Unmanned Surface Vehicles
deploy and forget sensor array. Also known as: USV
-
product
Surface Analysis
Innova-IRIS
This provides researchers a perfect combination of chemical or crystallographic information at high spatial and spectral resolution with the most advanced atomic force microscopy characterization. The Innova-IRIS can be integrated with your choice of a leading Raman system to provide the best opaque sample TERS investigations available today. However you tailor your system, your application will benefit from Bruker exclusive, high-contrast IRIS TERS probes and the best tip preservation and lowest drift, guaranteeing that alignment is preserved even over the optical integration times necessary to interrogate weak Raman scatterers.
-
product
Full Vehicle Test Systems
MB Dynamics delivers effective, low-cost, and quiet excitation technology to root source S&Rs in vehicles, trimmed bodies, subsystems and components, including 4 poster test rigs. MB’s patented Direct Body Excitation (DBE) Road Simulator and Dynamic Vehicle Torquer (DVT) are advanced vehicle road simulation technologies which help detect vehicle S&Rs during development, launch, and production.
-
product
Air and Water Permeability in Concrete Both At and Below the Surface
Poroscope
Poroscope Plus measures the time it takes for air to flow into a known volume of a sealed, evacuated chamber in the concrete. While the vacuum reduces from -55 Kpa to -50 Kpa, a measure of air permeability is determined. For water permeability, Poroscope Plus uses the same chamber filled with water, and measures the total time in seconds for a volume of 0.01 ml of water to escape.
-
product
Tow Doctor™ Vehicle Side Test Unit
50918
Hopkins Manufacturing Corporation
Specifically designed so that one person can make sure a vehicle has been wired properly and all functions are working. Plug the Tow Doctor™ into the vehicle towing connector, carry the display unit to the cab of vehicle and cycle through the vehicle lighting functions. Includes 7 Blade, 6 Round and 4 Flat adapters and durable carrying case.
-
product
Surface Carbon Analyzer
SurfaceC‑800
Determination of surface carbon is a special requirement for quality control in the metal producing and metal working industry. ELTRA’s SurfaceC-800 analyzer is designed for the precise determination of surface carbon in numerous kinds of solid samples from trace level up to 1000 µg/cm2. The SurfaceC-800 is equipped with a resistance furnace with quartz tube for sample oxidation and can provide temperatures up to 1000 °C. The temperature of the SurfaceC-800 can be set up in steps of 1 °C. As common carrier gas in the SurfaceC-800 oxygen is used.
-
product
Surface Thickness Gauges
The Cygnus range of ultrasonic surface thickness gauges are non-destructive testing (NDT) instruments that enable an accurate metal thickness measurement to be obtained from one side only, without the removal of protective coatings or damage to test materials.
-
product
Surface Profile Gages
PosiTector® SPG
Surface Profile Gages for Blasted Steel, Textured Coatings and Concrete Profile. Digital depth micrometer measures and records peak to valley surface profile heights.
-
product
Chemical Analysis + Surface Analysis
Rocky Mountain Laboratories, Inc.
An independent surface chemistry and microanalysis laboratory to serve the needs of industrial, academic, and governmental clients. Our objective – to provide real-world solutions for industries with materials and process development needs – is as fundamental to our organization today as when we began. Over the years we have strived to adapt our services to the specific needs of these clients.
-
product
NI Vehicle Radar Test System
VRTS provides automated radar measurement and obstacle simulation capabilities for 76 to 81 GHz automotive radar systems. With VRTS, you can perform precision RF measurements and simulate a wide range of test scenarios for radar hardware and software subsystems, including sensors, advanced driver assistance systems (ADAS), and embedded software. Use VRTS for all phases, from design to manufacturing, of ADAS and radar system test.
-
product
Gas Tester on Trolley for Measurement of Petrol, CNG and LPG Powered Vehicles
M4GT T | VP 135121
Maschinenbau Haldenwang GmbH & Co. KG.
