Product

Light Meters For LEDs

-

Gigahertz-Optik GmbH

Gigahertz-Optik GmbH

Photometers for the measurement of visible LEDs and radiometers for UV , visible and NIR LEDs.

Product

Fiber light source

-

Yamashita Denso Corp.

Yamashita Denso Corp.

UV irradiation UV curing, infrared irradiation Thermal curing is possible with one unit. All-round player suitable for R & D · mass production line

Product

Broadband Fiber Optic Light Sources

ASE Sources

-

Fibotec Fiberoptics GmbH

ASE Sources - Fibotec Fiberoptics GmbH

Broadband fiber optic light sources utilize amplified spontaneous emission (ASE) within optically pumped rare earth-doped fibers. The spectral width of such light sources can be set by the developer in a range from a few nm to the full width of the emission spectrum of the active ion (e.g. erbium ion).

Product

*Interferometer Fringe Analysis Software

IFA

-

Optik Elektronik Gerätetechnik GmbH

IFA - Optik Elektronik Gerätetechnik GmbH

IFA serves for the analysis of open interference fringes of interferograms. The system was developed as alternative of difficult and complicated solutions and is ideally suited for the employment in practice. IFA is a low-cost and easy to handle software, which includes all of the mostly used functions of data evaluation.

Product

Fiber End-Face Inspection Interferometer

CLEAVEMETER 3D

-

Nyfors Teknologi AB

CLEAVEMETER 3D - Nyfors Teknologi AB

The CLEAVEMETER 3D™ is a non-contact interferometer designed for inspecting the end-faces of cleaved or polished optical fibers with cladding diameters of 125 µm to 1200 µm. It gives immediate and precise information on important end-face properties such as flatness, perpendicularity, hackles and dust. Based on the NYFORS CLEAVEMETER 3D™ design, in addition to producing sharp fringe patterns it also generates three-dimensional images of the cleaved fiber end.

Product

Fiber Optic Light Source

-

Huihong Fiber Inc

Huihong Fiber Inc

Fiber optic light source is a fiber optic test equipment to measure the fiber optic loss for both single mode fiber cable and multimode fiber cables; usually the fiber optic light source is used with the fiber optic power meters. This fiber optical light source can provide wavelength output according to the specific requirements including the 650nm red source, 1310nm/1550nm wavelength for the single mode fiber and 850nm/1300nm wavelength for the multimode fiber. Used together with our fiber optic power meter, they act as an economic and efficient solution for the fiber optic network works.

Product

Light Pulse Generators

-

Berkeley Nucleonics Corporation

Berkeley Nucleonics Corporation

The optical equivalent to electrical pulse generators with rep rate, delay, width and amplitude control.

Product

Enhanced UV Light Source

Model 30E

-

OAI

Model 30E - OAI

The Model 30E Enhanced UV Lightsource is highly efficient and may be utilized in a variety of applications. Light is collected by an ellipsoidal reflector and focused on an integrating/condensing lens array to produce uniform illumination at the exposure plane. This UV light source is available in various beam sizes up to 24 inches square with output spectra ranging from 220 nm to 450 nm, using the appropriate lamp (included). Output power ranges from 200 watts to 5 kilowatts. All OAI UV Lightsources are easily equipped with quick-change filter assemblies, enabling the user to customize the output spectrum with little effort. Optional remote exhaust fans are available.

Product

Light Meters

-

Sper Scientific

Sper Scientific

Our light meters are designed for simple and accurate results in an industrial setting. Whether you are checking work spaces, parking lots, or baseball fields for safe levels of lighting or measuring for testing design compliance, a light meter from Sper Scientific will get the job done. Obtain precise UV, FC or Lux measurements, in multiple light measurement ranges. These light meters are designed for use in work spaces, labs, schools, outdoor studies, optics, home inspections, and many others. In addition, you may use these meters to check compliance with ANSI/NFPA 101 (standards for emergency & exit lighting).

Product

UNIVERSAL NOID LIGHT

27800

-

Matco Tools

27800 - Matco Tools

Tests throttle body injectors, ported fuel injectors and sequential central port injectors, Adjustable probe fits all electronic fuel injection systems and swivels to fit various widths, Flashing light indicates normal pulses, no light indicates a problem.

Product

Interferometers

-

DYNEOS AG

DYNEOS AG

* Michelson Interferometer with a stabilized single-frequency He-Ne Laser as scale *Measurement range: up to 80 m *Resolution: 5 pm *Wide acceptance angle (up to ± 22.5°) for ball/hollow cube reflector

Product

Trailer Light and Air Brake System Tester

Express Mobile

-

Square Wheel Industries, Inc.

Express Mobile - Square Wheel Industries, Inc.

