LED
Semiconductor diode that emits narrow spectrum light by converting electric energy into electromagnetic radiation.
See Also: GaN
-
Product
Integrating Sphere
-
The standard test temperature is 25, but high power lamps such as HID lamps and LED outdoor luminaires will produce a lot of heat during the test, thus the temperature inside the integrating sphere can not meet the requirements of IEC standards. Lisun Group designed the Constant Temperatured Integrating Sphere which allows the lamp was tested in a constant air temperature.
-
Product
Battery/Alternator Tester
BT55U
-
Schumacher Electric Corporation
BATTERY/ALTERNATOR TESTERFOR TESTING:• Battery state of charge• Charging system outputFEATURES:• Accurate, easy-to-read LCD screen.• Checks the battery, alternator systems• Two LED indicators• Overvoltage and Reverse Polarity Protection Contents: (1) Battery/Alternator Tester
-
Product
12V Auto Battery And Charging System Analyzer
1947
-
Peaceful Thriving Enterprise Co Ltd
1. Check for batteries, regulators and alternators. 2. For all 12V system vehicles, with LED indicator that helps pinpoint problems for fast troubleshooting. 3. Other car battery testers are also available.4. With CE Approval.
-
Product
3U CompactPCI® Subsystem with 13-slot Backplane, 2 + 1 CompactPCI® Redundant Power Modules
cPCIS-2633 Series
Backplane
- 3U CompactPCI® backplane with 12 peripheral cand slots and one system slot- 2 + 1 hot swappable 500 W + 250 W CompactPCI® Power supply (supports three 250 W PSUs)- Temperature, voltage, and fan monitoring LEDs- Supports current sharing on +5V, +3.3V, and +12V- PICMG® 2.11 47-pin power interface- Hot-swappable cooling fans & filter
-
Product
Fault Finder for Electrical Wiring Open / Short Circuit
FF310
-
42 V Ready: for use in the new generation of vehicles with mixed or single 42 Volt systems. Operates on DC voltages from 6 to 42 volts. Internally protected against power surges and overloads. 8" flexible probe allows reaching wires in congested places. Transmitter and Receiver LEDs show open or short circuit conditions.
-
Product
ATA-500UV LED Auto-Temperatured Opto-Electronic Analyzer
-
Hangzhou Everfine Photo-E-Info Co., LTD
ATA-500UV is a laboratory-level solution with HAAS-2000 series of High Accuracy Array Spectroradiometer as the core.The design of constant temperature system enables the system to conduct professional photometric, chromaticity and temperature testing for UV LED, which is the most ideal solution for the rapid testing of UV LED.
-
Product
Short Light Source
LM-AS
-
The short light source is compatible with the LM-101 or the LMC-20. The light is supplied with a 50 watt tungsten halogen convection cooled light source which provides suffcient energy for use with narrow band pass filters or monochronomators in the wave length range of .35 to 2.5 microns. The light beam is chopped at 200 hz by a quiet, vibration free, synchronous motor. The housing also contains a secondary LED light source and detector for synchronization of the amplifier, plus an electro-mechanical shutter to block the light output when the instrument is zeroed. An internal collimating lens produces a narrow beam (<1") so the LM-AS can be used in bell-jar and large coating systems.
-
Product
18.5" WXGA Industrial Monitor With PCAP Touch Control, Direct VGA, And DVI Ports
FPM-7181W
Industrial Monitor
18.5" WXGA TFT LED LCD16:9 widescreen aspect ratio, increases viewing area by 40%Supports 10-point multi-touch control via USB interface in Windows 7/8 OSSlim design enables easy installationSupports various mount options: panel, wall, desktop, and VESA armTouchscreen with reliable glass surface and PCAP touch controlRobust system with SECC chassis and IP66-rated magnesium alloy front panelOSD control buttons on rear panelLockable I/O connectors
-
Product
Multipurpose Debug Board
DB40 Debug Module
-
The DB40 Debug Card is designed for debugging of COM Express and PC/104 boards. It includes the following features: - Port 80/81 decoding for Power On Self Test (POST) via LPC - Interface to SPI Flash for BIOS update - Interface to Board Management Controller (BMC) for update - Power and Reset buttons and status LEDs The DB40 Debug card can only be used on products that have the appropriate FFC debug connector designed for this purpose. (Includes DB40 Debug Module, two 40-pin FFC cables, and 14-pin cable for SP100 DediProg USB to SPI programmer.)
