Bare Board Test
SMT and PCB check prior to being populated with components.
See Also: Bare board, Bare Board Testers
-
Product
3U cPCI I/O & Comm Board
75C3
Multifunction I/O
NAI’s 75C3 is a 3U cPCI multifunction I/O and communication board with three independent function module slots. Two of the slots can be configured with a variety of I/O and communication functions; the third, with either a combination module featuring four multiplexed A/D channels and 28 Discrete I/O programmable channels, or with a reference supply. Using multiple DSPs, the enhanced motherboard enables higher processing power and dedicated pre-processing control for each module.
-
Product
Functional test
-
Maschinenbau Haldenwang GmbH & Co. KG.
Test bench for small vehicles with 2 wheelsRoad load simulationDetermination of maximum speedMeasurement and evaluation of speed, speed, distance traveledDisplay of wheel power at test speedDisplay on your PC monitorExpression of test resultsCustomer and vehicle databaseEuro system console MCD 2000 with switching elements for roller setPort for external devices
-
Product
Digital Interface Boards
Model 2363 OEM
-
* 114515 Board has same digital capability as the 2363 described above with Serial and GPIB IO.* Serial interface header includes RS-232 and RS-485 signals. Use the 114597 Serial Cable Kit to connect the serial signals to your rear panel* GPIB header mates with 113640 or 113642 GPIB Connector/Address Switch Cable Assemblies* Accepts 9-32 Vdc power.
-
Product
Supercapacitor Test
-
The CT3001A/C battery test systems are upgraded from CT2001A/C with higher precision and data logging rate. The tester can be used to run precision tests for coin cells, pouch cells, prismatic cells, and especially supercapacitors (ultra-capacitors). Each tester has 8 independent channel which can be programmed to run constant current charge/discharge, constant voltage charge, constant power discharge, constant resistant discharge, and direct current internal resistance (DCIR) tests.
-
Product
Test Compliance
CTS Series 3.2
-
AMETEK Programmable Power, Inc.
The CTS Series is a complete, turn-key compliance test system for EN IEC 1000-3-2 (Harmonics) Including A14, EN IEC 1000-3-3 (Flicker) and various EN IEC 1000-4 AC immunity tests. Consisting of an AC power source, a power analysis conditioning system (PACS) and a PC based data acquisition system, the CTS provides a complete turn-key solution for IEC testing. The Windows™ based CTS software performs the IEC tests and generates detailed test reports. Comprehensive data files are stored on disk to allow post test analysis.
-
Product
Test & Measuring
-
Messung Electrical Engineering
Electronics manufacturing, testing and quality control need test and measuring equipment and ergonomic environments that are flexible, versatile and safe. Hence we bring the future of modern workplace systems for R&D labs, calibration centres, training and didactic centres, electronic assembly & testing, spread across the Indian electronic industry. Our innovative, modular & customised laboratory furniture systems, and intelligent test & measurement solutions are designed to improve efficiency while offering user comfort.
-
Product
Test Sets
-
A set of examples used only to assess the performance of a specified classifier on unseen data.
-
Product
3.5" MI/O-Compact Single Board Computers
Single Board Computer
Advantech's 3.5" MI/O-Compact embedded single board computers (SBC) measure 146 x 102 mm, offer scalable x86 performance for low-power Intel Xeon/Atom™/Core™ i7 platforms, and feature rich I/O, fanless operation, compact design, extended temperature range, and increased longevity.
-
Product
3U CompactPCI® Single Board
CP32103
-
LinkedHope Intelligent Technologies Co.,Ltd.
CP32103 is a 3U CompactPCI® single board, low power, small size, high integration, high reliability embedded computer module compliant with PICMG® CompactPCI® specifications.CP32103 offers a variety of processor options enabling customers to choose such as D2550、N2600 and N2800. The onboard memory, flash and SATA make sure CP32103 with good anti-shock and vibration performance.The design and production of CP32103 are controlled by full life-cycle management, so CP32103 can be long time available, as ensures maximum support for the maintenance of long life programs.
-
Product
A to Z Testing
-
Elemental Analysis has the ability to analyze, and to test for all of the substances listed below, and many more. If you do not see the substance you need analyzed or tested for, please give us a call! We can test almost ANYTHING!
-
Product
Packaging Test
-
Underwriters Laboratories Inc.
UL offers ISTA packaging tests to assess the security of goods during transport, so retailers and manufacturers can feel confident that packaging is up to the job, thus reducing product loss and customer complaints.
-
Product
ERP Testing
-
Signing up for an ERP package is a big decision for any enterprise since it is closely related to key business processes and has the potential to significantly enhance the customer service and experience. To ensure an optimized return on investment, it is critical to have a successful roll-out with the desired features and benefits. With a high failure rate for ERP implementations, it is very crucial to have a comprehensive QA strategy and expertise. TestingXperts offers you specialist QA and solutions for ERP testing and ensures that your ERP systems function properly and meet your business needs. We have subject matter expertise on leading ERP QA packages, coupled with best-in-class QA processes, frameworks and accelerators to help you achieve your ERP goals. Our expert ERP software testing experts have the ability to test features of core applications end to end and also keep pace with the evolution.