The MAHA 4-Gas Tester on trolley serves for the measurement of petrol, CNG and LPG powered vehicles as well as the precise analysis of the gas components HC, CO, CO2, O2 with lambda value calculation. The M4GT impresses with its low weight, compact design and short warm-up time for easy handling, precise measurement results and rapid measurement readiness.
-
product
Surface Resistance Meter
990SRM
The Model 990SRM is a convenient, pocket-sized meter for measurement of surface resistivity and resistance to ground.
-
product
Portable Surface Roughness Tester Profilometer
SRG-4000
The latest in state-of-the-art surface roughness testers profilometer, the SRG-4000 is designed with the shop environment in mind. These surface roughness testers profilometer are distinguished by a high level of accuracy, multiple parameters and simplicity of operation. Extremely sensitive and highly accurate readings from this Phase II surface roughness tester are offered via multiple surface roughness profilometer parameters, Ra, Rq(Rms), Rt and Rz.
-
product
Software For Visualizing Surface Quality
STATOVISION
Foerster Instruments, Incorporated
In combination with a STATOGRAPH module, the STATOVISION software enables the visualization of eddy current signals in a clearly arranged C-Scan. This results in an image of the surface quality of the components, allowing surface defects to be precisely localized. A major advantage of the STATOVISION software is the pattern recognition, which can be used for surpressing drill holes on brake discs, for example. The documentation of the entire scan is used for continuous quality assurance.
-
product
K Thermocouple Surface Probe
TP754
Surface thermocouple Type “K” probe. Tolerance according to IEC 60584-2 standard.
-
product
12V/24V Jump Start System for Service Vehicles
Super-Boost-All
The Super Boost•All® is designed to be mounted on your service vehicle with 2 or 4 auxiliary jump starting batteries to start 12 or 24 volt vehicles. The auxiliary batteries are charged from the service vehicles electrical system through the internally mounted battery separator.
-
product
Elcometer MarSurf PS10 Surface Roughness Tester
7062
In protective coating applications there is a requirement to measure surface roughness. With 31 surface parameter settings available the Elcometer 7062 surface roughness tester can display all parameters that comply to National & International Standards.These values include peak-to-valley profile measurement in combination with an assessment of the frequency of peaks within the sample area.The Elcometer 7062 surface roughess tester is a light weight and portable measuring solution for the range of surface roughness measurements required for compliance to International Standards.The unit is also suitable for assessing surface roughness conditions in a wide range of general industrial applications; particularly where the sample is too large to bring to the laboratory.
-
product
BET Flowing Gas Surface Area Analyzers
SA-9600 Series
The surface area of a material is, in many cases, as important as the chemical properties. As particle size decreases, surface area increases. Porosity of materials - from micropores to macropores - contribute even more to the total surface area. The interface at the surface is what defines how a solid reacts to other substances, be they gases, liquids, or solids.Surface area can impact shelf life, stability, dissolution and efficacy of pharmaceutical powders and tablets. Likewise, surface area can affect the rheological properties and hiding powers of pigments, paints, and coatings. It has a significant impact on the ability for materials like catalysts, adsorbents, filtration materials and air separation products to react in the designed application. Ceramics used in applications ranging from; dinner plates, to dental implants, to electronics, all are affected by surface area.
-
product
Commercial Vehicle
An advanced commercial vehicle diagnostic tablet compatible with 80+ models of light, medium and heavy duty vehicles.
-
product
19" Drawer with Writing Surface, Unshielded, 3.5"H x 24"D
DR-031924-S
Unshielded drawers with writing surface are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock
-
product
Surface Inspection Gauge for the Shop Floor
4D Inspec Surface Gauge
Your product description goes here.
