Product

Light Section Sensors

-

Leuze electronic GmbH + Co. KG

Leuze electronic GmbH + Co. KG

Switching light section sensors are designed to perform scanning, two-dimensional object detection along a laser line. They are especially well suited for completeness monitoring or product monitoring in the case of multiple track transport. The short measurement time and the detection range from 200 to 800 mm enable an inspection of the content at a high throughput rate even with deep containers. The internal data processing offers programming and differentiation of 16 different object types, thereby conserving control capacity. Complex detection tasks can be solved with one sensor. The compact housing ensures high flexibility during installation and saves installation space.

Product

Light I-V Testing for Solar Cells

FCT-650

-

Sinton Instruments

FCT-650 - Sinton Instruments

Advanced analysis of solar cells including light I-V and Suns-Voc data.

Product

Light Meter

PLMT56

-

Pyle Audio Inc.

PLMT56 - Pyle Audio Inc.

Light Meter Measures In LuxOver-Range IndicatorLong-Life Silicon Photo Diode InsideMeasurement Rate: 1.5 Times per SecondMax Range: 50,000 LuxAccuracy: +/- 5% Under 10000 Lux, +/- 10% Over 10000 LuxMax Resolution: 0.1 LuxDimensions: 7.40' H x 2.52' W x 0.96' DAccessories Included: 12V A23 Battery, Photo DetectorSold as : Unit

Product

Multiple Light Beam Safety Devices

-

Leuze electronic GmbH + Co. KG

Leuze electronic GmbH + Co. KG

The multiple light beam safety devices of the MLD 300 (type 2) and MLD 500 (type 4) series are used for access guarding at machines and systems. The devices are available as 2-, 3- and 4-beam transmitter-receiver systems for large operating ranges up to 70 m and as cost-efficient 2- and 3-beam transceiver systems for operating ranges up to 8 m.

Product

LED Phosphorescence Light Sources

SpectraLED

-

HORIBA, Ltd.

SpectraLED - HORIBA, Ltd.

Innovative and affordable pulsed light source for phosphorescence measurements from deep UV to NIRThe SpectraLED is a novel light source designed specifically for the measurement of phosphorescence lifetimes. These phosphorescence sources are based on LED technology and the emission wavelengths range from the deep UV to the NIR.

Product

Bench-Top Type ASE Light Source

-

FiberLabs Inc.

FiberLabs Inc.

ASE(Amplified Spontaneous Emission) light sources are low-coherent light sources ,which combines the both features of high intensity like laser and broad spectrum like LED. Output stability is greater than those of LD and LED, and therefore they are suitable for high accuracy measurement applications. With the use of rare-earth-doped fluoride fibers, the plentiful lineup of FiberLabs light sources includes the 540 nm-, 850 nm-, 1300 nm-, 1480 nm- and SCL-bands that other companies do not provide.They are the best light sources for FBG sensors, OCT, fiber optic gyroscopes, gas sensors, and fluorescence excitation, as well as for measurement of optical components. The bench-top type is easy to use as a stand-alone light source and the modular type is convenient for integration into equipments.

Product

Light / Lux Meter, 100000 lx, 100 lx, 5 %, 180 mm, 72 mm, 32 mm

72-6693

-

Tenma

72-6693 - Tenma

The Tenma 72-6693 is a high accuracy Illuminance meter. Featuring a dual function display, this meter can record both maximum, minimum and average readings. User selectable lighting types of tungsten/sun, fluorescent, sodium and mercury.

Product

Fiber Optic Light Sources

-

Fiberinthebox

Fiberinthebox

Fiber optic light sources are a necessity for performing optical fiber network testing to measure the optical fiberal loss for both single mode fiber cable and multimode fiber cables. They are designed to cover a variety of wavelength ranges to suit all optical testing needs and usually the optical light sources are used with the optical fiber power meter to test the fiber system loss. Light sources are offered in a variety of types including LED, halogen and laser. Usually the optical light source is used with the optical fiber power meters, they act as an economic and efficient solution for the optical fiber network works.

