Showing results: 9421 - 9435 of 10972 items found.
-
MT-1705 -
Prokit's Industries Co., Ltd.
1/2 digits 1999 counts.0.5% best accuracy.CAT III 600V safety rated.Auto polarity indication.AC True-RMS for accurate measurements.Large backlight LCD display for easy reading.Extra Functions: Continuity with beeper, Diode test, Data hold, Auto power off, Low battery indication, Overload indication, LCD backlight,Frequency and Capacitance are auto rangeIdeal for wide variety of electrical and electronic testing applications.
-
GT4000 -
Guide Technology, Inc.
A true breakthrough in high-speed, asynchronous and serial interface test technology the GuideTech GT4000 leverages the power of CTIA continuous time-stamping technology to eliminate the need for supplemental triggers, pattern markers or clock recovery circuits. GuideTech CTIAs enable serial interface pattern verification and full jitter analysis in milliseconds for fast, automated characterization or high-throughput production test on any ATE platform, including low-cost and in-house testers.
-
Extech UV510 -
Extech Instruments Corporation
The Extech UV510 UV light meter measures UVA light radiation from natural and artificial light sources. It offers a backlit dual display, cosine corrected sensor, two selectable ranges, zero function, min/max recording, display hold, and auto power off. Compact size with handy wrist strap gives you convenience in taking quick UV reading wherever you go.
-
Precision Development Consulting Inc
Hand control module for teleprompter, Analog data acquisition and filtering, High-Power Arc Lamp Power Supply Controller and RTP gas flow and Vacuum System controller, Disk drive company test racks, Disk Drive Spindle Motor Tester, Disk Drive Head Stack Tester, Wafer photoresist coating and development system control PC boards, Nuclear Plant secondary water temperature monitor
-
D1 -
Virginia Panel Corporation
iDock Series connectors are a mass interconnect for use with automatic machine handlers. As VPC's most compact design, the D1 is compatible with a variety of hybrid I/O modules that include: power, coax, signal, vacuum, pneumatic, and high speed digital. Despite its compact size, the D1 can engage up to 160 signal contacts simultaneously. The iDock Series connectors are compatible with VPC's existing line of modules, contacts, and tools.
-
18534PS1 -
Carl E. Holmes Company
Input power is 380 VAC, 3 PH, 50 Hz, P/N 18534PS1Output is 0 to 250 VDC, 200 Amp max.Variable Transformer is used to vary the output. SCR controller is not used, as it generates harmonics.Input control is 0 to 3.6 VDCIndoor enclosure, 50"H x 46"W x 36"DOutput voltage and current feedback as 4/20 mA for PLC interface.All input/output connections are inside the enclosure
-
bsw TestSystems & Consulting AG
Up To 1.5THz For Network Analyzers Modern communication standards, like for instance 5G, place high demands on components (mixers, amplifiers, antennas, etc.), which have to be examined in high frequency bands (millimeter waves); the requirements include: broad frequency coverage, sufficient output power to operate the components under compression, high dynamic range and stability as well as a reduced dynamic content within the spectrum.
-
AUTO DIAGNOSTECH LTD
Our innovative multi-function Electrical Component Testers have advanced functions such as voltage power control feed to activate components like radiator fan, headlights, horn, actuators, etc. and the sensor simulator can provide simulation of voltage signals, frequencies, square waves & duty signals with varying intensity to test the feasibility of good sensor signals in comparison to bad ones when troubleshooting vehicle electrical faults.
-
PWC200 -
Rohde & Schwarz GmbH & Co. KG
The R&S®PWC200 Plane Wave Converter is a bidirectional array of 156 wideband Vivaldi antennas placed in the radiating near field of the device under test (DUT). The phased antenna array can form planar waves inside a specified quiet zone within the radiating near field of the 5G massive MIMO base station for realtime radiated power and transceiver measurements (EVM, ACLR, SEM, etc.).
-
Model 51 -
Patton Electronics Co.
The Patton Model 51 DB-9 PockeTester™ monitors the seven most important async EIA-574 (RS-232 on a DB-9) data and control lines. The Model 51 uses seven tri-state LEDs to indicate the presence of the following signals: TD, RD, DTR, DSR, RTS, CTS and DCD. A red light = Mark, a green light = Space and no light indicates no signal on the line. No AC power or batteries required.
-
Extech 392050 -
Extech Instruments Corporation
The 392050 is a Penetration Stem Dial Thermometer that has a temperature range of-58 to 302 Degrees F (-50 to 150°C) and an accuracy of +/-2 Degrees F. Ideal for use in liquids, semi-solids, and solids. It features a 5-Inch stainless steel shaft with a 2-Inch dial, an On/Off switch, and Auto power off after an hour. Meter includes 1.5V battery button and protective plastic sheath with pocket clip.
-
NEO TELE-TRONIX PVT. LTD
Highly experienced in this industry, we are a well recognized manufacturer and exporter of Time Interval Meter. Supplied to electrical, power and engineering industry for instrument transformer and switchgear testing, this instrument is available to clients in different technical specifications. We use certified quality raw materials and components, procured from trusted vendor in market. We offer this Time Interval Meter (1 & 3 Channel) to clients at competitive price.
-
NEO TELE-TRONIX PVT. LTD
Fully equipped with latest machines and tools, we are a prominent manufacturer and exporter of Transformer Winding Resistance Meter. The meter is used in electrical, power generation and engineering sector for testing transformers. Available in different models, this testing equipment is in strict tandem with industry standards. We use best grade raw materials to manufacture this Transformer Winding Resistance Meter. We offer this resistance meter to clients at economical price.
-
Uprog -
RK-System
Uprog is universal device programmers family. It uses LPT parallel port or USB for communication with PC.Graphical interface of Uprog software is very confortable in usage for programming and testing tasks. Uprog programmers have 100% universal programming socket. They allow to put independly on any pin programming voltage (0-30V), power supply (1.8-8V), ground or clock, so this flexibility allow Uprog programmers to handle any device.
-
Model 2635 -
DIT-MCO International
The perfect tester for field use is rugged, mobile, and lightweight, without sacrificing the functionality and power of a larger system. That tester is found in the Model 2635. Weighing 32 pounds (14.5 kg), this wiring analyzer handles up to 400 test points of Series 10 switching per unit. The 2635 can be powered from any AC source 100-240 VAC or 28 VDC so you can use it anywhere in the world.