-
Product
Square Lenticular Pulsed Backlight
ViTech B108
-
Lensed illumination is intended for pulsed illumination of objects in machine vision systems, in which it is not possible to mount an additional light source close to the object or where it is necessary to create the required glow intensity in a certain area. A distinctive feature of the B108 modules is the absence of persistence (except for the version with white LEDs).
-
Product
Video Signal Generator
MSHG-800Plus
-
MSHG-800Plus construct HDMI 2.0(HDCP 2.2) 4Port, HDMI 1.4 & MHL 2.0 1Port - HDMI 2.0 (HDCP 2.2) supports 4Ports - HDMI 1.4 (HDCP 1.4) & MHL 2.0 supports 1Port - 4 Ports ARC functions supports - RS-232C Control supports - Each outputs status with front LED button - Button locking function - Easy upgrade / update to USB memory stick
-
Product
CREE LED’s
-
Marktech offers the complete line of both CREE LED’s High Brightness LEDs and Marktech’s custom designed components and assemblies which utilize CREE LED’s chips. Our main focus has always been in the area of application solutions to optimize your products performance. Our team of design engineers and R&D scientist are committed to providing you with unsurpassed technical support.
-
Product
Atlas DCA Semiconductor Analyser
DCA55
-
Intelligent and flexible semiconductor analyser. Connect any way round! The DCA55 then displays the following on its backlit alphanumeric display:- Component type (such as NPN transistor, P-Ch MOSFET, LED, diode etc)- Pinout information (such as Base, Emitter, Collector etc)- Parameter measurement (hFE, Vbe, Vf, leakage current etc)
-
Product
Low On-state Resistance
-
Is a low output capacitance solid state relay containing a GaAs LED on the light emitting side (input side) and MOS FETs on the output side. A small flat-lead package has been provided which realizes a reduction in mounting area of about 50% compared withthe PS78xx series. It is suitable for high-frequency signal control, due to its low C × R, low output capacitance, and low off-state leakage current.
-
Product
Switchig Power Supply For LED Products
CX-P30
-
Shenzhen Chuangxin Instruments Co., Ltd.
switchig power supply for LED productsThis serial single output switch power supply is a kind of DC regulated power supply with high efficiency and stability.
-
Product
PXIe-8521, 4-Port, 100BASE-T1 PXI Automotive Ethernet Interface Module
786771-01
Ethernet Interface
PXIe, 4-Port, 100BASE-T1 PXI Automotive Ethernet Interface Module - The PXIe-8521 is a 100BASE-T1 unshielded twisted pair (UTP) Automotive Ethernet interface for developing applications with the NI‑XNET driver. The PXIe-8521 is ideal for developing applications that require … Automotive Ethernet to test and validate automotive electronic control units (ECUs). The interface provides up to four independent endpoints or up to two network terminal access points (TAPs). It features onboard hardware timestamping and can act as up to four separate 802.1AS masters or slaves, which allows it to synchronize with an external network as well as the rest of a PXI system. The PXIe-8521 also provides LEDs on the front panel so that you can monitor the network link and activity.
-
Product
Differential Probe
DP-16K Series
-
*High Frequency Performance Model*Bandwidth:(-3 dB)**DC~100 MHz (DP-16K)**DC~70 MHz (DP-16KM)**DC~50 MHz (DP-16KL)*2 Range: x100, x1000*Input Impedance:**10 MΩ // 10 pF each side to ground*Over Range Indicate LED*Rise Time: 4 ns
-
Product
Goniophotometer Test System For Led Lamp
1680A 1680B
-
Shenzhen Chuangxin Instruments Co., Ltd.
Design according to IEC61341,the test method of central luminous intensity and beam angle for reflecting light, this instrument can be used to test the cross section luminous intensity distribution curve, central luminous intensity and effective beam angle of LED assembled luminaries and LED lens system with diameter less than 180mm.
-
Product
Phase Squence Tester
-
Measurement Range3 phase check for AC 90V ~ AC 600V (Sine Wave) Operation Frequency45Hz ~ 70Hz Test Time LimitationAC 110V(continuous)AC 220V(3 hours)AC 480V(12 minutes)AC 600V(3 minutes) Power Supplyno battery required Color change LED phase direction indication
-
Product
Spectroradiometer
SpectraScan® PR-730
-
The SpectraScan® Spectroradiometer PR-730 is JADAK’s enhanced sensitivity portable solution for spectral based photometric and colorimetric light measurements, designed for applications requiring precise light measurements from a range of light sources, such as display monitors and projectors, reflective surfaces, and industrial applications (visual display testing, LED testing, film and video post-production, auto/aerospace displays, and dental color testing).
