Unmanned Surface Vehicles
deploy and forget sensor array. Also known as: USV
-
Product
Surface Mount-to-DIP JEDEC SOT-25, SOT-23A-6 Adaptor
1110748
-
Surface Mount to DIP Adapter for SOT-25, SOT-23A-6. Allows for breadboarding or substitution of microgate SOT-23A-6 and SOT-25 IC and transistor packages into .100 [2.54] pitch proto boards or PC boards. Solder masked top-side pads allow user to hand solder devices directly to topside of adapter with fewer problems of solder bridging. Longer male bottom pins are available at special request for easy use of probe clips. Large topside pads allow for soldering test pins, jumpers, etc. to top of adapter.
-
Product
Portable Hardness TesterFor cast/rough surface parts
PHT-1750
-
Loaded with features, this economically priced portable hardness tester is capable of measuring the surface hardness of a broad variety of metals on flat and round surfaces. This portable hardness tester comes complete with the G impact device, calibrated test block and rugged carry case.
-
Product
LoRa Vehicle Gateway
USM-S66
-
Can support up to 200 x TREK-120 sensors, Use RS-232/UART/USB to connect with Vehicle Terminal.
-
Product
Surface Profile
-
Surface profile: The degree of profile on the surface affects a coating’s overall performance and determines aspects such as adhesion, coverage and overall volume of coatings used. If the profile is too large the amount of coating required increases, otherwise there is a danger that the peaks remain uncoated - allowing rust spots to occur. If the profile is too small there may be an insufficient key for adequate adhesion.
-
Product
Fixed Writing Surface for Double-Bay 19" RA & RC Cabinets
WS2-119
-
This fixed shelf / writing surface for a double-bay RA & RC cabinets spans the full width of the cabinet and extends 18” in front.
-
Product
Motor Vehicle Inspect Lines Engineer Program
-
Foshan Analytical Instrument Co, Ltd.
It is suitable for measurement of motor vehicles equipped ignition engine with max total mass more than 3500kg.Including the dual idle speed method test.Meet the requirement of GB18285-2005"Limits and Measurement Methods for Exhaust Pollutomts from Vehicles Equipped Igintion Eigine under Two-speed Idle conditions and simple Driving Mode Conditions".The system can select the prompt mode of the dirver mode or the prompt mode of lattice screen.
-
Product
Meters for Contact Angle and Surface Tension
SURFTENS UNIVERSAL
-
Optik Elektronik Gerätetechnik GmbH
Robust measuring device for contact angle, SFE and surface tension with numerous equipment variants such as motorized dosing systems, multiple dosing systems and tilting device.
-
Product
Surface Texture And Contour Measuring Instruments/Systems
-
We provide high performance, easy-to-use systems from highly efficient hybrid types that can measure the surface roughness and the contour in one trace, to portable types that can be used even on the production site.
-
Product
Skin Surface Probe
SST-2
-
The SST-2 skin surface temperature probe for humans, with convenient plastic handle. Probe re-useable and has a fast response time.
-
Product
Flood Modeling for River, Surface Water, and Urban Drainage Systems
Digital OneWater Flood Modeller
-
Flood Modeller, a Digital OneWater solution, is an industry-leading software platform which enables engineers and scientists to deliver faster and more accurate results by simplifying the modeling of river, surface water, and urban drainage systems. It enables you to confidently understand flood risk and develop optimal solutions to manage the impacts of climate change.
-
Product
Electric Vehicle Charging Station EVSE Test Adapter
FEV100
-
Test the safety and performance of a type 1, level 1 or level 2 electric vehicle ac charging stations (EVSEs) with the Fluke FEV100. This test adapter simulates the presence of an electrical vehicle, allowing you to conduct tests in combination with appropriate test instruments such as a digital multimeter or oscilloscope.