-
product
Vehicle Presence and Data Collection Sensor
FLIR TrafiCam x-stream2
The FLIR TrafiCam x-stream2 combines a digital camera and video detector into a single vehicle presence sensor. Detecting moving and stationary vehicles at signalized intersections, TrafiCam x-stream2 transmits vehicle presence information to a traffic controller via detection outputs or TCP/IP communication for adaptive and responsive signal timing. Each cost-effective TrafiCam x-stream2 sensor helps reduce vehicle idling time and optimize traffic flow.
-
product
19" Drawer With Writing Surface, Unshielded, 5.25"H X 24"D
DR-051924-S
Unshielded drawers with writing surface are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock.
-
product
Surface Cleanliness Analyzer
Surface Analyst
The Surface Analyst is a fast, easy, accurate, and non-destructive instrument that quantifies your level of surface preparation from the lab to the manufacturing floor. In 2 seconds, the Surface Analyst determines the surface cleanliness level by providing the contact angle measurement and a pass/fail result.
-
product
Integrated Multi-Gas Detector for Unmanned Aerial System
MUVE C360
The FLIR MUVE™C360 is a multi-gas detector completely integrated with an unmanned aerial system (UAS) to provide real-time continuous monitoring of chemical hazards while on the move. The sensor block boasts 8-channels, which includes a photoionization detector (PID), Lower Explosive Limit (LEL) detector, and six other sensors. The integrated snorkel is designed to negate the effects of rotor wash, extending past the propellers to sample the unperturbed air. The MUVE C360 sensor block quickly latches to a proprietary integration dock mounted to the UAS. The FLIR calibration station features the same dock, so the operator can easily connect for routine sensor verification. Sensor readouts are prioritized based on alarm conditions and are displayed real-time on the pilot’s interface in the FLIR VueLink™ app. The MUVE C360 is a time-saving, game-changer for emergency responders, industrial safety officers, and environmental monitoring experts.
-
-
product
Outdoor Surface Mounted
HYLO
Available as uplighter, downlighter and up-/downlighter. Choice of multiple colours of LED light sources and a variety of beam angles. The up/down version offers the possibility to use two different colours of light and two different beamangles within one single fixture. Up to 80% energy savings compared to traditional light sources.
-
product
Meters For Contact Angle And Surface Tension
SURFTENS Basic
Optik Elektronik Gerätetechnik GmbH
Low cost contact angle meter provides all functions for DIN conform measurement of contact angle and SFE.
-
product
Rework Station, Dual, Surface Mount, 896 °F
21-10130
The 21-10130 is a SMD Rework Dual Station, intelligent rework station which combines rework station with soldering station to become an essential centerpiece of any technician or hobbyist bench. A MCU thermostat provides accurate and consistent working temperature. The dual LCD displays show live working states of both the iron and the hot air hand pieces, as well as provides access to three programmable presets for each unit. Temperature and airflow for the hot air tool can also be controlled from buttons on the hand-piece.
-
product
Vehicle Electromagnetic Field Exposure Test System
SEM-400
Beijing KeHuan Century EMC Technology Co,.LTD
Vehicles are our daily public transportation. Electromagnetic pollution in vehicles has attracted more and more public attention. The newly revised compulsory standard GB27630-201X "Passenger Car Air Quality Evaluation Standard" intends to require the electromagnetic field in the car as one of the indicators, according to GB/T37130-2018 "Measurement method of vehicle electromagnetic field relative to human exposure" The measurement method is to measure the intensity of the magnetic field in the car. In the frequency range of 10Hz-400kHz, the electromagnetic field measurement result should meet the public limit requirements of GB8702-2014 for electromagnetic exposure.
-
product
Automatic Liquid Interface Tension Meter,Surface Tension Analyzer,Oil Interface Tension Meter
Chongqing Assen Power Equipment Co., Ltd
Our HTID-1 Automatic Interface Tension Tester is used to test various liquid surface tension and interface tension based on the ring method that is simple and high accurate, which is widely applied in electric, petroleum, chemical, medicine, food, and teaching filed.
