Filter Results By:

Products

Applications

Manufacturers

Power

a measure of watts in electricity and radiant energy in optics.

See Also: Power Quality


Showing results: 9691 - 9705 of 10964 items found.

  • PXI 2.5W Programmable Resistor Module, 8-Channel, 1Ω to 122Ω

    40-251-012 - Pickering Interfaces Ltd.

    The 40-251-012 is a programmable resistor module with 8 channels which can be set between 1Ω and 122Ω with 0.5Ω resolution The 40-251 range provides a simple solution for applications requiring up to 2.5W of power handling per channel. The 40-251 is available in a variety of resistance ranges and resolution capabilities that meet the needs of most functional test systems. Each channel is able to simulate short or open circuit conditions that can be experienced in a system caused by faulty wiring or sensors.

  • Laser Pulse Shaper

    MIIPS-HD - Biophotonics Solutions Inc.

    MIIPS-HD is the first line of pulse shapers on the market that relies on a Hamamatsu''s 2D (792×600 pixels) liquid crystal on silicon-spatial light modulator (LCOS-SLM), and uses diffractive shaping to enable independent phase and amplitude control, without using a polarizer. The system features enhanced power (pulse energy) handling capabilities and offers superior throughput for selected spectral ranges by utilizing SLMs with dielectric back mirrors. It is ideal for direct amplified pulse compression and shaping.

  • Encrypted, Dual IF/L-Band Satellite Modem

    QFlex-400™ Encryption - Teledyne Paradise Datacom

    Our Flagship QFlex-400 Encryption software defined Satellite Modem is our highest data rate Modem to date. The unit supports data rates to 345Mbps and has AES 256 Encryption capability as standard, along with an extended L-band frequency range, better RF performance, improved carrier cancellation with paired carrier+, higher processingcapability allowing for future upgrades and yet, is smaller and lighter than its predecessors and has the lowest power consumption to date.

  • Model Vector Network Analyzer

    DZV-1 - Digital Signal Technology, Inc.

    DZV-1 is the vector network analyzer which can be measured the impedance and VSWR of the antenna, S Parameter of RF component and devices. It is small and low-priced. So, it is suitable for the production line, laboratory use, various testing applications, and the educational use. The communication between the DZV-1 unit and PC is done via USB, which is also used for power supply. The LOG-MAG characteristic, the phase-characteristic, the group delay frequency characteristics, the Smith chart, the polar coordinates, the SWR characteristic can be displayed on PC.

  • IRD

    SFT356x - Hangzhou Softel Optic Co., Ltd.

    SFT356X SD IRD is DEXIN’s all-in-one device which integrates demodulation, de-scrambler and decoding (DVB-C, T/T2, S/S2 optional) in one case to convert RF signals into analogue video (CVBS) output. It is a 1-U case which supports 2 tuner inputs. The two CAMs/CIs accompanied can descramble the programs input from encrypted RF, ASI and IP. The CAM requires NO unsightly external power cords, cables, or additional remote control device.

  • Wireless Gateways

    Networked Communication Solutions, LLC

    The Wi-In™ USB gateway from Networked Communications Solutions allows your NCS Wi-In™ wireless sensors to communicate with the NCS Wi-In™ Online Wireless Sensor Monitoring and Notification System. Instantly connect with our online servers by plugging the device into any computer with an internet connection. Our Windows compatible USB gateway supports up to 100 sensors per USB wireless gateway. No additional power is needed. A PC is required.

  • Satellite Optical Transmitter

    SST-15CW - Hangzhou Softel Optic Co., Ltd.

    * Designed for satellite optical system*Wide operating frequency range: 47-2150MHz*Excellent linearity and flatness*Using 1-core single-mode fiber, high return loss*Build-in CWDM, using DFB coaxial small package laser*Output 13/18V, 0/22KHz to LNB working*ALNB mode switch offers the possibility to use either Quattro or QUAD LNB*A distribution of up to 16 optical nodes is possible*Red-LED for power indication*Smaller size and easier installation

  • TTL/I2C/SPI* Expansion Kit

    OP-SB5GL - LINEEYE Co., Ltd.