-
Product
19" Drawer with Writing Surface, Unshielded, 5.25"H x 30"D
DR-051930-S
-
Unshielded drawers with writing surface are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock
-
Product
Surface Resistance Meter
SRMETER2
-
The Surface Resistance Meter is a wide range, multi-scale, auto-ranging meter. This meter is appropriate for auditing static control work surfaces.The meter is 9V battery powered and simple to use.NIST Calibrated
-
Product
Surface & Volume Resistivity Meter for Nonconductive Materials
Hiresta UX
-
The new Hiresta-UX is a high performance meter for measuring the surface and volume resistivity of a wide variety of nonconductive materials. With an extended measurement range of 103 ~ 1014Ω, this meter is ideal for Production, Engineering, R&D and Quality Control. The new Hiresta-UX features powerful new algorithms that automatically choose the right voltage, which optimizes the surface and volume resistivity testing. This versatile, high performance resistivity meter includes a built-in switch box that can be mated with a J-Box (meets JIS K 6911 for surface & volume resistivity and is compatible with ASTM D 257) as an option. The Hiresta-UX can store up to 2,000 measurement results, which can be easily exported to a USB memory device.
-
Product
Resistance System - Digital Surface Resistance Meter up to 200 TeraOhms
PRS-801B
-
- Accurate Wide Range Resistance Measurements: 0.01 Ω to 2.00x1014 Ω- Accuracy of ±2% from 1.00 Ω to 9.99x1010Ω- Variable Voltage 0.1 mv to 9.99 V for low resistance measurements- Constant Test voltages 10V and 100V meeting ANSI/ESD S20.20- Auto Resistance Range Control- Auto Test Voltage Control- Uses a Rechargeable Li-ion Battery Pack- Takes Approximately 8,000 Measurements on a Single Charge (480 hours typical)- 999 Data Set Memory- Download to Excel® in Batches or Individual Measurements with Prostat Connect 2.0- Uses Micro USB Cable for Charging and Downloading Data- Charges in 2 Hours- 2-year Limited Warranty on Main Instrument
-
Product
0.35° Accuracy Roll & Pitch Surface Dynamic Motion Sensor
DMS-535RP
-
The DMS range of motion sensors is designed specifically for the motion measurement needs of the marine industry. Whether it is achieving IHO standard survey from any size of vessel, or providing safety critical monitoring of offshore platforms, large vessels, helicopter landing decks, cranes and positioning systems, the DMS provides accurate motion measurement in all sea conditions. Incorporating an enhanced external velocity and heading aiding algorithm for improved accuracy during dynamic manoeuvres, the solid state angular rate sensors offer reliability in the highest performing vertical reference units ever produced by TSS.
-
Product
BET Flowing Gas Surface Area Analyzers
SA-9600 Series
-
The surface area of a material is, in many cases, as important as the chemical properties. As particle size decreases, surface area increases. Porosity of materials - from micropores to macropores - contribute even more to the total surface area. The interface at the surface is what defines how a solid reacts to other substances, be they gases, liquids, or solids.Surface area can impact shelf life, stability, dissolution and efficacy of pharmaceutical powders and tablets. Likewise, surface area can affect the rheological properties and hiding powers of pigments, paints, and coatings. It has a significant impact on the ability for materials like catalysts, adsorbents, filtration materials and air separation products to react in the designed application. Ceramics used in applications ranging from; dinner plates, to dental implants, to electronics, all are affected by surface area.
-
Product
24" Drawer With Writing Surface, Unshielded, 5.25"H X 30"D
DR-052430-S
-
Unshielded drawers with writing surface are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock.
-
Product
Surface Calibrators
-
Electronic Development Labs, Inc.
A software-driven process for gaming mice that optimizes the sensor to a specific surface's texture, reflectivity, and weave.
