Showing results: 451 - 465 of 1232 items found.
-
X Series -
IDS Imaging Development Systems GmbH
The Ensenso X series is a modular and ultraflexible 3D camera system. The projector module with 100 W LED projector power is equipped with an integrated Gigabit Ethernet switch and can be combined with selected GigE uEye camera models to a customised 3D camera system.
-
Chroma Systems Solutions, Inc.
Power conversion testing for automated test systems, LED drivers, power supply testing, battery testing, and much more.
-
LAB / S -
ET System Electronic GmbH
*Linear laboratory power supply*High quality DC sources with the lowest residual ripple*CV / CC mode with LED display*Protection against short circuit, overload and overtemperature*Optional IEEE 488, RS232, analog interfaces*3-phase input optional
-
TBM300 -
Telonic Berkeley, Inc.
The Model TBM300 Portable Opacity Meter consists of two basic units connected by a single cable. The sensor unit is installed end-of-line on the exhaust outlet of the vehicle under test and contains the light source (green led) and receiver (photo detector) modules.
-
e-con Systems Inc.
See3CAM_CU22, is a 2MP color USB 3.1 Gen1 SuperSpeed camera featuring High Dynamic Range (HDR) with LED flicker mitigation (LFM). This HDR camera is based on 1/2.5" AR0233AT CMOS image sensor and a dedicated high-performance Image Signal Processor (ISP).
-
RW1210 -
Manncorp
Safely and precisely rework SMD, BGA, or LED chips. This all-in-one solution covers rework needs for even the most complex, densely populated PCBAs. Yet it is easy to use, enabling technicians to quickly master delicate alignment, placement, and heating controls.
-
TA-900 -
Tech-Aid Products
This has been the New standard in Angle Position Indicators. 4 digit API has fault monitoring for both low-level and loss of signal (LOS) and this status is shown on the front panel led. The unit provides simultaneous connection of both synchro and resolver devices.
-
LS-7000 Series -
Keyence
Breakthrough technology intelligent optical micrometer with 0.01-micron high resolution, 2400 samples/second high speed. Maintenance - free LED emitter and design (no laser diode or motor). High performance controller with statistical analysis. Controller with target viewer available for easy setup
-
TOMSAD
*on / off switch output section*two independent adjustable DC output*independent outputs serial and parallel*constant voltage and current*Low ripple and noise*four digit LED displays three*for 16 hours at full load*automatically search out
-
TOMSAD
*on / off switch output section*two independent adjustable DC output*independent outputs serial and parallel*constant voltage and current*Low ripple and noise*four digit LED displays three*for 16 hours at full load*automatically search out
-
IEC60529 -
Shenzhen Chuangxin Instruments Co., Ltd.
This device is designed according to terms and conditions of IEC60529,GB4208-2008,GB7000.1-2007,GB4706.1-2005.Satisfying requirements of level IPX1/2. Applide to test LED lamps and house hold appliances, and other electric and electronic products waterproof test of IP code level IPX 1/2.
-
LF500CS -
Tracer Products
The LeakFinder LF500CS is a powerful violet light LED leak detection flashlight. The flashlights compact design offers optimal coverage of a vehicle’s leaking systems – allowing the user to scan for escaping fluorescent dye in the tightest and hardest to reach places. available 3 /18
-
ASD12-N -
optek
The ASD12-N absorption probe has a durable LED light source for direct installation into laboratory bioreactors and disposable bioreactors for measuring cell growth and optical density. The probe is available in three different lengths to fit any vessel and is suited for sterilization / autoclaving procedures.
-
ifm efector, inc.
*High reliability due to the elimination of mechanical components*Different function principles: Guided wave radar, capacitive and hydrostatic*Devices for limit level detection or continuous level measurement*Clearly visible LED display*Suitable for all common industrial and process fluids
-
325 SVD -
Standard Electric Works Co., Ltd
● Compact, easy to wear and convenient in use● Designed for indoor and outdoor use● Water-proof design. (IP65)● Equipped with self-testing functions● Able to sense all kinds of AC High Voltage System● Low power consumption● CE Certifiedright LED visual indication