXI modules and can be controlled via USB or Ethernet.
-
Product
3U CompactPCI Serial 7-slot SSR w/ RTM w/ Ethernet
1CPCIS-307-R110
-
3U CompactPCI Serial Backplane with 7 CompactPCI S.0 slots, system slot right, with rear IO: 1x CompactPCI S.0 CPU slot, 6x CompactPCI S.0 peripheral slots, with connectors for RTMs, Ethernet single star from system slot to all peripheral slots.
-
Product
3U CompactPCI Quad-Core Intel Atom® Processor Blade
cPCI-3620
Processor Blade
The ADLINK cPCI-3620 Series is a 3U CompactPCI® processor blade featuring a quad-core 4th generation Intel® Atom SOC and soldered DDR3L-1333 ECC memory up to 4GB.
-
Product
Chassis Position Sensors
-
Chassis height sensing is a specific application of CTS' rotary sensor technology. Chassis height sensors measure the position of the control arms relative to the frame or body of the vehicle. This information is used in systems such as headlight leveling and real-time-dampening. Key features of the CTS' chassis height sensors is the ability to mount in a variety of angles and projections to accommodate difficult packaging as well as robust sealing required for under chassis applications. With a global team of application engineers, CTS can package one of our generic, tooled for sales sensors or develop a custom product, unique for your application.
-
Product
Chassis Mount Kit for PXIT 2000-514A/B, 14 Slot
310113374
Mounting Kit
The Chassis Mount Kit allows you to mount the Vertical Hinged Mounting Frame to a chassis. The row of mounting holes allow for adjustability.
-
Product
3U CompactPCI 2-slot SSL 33MHz VIO 3.3V BW 64-Bit
80932-302-6600
-
3U CompactPCI Backplane 2-slot, PICMG 2.0 R3.0, system slot left, supports full hot swap function according to PICMG 2.1 R2.0, clock frequency 33MHz, V(I/O) +3.3V, bus width 64-bit, power input connection with Fastons connectors
-
Product
4U 20-slot Extended Rackmount Chassis
AX61492
-
*Three 5.25" and two 3.5" HDD drive bays*Three 12 cm hot-swap ball-bearing fans*Supports 20-slot backplane*Hot-swap redundant or PS/2 power supply supported
-
Product
CompactPCI 6U 64 bit ATX 5 slot, P1s no P2-5, RoHS
102CPCI605-41XXR
-
CompactPCI 6U 5 slot 64 bit low Easycable, system slot left, with ATX connector. It is fully compliant to the PICMG basic specification 2.0 R3.0 and Hot Swap specification 2.1 R1.0.
-
Product
Chassis Mount / Open Frame AC-DC Power Supplies
-
Chassis Mount / Open Frame AC-DC Power Supplies
-
Product
3U CompactPCI 32-Bit 13-Slot Backplane with Rear I/O
cBP-3213PR
Backplane
- PICMG 2.0 CompactPCI Specification Rev. 3.0 compliant- One system slot and twelve peripheral slots via cBP-*R3213 bridge boar- 10-layer PCB for accurate impedance control and electronic noise immunity- Two ATX sockets with DC screw terminals
-
Product
AXIe Chassis and Controllers
-
AXIe is a new open standard for high-performance, modular instrumentation, and incorporates the best features of other modular formats including VXIbus, LXI and PXI. Keysight has designed a new line of scalable chassis in this new format. Along with controller options, these new AXIe chassis will form the basis of a high-performance, AXIe-based test system.
-
Product
ARINC 3U/6U CompactPCI Interface Card
CPCIC3/6-A429
Interface Card
Alta Data Technologies’ CPCIC-A429 interface module offer a variety of ARINC-419/429/575/573/717 channel configurations with software selectable RX/Tx channels, baud rates, bit encoding and word configurations (Start/Sync/Stop length, Parity, bits/word, MSB/LSB).Encode or decode almost any ARINC-429 physical layer signal.