Product

Light Measurement Sensors

-

Gamma Scientific Inc.

Gamma Scientific Inc.

Gamma Scientific offers a catalog of professional light intensity measurement devices for photometric and radiometric applications. These devices are typically utilized by laboratories, OEM’s, value-added resellers and other groups seeking to accurately measure light intensity and brightness. Browse our light intensity measurement device catalogs to find the right photometry or radiometry solution today.

Product

Optical Light Sources

FLS200 Series

-

Shanghai Tarluz Telecom Tech Co., LTD

FLS200 Series - Shanghai Tarluz Telecom Tech Co., LTD

FLS200 Optical Light source could provide maximum 4 wavelengths in one unit, customer could select arbitrary four output wavelengths from 650nm, 850nm, 1300nm, 1310nm, 1490nm, 1550nm. The unit support Single mode and Multimode (50/125um or 62.5/125um MM fiber) optical cable in one unit. It could support FC, SC, ST, LC and 2.5mm universal optical connector.

Product

Light Meters

LXP-2

-

Sonel S.A.

LXP-2 - Sonel S.A.

The digital light meter is a precision instrument used to measure illuminance (Lux, footcandle) in the field. It is meet CIE photopic spectral response. It is fully cosine corrected for the angular incidence of light. The illuminance meter is compact, tough and easy to handle owing to its construction. The light sensitive component used in the meter is a very stable, long-life silicon photo diode and spectral response filter.

Product

Ambient Light Sensors

-

ams-OSRAM AG

ams-OSRAM AG

The Ambient Light Sensor (ALS) products from ams provide measurements of ambient light intensity which match the human eye’s response to light under a variety of lighting conditions. Each device has a specific operating range of performance, from very low light up to bright sunlight. High sensitivity coupled with wide dynamic range make these ALS products ideal for operation behind dark inked glass. They enable consumer electronics device manufacturers to implement display dimming and brightness control functions, helping to reduce power consumption and extend battery run-time.

Product

Serial FPDP Extreme 1/2 ATR Recorder

Talon RTX 2596

-

Mercury

Talon RTX 2596 - Mercury

- Rugged 1/2 ATR MIL-spec chassis for harsh mechanical and thermal environments- Environmentally sealed, conduction-cooled- Fully sealed for RF emissions with EMI power line filter- MIL-STD circular connectors- Compact and lightweight design - 18 lb (8 kg)- QuickPac® drive packs allow quick removal of all data storage up to 61 TB via the front panel- Ideal for UAVs, military vehicles, aircraft pods and outdoor environments- Four-channel Serial FPDP record/playback- Supports Flow Control, CRC, and Copy/Loop Mode as a receiver and transmitter- Supports 1.0625, 2.125, 2.5, 3.125 and 4.25 GBaud link rates- Single-mode and multi-mode fiber interfaces available- Sustained real-time record rates up to 4 GB/s- 12 to 28 VDC power supply- Optional GPS receiver for precise time and position stamping- SystemFlow API, GUI and Signal Viewer analysis tools- Optional telnet remote connection to recorder

Product

LED Lighting Drivers

-

Renesas Electronics Corp.

Renesas Electronics Corp.

Renesas' dimmable AC mains LED driver with PFC and primary side regulation provides all of the features required for high-performance dimmable LED ballast designs and supports AC or DC input, isolated or non-isolated flyback and boost topologies.

Product

Portable Spectrophotometers For Light Transmission

-

Gigahertz-Optik GmbH

Gigahertz-Optik GmbH

Portable and benchtop spectrophotometers for measuring light transmission in the full visible range in-situ. Due to the innovative approach of mutual correction, these measurements are also possible in ambient light.