-
Product
Measurement Of Surface Tenison Using The Pendant Drop Method
SURFTENS PD
-
Optik Elektronik Gerätetechnik GmbH
SURFTENS PD is an image processing software for measurement of surface tension of liquids by pendant drop method. By help of drop shape analysis the surface tension is calculated, using the form parameters of the pendant drop. SURFTENS PD is used in connection with OEG equipment, but also available as standalone solution for applications of customer.
-
Product
24" Drawer with Writing Surface, Unshielded, 8.75"H x 30"D
DR-082430-S
-
Unshielded drawers with writing surface are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock
-
Product
Optical Tactile Surface Finish
1000Z
-
The Adcole Model 1000-Z features both optical and tactile measuring heads to deliver high precision surface measurements of camshafts, crankshafts and turned parts. The non-contact interferometric probe greatly expands on the measurement capabilities from the diamond tipped contact probe of the standard Adcole 1000 gage, as the optical accessory can precisely measure surface finish of cam track groove sidewalls, cam track bottom grooves and more. Profilometers such as the 1000-Z quantify surface roughness and are relied on to maintain quality and identify potential problems in the manufacturing and coating process.
-
Product
General Purpose Surface Temperature Assembly
S2-2
-
The Series S2-2 General Purpose Surface Temperature Assembly is ideal for monitoring the temperature of indoor distribution lines when it is not possible to penetrate the pipe. The plastic housing is in the shape of a standard junction box with multiple knockouts for easy conduit access. The strap-on connection quickly wraps around a pipe and can be securely tightened using a flat head screw driver. The Series S2-2 can be ordered with a choice of 11 output options that allow it to communicate to any standard building control system
-
Product
Gas Tester on CONNECT Trolley for Measurement of Petrol, CNG, and LPG Powered Vehicles
M4GT CT | VP 135122
-
Maschinenbau Haldenwang GmbH & Co. KG.
The MAHA 4-Gas Tester on CONNECT trolley serves for the measurement of petrol, CNG and LPG powered vehicles as well as the precise analysis of the gas components HC, CO, CO2, O2 with lambda value calculation. The M4GT impresses with its low weight, compact design and short warm-up time for easy handling, precise measurement results and rapid measurement readiness.
-
Product
Analog Surface Profile Gauge
NOVOTEST LIMIT
-
Mechanical depth gauge is designed to comply with ASTM D 4417-B, SANS 5772, US Navy NSI 009-32, US Navy PPI 63101-000 for (depending on configuration): measures the peak-to-valley height of a blast cleaned surface; measurement the depth of focal corrosion; measures depth of narrow holes and grooves.
-
Product
Big Data Web Platform to Measure Vehicle, Transit, Bike, and Foot Traffic Virtually
StreetLight InSight
-
StreetLight InSight® is big data web platform that harnesses connected device and IoT data to measure vehicle, transit, bike, and foot traffic virtually anywhere. Use our self-serve software 24/7 to analyze traffic volumes, Origin-Destination, turning movement counts, and other transportation metrics — for any road, area or time period.
-
Product
Mobile Surface Measuring
-
The mobile surface measuring instruments and analysis units from ZEISS are robust and easy to use. They are suitable for non-transportable workpieces.
-
Product
Surface Analysis and Materials Characterization Services
-
The Materials Characterization division of Evans Analytical Group is the leading global provider of surface analysis and materials characterization services. Our international network delivers world-class analytical services directly to you. EAG''s expertise in surface analysis, composition and contamination measurement, trace elemental analysis and microscopy can help you and your company meet your goals, no matter what high technology industry you work in.
-
Product
Installation of Visual Inspection of the Inner Surface of Hollow Cylindrical Parts
-
Create an installation that allows visual inspection of the inner surface of hollow cylindrical parts with the ability to display the resulting image on a personal computer monitor with its subsequent saving in the JPEG format.
-
Product
Surface Photovoltage
-
The surface photovoltage spectroscopy modules are the perfect all-in-one solution for in-depth studies of light sensitive materials such as organic semiconductors, solar cells or light sensitive dyes.