-
Product
BMP-5 Board Marker Probe
BMP-5
ICT/FCT Probe
Voltage Rating (VDC): 12Recommended Duty Cycle: 2 sec. On (min.), 3 sec. OffCurrent Rating (Amps): .020Test Center (mil): 1,000Test Center (mm): 25.40Full Travel (mil): 79Full Travel (mm): 2.01Recommended Travel (mil): 50Recommended Travel (mm): 1.27Full Marker Travel (mil): 62Full Marker Travel (mm): 1.57Direction of Rotation: CCWScribed Diameter (mil): 50Scribed Diameter (mm): 1.27Test Center Remark: Ø .472 (12.1) or M12
-
Product
In-circuit Test
Medalist i1000 Systems
-
Cover Extend Technology (CET) is now supported on the Medalist i1000D. The i1000D only requires a VTEP MUX card to enable CET. If you are already using test fixtures with VTEP MUX cards , you can now implement CET without any fixture modification. Simply add new VTEP probes to devices that were previously not testable. This greatly reduces implementation efforts.
-
Product
6U CompactPCI Boards
-
Full line of 6U CompactPCI products supporting PICMG 2.16, IPMI, Hotswap, TPM, System Management.
-
Product
RTM Discrete Signal Conditioning Board
MS 3632I
-
CPCI Rear IO Discrete Signal Conditioning Board is a signal conditioning and interface board for CPCI based Advance Compute & IO Module (MS3639i). This board primarily focusing on signal conditioning of TTL/CMOS DIO levels to required type of discrete input and output interface. Digital IO from ACIO board to discrete IO at Rear IO interface. Board takes 144 DIO from ACIO and does Open/Ground, 28V/Open, 28V/Ground configuration. In addition it shall generate additional 32 discrete input / output signals with signal conditioning and all IO interfaces are brought to two 96 Pin Euro Connector.
-
Product
Leak Testing
M SERIES
-
For several years, the M series has been the high-quality leak testing line, created by FORTEST for sealing and capacity testing, a series that offered great performance and is now in its new T-range its natural evolution.
-
Product
PICMG 1.3 Full-Size Single Board Computers
Single Board Computer
PICMG 1.3 Full-Size Single Board Computer (SBC), with multiple backplanes to achieve unrivaled flexibility and performance. Our Slot SBC with rich I/O interface and expansion slots also support Intel's latest processors.
-
Product
Boresight Testing
-
CI Systems provides different types of boresighting capabilities, such asLine of Sight BoresightingMission Ready BoresightingMechanical to Optical Alignment
-
Product
Test tools
-
Try our low-cost RF sniffers for fast and easy troubleshooting of unwanted interference caused by electromagnetic radiation sources in your local environment.
-
Product
6U VPX Single Board Computer
VP62007
-
LinkedHope Intelligent Technologies Co.,Ltd.
VP62007 is a 6U VPX single board computer designed by LinkedHope® based on Intel® QM170/CM236 chipset. The compact and space-saving processor board meets the VITA46.0 specifications. VP62007 provides 4 x4 SRIO2.1 for VPX Data Plane communication, 2 x8 PCIe for VPX Expansion Plane communication, 4 GbE for VPX Control Plane communication. Rich data exchange interfaces on VP62007 make it easy to build box-level or system-level solutions.
-
Product
Single Board Computer
VME-183
-
Curtiss-Wright Defense Solutions
AltiVec technology, and up to 1 GB of DDR1 SDRAM, the VME-183 Single Board Computer provides an ideal platform for general purpose computing.
-
Product
Temperature Test
Series T
-
The temperature test are characterized by high rates of temperature change, ease of programmability through our color touch panel, as well as extremely low noise levels
-
Product
Test Fixtures & Test Sets
-
Keysight test fixtures are used to hold electronic components or materials (physically and electrically) in order to perform various measurements. Keysight offers a variety of test fixtures from Parametric, Dialectrice, Liquid test fixtures and more.Some of our test fixtures allow you to connect directly to your measurement instrument, while others require various adapters.
-
Product
Security Testing
-
We protect your business from cyber attacksSecure online transactionsPrevent unauthorized accessMinimize the risk of data lossEnhance resistance to DoS attacks
-
Product
One Wire Communication Board
MS 1727
-
- Digital serial bus communication with low speed data over a single line, Both signaling and driving power over a same single signal.- Protocol used in small inexpensive devices. Such as digital thermometer, weather instruments, laptop sub module, authenticate system and some cell phone battery packs.- Always master only initiates the communication and in overall in charge of the network.- Bus communicates with master and slave at a low data rate of 12kbps.- All terminals in the network are communicating by half-duplex mode.- Maximum of 255 nodes in each 1-wire network- Each data transaction will start with 480micro second low RESET pulse.
-
Product
IF Digital Processing Board for Demodulation and Combining
LS-35-R
-
The Lumistar LS-35-R is part of the Lumistar family of digital processing boards used for programmable telemetry systems. The LS-35-R consists of a digital processing main board with two high capacity Xilinx Virtex-5 arrays. The LS-35-R provides a two-channel IF Receiver with Pre/Post detect combining, multimode demodulators with data rates up to 40 Mbps, bit synchronizer outputs, Viterbi decoding, spectral and constellation display, BER reader display and 70 MHz IF modulator with calibratednoise feature. The all-digital design assures a consistent product with high reliability and long-term stability.
-
Product
Test And Measurement
-
Standardized instruments used to evaluate individuals, populations, or processes.
-
Product
Function Test and In-Circuit Test
CT350
-
ICT test points: max 2736 CAD Data import Automatic program generator Powerful debugging tools Test coverage analysis Paperless repair station Logging- and statistic functions Full graphical functions Panel and multisite tests Fast adapter exchange High Pin Count-Interface On table optional usable shelf part.
-