The Express Mobile eliminates most of the walkingassociated with trailer servicing. When you eliminate all that non-productive time and effort, you can easily check all lighting functions and the air brake system (including brake adjustment) in just two minutes, start to finish.

Product

Entry-level Price Interferometer for Geometry Measurement of Single Fibers

3D SCOPE-V2

-

DATA-PIXEL SAS

3D SCOPE-V2 - DATA-PIXEL SAS

Specifically designed for use in a production environment, 3D Scope-V2 is a robust, compact and easy to use interferometer that brings speed and precision to operators. 3D Scope-V2 supports our Blink software platform. Non-compressed, real time and high quality images are transfered from the hardware to the software via a USB 2.0 link in addition to the automation and control commands.

Product

LilyPad Light Sensor

-

SparkFun Electronics

SparkFun Electronics

The LilyPad Light Sensor is a sewable breakout board with an ALS-PT19 light sensor built in and ready to use right away. Each sensor outputs voltage between 0V and 3.3V depending on the level of ambient light shining on it. As more light is applied on the sensor, more current will flow from the board through the signal tab to the microcontroller you connect the sensor to. If the sensor receives no light, no current will flow through it. In a typical indoor lighting situation, the sensor will output around 1 to 2V. Adding this board into your next e-textile or wearable project will really open up the possibilities by being able to incorporate light level sensing capabilities.

Product

SpectralLED® Tunable Light Sources

-

Gamma Scientific Inc.

Gamma Scientific Inc.

The award-winning SpectralLED® family of uniform intensity tunable light sources are designed to deliver unmatched resolution and accuracy. These adjustable wavelength LED light sources also have an operating lifetime and cost of ownership that cannot be duplicated with traditional light sources such as Tungsten-Halogen and Xenon lamps. With a fully spectrally tunable output, all you need is one SpectralLED to generate any arbitrary spectral power distribution, whether it be blackbody, daylight, fluorescent, LED, or something completely unique. By sweeping through individual LED channels, the SpectralLED can even emulate a traditional monochromator light source, with no moving parts and no halogen input illumination.

Product

Flameproof Type Safety Light Curtain Type 4

BSF4-AH80

-

Panasonic Industrial Devices Sales Company of America

BSF4-AH80 - Panasonic Industrial Devices Sales Company of America

Flameproof Type Safety Light Curtains Type 4 from Panasonic comply with worldwide flameproof standards. Protection height of 1,595 mm or 62.8 inches.

Product

2MP Sony STARVIS IMX290 Ultra-low Light Jetson TX2 Camera

E-CAM21_CUTX2

-

e-con Systems Inc.

E-CAM21_CUTX2 - e-con Systems Inc.

e-CAM21_CUTX2 is a 2MP Ultra-Lowlight 4-lane MIPI CSI-2 camera board for NVIDIA® Jetson TX2 developer kit. This camera is based on 1/2.8" SONY IMX290 CMOS Sensor, one of the most popular Sony's STARVIS® sensor. Its effective pixel back-illuminated technology with improved sensitivity in the visible-light and near infrared light enables customers to capture images even in absolute darkness. This Starlight Camera uses NVIDIA® on-board Jetson TX2 Image Signal Processor (ISP) to perform all the Auto functions (Auto White Balance, Auto Exposure control) and significantly, improved image quality. It has S-mount (M12) lens holder which allows customers to choose and use the lens according to their requirement.

Product

Low Light USB Camera With Microphone

Conversa

-

e-con Systems Inc.

Conversa - e-con Systems Inc.

Conversa, camera for conversation (See3CAM_CU38), is a 3.4 MP low light USB 3.1 Gen1 camera with built-in stereo microphone providing 16bit audio @48KHz. This low-light USB camera is the next advanced version of our flagship product See3CAM_CU30, with built-in stereo microphone for crystal clear sound. It is a plug-and-play (UVC and UAC) compliant USB 3.1 Gen1 SuperSpeed camera and is also backward compatible with USB 2.0 host ports. It has S-mount (M12) lens holder which allows customers to choose and use the lens according to their requirement. It has a dedicated, high-performance Image Signal Processor chip (ISP) that performs all the Auto functions (Auto White Balance, Auto Exposure control).

Product

Revopoint MetroX: Blue Laser Line and Full-field Structured Light 3D Scanner

-

Revopoint3D

Revopoint3D

4 Flexible Scanning Modesꔷ Metrology-grade Accuracy: Up to 0.03 mmꔷ Volumetric Accuracy: Up to 0.03 mm + 0.1 mm × L(m)ꔷ Up to 7,000,000 Points/s in Full-field Structured Light Modeꔷ Up to 800,000 Points/s in Multi-line Laser Mode

Product

Reading Lights

-

Astronics Corporation

Astronics Corporation

Our Carat® lights offer a wide range of fully customized reading light solutions crafted for your unique needs.