    OP-SB5GL is the interface expansion kit that has a port to measure RS-232C(V.24) and a port to measure the TTL / CMOS signal level communications. The port for TTL / CMOS supports the measurement of TTL / CMOS level communications that power supply system is from 1.8V to 5V. It is suitable for monitoring the communications between the LSI and the interface IC on the printed circuit board by directly probing into the lines. It supports the protocol of not only UART and HDLC but also I2C and SPI* on monitoring and simulating.

  • Ultrasound Pulser ICs And HV Multiplexers

    STMicroelectronics

    ST's Ultrasound Imaging IC Solutions offer a complete range of integrated high-voltage transmitters from quad and octal, to the latest device, the state-of-the art STHV1600 ultrasound pulser IC,  to high-voltage multiplexer IC, the STHV64SW, a 64-channel, high voltage analog independent switches. ST’s proprietary BCD6s-SOI and BCD8sSOI process technologies enable the combination of low-voltage CMOS logic, precise analog circuitry, and robust power stages on the same chip, offering unprecedented level of integration.

  • Wireless Data Logger

    EVA100 - Advantest Corp.

    The new highly integrated measurement system "EVA100" is supporting Power Supplies, SMU( 4 quadrant DC Signal Measurement Units ), Pattern Generators, Arbitrary Waveform Generators, Digitizers and Oscilloscopes necessary for complete analog / mixed-signal / sensor / digital IC devices and Modules including Electronic Control Unit (ECU) for automotive evaluation and measurement.This new measurement system allows engineers quickly to build their own measurement environment without combining several standalone instruments.

  • 32 Channel Driver

    Spectronix

    The MultiChannel RF Driver is a 32 channel signal generator / amplifier intended to drive multchannel acousto-optic cells such as the Harris H-601.  The driver can be operated either as an RF amplifier, providing 32dB of gain or as a high power signal generator making use of a dedicated 1GSPS, 14bit digital synthesizer on each channel.  Modulation can be performed through the use of the internal source, external global input, external individual input, or programmable 16K sample RAM lookup table.

  • Surge Generator

    CFL SG 3220 - Scope T&M Pvt, Ltd.

    SCOPE offers CFL SG 3220, Surge Generator with output of 32kV and 2000 Joules. It is ideal choice for fault location on all types of power cables from LV to EHV. CFL SG Series is equipped with different Protections, Interlocks and Auto-discharge Facility to ensure User Safety during operation. User Friendly controls, adequate form factor, contact free HV terminations makes this CFL SG Series most durable and best-designed sets in the segment.

  • High Voltage Test Set

    Hi-Pot Series - Scope T&M Pvt, Ltd.

    SCOPE introduces a high voltage test set, these high voltage testing sets comes with Power frequency AC high voltage /DC high Voltage test /AC-DC high Voltage test set for testing transformers, motors, insulators, cables etc. Further, these testing sets are capable of giving continuously variable HIGH VOLTAGE from zero to maximum rated output voltage. Wide range of up to 100 kV is available in user selectable combinations.

  • Low Noise Op Amplifiers (≤ 10nV/√Hz)

    Analog Devices Inc.

    Analog Devices’ portfolio of low noise (≤ 10nV/√Hz) op amps includes many amps with the lowest noise performance in the industry. These high speed, low distortion (1 nV or less) op amps enable better signal fidelity in the most demanding conditions, allowing system designers to achieve the lowest total system noise performance in applications with high source impedances. We feature a considerable variety of these amps with wide supply ranges and low power.

  • RS-232 and RS-562 Transceivers

    Analog Devices Inc.

    Analog Devices offers single, dual, and combination transceivers of up to five RS-232/RS-562 drivers and receivers for 1.8 V to 5.5 V power supplies. Data terminal equipment (DTE) or data communications equipment (DCE) configurations are also available in 3.3 V or 5 V versions. Galvanically isolated modules break ground loops and provide a convenient, self-powered, isolated, low EMI solution that drastically reduces component count and design complexity.

Get Help