-
Product
CYCLOPS Battery Powered Headlamps
CY3-LED
-
*LED light mounts on hard hat and allows quick and efficient hands-free movement*Allows for even distribution of weight across the forehead*Water-resistant*Field replaceable batteries
-
Product
Torque Tester
DI-1M-IP Series (50/200)
-
Best for managing impact tools. High accuracy, small size and light weight. Installed on the work line, it is effective for regular inspection of tools. The blow counter displays the number of blows and torque values, and the LED display is bright and easy to read be used to manage torque wrenches, nutrunners, etc.
-
Product
Eurorack Module Tester
TST
-
Test your modules safely without reaching into your case! The TST has two keyed 16-pin headers on the front of the module so you can plug and unplug quickly and easily. Two 16-pin plugs are included to shield the power pins when the module is not in use. It also has LEDs to indicate the power status on each rail.
-
Product
6-24V LED Heavy Duty Circuit Tester
1646
-
Peaceful Thriving Enterprise Co Ltd
Check on 6, 12 and 24V systems. Quickly and safely test high and low voltages on all vehicle voltages, including computerized engine. High impedance to protect sensitive electronic sensors, microprocessors, electronic ignition components and air bags.
-
Product
LM-79 Moving Detector Goniophotometer
LSG-5000
-
Moving Detector Goniophotometer completely meets LM-79 Clause 9.3.1 and EN13032-1 clause 6.1.1.3 goniophotometer type 4 requirements. The LSG-5000 is an automatic light distribution intensity 3D curve testing system for measuring light. The measuring distance is from 5m to 30m. It can measure all types of lighting sources, LED or HID luminaires such as indoor and outdoor luminaires, roadway luminaires, street lamps, flood lights and other kinds of luminaires.
-
Product
Saluki SEL7 Series Programmable DC Electronic Load (up to 6kW)
-
The new SEL7 series programmable DC electronic load is a new generation product designed by Saluki Technology. Incorporating high-performance chips, the SEL7 series delivers high speed and high accuracy with a resolution of 0.1mV and 0.01mA (basic accuracy is 0.03% and basic current rise speed is 2.5 A/μs).SEL7 series have wide application from production lines for cell phone chargers, cell phone batteries, electronic vehicle batteries, switching power supplies, linear power supplies, and LED drivers, to research institute, automotive electronic, aeronautic and astronautic, maritime, solar cell and fuel cell etc. test and measurement applications.
-
Product
Socket Outlet Tester
-
Using the new Testavit Schuki 1 LCD and 3 LCD, specialists easily check to see if sockets, cable drums or connecting cables are correctly connected in 230 V installations. Due to three LEDs, the connection status can be quickly and clearly determined. In addition, through the finger contact, it can be tested to see whether an impermissible, high contact voltage is applied at the protective earth connection. In addition, using the Testavit Schuki 1 LCD, a 30 mA FI circuit breaker (RCD) can be triggered via a pushbutton.
-
Product
VOICE OF THOR
-
THOR GUARD's Voice of Thor or VOT lightning alarm system is utilized to provide a unique aubible warning pattern when the area THOR GUARD is monitoring has become susceptible to a lightning strike. Simultaneously during the hazard time, LED strobe lights can be utilized to provide a continued visible notification of the impending hazard. THOR GUARD allows for a base horn with the remotes, either electric or solar powered, being controlled using THOR GUARD’s dedicated RF system. When combined with the Guardian Emergency Notification System, a special 1-minute pattern is generated to provide for any unexpected emergency.
-
Product
LXI 24-Channel 1GHz Video Multiplexer
60-721A-001
Multiplexer Module
This High Performance Video MUX is designed for the switching of RF signals in 75Ω systems at frequencies up to 1GHz. It is ideal for 75Ω monitoring applications that require a multiplexer to select one channel to be routed to measuring equipment. The automatic connection of unused channels into 75Ω terminations helps maintain signal integrity and minimizes the possibility of introducing unwanted responses. The common connection is also automatically terminated into 75 Ohm when unused. Front panel LED indicators adjacent to each multiplexer input connector provide an easy visual identification of the active channel.
-
Product
LCD Display Optical Measurement System
-
RayClouds Photoelectric Technology Co.,Ltd.
LCD display optical characteristics automatic measurement system is mainly used in LCD, LED screen, OLED screen, FPD, Mini LED, Micro LED and various new luminous materials.LCD display optical characteristic automatic measurement system supports the test of optical performance parameters such as viewing angle, luminance, uniformity, contrast, chrominance, response time, flicker, and refresh rate, etc.