Product

Light Section Sensors for Object Detection

-

Leuze electronic GmbH + Co. KG

Leuze electronic GmbH + Co. KG

Switching light section sensors are designed to perform scanning, two-dimensional object detection along a laser line. They are especially well suited for completeness monitoring or product monitoring in the case of multiple track transport. The short measurement time and the detection range from 200 to 800 mm enable an inspection of the content at a high throughput rate even with deep containers. The internal data processing offers programming and differentiation of 16 different object types, thereby conserving control capacity. Complex detection tasks can be solved with one sensor. The compact housing ensures high flexibility during installation and saves installation space.

Product

Fiber Optic Light Source

-

Fiberstore

Fiberstore

Fiber Optic Light Source.

Product

Aircraft Lighting And Safety Solutions

-

Astronics Corporation

Astronics Corporation

Whether it’s VIP seat lighting, backlit cockpit displays, emergency lighting, or external enhanced vision equipment, Astronics technologies improve the experience and safety of your passengers and crew.

Product

Low Light Imagers for Defense

-

Teledyne e2v

Teledyne e2v

Teledyne Imaging addresses low light imaging applications with a range of standard CMOS and EMCCD image sensors suitable for defense and security surveillance systems, whether for battlefield, vehicle, airborne, CCTV or security day camera’s.

Product

Light Sources & Calibration Standards

-

Photometric Solutions International Pty Ltd

Photometric Solutions International Pty Ltd

We offer a range of specialised and customised light sources for various applications.The spectral range goes from 200 nm to 40 µm.

Product

Three-Pole Lighting And Surge Arrestor

PIVM12,5-275/3+0 Vseries

-

HAKEL Ltd.

PIVM12,5-275/3+0 Vseries - HAKEL Ltd.

PIVM12,5-275/3+0 Vseries is a three-pole lightning and surge arrester Type 1+2 according to EN 61643-11 and IEC 61643-11. These arresters are recommended for use in the Lightning Protection Zones Concept at the boundaries of LPZ 0 – 1 (according to IEC 1312-1 and EN 62305), where they provide the equipotential bonding and discharge of both, the lightning current and the switching surge, which are generated in power supply systems entering the building. The use of the lightning current arresters PIVM12,5-275/3+0 Vseries is mainly in the power supply lines, which are operated as TN-C system. The main use of PIVM12,5-275/3+0 Vseries arrester is in structures of LPL III – IV according to EN 62305 ed.2. The marking M specifies a type of construction with removable module.

Product

Solar Ultraviolet Pyranometers

UVR1-T, UVR1-A, &

-

Middleton Solar

UVR1-T, UVR1-A, & - Middleton Solar

The Middleton Solar UVR1 series are precision filter radiometers for measuring solar global ultraviolet irradiance. The UVR1-T and UVR1-A are suitable for air pollution monitoring. The UVR1-B is suitable for biological and human erythema (sunburn) monitoring.

Product

Evaporative Light Scattering Detector for HPLC

ELSD-LT III

-

Shimadzu Corp.

ELSD-LT III - Shimadzu Corp.

The evaporative light scattering detector (ELSD) is a general-purpose universal detector that can even detect components with no UV absorption, such as carbohydrates, lipids, surfactants, and synthetic polymers. With exceptional sensitivity, a wide dynamic range through Analytical Intelligence features, and easy operability using LabSolutions™ software, the ELSD-LT III contributes to more effective analysis in a wide variety of fields.

Product

3.4 MP Custom Lens Low Light Camera Module

e-CAM30_CUMI0330_MOD

-

Sensory Analytics

e-CAM30_CUMI0330_MOD - Sensory Analytics

e-CAM30_CUMI0330_MOD is a high performance, small form factor, 3.4 MP pluggable Low Light Camera Module with S-Mount lens holder. It is based on AR0330 - a 3.4MP CMOS Image sensor from ON Semiconductor®. It has a dedicated, high-performance Image Signal Processor chip (ISP) on-board that performs the entire Auto functions (Auto White Balance, Auto Exposure control) in addition to complete image signal processing pipeline that provides best-in-class images, videos and the optional MJPEG compressions.