-
Product
Mounting Flange Kit, G20/G20X, f/ NI PXI-1095 and PXIe-1084 Chassis
310113760
Mounting Kit
Mounting Flange Kit, G20/G20X Slide Mount, 6.75" Series Adapters, for NI PXI-1095 Chassis and NI PXIe-1084 Chassis
-
Product
M-Module Carrier for CompactPCI (3U)
i3002
-
The i3002 provides a high-performance CompactPCI bus gateway to the M-module interface. The i3002 has a 3U form factor. Two M-modules can be mounted on the i3002. The M-module interface of the i3002 complies with the M-module specification. The M-module interface feature A8, A24, D16 and D32 access types.
-
Product
PCI Express® Bus To 3U PXI Express™ Chassis Expansion Kit
ACL-EXPRESS-3
-
The PCIe-to-PXIe expansion kit includes one PCIe-8560, one PXIe- 8565, and one ACL-EXPRESS cable (3 meters).
-
Product
6U CompactPCI 9th/8th Gen Intel® Core™ I3/i5/i7 Processor Blade
cPCI-6640 Series
Processor Blade
The ADLINK cPCI-6640 is a 6U CompactPCI® processor blade featuring an 8th/9th Gen Intel® Core™ (formerly Coffee Lake-H) with Mobile Intel® CM246 Chipset. Dual SO-DIMM slots provide up to 64GB of DDR4-2666 dual-channel memory (2x 32GB modules). ECC memory is also available when paired with a supporting CPU.
-
Product
CompactPCI Serial, 5 Slots, SSR, 4U, 35HP, 290mm
435V0-E05R-25FA1-000
-
CompactPCI Serial System with 5 Slots: 4x CompactPCI-S.0 Peripheral Slots and 1x CompactPCI-S.0. System Slot on the right side of the system platform. 1x 250W ATX, air-cooled with fan fix-mounted and powder coated.
-
Product
4U Rackmount Chassis
Chassis
4U rackmount chassis is a cost-effective computer chassis featuring a complete line of backplanes, power and storage device options. The 4U computer chassis provide the best support for various wallmount and rackmount system.
-
Product
L-Frame, CompactPCI Serial, 5 Slots, SSR, 6U, 32HP, 299mm
632V0-E05R-50FA1-000
-
CompactPCI Serial System Type L-Frame with 5 Slots: 4x CompactPCI-S.0 Peripheral Slots and 1x CompactPCI-S.0. 1x 550W ATX, air-cooled with fan fix-mounted.Vertical backplanes and have a 160mm card cage in the front and a 80mm rear I/O.
-
Product
LS-28-1U Chassis Cable Assembly Set
28U-CBLSET
-
Cable assembly set for LS-28-DRSM 1U Rack Mount Unit
-
Product
10U cPCI Chassis
DP-cPCI-8010
-
DP-cPCI-8010 is a Compact high performance, high reliablity 10U cPCI chassis. The DP-cPCI-8010 provides user the right platform options to meet the system integration needs. The chassis is complied with the features defined by the Compact PCI specifications, including rugged features, modular construction, integrated cooling and EMI-EMC protection. The DP-cPCI-8010 is available with high performance 4 - 21 cPCI slot backplane and with various power supply configurations.
-
Product
Receiver, G20, Slide Mount, with Mounting Flanges for Pickering Chassis
310120143
Receiver
Receiver, G20, Slide Mount, with Mounting Flanges for Pickering Chassis (40-908, 40-914, 40-918)
-
Product
Chassis Controllers and Bus Expanders
-
With over 20 different chassis configurations, our Smart PXI chassis product line (3U chassis, 6U chassis, 3U/6U chassis) offers the most features, slot configurations, UUT interface options, system power, and embedded / external controller options in the industry.
-
Product
PXI Chassis And Remote Controllers
-
We offer both PXI & PXIe chassis and controllers that support all of our PXI switching and simulation modules as well as those from third parties. There is a choice of up to 21-slot 3U chassis with options to reduce acoustic noise and modules that can be powered from a DC source.
